Co-treatment of hydrogen sulfide and methanol in a single-stage biotrickling filter under acidic conditions

Biofiltration of waste gases is cost-effective and environment-friendly compared to the conventional techniques for treating large flow rates of gas streams with low concentrations of pollutants. Pulp and paper industry off-gases usually contain reduced sulfur compounds, such as hydrogen sulfide and a wide range of volatile organic compounds (VOCs), e.g., methanol. It is desirable to eliminate both of these groups of compounds. Since the co-treatment of inorganic sulfur compounds and VOCs in biotrickling filters is a relatively unexplored area, the simultaneous biotreatment of H2S and methanol as the model VOC was investigated. The results showed that, after adaptation, the elimination capacity of methanol could reach around 236 g m(-3) h(-1) with the simultaneous complete removal (100%) of 12 ppm H2S when the empty bed residence time is 24 s. The pH of the system was around 2. Methanol removal was hardly affected by the presence of hydrogen sulfide, despite the low pH. Conversely, the presence of the VOC in the waste gas reduced the efficiency of H2S biodegradation. The maximal methanol removal decreased somewhat when increasing the gas flow rate. This is the first report on the degradation of methanol at such low pH in a biotrickling filter and on the co-treatment of H2S and VOCs under such conditions.     

Structure of Mn-Zr mixed oxides catalysts and their catalytic performance in the gas-phase oxidation of chlorocarbons

The catalytic activity and selectivity of manganese zirconia mixed oxides were evaluated for the oxidation of two common chlorinated pollutants found in waste streams, namely 1,2-dichloroethane (DCE) and trichloroethylene (TCE). Mixed oxides with varying Mn-Zr content were prepared by coprecipitation via nitrates, and subsequent calcination at 600 degrees C for 4 h in air. These catalysts were characterised by means of several techniques such as atomic emission spectrometry, N2 adsorption-desorption, powder X-ray diffraction, temperature-programmed desorption of ammonia, pyridine adsorption followed by diffuse reflectance infrared spectroscopy and temperature-programmed reduction with hydrogen. The active catalytic behaviour of Mn-Zr mixed oxides was ascribed to a substantial surface acidity combined with readily accessible active oxygen species. Hence, the mixed oxide with 40 mol% manganese content was found to be an optimum catalyst for the combustion of both chlorocarbons with a T50 value around 305 and 315 degrees C for DCE and TCE oxidation, respectively. The major oxidation products were carbon dioxide, hydrogen chloride and chlorine. It was observed that the formation of both CO2 and Cl2 was promoted with Mn loading.     

Acid-base properties of humic substances from composted and thermally-dried sewage sludges and amended soils as determined by potentiometric titration and the NICA-Donnan model

The acid-base properties of humic acids (HAs) and fulvic acids (FAs) isolated from composted sewage sludge (CS), thermally-dried sewage sludge (TS), soils amended with either CS or TS at a rate of 80 t ha(-1)y(-1) for 3y and the corresponding unamended soil were investigated by use of potentiometric titrations. The non-ideal competitive adsorption (NICA)-Donnan model for a bimodal distribution of proton binding sites was fitted to titration data by use of a least-squares minimization method. The main fitting parameters of the NICA-Donnan model obtained for each HA and FA sample included site densities, median affinity constants and widths of affinity distributions for proton binding to low and high affinity sites, which were assumed to be, respectively, carboxylic- and phenolic-type groups. With respect to unamended soil HA and FA, the HAs and FAs from CS, and especially TS, were characterized by smaller acidic functional group contents, larger proton binding affinities of both carboxylic- and phenolic-type groups, and smaller heterogeneity of carboxylic and phenolic-type groups. Amendment with CS or TS led to a decrease of acidic functional group contents and a slight increase of proton binding affinities of carboxylic- and phenolic-type groups of soil HAs and FAs. These effects were more evident in the HA and FA fractions from CS-amended soil than in those from TS-amended soil.     

