Effect of physico-chemical pretreatment on the removal efficiency of horizontal subsurface-flow constructed wetlands

In this study, we tested the effect of a physico-chemical pretreatment on contaminant removal efficiency in two experimental horizontal subsurface-flow constructed wetlands (SSF CWs). One SSF CW was fed with settled urban wastewater, whereas the other with the same wastewater after it had undergone a physico-chemical pretreatment. The SSF CWs were operated with three different hydraulic retention times. During the experiments the effluent concentrations of COD, ammonia N and sulfate were very similar, and, therefore, the physico-chemical pretreatment did not improve the quality of the effluents. COD removal efficiency (as percentage or mass surface removal rate) was slightly greater in the SSF CW fed with pretreated wastewater. Ammonia N removal efficiency was, in general, similar in both SSF CWs and very high (80-90%). At the end of the experiments it was observed that in the SSF CW fed with settled wastewater the hydraulic conductivity decreased by a 20%.     

Distribution of polycyclic aromatic hydrocarbons (PAHs) and tributyltin (TBT) in Barcelona harbour sediments and their impact on benthic communities

Sediments have long been recognised as a sink for many contaminants like polycyclic aromatic hydrocarbons (PAHs) and tributyltin (TBT), which by virtue of their nature can strongly adsorb onto sediments affecting the benthic community inhabiting them. Using geographical information systems, this study reports and combines the results of several already existing studies along Barcelona harbour in order to assess the potential ecological impacts of these contaminants on the benthos of the harbour ecosystem. Chemical analysis indicated low to moderate contents of PAHs and high contents of TBT in sediments in Barcelona harbour. Comparison against existing sediment quality guidelines (SQGs) indicated that acutely toxic effects would not be expected for PAHs but for TBT, which represents a serious environmental threat for the benthic community. Benthos surveys revealed a deterioration of the benthic community throughout the harbour, especially in the inner port.     

Effects of wastewater disinfection on waterborne bacteria and viruses.

Wastewater disinfection is practiced with the goal of reducing risks of human exposure to pathogenic microorganisms. In most circumstances, the efficacy of a wastewater disinfection process is regulated and monitored based on measurements of the responses of indicator bacteria. However, inactivation of indicator bacteria does not guarantee an acceptable degree of inactivation among other waterborne microorganisms (e.g., microbial pathogens). Undisinfected effluent samples from several municipal wastewater treatment facilities were collected for analysis. Facilities were selected to provide a broad spectrum of effluent quality, particularly as related to nitrogenous compounds. Samples were subjected to bench-scale chlorination and dechlorination and UV irradiation under conditions that allowed compliance with relevant discharge regulations and such that disinfectant exposures could be accurately quantified. Disinfected samples were subjected to a battery of assays to assess the immediate and long-term effects of wastewater disinfection on waterborne bacteria and viruses. In general, (viable) bacterial populations showed an immediate decline as a result of disinfectant exposure; however, incubation of disinfected samples under conditions that were designed to mimic the conditions in a receiving stream resulted in substantial recovery of the total bacterial community. The bacterial groups that are commonly used as indicators do not provide an accurate representation of the response of the bacterial community to disinfectant exposure and subsequent recovery in the environment. UV irradiation and chlorination/dechlorination both accomplished measurable inactivation of indigenous phage; however, the extent of inactivation was fairly modest under the conditions of disinfection used in this study. UV irradiation was consistently more effective as a virucide than chlorination/dechlorination under the conditions of application, based on measurements of virus (phage) diversity and concentration. Taken together, and when considered in conjunction with previously published research, the results of these experiments illustrate several important limitations of common disinfection processes as applied in the treatment of municipal wastewaters. In general, it is not clear that conventional disinfection processes, as commonly implemented, are effective for control of the risks of disease transmission, particularly those associated with viral pathogens. Microbial quality in receiving streams may not be substantially improved by the application of these disinfection processes; under some circumstances, an argument can be made that disinfection may actually yield a decrease in effluent and receiving water quality. Decisions regarding the need for effluent disinfection must account for site-specific characteristics, but it is not clear that disinfection of municipal wastewater effluents is necessary or beneficial for all facilities. When direct human contact or ingestion of municipal wastewater effluents is likely, disinfection may be necessary. Under these circumstances, UV irradiation appears to be superior to chlorination in terms of microbial quality and chemistry and toxicology. This advantage is particularly evident in effluents that contain appreciable quantities of ammonia-nitrogen or organic nitrogen.     

Characterizing the passage of personal care products through wastewater treatment processes.

