Distribution of vehicular pollutants in street canyons of Varanasi, India: a different case

In present study horizontal and vertical distribution of traffic-related pollutants (CO and SO(2)) within the street canyons in (CO and SO(2)) Varanasi, India was monitored. The results showed that average horizontal profiles of traffic-related pollutant concentrations within street canyon at leeward side were approximately same as that of windward side. However, the vertical concentration of both the pollutants decreases with height above the ground and study indicated that CO and SO(2) concentrations at different heights below the roof showed clear vertical self-gradient. CO and SO(2) concentration decreased with height and the minimum value occurred at the roof. It was concluded from the observed results that pollutants from vehicular exhaust emissions in the street canyon of Varanasi were evenly distributed. This result may be due to the fact that wind vortices are not formed. Therefore, urban planners can use this type of streets so that there is proper ventilation and dispersal of pollutants.     

Identification of air pollutant sampling period using horizontal dilution potential

A new model is proposed for estimating horizontal dilution potential of an area using wind data. The mean wind speed and wind direction variation are used as a measure of linear and angular spread of pollutant in the atmosphere. The methodology is applied to monitored hourly wind data for each month of 1 year for wind data collected at Vadodara, Gujarat and monthly dilution potential is estimated. It is found that there is a gradual variation of horizontal dilution potential over a year with limited dilution during post monsoon period i.e., October and November and a high dilution in pre monsoon period i.e., May and June. This information can be used to design air quality sampling network and duration of sampling for source apportionment study. Air pollutant sampling during high dilution period can be carried out for identifying urban and rural dust and wind blown dust from mining activity. Air pollutant sampling during low dilution period can be carried out for capturing large amount of particulate matter from anthropogenic sources like elevated stack of furnace.     

Assessment and significance of phytoplankton species composition within Chesapeake Bay and Virginia tributaries through a long-term monitoring program

Phytoplankton and water quality long term trends are presented from a 20-year monitoring program of Chesapeake Bay and several of its major tributaries. Increasing phytoplankton biomass and abundance are ongoing within this estuarine complex, with diatoms the dominant component, along with chlorophytes and cyanobacteria as sub-dominant contributors in the tidal freshwater and oligohaline regions. Diatoms, dinoflagellates, and cryptomonads are among the major flora downstream in the tributaries and within the Chesapeake Bay. Water quality conditions within the three tributaries have remained rather stable over this time period; while there are long term trends of reduced nutrients, increasing bottom oxygen, and decreasing water clarity for the lower Chesapeake Bay. Of note is an increasing trend of cyanobacteria biomass at 12 of the 13 stations monitored at tributary and Chesapeake Bay stations, plus the presence of 37 potentially harmful taxa reported for these waters. However, the overall status of the phytoplankton populations is presently favorable, in that it is mainly represented and dominated by taxa suitable as a major food and oxygen source within this ecosystem. Although potentially harmful taxa are present, they have not at this time exerted profound impact to the region, or replaced the diatom populations in overall dominance.     

Estimation of air pollutant emission loads from construction and operational activities of a port and harbour in Mumbai, India

Port causes environmental and health concerns in coastal cities if its operation and development are not made environmentally compatible and sustainable. An emission inventory is necessary to assess the impact of port projects or growth in marine activity as well as to plan mitigation strategies. In this study, a detailed emission inventory of total suspended particulate (TSP) matter, respirable particulate matter (PM₁₀), sulphur dioxide (SO₂) and oxides of nitrogen (NO_x) for a port having operation and construction activities in parallel is compiled. The study has been done for 1 year. Results show that the maximum contribution of emission of air pollutants in the port area was from TSP (68.5%) and the minimum was from SO₂ (5.3%) to the total pollutants considered in this study. Total TSP emission from all activities of the port was 4,452 tyr^???1 and PM₁₀ emission was 903 tyr^???1 in the year 2006. Re-suspension of dust from paved roads was the major contributor of TSP and PM₁₀ in the road transport sector. Construction activities of the port had contributed 3.9% of TSP and 7.4% of PM₁₀ to total emission of particulate matter. Of the total particulate emissions from various port activities approximately 20% of TSP could be attributed to PM₁₀. The sectoral composition indicates that major contribution of SO₂ emission in the port was from maritime sector and major contribution of NO_x was from road transport sector.     