Heavy metal-rich wastes sequester in mineral phases through a glass-ceramic process

Certain sludges generated by industry are rich in contaminating elements and are a major environmental problem. In this study, we determine the ability of these contaminating elements to be incorporated into a glass-matrix and in various mineral phases after a crystallization process. The contaminating elements studied were obtained from sewage sludges (SS) and galvanic sludges (GS), our raw materials. The sludge samples were taken from urban wastewater treatment plant in Catalonia (NE Spain) with high levels of phosphorus oxide (P(2)O(5)). In silica glasses, P(2)O(5) acts as a network former. We determined the chemical composition of both the SS and GS, as well as their thermal behaviour by differential thermal analysis and thermal gravimetric analysis (DTA-TG) to obtain their melting curves. The vitreous transition temperature of the obtained glass was established by dilatometer technique at 725 degrees C. The DTA-TG curve of the glass obtained has an exothermal wide peak at 860 degrees C corresponding to crystallization of the two phases: a spinel phase and a phosphate phase. A second exothermal wide peak at 960 degrees C was attributed to the crystallization of aluminium pyroxene, anorthite and fluor-apatite, with two exothermal phenomena attributed to the evolution of these phases. An exothermal peak at 1100 degrees C was attributed to gehlenite crystallization. Scanning electron microscope observations and energy-dispersed X-ray spectroscopy microanalyses of glass-ceramic showed that the contaminating elements were concentrated in the spinel phases, which are the first phases to crystallize during the cooling of glass. Finally, the spinel structure permits the incorporation of all the contaminating elements into it.     

Estrogenic activity removal of 17beta-estradiol by ozonation and identification of by-products

This work investigated the degradation of a natural estrogen (17beta-estradiol) and the removal of estrogenic activity by the ozonation process in three different pHs (3, 7 and 11). A recombinant yeast assay (YES assay) was employed to determine estrogenic activity of the ozonized samples and of the by-products formed during the ozonation. Ozonation was very efficient for the removal of 17beta-estradiol in aqueous solutions. High removals (>99%) were achieved with low ozone dosages in the three different pHs. Several by-products were formed during the ozonation of 17beta-estradiol. However, only a few compounds could be identified and confirmed. Different by-products are formed at different pHs, which is probably due to different chemical pathways and different oxidants (O(3) and OH radical). The by-products formed at pH 11 were 10epsilon-17beta-dihydroxy-1, 4-estradieno-3-one (DEO) and 2-hydroxyestradiol, which were not formed in pH 3. Only testosterone could be observed in pH 3, whereas at pH 7 all three by-products were found. At pH 7 and 11 the applied ozone dosages were not enough to remove all the estrogenicity from samples, even though the 17beta-estradiol residual concentration for these two pHs was lower than at pH 3. Higher estrogenicity was detected at pH 11. An explanation to this fact may be that oxidation via OH radical forms more by-products with estrogenic activity. Probably, the formation of 2-hydroxyestradiol at pHs 7 and 11 is contributing to the residual estrogenicity of samples ozonized at these pHs. In this work, complete removal of estrogenic activity was only obtained at pH 3.     

Seasonal variations of selected herbicides and related metabolites in water, sediment, seaweed and clams in the Sacca di Goro coastal lagoon (Northern Adriatic)

This study assesses the status of Sacca di Goro coastal lagoon (Northern Adriatic, Italy) with respect to watershed pollution. Because 80% of its watershed is devoted to agriculture, plant protection products and their metabolites were found in the water column, sediments (the upper 0-15 cm layer), macroalgae (Ulva rigida) and clams (Tapes philippinarum). Five seasonal sampling campaigns were performed from May 2004 to April 2005 and concentrations measured in five stations in the lagoon and six in the watershed. Relatively high concentrations of the s-triazine - terbuthylazine -, urea herbicides - diuron - and alachlor were detected through the year mainly at stations directly influenced by the Po di Volano inflow. The concentrations of products in use follow a clear seasonal pattern with spring peaks. This pattern is also visible in the sediments as well as in biota. Among metabolites, hydroxylated compounds prevailed, often with concentrations greater than those of the parent compounds. For the most part of the year, the concentrations in biota were close to detection limits, with concentration peaks in spring.     

