A biomimetic absorbent for removal of trace level persistent organic pollutants from water

A novel biomimetic absorbent containing the lipid triolein was developed for removing persistent organic pollutants (POPs) from water. The structural characteristics of the absorbent were obtained by SEM and a photoluminescence method. Under optimum preparation conditions, triolein was perfectly embedded in the cellulose acetate (CA) spheres, the absorbent was stable and no triolein leaked into the water. Dieldrin, endrin, aldrin and heptachlor epoxide were effectively removed by the CA--triolein absorbent in laboratory batch experiments. This suggests that CA-triolein absorbent may serve as a good absorbent for those selected POPs. Triolein in the absorbent significantly increased the absorption capacity, and lower residual concentrations of POPs were achieved when compared to the use of cellulose acetate absorbent. The absorption rate for lipophilic pollutants was very fast and exhibited some relationship with the octanol--water partition coefficient of the analyte. The absorption mechanism is discussed in detail.     

Column studies on transport of deicing additive benzotriazole in a sandy aquifer and a zerovalent iron barrier

Benzotriazole (BTA), a chemical with wide industrial applications, is a typical additive in deicer/anti-icer used at airport. To achieve a better understanding of the transport behaviour and environmental fate of BTA, laboratory column studies have been performed on subsoil samples from Oslo Airport, Gardermoen. To explore possibilities for aquifer remediation, BTA behaviour was also studied in a column of granular zerovalent iron (Fe(0)). The subsoil column study demonstrates a very limited retardation of BTA. Consecutive loadings of BTA of the subsoil column showed no change of the break-through curve (BTC) and complete desorption was observed. The sorption behaviour of BTA to metallic iron (Fe(0)) was rather complex. Considerable retardation was observed in the Fe(0) column and repeated BTA loading resulted in an earlier break-through. Between 20% and 50% of the input concentration was retained permanently in the iron (Fe(0)) column. The BTA sorption to metallic iron was found to be enhanced by chloride which lowered the break-through concentration (i.e the C/C(0) plateau). The fraction of BTA remaining in the iron column was found to vary with the flow rate, indicating a time dependant multilayer sorption mechanism. The steady increase in the amount of adsorbed BTA to the iron column during loading corresponds to a rather strong bonding of 4-15 BTA layers to the iron surface. A very slow desorption of BTA was observed; even after flushing with 753 pore volumes of BTA free water, 7.5% of the BTA remained in the column. A geochemical model was developed based on PHREEQC-2 to simulate the sorption and transport of BTA in the tested materials. The BTA sorption was modelled with Freundlich sorption isotherms, as earlier determined in batch experiments. A slight adjustment of the Freundlich parameters was required to fit the observed column break-through. However, our model was not able to simulate the long-term retainment of BTA in the granular iron columns. The simulations confirm the high mobility of BTA in groundwater aquifers and suggest that zerovalent iron could be used to retain a BTA plume, although oxidation of the sorbent might reduce the long-term performance of such a remediation scheme and slow desorption has been observed.     

Zinc and cadmium accumulation and tolerance in populations of Sedum alfredii

To investigate the variation of Zn and Cd accumulation and tolerance of Sedum alfredii (a newly reported Zn/Cd hyperaccumulator), field surveys and hydroponic experiments were conducted among three populations of this species: two originating from old Pb/Zn mines in Zhejiang (ZJ) and Hunan (HN) Provinces and one from a "clean" site in Guangdong (GD) Province, China. Under field conditions, up to 12,524 and 12,253 mg kg(-1) Zn, and 1400 and 97 mg kg(-1) Cd in shoots of ZJ and HN plants were recorded respectively. Under hydroponic conditions, ZJ and HN plants accumulated significantly higher Zn and Cd in their leaves and stems, and possessed significantly higher Zn and Cd tolerance than GD plants. Among the two contaminated populations, ZJ plants showed higher Cd tolerance and accumulation (in leaves) than HN plants. The present results indicate that significant differences in Zn and Cd accumulation and tolerance exist in populations of S. alfredii.     

三种偶氮染料降解历程在紫外-可见光谱上的表现

本文对基本结构相似的三种偶氮染料橙黄Ⅱ、活性艳红Ｘ－３Ｂ和活性黑Ｋ－ＢＲ水溶液在铁粉还原－光氧化两步法处理中的紫外－可见光谱图作对比分析,依据其结构与特征吸收的关系,初步推测还原铁粉－光氧化法降解染料的历程。     

Temporal and Spatial Variations of Phytoplankton Community Structure in Lake Erhai,a Chinese Plateau Lake,with Reference to Environmental Factors

Russian Journal of Ecology - Temporal and spatial variations of phytoplankton community in Lake Erhai were investigated from May 2010 to April 2011. A total of 124 species belonging to 8 phyla and...     

Sb release characteristics of the solid waste produced in antimony mining smelting process

Sb release characteristics of blast furnace slag, mining waste rock and tailing sand were investigated in static immersion and dynamic leaching test. These three kinds of waste samples were collected from the antimony mine in Lengshuijiang, China, produced in mining smelting process. Effects of solid/liquid ratio, sample size and pH of leaching solution on Sb release characteristics were inspected based on the analysis of scanning electron microscope, pH and EC of leachate. The optimal parameters for Sb leaching of each sample were analyzed. For blast furnace slag and mining waste rock, Sb release contents increased along with the decline of solid/liquid ratio. The maximum accumulative release contents were 42.13, 34.26 mg/kg at the solid/liquid ratio of 1:20. While Sb release content for tailing sand decreased first and then increased with the reduction of solid/liquid ratio. When the solid/liquid ratio was 1:5, the accumulative Sb release content reached the most (24.30 mg/kg). Sb release content of mining waste rock increased with the drop of leaching solution pH, with the highest accumulative release content of 26.01 mg/kg at pH 2.0. Sb release contents of blast furnace slag and tailing sand showed positive correlation with the variation of leaching solution pH. The maximum accumulative release contents of these two samples were 215.91 and 147.83 mg/kg, respectively, when leaching solution pH was 7.0. In summary, Sb release capacity of the three samples in descending order was tailing sand, blast furnace slag and mining waste rock. pH and EC of the leachate in dynamic test varied independently with the initial pH of leaching solution while showing close relationship with mineral hydrolysis in the waste.     