Bioaccumulation of heavy metals in fish tissues of a freshwater lake of Bhopal

Contamination of heavy metals, namely, lead, cadmium, zinc, nickel, copper, chromium and mercury was evaluated in the samples of water and tissues of Labeo rohita and Ctenopharyngodon idella of Upper Lake of Bhopal collected during summer, rainy and winter seasons of 2005–2006. Different organs of the fishes accumulated varying quantities of different heavy metals. In L. rohita, accumulation of heavy metals was in the sequence liver > kidney > gills > muscles, and in C. idella, it was gills > liver > kidney > muscles. Zn was the highest accumulating metal in fish, whilst Hg was the lowest and was well corroborated with those of water. The values of heavy metals were so far well within the maximum permissible standard value of heavy metals for drinking water and for fish culture as prescribed by various national and international agencies.     

Hydrogeochemical data as a tool for exploration and mapping: a case study from part of Afikpo Basin southeastern Nigeria

Fourteen (14) characters from six (6) water samples collected from springs, ponds, and streams located in Lower Cretaceous sedimentary area of Afikpo Basin have been analyzed. These include pH, turbidity, conductivity, total dissolved solid, hardness, Fe²⁺, Ca²⁺, Mg²⁺, K⁺, NO₃ ^?, Cl^?, SO₄ ^2?, and Na⁺. These sediments, which are Turonian and Coniacian in age, are subdivided into two by a basic rock dyke. Results of the analyses show clearly that the Turonian sediments, intruded by dolerite, have net Fe²⁺, HCO₃ ^?, Ca²⁺, Mg²⁺, Mn²⁺, Cl^?, and SO₄ ^2? concentration while those from the younger Coniacian sediment have net higher amounts of K⁺, Na⁺, and Mn²⁺. The overriding mafic minerals in the basic intrusive rock possibly led to higher leaching into ground water system near it. On the other hand, the presence of feldsparthic to kaolinitic sands of the younger Coniacian units led to higher K⁺ and Na⁺ matter in the water from these zones. The formations dip away from the older sediments. Concentrations of these characters are within acceptable drinking water standards by World Health Organization but noticeable anomalous zones for Fe²⁺, Mg²⁺, and Ca²⁺ are zones of basic rock suites. Areas with greater Na⁺ and K⁺ are traceable to sandy units. It is thus concluded that more analysis of surface, subsurface, and pond water samples can be utilized for minerals search and geological mapping. At this stage, it forms a veritable reconnaissance tool.     

Arsenic in shallow aquifer in the eastern region of Bangladesh: insights from principal component analysis of groundwater compositions

Probable sources and mechanisms of arsenic (As) release in shallow aquifer in eastern Bangladesh are evaluated using statistical analysis of groundwater compositions. Dissolved As in 39 samples ranged from 8.05 to 341.5 μg/L with an average of 95.14 μg/L. Ninety seven percent of wells exceed the WHO limit (10 μg/L) for safe drinking water. Principal component analysis is applied to reduce 16 measured compositional variables to five significant components (principal components—PCs) that explain 86.63% of the geochemical variance. Two component loadings, namely PC 1 and PC 2 (45.31% and 23.05%) indicate the natural processes within the aquifers in which organic matter is a key reactant in the weathering reactions. Four groups of wells are defined by the PCA and each group of wells represents distinct physicochemical characteristics. Among them, group III groundwater shows higher As concentration together with high concentrations of Fe, Mn, dissolved organic carbon, $\text{PO}_{4}^{3-}$ and $\text{HCO}_{3}^{-}$ than groups I and II. Speciation calculations suggest that only wells of group III are saturated with respect to siderite, and all groups of samples are supersaturated with respect of rhodochrosite. The relationship of As with these parameters in the different groups of wells of the study area suggests that reductive dissolution of Fe–Mn oxyhydroxides with microbially mediated degradation of organic matter is considered to be the dominant processes to release As in groundwater.     

