The application of a simplified method to map the aerobic acetate mineralization rates at the groundwater table of the Netherlands

A simplified method is used to assess the microbial activity of subsoils and soils across a broad geographic scale. Acetate was selected because it is a major intermediate in catabolic biochemical pathways. In order to get minimal disturbance, only a small amount of tritium labelled acetate and water is added to the subsoil material. After an incubation time, the subsoil material is separated from the water by centrifugation and the formed tritium labelled water is separated from the remaining acetate by evaporation. The data of 128 locations in the Netherlands were plotted in a soil map and were also compared with the depth, dry weight, electric conductivity, pH and nitrate concentration. The peat areas consisted of limed meadows with a high groundwater level whereas the sand areas often showed deeper groundwater levels and a lower pH. The subsoils at the groundwater table of the peat areas, which are in contact with soil air, showed a higher mineralization rate compared with the surface soils in our study. In contrast, the mineralization rate of the subsoil at the groundwater table of sandy soils showed on average a factor 30 lower rate. Nevertheless, the self purification capacity of the subsoil can be vital under weather conditions where the surface soil becomes less active.     

Influence of RFID tags on recyclability of plastic packaging

The use of Radio Frequency IDentification Technology (RFID) in the packaging sector is an important logistical improvement regarding the advantages offered by this technology in comparison with barcodes. Nevertheless, the presence of these devices in plastic packaging, and consequently in plastic waste, can cause several problems in the recycling plants due to the materials included in these devices.In this study, the mentioned recycling constraints have been experimentally identified in a pilot scale recycling study consisting in three recycling tests with an increasing presence of RFID tags. Differences in each test were evaluated. Furthermore, the quality of the recycled material of each test was studied through the injection and testing of tests probes.The results of the pilot scale recycling tests did not show a decrease in the quality of the recycled plastic due to the presence of RFID tags. Nevertheless, several operational problems during the recycling process were observed such as the obstruction of the screens, which lessened the process yield and created process interruptions, as well as the loss of extruded plastic during the process.These recycling constraints cannot be directly extrapolated to the industrial plants due to the different working scales. Nevertheless, technological solutions are proposed in order to avoid these recycling constraints if they appear.     

Correlation between physicochemical and ecotoxicological approaches to estimate landfill leachates toxicity

Leachates from municipal solid waste (MSW) landfills may contain a huge diversity of contaminants; these wastewaters should be considered as potentially hazardous complex mixtures, representing a potential environmental risk for surface and groundwater. Current MSW landfill wastes regulatory approaches deem exclusively on the physicochemical characterization and does not contemplate the ecotoxicological assessment of landfill leachates. However, the presence of highly toxic substances in consumer products requires reconsideration on the need of more specific ecotoxicological assessments. The main aim of this study was to evaluate the toxicity of different MSW landfill leachates using a battery of toxicity tests including acute toxicity tests with Daphnia magna and the anuran Xenopus laevis and the in vitro toxicity test with the fish cell line RTG-2. The additional objective was to study the possible correlation between physicochemical properties and the toxicity results obtained for untreated landfill leachates. The results showed that the proposed test battery was effective for the ecotoxicological characterization of MSW landfill leachates. A moderate to strong correlation between the measured physicochemical parameters and the calculated toxicity units was detected for all toxicity assays. Correlation factors of 0.85, 0.86 and 0.55 for Daphnia, Xenopus and RTG-2 tests, respectively, were found. The discriminant analysis showed that certain physicochemical parameters could be used for an initial categorization of the potential aquatic acute toxicity of leachates; this finding may facilitate leachates management as the physicochemical characterization is currently the most common or even only monitoring method employed in a large majority of landfills. Ammonia, alkalinity and chemical oxygen demand (COD), together with chloride, allowed a proper categorization of leachates toxicity for up to 75% of tested samples, with a small percentage of false negatives.     

A Methodology for the Evaluation of Water Policies in European Countries

Periodic assessment of progress toward established policy goals is crucial to understanding whether the applied efforts are effective. In Europe, the Water Framework Directive (WFD) adopted in year 2000 set ambitious environmental objectives to be achieved by the end of 2015 through the implementation of Integrated Water Resources Management (IWRM) principles. While at this stage it is premature to measure the impact of this Directive in terms of environmental outcomes, it is nonetheless important to develop indicators in order to monitor whether water management practices throughout Europe are aligning towards IWRM. This article presents the methodological development of the Water and Wetland Index, a comparative water policy assessment by environmental NGOs that was carried out in 2002–2003, and highlights the interest of repeating it in 2015, when the first WFD planning cycle will be completed.     

Spatial configuration of land-use/land-cover in the Pujal-Coy project area, Huasteca Potosina region, Mexico

This article analyzes the relationship between the configuration and spatial reorganization of land-use and land-cover in the Pujal-Coy project area, Huasteca Potosina region, eastern San Luis Potosí, Mexico, as well as the relationship between these changes and the environmental conditions prevailing in the area. Land-use and land-cover changes were determined through the analysis and interpretation of satellite images from different dates. The changes identified in the different study periods were correlated with the prevailing physical factors. The results show that the spatial configuration of farming activities, initially induced by the implementation of a regional development project, is highly correlated to the presence of limiting factors such as soil type, slope, and climate. Particularly, the former represents the element that has led to the establishment of the current distribution pattern of farming activities.     

