Effect of soil solids concentration in batch tests on the partition coefficients of organic pollutants in landfill liner-soil materials

 The effect of the soil solids concentration in batch tests on the measured values of the partition coefficient (K _p) of organic pollutants in landfill liner-soil material was investigated. Since this study was based on the results of batch and column tests conducted independently, there were limitations to the conclusions derived. The organic compounds tested were benzene, methylene chloride, toluene, trichloroethylene, and p-xylene. The results of this study showed that as soil solids concentrations increased, the measured K _p values of these organic compounds strongly decreased. The observed values of K _p stabilized when the soil solids concentration was above a certain value. Typical K _p values obtained from batch tests conducted under high soil solids concentrations were close to those obtained from column tests. It was concluded that the K _p values of organic compounds measured under low soil solids concentrations, i.e., less than 100 g/l, may not correctly simulate the field situation. Consequently, the values of K _p obtained with low soil solids concentrations can result in an overestimation of the retardation factor of the landfill liner material. Received: March 14, 2002 / Accepted: August 25, 2002     

Microbial cycling of iron and sulfur in acidic coal mining lake sediments

Lakes caused by coal mining processes are characterized by low pH, low nutrient status, and high concentrations of Fe(II) and sulfate due to the oxidation of pyrite in the surrounding mine tailings. Fe(III) produced during Fe(II) oxidation precipitates to the anoxic acidic sediment, where the microbial reduction of Fe(III) is the dominant electron-accepting process for the oxidation of organic matter, apparently mediated by acidophilic Acidiphilium species. Those bacteria can reduce a great variety of Fe(III)-(hydr)oxides and reduce Fe(III) and oxygen simultaneously which might be due to the small differences in the redox potentials under low pH conditions. Due to the absence of sulfide, Fe(II) formed in the upper 6 cm of the sediment diffuses to oxic zones in the water layer where itcan be reoxidized by Acidithiobacillus species. Thus, acidic conditions are stabilized by the cycling of iron which inhibits fermentative and sulfate-reducing activities. With increasing sediment depth, the amount of reactive iron decrease, the pH increases above 5, and fermentative and as yet unknown Fe(III)-reducing bacteria are also involved in the reduction of Fe(III). Sulfate is reduced apparently by the activity of spore-forming sulfate reducers including new species of Desulfosporosinus that have their pH optimum similar to in situconditions and are not capable of growth at pH 7. However, generation of alkalinity via sulfate reduction is reduced by the anaerobic reoxidation of sulfide back to sulfate. Thus, the microbial cycling of iron at the oxic-anoxic interface and the anaerobic cycling of sulfur maintains environmental conditions appropriate for acidophilic Fe(III)-reducing and acid-tolerant sulfate-reducing microbial communities.     

Drying of granulated wood ash by flue gas from saw dust and natural gas combustion

At the district heating plant of Kalmar, Sweden an on-line unit for production of granulated wood ash for nutrient recycling on forest soils is being applied. Currently, the granules are dried by hot air from an oil-fired burner. The objective of this work was to investigate how drying by flue gas affects the hardening of granules, or impacts their chemical composition and properties. Ninety-six granule samples were treated by flue gas from natural gas combustion in a laboratory pilot scale flue gas generator. CO₂, CO, O₂, C₃H₈ and NO concentrations were varied during the experiment. Additionally, some samples were treated by flue gas from combustion of sawdust at the heating plant in Kalmar. Drying by flue gases did not affect the chemical composition of granules, but minor effects were seen in their mineralogy. The carbonate content was slightly higher in granules treated with flue gas from natural gas combustion compared to the granules dried by hot air only, when measured by wet chemical methods. Results from XRD analysis imply that the calcite content is higher and the portlandite and arcanite content slightly less in granules treated with flue gas from sawdust combustion compared to the granules dried by hot air only. The results from this investigation showed no negative effects on ash granule composition or physical structure by the use of a flue as a drying medium.     