Polychlorinated biphenyls (PCBs) and halogenated flame retardants (HFRs) in multi-matrices from an electronic waste (e-waste) recycling site in Northern China

The present study investigated the occurrence of polychlorinated biphenyls (PCBs) and halogenated flame retardants (HFRs) in soil, water, reed, air and dust samples collected from the e-waste recycling region in Ziya Town, Northern China. The results showed that the concentrations of PCBs reached relative high level in environmental matrices in the study area. HFRs including polybrominated diphenyl ethers (PBDEs), dechlorane plus (DP), allyl 2,4,6-tribromophenyl ether (ATE), tetrabromoethylcyclohexane (TBECH), pentabromotoluene (PBT), pentabromoethylbenzene (PBEB), 2,3-dibromopropyl 2,4,6-tribromophenyl ether (DPTE), 1,2-bis-(2,4,6-tribromophenoxy) ethane (BTBPE) and so on were also widely detected in multi-matrices. Long-range atmospheric transport (LRAT) potentials of non-BDE HFRs were assessed to address the LRAR abilities of these compounds. Analysis of soil–air exchange of PCBs and HFRs showed that soil acted as a secondary source to the atmosphere only for a few low molecular weight compounds, while the direction of the flux of most detected chemicals was from air to soil.     

Preparation and Characterization of Collagens from the Skin of Northern Snakehead (<Emphasis Type="Italic">Channa argus)</Emphasis>

Channa argus, a type of snakehead fish native to China, is a popular food fish in certain Asian countries but is a known destructive invasive species in the US. In this study, the two collagens, i.e. acid-soluble collagen (ASC) and pepsin-solubilized collagen (PSC), were obtained from C. argus skin. The yield of ASC was 28.0% and that of PSC was 16.8% on the dry bases. The collagens were identified as the collagen of type I by SDS–PAGE patterns. The Tds were approximately 27.0?°C. Similar ultraviolet spectra of both collagens were observed. Fourier Transform infrared spectra indicated PSC structure had a little change due to the loss of terminal domains by pepsin digestion. The results of XRD proved that the two collagens retained their helical structures. The results suggest that the collagens isolated from C. argus can potentially be alternative sources of vertebrate collagens for use in the food and other industries.     

Influence of filtration velocity on DON variation in BAF for micropolluted surface water treatment

Biological aerated filters (BAFs) are widely used for the treatment of micropolluted surface water. However, the biological process produces dissolved organic nitrogen (DON), which, as precursors of nitrogenous disinfection by-products, pose potential threats to drinking water safety. Therefore, to control DON in BAF effluent, it is necessary to study the influence of BAF operation parameters on DON production. In this study, the influence of filtration velocity in a BAF on DON production was investigated. Under different filtration velocity (0.5, 2, and 4 m/h) conditions, profiles of DON concentrations along the media layer were measured. The profile at a filtration velocity of 0.5 m/h showed a decreasing trend, and the ones under filtration velocities of 2 and 4 m/h fluctuated in a small range (from 0.1 to 0.4 mg/L). Moreover, the relatively high filtration velocities of 2 and 4 m/h resulted in a lower level of DON concentration. Additionally, 3D excitation-emission matrix fluorescence spectroscopy was used to characterize DON. It is found that the patterns of DON at a relatively high filtration velocity condition (4 m/h) were obviously different from the ones under low filtration velocity conditions (0.5 and 2 m/h).     

Potential of fly ash for neutralisation of acid mine drainage

Lignite (PK), bituminous (FI) and biomass (SE) fly ashes (FAs) were mineralogically and geochemically characterised, and their element leachability was studied with batch leaching tests. The potential for acid neutralisation (ANP) was quantified by their buffering capacity, reflecting their potential for neutralisation of acid mine drainage. Quartz was the common mineral in FAs detected by XRD with iron oxide, anhydrite, and magnesioferrite in PK, mullite and lime in FI, and calcite and anorthite in SE. All the FAs had high contents of major elements such as Fe, Si, Al and Ca. The Ca content in SE was six and eight times higher compared to PK and FI, respectively. Sulphur content in PK and SE was one magnitude higher than FI. Iron concentrations were higher in PK. The trace element concentrations varied between the FAs. SE had the highest ANP (corresponding to 275 kg CaCO₃?tonne^?1) which was 15 and 10 times higher than PK and FI, respectively. The concentrations of Ca²⁺, SO₄ ^2?, Na⁺ and Cl^? in the leachates were much higher compared to other elements from all FA samples. Iron, Cu and Hg were not detected in any of the FA leachates because of their mild to strong alkaline nature with pH ranging from 9 to 13. Potassium leached in much higher quantity from SE than from the other ashes. Arsenic, Mn and Ni leached from PK only, while Co and Pb from SE only. The concentrations of Zn were higher in the leachates from SE. The FAs used in this study have strong potential for the neutralisation of AMD due to their alkaline nature. However, on the other hand, FAs must be further investigated, with scaled-up experiments before full-scale application, because they might leach pronounced concentrations of elements of concern with decreasing pH while neutralising AMD.