关于区域性污水收集处理系统的一些建议

对太湖流域小城镇污水收集处理系统的现状进行了分析,找出了目前污水收集处理系统存在的主要问题,并根据太湖流域相关污水治理要求提出了区域性污水收集处理的方案,同时结合目前工程规划建设的实际对该方案的实施提出了一些合理性建议.     

煤炭开发建设项目环境影响后评价初步研究

环境影响后评价作为环境影响评价的延伸,是提高环评有效性的有力手段,目前我国环境影响后评价仍处于起步阶段,其理论和实践都具有很强的探索性。煤炭在我国的能源地位突出,但对煤炭开采建设项目的环境影响后评价研究甚少,文章介绍了国内外环境影响后评价的研究进展,并针对煤炭项目,通过识别煤炭开采的环境影响,概述了其评价指标的选取原则、指标体系的构建和评价方法。     

煤炭开发建设项目环境影响后评价初步研究

环境影响后评价作为环境影响评价的延伸,是提高环评有效性的有力手段,目前我国环境影响后评价仍处于起步阶段,其理论和实践都具有很强的探索性。煤炭在我国的能源地位突出,但对煤炭开采建设项目的环境影响后评价研究甚少,文章介绍了国内外环境影响后评价的研究进展,并针对煤炭项目,通过识别煤炭开采的环境影响,概述了其评价指标的选取原则、指标体系的构建和评价方法。     

高温下好氧污泥接种启动UASB的试验研究

采用高温UASB处理柠檬酸废水,研究利用好氧脱水污泥接种启动高温UASB的可行性。试验结果表明,在温度55℃,HRT为6天的条件下,UASB反应器能降解的柠檬酸废水浓度为10000mg/L,容积负荷为1.67gCOD/(L.d),柠檬酸废水的去除率达到90%以上。     

苯酚对活性污泥活性及微型动物群落结构的影响

为了探究苯酚对污泥活性及微型动物群落结构的影响,以SBR工艺的活性污泥为研究对象,分析苯酚对污泥TTC-ETS活性、INT-ETS活性和微型动物群落结构及其动态变化的影响.结果表明,污泥TTC-ETS活性较之INT-ETS活性能够更有效表征有机毒害物质苯酚对污泥活性的影响,且随着进水苯酚浓度的增大,苯酚对污泥活性的抑制越明显:进水浓度在50mg·L-1时,苯酚对污泥活性的抑制率为(20.75±10.43)%.进水苯酚浓度为100 mg·L-1时,抑制率为(39.73±26.92)%,且波动较大.在300 mg·L-1进水运行后期,苯酚对污泥活性的抑制率稳定在40%左右;苯酚对活性污泥微型动物群落结构的影响随浓度的增大而增大,且对不同微型动物类群影响不同:在低浓度苯酚进水条件下,只有单个微型动物类群(有壳变形虫)受到明显的抑制,而当浓度增大至100 mg·L-1和300 mg·L-1时,对多个微型动物类群(固着型纤毛虫、有壳变形虫、匍匐型纤毛虫、肉食性纤毛虫等)产生抑制,对少数类群(鞭毛虫、线虫等)产生促进作用;苯酚影响下的污泥活性与微型动物之间存在一定的关联性,针棘匣壳虫(Centropyxis aculeata)、多变斜板虫(Plagiocampa mutabilis)等可作为含酚废水处理过程中污泥活性低的指示生物,湖累枝虫(Epistylis lacustris)、软波豆虫(Bodo lens)、跳侧滴虫(Pleuromonas jaculans)等可作为污泥活性高的指示生物.     

基于快速聚类方法分析常州市区PM2.5的统计特性

运用统计方法研究常州市区2013~2014年6个国控点六项基本污染物(SO_2、NO_2、CO、O_3、PM_(2.5)和PM_(10))月平均浓度变化,结果表明,除O_3外,其它五项污染物月平均浓度夏季较低冬季较高.颗粒物与风速之间的关系为PM_(2.5)浓度随风速的升高一直降低,PM_(10)随风速的升高浓度先降低后升高.采用快速聚类分析(k-means)并运用SWV和DIV指数对六项基本污染物进行分类,得到4个样本分类.与依据颗粒物化学成分或粒径谱对PM进行源解析方法不同,本研究更多是从PM_(2.5)与其它污染物相关关系以及污染程度等角度按照欧式距离进行分类.不同类中PM_(2.5)来源明显不同,类1中PM_(2.5)与化石燃料燃烧排放密切相关,类2与O_3密切相关,类3与城市不完全燃烧排放、区域灰霾污染密切相关,类4可以归类于城市"背景"类.快速聚类分析结果也表明常州市区PM_(2.5)有着复杂的来源.     

