千层塔扦插繁殖研究

通过扦插试验,采用不同浓度水平的吲哚丁酸、萘乙酸、生根粉和吲哚丁酸＋萘乙酸等药剂处理千层塔插条,研究对插条的生根量、生根率、成活率等的影响和插条萌芽状况及扦插基质对插条生根的影响,为千层塔资源快速再生提供有效的繁殖途径。     

Health risk assessment maps for arsenic groundwater content: application of national geochemical databases

This investigation assesses the feasibility of calculating and visualizing health risk estimates from exposure to groundwater contaminated with arsenic (As) using data from national geochemical databases. The potential health risk associated with As-contaminated groundwater was assessed based on an elaboration of existing geochemical data in accordance with accepted methodological procedures established for human health risk assessment (U.S. Environmental Protection Agency methodology). A screening analysis approach was used for estimating the contribution of As to the total chronic health risk from exposure to groundwater contaminated with potentially toxic elements, including As, Ba, Cd, Cu, Hg, Pb, Sb, Se and Zn, and the results indicate that As contributes significantly (>50%) to this total health chronic risk in about 10% of Slovak territory. Based on the calculation of the potential risk level by exposure modelling, increased chronic as well as carcinogenic risk levels (medium to high) were documented in approximately 0.2 and 11% of the total Slovak area, respectively. The areas characterized by high health risk levels are mainly those geogenically contaminated. High and very high carcinogenic risk was determined in 34 of 79 districts and in 528 of 2924 municipalities.     

Analysis of emergency situations at municipal solid waste landfills

Journal of Material Cycles and Waste Management - This work focuses on the issue of emergency prevention in the operation of municipal solid waste landfills. In this work, an emergency is...     

Chemical characterization of fine aerosols in respect to water-soluble ions at the eastern Middle Adriatic coast

Fine particulate matter (PM2.5) concentrations at the Middle Adriatic coastal site of Croatia were affected by different air-mass inflows and/or local sources and meteorological conditions, and peaked in summer. More polluted continental air-mass inflows mostly affected the area in the winter period, while southern marine pathways had higher impact in spring and summer. Chemical characterization of the water-soluble inorganic and organic ionic constituents is discussed with respect to seasonal trends, possible sources, and air-mass inputs. The largest contributors to the PM2.5 mass were sea salts modified by the presence of secondary sulfate-rich aerosols indicated also by principal component analysis. SO42− was the prevailing anion, while the anthropogenic SO42− (anth-nssSO42−) dominantly constituted the major non-sea-salt SO42− (nssSO42−) fraction. Being influenced by the marine origin, its biogenic fraction (bio-nssSO42−) increased particularly in the spring. During the investigated period, aerosols were generally acidic. High Cl− deficit was observed at Middle Adriatic location for which the acid displacement is primarily responsible. With nssSO42− being dominant in Cl− depletion, sulfur-containing species from anthropogenic pollution emissions may have profound impact on atmospheric composition through altering chlorine chemistry in this region. However, when accounting for the neutralization of H2SO4 by NH3, the potential of HNO3 and organic acids to considerably influence Cl− depletion is shown to increase. Intensive open-fire events substantially increased the PM2.5 concentrations and changed the water-soluble ion composition and aerosol acidity in summer of 2015. To our knowledge, this work presents the first time-resolved data evaluating the seasonal composition of water-soluble ions and their possible sources in PM2.5 at the Middle Adriatic area. This study contributes towards a better understanding of atmospheric composition in the coastal Adriatic area and serves as a basis for the comparison with future studies related to the air quality at the coastal Adriatic and/or Mediterranean regions.     

Effects of reciprocal hybridization on cadmium accumulation in F1 hybrids of two Solanum photeinocarpum ecotypes

In this study, farmland and mining ecotypes of Solanum photeinocarpum (a potential cadmium (Cd) hyperaccumulator plant) were reciprocally hybridized each other, and the Cd accumulation characteristics of the F1 hybrids were studied. In pot experiments, higher biomasses and Cd extraction abilities were found for two S. photeinocarpum F1 hybrids than for the parents, but the Cd contents in various organs were lower in the hybrids than the parents. However, the differences between the Cd contents in the two hybrids were not significant. The antioxidant enzyme (superoxide dismutase and peroxidase) activities were higher for the S. photeinocarpum F1 hybrids than the parents. Less DNA methylation was found in the hybrids than the parents because more demethylation occurred in the hybrids than the parents. The biomass, Cd content, and Cd extraction ability effects in field experiments were similar to the effects in the pot experiments. It was concluded that reciprocally hybridizing different S. photeinocarpum ecotypes improved the ability of S. photeinocarpum to be used to phytoremediate contaminated land.