Performance evaluation of a biotrickling filter treating a mixture of oxygenated VOCs during intermittent loading

Laboratory scale-studies on the biodegradation of a 1:1:1 weight mixture of three oxygenated volatile organic compounds (VOCs), ethanol, ethyl acetate, and methyl-ethyl ketone (MEK) in a biotrickling filter (BTF) were carried out using two identically sized columns, filled with different polypropylene rings. The performance of the BTFs was examined for a period of 10 months applying several operational strategies. Similar performance was obtained for both supports. Intermittent flow rate of trickling liquid was shown beneficial to improve the removal efficiency (RE). Continuous feeding of VOC resulted in an excessive accumulation of biomass so high pressure drop was developed in less than 20-30 d of operation. Intermittent VOC loading with night and weekend feed cut-off periods passing dry air, but without addition of water, was shown as a successful operational mode to control the thickness of the biofilm. In this case, operation at high inlet loads (ILs) was extended for more than 75 d maintaining high REs and low pressure drops. Outlet emission concentrations lower than 100 mg Cm(-3) were obtained for ILs up to 100 g Cm(-3)h(-1) working at 15s of empty bed residence time. The most easily biodegradable compounds ethanol and ethyl acetate were used primarily than MEK. After a 3-wk-starvation period, the system performance was almost restored since the first d of operation, being the removal of the less biodegradable compound, MEK, partially deteriorated.     

Fungal biofilters for toluene biofiltration: evaluation of the performance with four packing materials under different operating conditions

Packing materials play a key role in the performance of bioreactors for waste gas treatment and particularly in biofilter applications. In this work, the performance of four differently packed biofilters operated in parallel for the treatment of relatively high inlet concentration of toluene was studied. The reactors were compared for determining the suitability of coconut fiber, digested sludge compost from a waste water treatment plant, peat and pine leaves as packing materials for biofiltration of toluene. A deep characterisation of materials was carried out. Biological activity and packing capabilities related to toluene removal were determined throughout 240 days of operation under different conditions of nutrients addition and watering regime. Also, biofilters recovering after a short shutdown was investigated. Nutrient addition resulted in improved removal efficiencies (RE) and elimination capacities (EC) of biofilters reaching maximum ECs between 75 and 95 g m(-3)h(-1) of toluene. In the first 80 days, the pH decreased progressively within the reactors, causing a population change from bacteria to fungi, which were the predominant decontaminant microorganisms thereafter. All reactors were found to recover the RE rapidly after a 5 days shutdown and, in a maximum of 7 days, all reactors had been completely recuperated. These results point out that fungal biofilters are a suitable choice to treat high loads of toluene. In general, coconut fiber and compost biofilters exhibited a better performance in terms of elimination capacity and long-term stability.     

Relations between PM10 composition and cell toxicity: a multivariate and graphical approach

Previous studies have used particle mass and size as metrics to link airborne particles with deleterious health effects. Recent evidence suggests that particle composition can play an important role in PM-toxicity; however, little is known about the specific participation of components (individually or acting in groups) present in such a complex mixture that accounts for toxicity. This work explores relationships among PM(10) components in order to identify their covariant structure and how they vary in three sites in Mexico City. Relationships between PM(10) with cell toxicity and geographical location were also explored. PM(10) was analyzed for elemental composition, organic and elemental carbon, endotoxins and the induction of inhibition of cell proliferation, IL-6, TNFalpha and p53. PM(10) variables were evaluated with principal component analysis and one-way ANOVA. The inhibition of cell proliferation, IL-6 and TNFalpha were evaluated with factorial ANOVA and p53 with the Welch test. The results indicate that there is heterogeneity in particle mass, composition and toxicity in samples collected at different sites. Multivariate analysis identified three major groups: (1) S/K/Ca/Ti/Mn/Fe/Zn/Pb; (2) Cl/Cr/Ni/Cu; and (3) endotoxins, organic and elemental carbon. Groups 1 and 3 showed significant differences among sites. Factorial ANOVA modeling indicated that cell proliferation was affected by PM concentration; TNFalpha and IL-6 by the interaction of concentration and site, and p53 was different by site. Radial plots suggest the existence of complex interactions between components, resulting in characteristic patterns of toxicity by site. We conclude that interactions of PM(10) components determine specific cellular outcomes.     

Biogenic sulphide plays a major role on the riboflavin-mediated decolourisation of azo dyes under sulphate-reducing conditions

The effect of high concentrations of sulphate on the reductive decolourisation of different azo dyes by anaerobic sludge was studied in batch cultures. Sludge cultures were pre-incubated under sulphate-reducing conditions prior addition of dyes. Little or no effects of sulphate (5-10 g sulphate l(-1)) on the rate of decolourisation of Reactive Orange 14 (RO14), Direct Blue 53 (DB53) and Direct Blue 71 (DB71) were observed when no external redox mediator was provided. However, an increase in sulphate concentration, in the presence of riboflavin (20 microM), enhanced the decolourisation of all dyes. The first-rate constant of decolourisation (k) was increased up to 2-, 3.6- and 2-fold for RO14, DB53 and DB71, respectively, by supplying high sulphate concentrations, compared to the controls lacking sulphate, in the presence of the redox mediator. Sulphate reduction did not take place during the course of azo reductions, but was only evident before dye addition and after complete decolourisation, suggesting azo dyes reduction out-competed sulphate reduction for the available reducing equivalents. The experimental data suggest that reduction of azo dyes by riboflavin, which had been reduced by biogenic sulphide, was the major mechanism implicated during decolourisations, which was corroborated by abiotic incubations. Riboflavin greatly accelerated the abiotic reduction of RO14, so that the k value was increased up to 44-fold compared to the control lacking riboflavin.