Paradise Threatened: Land Use and Erosion on St. John, US Virgin Islands

2 /yr, respectively. Geomorphic evidence indicates that plantation agriculture during the 18th and 19th centuries did not cause severe erosion. Since about 1950 there has been rapid growth in roads and development due to increasing tourism and second-home development. Our field investigations identified the approximately 50 km of unpaved roads as the primary source of anthropogenic sediment. Field measurements of the road network in two catchments led to the development of a vector-based GIS model to predict road surface erosion and sediment delivery. We estimate that road erosion has caused at least a fourfold increase in island-wide sediment yields and that current sedimentation rates are unprecedented. Paving the dirt roads and implementing standard sediment control practices can greatly reduce current sediment yields and possible adverse effects on the marine ecosystems surrounding St. John.     

Comparing Environmental Conditions Using Indicators of Pollution Hazard

/ Land use/land cover classifications for 1973 and 1991, derived from the interpretation of satellite imagery, are quantified on the basis of biophysical land units in a study area in southeastern Australia. Nutrient export potentials are estimated for each land unit based on their composition of land use/land cover classes. Spatial and temporal comparisons are made of the land units based on the calculated pollution hazard indicators to provide an insight into changes in the state of the environment and the regional significance of land use changes. For example, one ecosystem, unique to the study, showed a large increase in pollution hazard over the study period as a manifestation of an 11-fold rise in cleared area and an expansion of cropping activities. The benefits to environmental management in general are discussed.KEY WORDS: Land cover change; Nutrient export; Environmental condition; Pollution hazard; Agricultural pollution; Nonpoint source pollution; Diffuse pollution; Environmental degradation     

Quantitative Assessment of the Intertidal Environment of Kuwait I: Integrated Environmental Classification

Quantitative analysis of physical, chemical and biological data of the intertidal zone in Kuwait was undertaken to develop an integrated basis for assessing and protecting this sensitive coastal ecosystem. Cluster analyses were performed to determine the resemblance between the sampling stations based on the sediment composition, the benthic macrofauna and the physico-chemical characteristics of the intertidal sediment/water. Five distinct sub-environments were delineated within the intertidal zone of Kuwait. Each sub-environment was described in terms of number of taxa, mean density of organisms, sediment type, tidal level and dominant organisms. The physico-chemical parameters investigated were found to be unimportant in the distribution of the intertidal benthic macrofauna. On the other hand, sediment type was found to be a major factor in the overall composition of the benthic community. The benthic fauna and related characteristics of the sub-environments could be used as indicators to monitor changes in the intertidal ecosystem and as guides to protection and management of the different coasts. The approach described in this paper could also be adopted elsewhere to provide a sound basis for evaluating environmental impacts and for developing sustainable coastal management.     

Strategic environmental product planning within Philips sound & vision

Until now no structured methodology existed for attuning environmental considerations to the business strategy of companies. The Environmental Competence Centre of Philips Sound & Vision in The Netherlands has developed and tested a methodology for this purpose. This methodology, called Selection of STRrategic Environmen Tal CHallenges (STRETCH), has proven to lead to promising results and should therefore be actively promoted. In this article, the authors show how the application of STRETCH provides the possibility of meeting three main objectives: First, focusing on the incorporation of environmental aspects into the company's business strategy can elicit innovations that may enhance the competitive position of the company by cost reduction and/or higher market shares. Second, the environmental opportunities and threats to be expected in the future can be anticipated in an earlier phase. Through this proactive approach a company can avoid external criticism and take the lead in environmental priority setting. Third, by applying the STRETCH methodology even higher eco-efficiencies are expected to be reached than through incremental, step-by-step environmental improvements.     

Incidents in manual handling activities

More than 20000 handling manoeuvres in loading or unloading trailers in a large transportation company were observed. The aim of the study was to determine the frequency and nature of the incidents occurring whilst handling. The incidents were recorded and interpreted from a double perspective, namely as risk factors and as activity regulation factors. The study showed that on average, one incident occurred in every seven handling manoeuvres: 71% of them were related to the environment, and 29% to the activity. While numerous, the environment-related incidents were generally without consequences. In this respect, the activity incidents appeared more risky; also, the majority of these incidents occurred during the load positioning phase. The study also showed that loads are re-handled twice as often in unloading as in loading, the frequency of re-handlings varying widely from one handler to another. The reasons why so few of the observed incidents are reported in accident studies and their significance in the understanding of handling problems are discussed.