Biomass smoke in Burkina Faso: what is the relationship between particulate matter,carbon monoxide,and kitchen characteristics?

In Burkina Faso where cooking with biomass is very common, little information exists regarding kitchen characteristics and their impact on air pollutant levels. The measurement of air pollutants such as respirable particulate matter (PM₁₀), an important component of biomass smoke that has been linked to adverse health outcomes, can also pose challenges in terms of cost and the type of equipment needed. Carbon monoxide could potentially be a more economical and simpler measure of air pollution. The focus of this study was to first assess the association of kitchen characteristics with measured PM₁₀ and CO levels and second, the relationship of PM₁₀ with CO concentrations, across these different kitchen characteristics in households in Nouna, Burkina Faso. Twenty-four-hour concentrations of PM₁₀ (area) were measured with portable monitors and CO (area and personal) estimated using color dosimeter tubes. Data on kitchen characteristics were collected through surveys. Most households used both wood and charcoal burned in three-stone and charcoal stoves. Mean outdoor kitchen PM₁₀ levels were relatively high (774 μg/m³, 95 % CI 329–1,218 μg/m³), but lower than indoor concentrations (Satterthwaite t value, ?6.14; p?<?0.0001). In multivariable analyses, outdoor kitchens were negatively associated with PM₁₀ (OR?=?0.06, 95 % CI 0.02–0.16, p value <0.0001) and CO (OR?=?0.03, 95 % CI 0.01–0.11, p value <0.0001) concentrations. Strong area PM₁₀ and area CO correlations were found with indoor kitchens (Spearman’s r?=?0.82, p?<?0.0001), indoor stove use (Spearman’s r?=?0.82, p?<?0.0001), and the presence of a smoker in the household (Spearman’s r?=?0.83, p?<?0.0001). Weak correlations between area PM₁₀ and personal CO levels were observed with three-stone (Spearman’s r?=?0.23, p?=?0.008) and improved stoves (Spearman’s r?=?0.34, p?=?0.003). This indicates that the extensive use of biomass fuels and multiple stove types for cooking still produce relatively high levels of exposure, even outdoors, suggesting that both fuel subsidies and stove improvement programs are likely necessary to address this problem. These findings also indicate that area CO color dosimeter tubes could be a useful measure of area PM₁₀ concentrations when levels are influenced by strong emission sources or when used in indoors. The weaker correlation observed between area PM₁₀ and personal CO levels suggests that area exposures are not as useful as proxies for personal exposures, which can vary widely from those recorded by stationary monitors.     

Cytogenetic biomonitoring of oral mucosa cells of crack cocaine users

The aim of the present study was to comparatively evaluate genomic damage (micronucleus) and cellular death (pyknosis, karyolysis, and karyorrhexis) in exfoliated oral mucosa cells from crack cocaine users by micronucleus test. A total of 30 crack cocaine users and 30 health controls (non-exposed individuals) were included in this setting. Individuals had epithelial cells from cheek mechanically exfoliated, placed in fixative, and dropped in clean slides, which were checked for the above nuclear phenotypes. The results pointed out significant statistical differences (p?<?0.05) of micronucleated oral mucosa cells from crack cocaine users. Exposure to crack cocaine caused an increase of other nuclear alterations closely related to cytotoxicity such as karyolysis in oral cells as well. In summary, these data indicate that crack cocaine is able to induce chromosomal breakage and cellular death in oral mucosa cells of users.     

The Potential of Pulse-Jet Baghouses for Utility Boilers. Part 2: Performance of Pulse-Jet Fabric Filter Pilot Plants

Pulse-jet fabric filters (PJFFs) are widely used in U.S. industrial boiler applications and in utility and industrial boilers abroad. Their small size and reduced cost relative to more conventional reverse-gas baghouses makes the use of PJFFs appear to be an attractive particulate control option for utility boilers. This paper (Part 2 of a three-part series) summarizes the results of pilot PJFF studies sponsored by the Electric Power Research Institute at different utility sites in the United States. The purpose of these tests is to evaluate PJFF performance for U.S. fossil-fuel-fired applications. These data are also used to corroborate the results of a recent worldwide survey of PJFF user experience, as described in Part 1 of this series. Part 3 will provide a cost comparison of PJFFs to other particulate control options such as electrostatic precipitators and reverse-gas baghouses.     

