Rapid measurement of emissions from military aircraft turbine engines by downstream extractive sampling of aircraft on the ground: Results for C-130 and F-15 aircraft

Aircraft emissions affect air quality on scales from local to global. More than 20% of the jet fuel used in the U.S. is consumed by military aircraft, and emissions from this source are facing increasingly stringent environmental regulations, so improved methods for quickly and accurately determining emissions from existing and new engines are needed. This paper reports results of a study to advance the methods used for detailed characterization of military aircraft emissions, and provides emission factors for two aircraft: the F-15 fighter and the C-130 cargo plane. The measurements involved outdoor ground-level sampling downstream behind operational military aircraft. This permits rapid change-out of the aircraft so that engines can be tested quickly on operational aircraft. Measurements were made at throttle settings from idle to afterburner using a simple extractive probe in the dilute exhaust. Emission factors determined using this approach agree very well with those from the traditional method of extractive sampling at the exhaust exit. Emission factors are reported for CO₂, CO, NO, NO_x, and more than 60 hazardous and/or reactive organic gases. Particle size, mass and composition also were measured and are being reported separately. Comparison of the emissions of nine hazardous air pollutants from these two engines with emissions from nine other aircraft engines is discussed.     

Aerosol formation yields from the reaction of catechol with ozone

The formation of secondary organic aerosol from the gas-phase reaction of catechol (1,2-dihydroxybenzene) with ozone has been studied in two smog chambers. Aerosol production was monitored using a scanning mobility particle sizer and loss of the precursor was determined by gas chromatography and infrared spectroscopy, whilst ozone concentrations were measured using a UV photometric analyzer. The overall organic aerosol yield (Y) was determined as the ratio of the suspended aerosol mass corrected for wall losses (M_o) to the total reacted catechol concentrations, assuming a particle density of 1.4 g cm^?3. Analysis of the data clearly shows that Y is a strong function of M_o and that secondary organic aerosol formation can be expressed by a one-product gas–particle partitioning absorption model. The aerosol formation is affected by the initial catechol concentration, which leads to aerosol yields ranging from 17% to 86%. The results of this work are compared to similar studies reported in the literature.     

On experimental setup in bioelectromagnetics

Bioeffects created by electromagnetic field (EMF) are the subject of intensive studies. This paper critically considers estimations of exposure to EMF in bioelectromagnetic experiments. Results of calculations presented herein show the significant role of the presence of conducting bodies (the exposure system) near an object under test on EMF energy absorption as well as mutual interactions between simultaneously exposed objects. Our aims herein are twofold: firstly to find a way to refer measurement results to free-space conditions in order to enable comparison of results obtained in different laboratories, and secondly to show that EMF energy absorption in any exposed object is different and that this difference is a function of the size of the exposure system, the number of exposed objects, and the particular properties (i.e., the electromagnetic structure) of the objects. In the authors’ opinion the existence of interactions caused by the presence of the exposure system and other exposed objects is a reason why remarkable differences are observed between experiments performed even under supposedly identical conditions. The presented considerations and conclusion suggest wider participation of physicists and engineers in bioelectromagnetic experiments in order to ensure the correctness of metrological aspects of these experiments.     

Choice of parameters for passive shielding of power-frequency magnetic fields

Epidemiological studies suggesting the possibility of harmful effects on human (specifically children’s leukaemia) due to long-term exposure to magnetic fields of extremely low frequency (e.g. 50/60 Hz) and relatively low values (i.e. over the microtesla range) have stirred high activity in the topic of magnetic field mitigation. To reduce these fields, it is common to use passive metal screens (e.g. plates made of aluminium or steel). To design them, effective and fast numerical computations are highly desirable. In this article, a method is presented, which computes various parameters of screens in a given shielding problem and yields magnetic field distribution and shielding factors. The method takes into consideration the 3D field distribution and is able to solve systems with large aspect ratios (thin thickness in comparison with its other dimensions); this is a common problem where other methods such as finite elements often experience difficulties. The presented method computes separately the field inside and outside the screens. Afterwards, the solutions are “stitched” together along the border of the subregions. Two practical examples are given of the developed numerical method.     

Urbanization and its impact on groundwater: a remote sensing and GIS-based assessment approach

The perils of unplanned urbanization and increasing pressure of human activities on hydro-geomorphologic system often result in modification of the existing recharge mechanism, which leads to many environmental consequences. In the present research, an attempt has been made to investigate the applicability of remote sensing and geographical information system (GIS) in dealing with spatial and temporal variability of dynamic phenomena, like urbanization and its impact on groundwater. This paper covers primarily, quantitative and qualitative impacts of urban growth on the behavior of aquifer in Ajmer city (India). Urban growth of the Ajmer city in last 17 years has been estimated from the satellite images. Database related to urbanization and groundwater has been created in GIS. Groundwater recharge has been computed using a water balance approach known as Water Level Fluctuation Methodology. Recharge estimation methodology has been implemented in GIS to introduce the spatial variability of hydro-geological characteristics. Further, temporal and spatial variations in groundwater quality and quantity have been correlated with urban growth using overlay analysis in GIS. The study reveals a general decline in water table and quality with urbanization. Further, remote sensing and GIS technologies have been found useful in assessment of spatial and temporal phenomena of urbanization and its impact on groundwater system.     

