Analysis of perfluorooctanoate (PFOA) and other perfluorinated compounds (PFCs) in the River Po watershed in N-Italy

C7-C11 perfluorinated carboxylates (PFACs) and perfluorooctansulfonate (PFOS) were analysed in selected stretches of the River Po and its major tributaries. Analyses were performed by solid-phase extraction (SPE) with Oasis HLB cartridges and methanol elution followed by LC-MS-MS detection using 13C-labelled internal standards. High concentration levels ( approximately 1.3 microg l(-1)) of perfluorooctanoate (PFOA) were detected in the Tánaro River close to the city Alessandria. After this tributary, levels between 60 and 337 ng l(-1) were measured in the Po River on several occasions. The PFOA concentration close to the river mouth in Ferrara was between 60 and 174 ng l(-1). Using the river discharge flow data in m3 s(-1) at this point (average approximately 920 m3 s(-1) for the year 2006), a mass load of approximately 0.3 kg PFOA per hour or approximately 2.6 tons per year discharged in the Adriatic Sea has been calculated. PFOS concentration levels in the Po River at Ferrara were approximately 10 ng l(-1).     

Low cost measurements of nitrogen and sulphur dry deposition velocities at a semi-alpine site: gradient measurements and a comparison with deposition model estimates

The conditional time averaged gradient method was used to measure air-surface exchange of nitrogen and sulphur compounds at a semi-alpine site in Southern Norway. Dry deposition velocities were then obtained from the bi-weekly concentration gradient measurements. Annual deposition velocities were found to be 1.4, 11.8 and 4.0 mm s(-1) for NH3, HNO3 and SO2, respectively, if all data were included, and to be 10.8, 11.8 and 13.0 mm s(-1), respectively, if only positive values were included. Measured deposition velocities were compared to two sets of values estimated from a big-leaf dry deposition module applying to two different land types (short grass and forbs, and tundra), driven by measured micrometeorological parameters. The deposition module gives reasonable values for this site throughout the year, but does not reproduce the large variability as shown in the measured data. No apparent seasonal variations were found from either measurements or module estimates due to the very low productivity of the studied area.     

An inter-laboratory study to test the ability of amendments to reduce the availability of Cd, Pb, and Zn in situ

An international inter-laboratory research program investigated the effectiveness of in situ remediation of soils contaminated by cadmium, lead and zinc, measuring changes in soil and soil solution chemistry, plants and soil microbiota. A common soil, from mine wastes in Jasper County MO, was used. The soil was pH 5.9, had low organic matter (1.2 g kg(-1) C) and total Cd, Pb, and Zn concentrations of 92, 5022, and 18 532 mg kg(-1), respectively. Amendments included lime, phosphorus (P), red mud (RM), cyclonic ashes (CA), biosolids (BIO), and water treatment residuals (WTR). Both soil solution and NH4NO3 extractable metals were decreased by all treatments. Phytotoxicity of metals was reduced, with plants grown in P treatments having the highest yields and lowest metal concentration (0.5, 7.2 and 406 mg kg(-1) Cd, Pb, and Zn). Response of soil micro-organisms was similar to plant responses. Phosphorus addition reduced the physiologically based extraction test Pb from 84% of total Pb extracted in the untreated soil to 34.1%.     

Microbial degradation of the benzonitrile herbicides dichlobenil, bromoxynil and ioxynil in soil and subsurface environments--insights into degradation pathways, persistent metabolites and involved degrader organisms

The benzonitriles dichlobenil, bromoxynil and ioxynil are important broad-spectrum or selective herbicides used in agriculture, orchards and public areas worldwide. The dichlobenil metabolite 2,6-dichlorobenzamide is the most frequently encountered groundwater contaminant in Denmark, which suggests that the environmental fate of these three structurally related benzonitrile herbicides should be addressed in detail. This review summarises the current knowledge on microbial degradation of dichlobenil, bromoxynil and ioxynil with particular focus on common features of degradation rates and pathways, accumulation of persistent metabolites and diversity of the involved degrader organisms.     

A new approach to in-situ determination of roadside particle emission factors of individual vehicles under conventional driving conditions

A method for continuous on-road measurements of particle number emissions for both diesel- and petrol-fuelled vehicles is presented. The setup allows the determination of particle number emission factors on an individual vehicle basis by the simultaneous measurement of CO₂ and particle concentrations. As an alternative to previous measurements on the kerbside, the sample is taken directly in the street, with the advantage of sampling in-situ within the exhaust plumes of passing vehicles, allowing the separation of the individual high-concentration plumes. The method was tested in two experiments that were conducted in the Gothenburg area. In the first study, which was performed at an urban roadside, we were able to determine particle emission factors from individual vehicles in a common car fleet passing the measurement site. The obtained emission factors were of the same order of magnitude (between 1.4 × 10¹² and 1.8 × 10¹⁴ particles km^?1) as values published in the recent literature for light duty vehicles. An additional on-road experiment was conducted at a rural road with four light duty reference vehicles (three of them petrol-powered and one diesel-powered) at driving speeds of 50 and 70 km h^?1, realised with different engine speeds. The results of the traffic emission studies show that the method is applicable provided that instruments with an adequate dynamic range are used and that the traffic is not too dense. In addition, the variability in particle emissions for a specified driving condition was estimated.     

A method of approach to landscape stability. Part 1: Fundamentals and methodology

A four-stage method of providing conditions for improving the stability of a landscape sector is presented. In the first stage, structure and function of the landscape system is examined, predominantly based on the results of monitoring. In the second stage, a method is suggested for applying monitoring data to a dynamic structure with complex functions of the territory under examination. In the third stage, the territory is optimized as to the function of particular components within it. The optimization consists in controlling the dynamics of the flows of material, energy, and population within the sector. In the fourth stage, the holistic function of the landscape strip should be monitored with respect to representative key factors. The entire concept is based on assuming the existence of destabilizing processes leading to ecocritical situations and determining mitigating factors using heuristic methods of optimization.     

The case for free market environmentalism

Environmental Ethics is the ethics of how we humans are to relate to each other about the environment we live in. The best way to adjust inevitable differences among us in this respect is by private property. Each person takes the best care of what he owns, and ownership entails the free market, which enables people to make mutually advantageous trades with those who might use it even better. Public regulation, by contrast, becomes management in the interests of the regulators, or of special interests, such as lovers of rare species-not the people they're supposed to be serving.     

Impacts of foreign investment on sustainable development in a Chilean mining region

The desert mining region of Antofagasta, Chile, enjoyed spectacular economic growth in the 1990s as a result of foreign direct investment (FDI), mainly in the exploitation of the region's rich copper deposits. In a country considered by international financial institutions to be a good example of economic performance, Antofagasta has been termed a model region,and Chile's economic and social development in the 1990s has been considered a suitable model for other Latin American countries. However, development indices based on statistical data must be examined with caution, as human welfare does not necessarily keep pace with economic growth. This article analyses the Antofagasta Region in terms of problems that may occur in conjunction with accelerated economic growth, and how these can affect the environment, as well as the regional labour market. The article also examines a regional economic strategy for Antofagasta recently proposed by the local government, and suggests new alternatives for the sustainable economic development of the region.