Ozone Formation in California's San Joaquin Valley: A Critical Assessment of Modeling and Data Needs

ABSTRACT

Data from the 1990 San Joaquin Valley Air Quality Study/ Atmospheric Utility Signatures, Predictions, and Experiments (SJVAQS/AUSPEX) field program in California's San Joaquin Valley (SJV) suggest that both urban and rural areas would have difficulty meeting an 8-hr average O₃ standard of 80 ppb. A conceptual model of O₃ formation and accumulation in the SJV is formulated based on the chemical, meteorological, and tracer data from SJVAQS/ AUSPEX. Two major phenomena appear to lead to high O₃ concentrations in the SJV: (1) transport of O₃ and precursors from upwind areas (primarily the San Francisco Bay Area, but also the Sacramento Valley) into the SJV, affecting the northern part of the valley, and (2) emissions of precursors, mixing, transport (including long-range transport), and atmospheric reactions within the SJV responsible for regional and urban-scale (e.g., downwind of Fresno and Bakersfield) distributions of O₃. Using this conceptual model, we then conduct a critical evaluation of the meteorological model and air quality model. Areas of model improvements and data needed to understand and properly simulate O₃ formation in the SJV are highlighted.     

Development of Emission Factors for Polycarbonate Processing

Abstract

Emission factors for selected volatile organic compounds (VOCs) and particulate emissions were developed while processing eight commercial grades of polycarbonate (PC) and one grade of a PC/acrylonitrile-butadiene-styrene (ABS) blend. A small commercial-type extruder was used, and the extrusion temperature was held constant at 304 °C. An emission factor was calculated for each substance measured and is reported as pounds released to the atmosphere/million pounds of polymer resin processed [ppm (wt/wt)]. Scaled to production volumes, these emission factors can be used by processors to estimate emission quantities from similar PC processing operations.     

Using flue gas desulfurization gypsum to remove dissolved phosphorus from agricultural drainage waters

High levels of accumulated phosphorus (P) in soils of the Delmarva Peninsula are a major source of dissolved P entering drainage ditches that empty into the Chesapeake Bay. The objective of this study was to design, construct, and monitor a within-ditch filter to remove dissolved P, thereby protecting receiving waters against P losses from upstream areas. In April 2007, 110 Mg of flue gas desulfurization (FGD) gypsum, a low-cost coal combustion product, was used as the reactive ingredient in a ditch filter. The ditch filter was monitored from 2007 to 2010, during which time 29 storm-induced flow events were characterized. For storm-induced flow, the event mean concentration efficiency for total dissolved P (TDP) removal for water passing through the gypsum bed was 73 ± 27% confidence interval (α = 0.05). The removal efficiency for storm-induced flow by the summation of load method was 65 ± 27% confidence interval (α = 0.05). Although chemically effective, the maximum observed hydraulic conductivity of FGD gypsum was 4 L s(-1), but it decreased over time to <1 L s(-1). When bypass flow and base flow were taken into consideration, the ditch filter removed approximately 22% of the TDP load over the 3.6-yr monitoring period. Due to maintenance and clean-out requirements, we conclude that ditch filtration using FGD gypsum is not practical at a farm scale. However, we propose an alternate design consisting of FGD gypsum-filled trenches parallel to the ditch to intercept and treat groundwater before it enters the ditch.     

Modeling urban films using a dynamic multimedia fugacity model

A thin film coats impervious urban surfaces that can act as a source or sink of organic pollutants to the greater environment. We review recent developments in the understanding of film and film-associated pollutant behavior and incorporate them into an unsteady-state version of the fugacity based Multimedia Urban Model (MUM), focusing on detailed considerations of surface film dynamics. The model is used to explore the conditions under which these atmospherically-derived films act as a temporary source of chemicals to the air and/or storm water. Assuming film growth of 2.1 nm d⁻¹ (Wu et al., 2008a), PCB congeners 28 and 180 reach air-film equilibrium within hours and days, respectively. The model results suggest that the film acts as a temporary sink of chemicals from air during dry and cool weather, as a source to air in warmer weather, and as a source to storm water and soil during rain events. Using the downtown area of the City of Toronto Canada, as a case study, the model estimates that nearly 1 g d⁻¹ of ∑₅PCBs are transferred from air to film to storm water.     