     

Periphyton Developed on Artificial Substrates: Effect of Substrate Type and Incubation Depth

The aim of this study was to assess the effect of substrate type and incubation depth on periphyton that had developed on artificial substrates. Uniform rectangular tiles made out of artificial substrates: glass, ceramic, willow tree and yew tree, were fixed on a floating buoy and deployed at three different depths in a photic zone of the Sava Lake (Belgrade, Serbia). Non-taxonomic attributes in the developed biofilm were estimated week-by-week from the start of the experiment in July, until its end in September 2014. Through assessment of substrate type and depth of incubation effect we concluded that these parameters for the fact influence periphyton development and composition. Glass was preferred by autotrophic component over ceramic and wooden substrates. In general, substrate type effect was diminished by increasing incubation depth. When non-taxonomic parameters are to be used in biomonitoring studies, our results suggest that glass substrate and shallow layer of water column (up to 50 cm) for incubation should be preferred.     

Photocatalytic reduction of carbon dioxide over Cu/TiO<Subscript>2</Subscript> photocatalysts

The photocatalytic reduction of CO₂ with H₂O was investigated using Cu/TiO₂ photocatalysts in aqueous solution. For this purpose, Cu/TiO₂ photocatalysts (with 0.2, 0.9, 2, 4, and 6 wt.% of Cu) have been synthesized via sol-gel method. The photocatalysts were extensively characterized by means of inductively coupled plasma optical emission spectrometry (ICP-OES), N₂ physisorption (BET), XRD, UV-vis DRS, FT-IR, Raman spectroscopy, TEM-EDX, and photoelectrochemical measurements. The as-prepared photocatalysts contain anatase as a major crystalline phase with a crystallite size around 13 nm. By increasing the amount of Cu, specific surface area and band gap energy decreased in addition to the formation of large agglomeration of CuO. Results revealed that the photocatalytic reduction of CO₂ decreased in the presence of Cu/TiO₂ in comparison to pure TiO₂, which might be associated to the formation of CuO phase acting as a recombination center of generated electron-hole pair. Decreasing of photoactivity can also be connected with a very low position of conduction band of photocatalysts with high Cu content, which makes H₂ production necessary for CO₂ reduction more difficult.     

Biochemical biomarkers in environmental studies—lessons learnt from enzymes catalase,glutathione <Emphasis Type="Italic">S</Emphasis>-transferase and cholinesterase in two crustacean species

Background, aim and scope  

For reliable environmental risk assessment of pollutants, knowledge on the effects at different levels of biological organisation is needed. During the early days of biomarker research in environmental studies approximately two decades ago, biochemical biomarkers were considered as the most promising tool for such purposes. Among these, three enzymes have often been studied: catalase (CAT), glutathione S-transferase (GST) and cholinesterase (ChE). However, despite their intensive research, their measurements in invertebrates have not been commonly applied in environmental risk assessment (ERA) or for regulatory purposes.     

Forest Die-Back Modified Plankton Recovery from Acidic Stress

We examined long-term data on water chemistry of Lake Rachelsee (Germany) following the changes in acidic depositions in central Europe since 1980s. Despite gradual chemical recovery of Rachelsee, its biological recovery was delayed. In 1999, lake recovery was abruptly reversed by a coincident forest die-back, which resulted in elevated terrestrial export of nitrate and ionic aluminum lasting ~5 years. This re-acidification episode provided unique opportunity to study plankton recovery in the rapidly recovering lake water after the abrupt decline in nitrate leaching from the catchment. There were sudden changes both in lake water chemistry and in plankton biomass structure, such as decreased bacterial filaments, increased phytoplankton biomass, and rotifer abundance. The shift from dominance of heterotrophic to autotrophic organisms suggested their substantial release from severe phosphorus stress. Such a rapid change in plankton structure in a lake recovering from acidity has, to the best of our knowledge, not been previously documented.     

Highly active photocatalytic coatings prepared by a low-temperature method

Photocatalytic properties of titanium (IV) oxide (TiO₂) in anatase form can be used for various purposes, including photocatalytic purification of water. For such an application, suspended or fixed photocatalytic reactors are used. Those with fixed phase seem to be preferred due to some advantages, one of which is the avoidance of photocatalyst filtration. To avoid leaching and exfoliation of the fixed phase, an immobilization procedure leading to a good adhesion of a catalyst to a substrate is crucial. Within this work, we present physical and photocatalytic characterization results of five commercially available TiO₂ photocatalysts (P25, P90, PC500, KRONOClean 7000, VPC-10) and one pigment (Hombitan LO-CR-S-M), which were successfully immobilized on glass slides by a “sol suspension” procedure. Different mechanical tests and characterization methods were used to evaluate the stability and morphology of the layers. Evaluation of photocatalytic activity was done by tests under UVA and UV–vis irradiation, using a method based on the detection of the fluorescent oxidation product of terephthalic acid (TPA), i.e., hydroxyterephthalic acid (HTPA). Aeroxide® P90 incorporated into the silica-titania binder was the most photocatalytically active layer and, unlike the others, showed significant increase of photocatalytic activity through the entire range of tested UVA irradiation intensities (2.3 mW/cm²–6.1 mW/cm²). The high mechanical stability of some photocatalytic layers allows using them in water photocatalytic purification reactions.