Limitations of an optimum sustainable population or potential biological removal approach for conserving marine mammals: Pacific walrus case study

Decision rules are the agreed-upon points at which specific management interventions are initiated. For marine mammal management under the U.S. Marine Mammal Protection Act (MMPA), decision rules are usually based on either a numeric population or biological-removal approach. However, for walrus and other ice-associated pinnipeds, the inability to reliably assess population numbers or biological removals highlights a significant gap in the MMPA, particularly when the Arctic environment is rapidly changing. We describe the MMPA's ecosystem-based management goals, and why managers have bypassed these goals in favor of an approach that depends upon numerical population assessment. We then revisit the statute's primary goals in light of current knowledge about the Pacific walrus ecosystem and new developments in environmental governance. We argue that to monitor and respond to changes in the walrus ecosystem, decision rules should be based on scientific criteria that depend less on the currently-impractical goal of accurately enumerating population size and trends, or removals from that population. Rather, managers should base decisions on ecological needs and observed ecological changes. To implement this approach would require an amendment to the MMPA that supports filling the gap in management with achievable decision rules. Alternatively, walrus and other ice-associated pinnipeds will remain largely unmanaged during a period of profound environmental change.     

An analysis of assessment outcomes from eight years' operation of the Australian border weed risk assessment system

The majority of Australian weeds are exotic plant species that were intentionally introduced for a variety of horticultural and agricultural purposes. A border weed risk assessment system (WRA) was implemented in 1997 in order to reduce the high economic costs and massive environmental damage associated with introducing serious weeds. We review the behaviour of this system with regard to eight years of data collected from the assessment of species proposed for importation or held within genetic resource centres in Australia. From a taxonomic perspective, species from the Chenopodiaceae and Poaceae were most likely to be rejected and those from the Arecaceae and Flacourtiaceae were most likely to be accepted. Dendrogram analysis and classification and regression tree (TREE) models were also used to analyse the data. The latter revealed that a small subset of the 35 variables assessed was highly associated with the outcome of the original assessment. The TREE model examining all of the data contained just five variables: unintentional human dispersal, congeneric weed, weed elsewhere, tolerates or benefits from mutilation, cultivation or fire, and reproduction by vegetative propagation. It gave the same outcome as the full WRA model for 71% of species. Weed elsewhere was not the first splitting variable in this model, indicating that the WRA has a capacity for capturing species that have no history of weediness. A reduced TREE model (in which human-mediated variables had been removed) contained four variables: broad climate suitability, reproduction in less or than equal to 1year, self-fertilisation, and tolerates and benefits from mutilation, cultivation or fire. It yielded the same outcome as the full WRA model for 65% of species. Data inconsistencies and the relative importance of questions are discussed, with some recommendations made for improving the use of the system.     

The Effect of Shoreline Recreational Angling Activities on Aquatic and Riparian Habitat Within an Urban Environment: Implications for Conservation and Management

There is growing concern that recreational shoreline angling activity may negatively impact littoral and riparian habitats independent of any direct or indirect influences of fish harvest or fishing mortality through mechanisms such as disturbance (e.g., trampling, erosion) and pollution (e.g., littering). We sampled a suite of aquatic and terrestrial variables (i.e., water quality, aquatic and terrestrial macrophytes, soil compaction, anthropogenic refuse) at 14 high shoreline angling-activity sites (identified by way of interviews with conservation officers and angling clubs) within an urban area (Ottawa, Canada). For each high angling-activity site, a nearby corresponding low angling-activity site was sampled for comparison. We found that the percentage of barren area and soil compaction were greater in areas of high angling activity compared with areas that experienced relatively low angling activity. In addition, terrestrial and aquatic macrophyte density, height, and diversity were lower at high angling-activity sites. Angling- and non-angling-related litter was present in large quantities at each of the high angling-activity sites, and comparatively little litter was found at low angling-activity sites. Collectively, these findings indicate that shoreline angling does alter the riparian environment, contributing to pollution and environmental degradation in areas of high angling intensity. With growing interest in providing urban angling opportunities and in response to increasing interest in developing protected areas and parks, a better understanding of the ecologic impacts of shoreline angling is necessary to address multiuser conflicts, to develop angler outreach and educational materials, and to optimize management of angling effort to maintain ecologic integrity of riparian and aquatic ecosystems.     

Hydrogeochemical Indicators of Groundwater Flow Systems in the Yangwu River Alluvial Fan,Xinzhou Basin,Shanxi, China

Based on analysis of groundwater hydrochemical and isotopic indicators, this article aims to identify the groundwater flow systems in the Yangwu River alluvial fan, in the Xinzhou Basin, China. Groundwater δ²H and δ¹⁸O values indicate that the origin of groundwater is mainly from precipitation, with local evaporative influence. d-excess values lower than 10% in most groundwaters suggest a cold climate during recharge in the area. Major ion chemistry, including rCa/rMg and rNa/rCl ratios, show that groundwater salinization is probably dominated by water–rock interaction (e.g., silicate mineral weathering, dissolution of calcite and dolomite and cation exchange) in the Yangwu River alluvial fan, and locally by intensive evapotranspiration in the Hutuo River valley. Cl and Sr concentrations follow an increasing trend in shallow groundwater affected by evaporation, and a decreasing trend in deep groundwater. ⁸⁷Sr/⁸⁶Sr ratios reflect the variety of lithologies encountered during throughflow. The groundwater flow systems (GFS) of the Yangwu River alluvial fan include local and intermediate flow systems. Hydrogeochemical modeling results, simulated using PHREEQC, reveal water–rock interaction processes along different flow paths. This modeling method is more effective for characterizing flow paths in the intermediate system than in the local system. Artificial exploitation on groundwater in the alluvial fan enhances mixing between different groundwater flow systems.