Vitalizing effects of being outdoors and in nature

Five studies utilizing survey, experimental, and diary methods assessed the effects of being outdoors on subjective vitality. In Study 1, we used a vignette method to examine whether being outdoors was associated with vitality, above and beyond the influences of physical activity and social interactions. Study 2 explored the effects of being outdoors on vitality through an experimental design contrasting indoor and outdoor walks. In Study 3, participants were exposed to photographic scenes of either nature or buildings. Results showed that only the nature scenes enhanced subjective vitality. Studies 4 and 5 used a diary methodology to examine within-person variations in subjective energy as a function of being outdoors, again controlling for physical and social activity. Being outdoors was associated with greater vitality, a relation that was mediated by the presence of natural elements. Limitations of these studies are discussed, as well as their implications for research on energy and vitalization.     

A multibiomarker approach on the Atlantic tomcod (Microgadus tomcod) in the St. Lawrence Estuary

A multibiomarker approach was developed on juvenile Atlantic tomcod (Microgadus tomcod) to evaluate the pertinence of this approach for low-cost screening assessment of the environmental quality of various coastal sites within estuaries. Several biometric indices and biomarkers (ethoxyresorufin-O-deethylase (EROD) activity, metallothionein concentration, and immune responses) were investigated on immature and maturing tomcods (≤31 months) collected in four environmentally contrasted sites in the St. Lawrence Estuary (SLE). Simultaneous examination of various age classes provides the opportunity to detect short-term responses in sensitive young-of-the-year fish (e.g., EROD induction) and longer-time effects associated with chronic exposure and bioaccumulation (e.g., metallothionein induction). Principal component analysis was helpful to discriminate between responses possibly related to contaminant exposure (EROD, metallothionein) and responses that could be affected by upstream–downstream gradient (immune response, biometric indices). Measurement of a battery of biomarkers in young tomcods at several sites along the shore of the SLE is a low-cost screening investigation useful to identify hot spots requiring further investigation with chemical analysis and additional reference sites.     

Pesticide pressure and fish farming in barrage pond in Northeastern France. Part II: residues of 13 pesticides in water, sediments, edible fish and their relationships

Residues of pesticides in fish farming productions from barrage ponds are seldom studied in spite of increasing health questionings and environmental concerns. The purpose of this study is to establish the pesticide contamination profiles of sediments and edible fish from five ponds in Northeastern France. Multi-residues method and liquid chromatography–tandem mass spectrometry analysis were used to quantify 13 pesticides (azoxystrobin, carbendazim, clomazone, diflufenican, dimethachlor, fluroxypyr, iprodion, isoproturon, mesosulfuron-methyl, metazachlor, napropamid, quizalofop and thifensulfuron-methyl). Ten sediments and 143 muscles samples were analysed, corresponding to two successive fishing campaigns (first fishing date and second fishing date (P2), about 1 year later) on five sites (noted C-0, C-25, C-45, C-75 and C-85 to express the increasing gradient of crop area). Isoproturon was present in all sediments samples (1.8–56.4 μg/kg dry weight). During P2 period, carbendazim was quantified in the fish of site C-0 (0.09?±?0.02, 0.2?±?0.1 and 0.17?±?0.06 μg/kg wet weight (ww) for roach, carp and perch, respectively). Metazachlor was only quantified in perch of the site C-25 (0.13?±?0.02 μg/kg ww). Concentrations of isoproturon were similar for the sites C-45 and C-75 with 0.4?±?0.1 and 0.75?±?0.06 μg/kg ww for carp and perch, respectively. Contamination of fish reflected generally concentrations in surroundings. Isoproturon was the most concentrated and its main source was water for perch while carp was exposed through both water and sediments, highlighting their life strategies in pond.