Wastewater treatment facilities use secondary treatment to stabilize the effect of discharged effluent on receiving waters by oxidizing biodegradable organic matter and reducing suspended solids and nutrients. The process was never specifically intended to remove trace quantities of xenobiotics, such as endocrine-disrupting compounds (EDCs) and pharmaceuticals and personal care products (PPCPs). Nevertheless, European studies performed at bench-scale or at small facilities have demonstrated that a critical minimum solids retention time (SRT) can achieve good reduction of many EDCs and pharmaceuticals. The objective of this study was to expand these findings to the removal performance for 20 PPCPs commonly found in the influent to full-scale facilities operating in the United States. The participating plants use SRT conditions ranging from 0.5 to 30 days and include facility capacities ranging from 19 000 m3/d (5 mgd) to greater than 1 136 000 m3/d (300 mgd). Two pilot membrane bioreactors were also included in the study. The 20 PPCPs were categorized into nine bin combinations of occurrence frequency and treatment reduction performance. While most compounds were well removed, galaxolide (a musk fragrance) occurred frequently and was resistant to removal. A minimum critical SRT, defined as the minimum SRT, needed to consistently demonstrate greater than 80% removal (SRT80), was compound-dependent, with most compounds removed at 5 to 15 days and a small group requiring longer SRTs. From limited data, no additional removal could be attributed to the use of membrane bioreactors, media filters, or longer hydraulic retention times. Reverse osmosis was effective in removing any remaining compounds.     

Temporal Analysis of Airborne Particulate Matter Reveals a Dose-Rate Effect on Mortality in El Paso: Indications of Differential Toxicity for Different Particle Mixtures

Abstract

One of two topics explored is the limitations of the daily average in summarizing pollutant hourly profiles. The daily average of hourly measurements of air pollutant constituents provides continuity with previous studies using monitoring technology that only provided the daily average. However, other summary statistics are needed that make better use of all available information in 24-hr profiles. The daily average reflects the total daily dose, obscuring hourly resolution of the dose rate. Air pollutant exposures with comparable total daily doses may have very different effects when occurring at high levels over a few hours as opposed to low levels over a longer time. Alternative data-based choices for summary statistics are provided using principal component analysis to capture the exposure dose rate, while preserving ease of interpretation. This is demonstrated using the earliest hourly particle concentration data available for El Paso from archived records of particulate matter (PM)₁₀. In this way, a significant association between evening PM₁₀ exposures and nonaccidental daily mortality is found in El Paso from 1992 to 1995, otherwise missed using the daily average. Secondly, the nature and, hence, effects of particles in the ambient aerosol during El Paso sandstorms is believed different from that of particles present during stillair conditions resulting from atmospheric temperature inversions. To investigate this, wind speed (ws) is used as a surrogate variable to label PM₁₀ exposures as Low-ws (primarily fine particles), High-ws (primarily coarse particles), or Mid-ws (a mixture of fine and coarse particles). A High-ws evening is significantly associated with a 10% lower risk of mortality on the succeeding third day, as compared with comparable exposures at Low- or Mid-ws. Although this analysis cannot be used to form firm conclusions because it uses a very small data set, it demonstrates the limitations of the daily average and suggests differential toxicity for different particle compositions.     

Spatial distribution of polychlorinated biphenyls in High Tatras lake sediments

The objective of the present study was to gain insight on the spatial distribution of seven polychlorinated biphenyl (PCB) congeners in the High Tatras mountain range in Eastern Europe. Twenty high mountain lakes were sampled on their top-core sediment. Despite the relative uniform composition of PCB congeners among the lakes, there are important differences in the observed concentrations. Moderate top-core sediment concentrations of PCB congeners were observed (1.9 to 38 ng/g dw for ∑PCB) in comparison to other high mountain or Arctic areas. The variation in PCB concentrations can partly be explained by a possible altitudinal effect, resulting in higher PCB concentrations at higher (colder) altitudes. Part of this enhanced accumulation of PCBs could be caused by external factors (topography and meteorology) and internal lake factors (sediment dynamics). Many of these factors were not quantified for all individual lakes and their influence could, therefore, only be studied for some.     

Experiences with greening suppliers. The Universitat Autònoma de Barcelona

This paper explains the strategy and procedures followed by the Universitat Autònoma de Barcelona (UAB) to spread green purchasing practices throughout its administration and supply chain, highlighting the identified barriers against their implementation and monitoring, and showing the actions carried out to overcome them. The university's green supply chain management has been analysed in five selected case studies: office material, recycled toner cartridges, fair trade coffee, reusable glass bottles and catering services. These cover the wide range of purchasing patterns currently taking place at UAB taking into account both the acquisition model (directly or indirectly through contracted firms) and the supply chain management perspective (linear or loop). A comparison of the different cases is carried out and some general rules are created that should be investigated further.     

The Role of Fungal Symbioses in the Adaptation of Plants to High Stress Environments

All plants studied in natural ecosystemsare symbiotic with fungi that either resideentirely (endophytes) or partially(mycorrhizae) within plants. Thesesymbioses appear to adapt to biotic andabiotic stresses and may be responsible forthe survival of both plant hosts and fungalsymbionts in high stress habitats. Here wedescribe the role of symbiotic fungi inplant stress tolerance and present astrategy based on adaptive symbiosis topotentially mitigate the impacts of globalchange on plant communities.