Expression of sulfur uptake assimilation-related genes in response to cadmium, bensulfuron-methyl and their co-contamination in rice roots

The responses of sulfur （S） uptake assimilation-related genes＇ expression in roots of two rice cultivars to cadmium （Cd）, bensulfuron-methyl （BSM） and their co-contamination （Cd＋BSM） were investigated by gene-chip microarray analysis and quantitative real-time PCR （QRT-PCR） technology. Treatments of Cd and Cd＋BSM induced expression of sulfate transporter and permease genes, and promoted sulfate uptake in rice roots. Cd＋BSM could alleviate Cd toxicity to cv. Fengmeizhan seedlings, probably due to Cd＋BSM promoting greater S absorption by seedlings. Cd and Cd＋BSM induced expression of sulfate assimilation-related genes, and thus activated the sulfur assimilation pathway. Cd and Cd＋BSM induced expression of phytochelatin synthase and metallothionein genes, and induced expression of glutathione S-transferases （GSTs）, glutathione synthase （GS） and S- containing antioxidation enzyme genes, which detoxified Cd2＋. It is suggested that （to cope with the toxicity of Cd, BSM and their co-contamination） the S uptake and assimilation pathway was activated in rice roots by increased expression of related genes, thus enhancing the supply of organic S for synthesis of Cd or BSM resistance-related substances.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

Characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China

To understand the pollution characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China, total suspended particulate(TSP) and PM10samples were collected in cities of Changsha, Zhuzhou and Xiangtan from December 2011 to January 2012, and heavy metals of Cd, Pb, Cr, and As were analyzed. It shows that the average TSP concentration in Changsha, Zhuzhou and Xiangtan were(183 ± 73),(201 ± 84) and(190 ± 66) μg/m3respectively, and the average PM10 were(171 ± 82),(178 ± 65) and(179 ± 55) μg/m3respectively. The lowest TSP and PM10concentrations occurred at the background Shaping site of Changsha. The average ratio of ρ(PM10)/ρ(TSP) was 91.9%, ranging from 81.3% to 98.9%. Concerning heavy metals, in TSP samples, the concentration of Cr, As, Cd and Pb were 28.8–56.5, 18.1–76.3, 3.9–26.1 and 148.0–460.9 ng/m3, respectively, while in PM10samples, were 16.4–42.1, 15.5–67.9, 3.3–22.2 and 127.9–389.3 ng/m3, respectively. The enrichment factor of Cd was the highest, followed by Pb and As, while that of Cr was the lowest.     

Submerged vegetation removal promotes shift of dominant phytoplankton functional groups in a eutrophic lake

Historical data indicate that the dominance of submerged plants in Dianchi Lake in the 1960 s was characterized by low algal density with dominance of non-toxic group J（Scenedesmus,Pediastrum,etc.）. The removal of submerged plants,which began in the 1970 s,resulted in the expansion of bloom-forming Microcystis（group M）. Laboratory experiments suggested that Microcystis aeruginosa was inclined to grow and develop at elevated temperatures. The growth of Scenedesmus obliquus was slower than that of co-cultivated M. aeruginosa in the absence of Ceratophyllum demersum,especially at higher temperatures. The existence of submerged plant C. demersum could inhibit the growth of the harmful algae M. aeruginosa and this inhibitory effect by C. demersum was enhanced with an increase in temperature. Instead,with C. demersum,the growth of S. obliquus was not inhibited,but the co-cultivated M. aeruginosa was eliminated in a short time. Combined with the historical data and laboratory experiments,it was indicated that the submerged plants might play important roles in the dominance of the non-toxic group J in the historical succession. Consequently,the introduction of the submerged plant such as C. demersum might alter the dominant phytoplankton functional groups from M to J and benefit the restoration of the eutrophic lake.