Impact of overland traffic on heavy metal levels in highway dust and soils of Istanbul, Turkey

The purpose of this study was to investigate the impact of overland traffic on the spatial distribution of heavy metals in urban soils (Istanbul, Turkey). Road dust, surface, and subsurface soil samples were collected from a total of 41 locations along highways with dense traffic and secondary roads with lower traffic and analyzed for lead (Pb), zinc (Zn), and copper (Cu) concentrations. Statistical evaluation of the heavy metal concentrations observed along highways and along the secondary roads showed that the data were bimodally distributed. The maximum observed Pb, Zn, and Cu concentrations were 1,573, 522 and 136 mg/kg, respectively, in surface soils along highways and 99.3, 156, and 38.1 mg/kg along secondary roads. Correlation analysis of the metal concentrations in road dust, surface and 20-cm depth soils suggests the presence of a common pollution source. However, metal concentrations in the deeper soils were substantially lower than those observed at the surface, indicating low mobility of heavy metals, especially for Pb and Zn. A modified kriging approach that honors the bimodality of the data was used to estimate the spatial distribution of the surface concentrations of metals, and to identify hotspots. Results indicate that despite the presence of some industrial zones within the study area, traffic is the main heavy metal pollution source.     

Fire risk evaluation using multicriteria analysis—a case study

Forest fires are one of the major causes of ecological disturbance and environmental concerns in tropical deciduous forests of south India. In this study, we use fuzzy set theory integrated with decision-making algorithm in a Geographic Information Systems (GIS) framework to map forest fire risk. Fuzzy set theory implements classes or groupings of data with boundaries that are not sharply defined (i.e., fuzzy) and consists of a rule base, membership functions, and an inference procedure. We used satellite remote sensing datasets in conjunction with topographic, vegetation, climate, and socioeconomic datasets to infer the causative factors of fires. Spatial-level data on these biophysical and socioeconomic parameters have been aggregated at the district level and have been organized in a GIS framework. A participatory multicriteria decision-making approach involving Analytical Hierarchy Process has been designed to arrive at a decision matrix that identified the important causative factors of fires. These expert judgments were then integrated using spatial fuzzy decision-making algorithm to map the forest fire risk. Results from this study were quite useful in identifying potential “hotspots” of fire risk, where forest fire protection measures can be taken in advance. Further, this study also demonstrates the potential of multicriteria analysis integrated with GIS as an effective tool in assessing “where and when” forest fires will most likely occur.     

Monsoon-induced changes in the size-fractionated phytoplankton biomass and production rate in the estuarine and coastal waters of southwest coast of India

Changes in the autotrophic pico- (0.2–2 μm), nano- (2–20 μm), and microplankton (>20 μm) biomass (chlorophyll a) and primary production were measured in the estuarine and coastal waters off Cochin, southwest coast of India during the onset and establishment of a monsoon. During this period, the estuary was dominated by nutrient-rich freshwater, whereas the coastal waters were characterized with higher salinity values (>30 psu) and less nutrients. The average surface chlorophyll a concentrations and primary production rates were higher in the estuary (average 13.7 mg m^???3 and 432 mgC m^???3 day^???1) as compared to the coastal waters (5.3 mg m^???3 and 224 mgC m^???3 day^???1). The nanoplankton community formed the major fraction of chlorophyll a and primary production, both in the estuary (average 85 ± SD 8.3% and 81.2 ± SD 3.2%) and the coastal waters (average 73.2 ± SD 17.2% and 81.9 ± 15.7%). Nanoplankton had the maximum photosynthetic efficiency in the coastal waters (average 4.8 ± SD 3.9 mgC mgChl a m^???3 h^???1), whereas in the estuary, the microplankton had higher photosynthetic efficiency (average 7.4 ± 7 mgC mgChl a m^???3 h^???1). The heavy cloud cover and increased water column turbidity not only limit the growth of large-sized phytoplankton in the Cochin estuary and coastal waters but also support the proliferation of nanoplankton community during the monsoon season, even though large variation in nanoplankton chlorophyll a and production exists between these two areas.