Evaluation of natural and anthropogenic influences on the Guadalquivir River (Spain) by dissolved heavy metals and nutrients

To evaluate both the natural and anthropogenic influences on surface waters of Guadalquivir River (SW-Spain), concentrations of dissolved trace metals (Mn, Co, Ni, Cu, Cd, Zn, and Pb), inorganic nutrients (N-NH(4)(+), N-NO(3)(-), N-NO(2)(-), and P-PO(4)(3-)) and other variables as conductivity, pH, dissolved oxygen (DO) and suspended solids (SS) were measured during a three-years period (2001-2003). Samples were taken at 26 stations twice a year, during rain and dry periods. The analysis of variance (ANOVA) suggested that temporal variations within the period of study were statistically negligible. Spatial distributions identified three different zones, mainly influenced by sewage (Eastern Zone), agriculture runoffs (Central Zone), and estuarine processes (Western Zone), respectively. Principal Component and Cluster Analysis allowed to identify the variables controlling the water quality of each zone as: N-NH(4)(+), N-NO(2)(-), Mn, and Co, (Eastern Zone), SS, and P-PO(4)(3-) (Central Zone), and Cd, pH and conductivity (Western Zone). Other variables such as Ni, Cu, Zn or N-NO(3)(-), influenced two different zones, while Pb presented a singular behavior.     

Biodegradability and ecotoxicity of amine oxide based surfactants

The aerobic and anaerobic biodegradability as well as the aquatic toxicity of two fatty amine oxides and one fatty amido amine oxide were investigated. Aerobic biodegradation was evaluated using the CO(2) headspace test (ISO 14593) and biodegradation under anaerobic conditions was assessed employing a standardised batch test. The three amine oxide based surfactants tested were readily biodegradable under aerobic conditions but only the alkyl amido amine oxide was found to be easily biodegradable under anaerobic conditions. Toxicity to Photobacterium phosphoreum and Daphnia magna was evaluated. Bacteria (EC(50) from 0.11 to 11 mg l(-1)) proved to be more sensitive to the toxic effects of the amine oxide based surfactants than crustacea (IC(50) from 6.8 to 45 mg l(-1)). The fatty amido amine oxide showed the lowest aquatic toxicity.     

Transport of simazine in unsaturated sandy soil and predictions of its leaching under hypothetical field conditions

The potential contamination of groundwater by herbicides is often controlled by processes in the vadose zone, through which herbicides travel before entering groundwater. In the vadose zone, both physical and chemical processes affect the fate and transport of herbicides, therefore it is important to represent these processes by mathematical models to predict contaminant movement. To simulate the movement of simazine, a herbicide commonly used in Chilean vineyards, batch and miscible displacement column experiments were performed on a disturbed sandy soil to quantify the primary parameters and processes of simazine transport. Chloride (Cl(-)) was used as a non-reactive tracer, and simazine as the reactive tracer. The Hydrus-1D model was used to estimate the parameters by inversion from the breakthrough curves of the columns and to evaluate the potential groundwater contamination in a sandy soil from the Casablanca Valley, Chile. The two-site, chemical non-equilibrium model was observed to best represent the experimental results of the miscible displacement experiments in laboratory soil columns. Predictions of transport under hypothetical field conditions using the same soil from the column experiments were made for 40 years by applying herbicide during the first 20 years, and then halting the application and considering different rates of groundwater recharge. For recharge rates smaller than 84 mm year(-1), the predicted concentration of simazine at a depth of 1 m is below the U.S. EPA's maximum contaminant levels (4 microg L(-1)). After eight years of application at a groundwater recharge rate of 180 mm year(-1) (approximately 50% of the annual rainfall), simazine was found to reach the groundwater (located at 1 m depth) at a higher concentration (more than 40 microg L(-1)) than the existing guidelines in the USA and Europe.     

Comment on "Analysis of groundwater contamination using concentration-time series recorded during an integral pumping test: Bias introduced by strong concentration gradients within the plume" by Allelign Zeru and Gerhard Schäfer

We consider the results of a recent paper in this journal [Zeru, A. and Sch?fer, G., 2005. Analysis of groundwater contamination using concentration-time series recorded during an integral pumping test: Bias introduced by strong concentration gradients within the plume. Journal of Contaminant Hydrology 81 (2005) 106-124], which addresses the field-scale characterisation of contaminant plumes in groundwater. There, it is concluded that contaminant concentration gradients can bias Integral Pumping Test (IPT) interpretations considerably, in particular if IPTs are conducted in advective fronts of contaminant plumes. We discuss implications of this setting and also argue that the longitudinal and transverse dispersivities used in the examples of Zeru and Sch?fer (2005) of up to 30 m and 3 m, respectively, are generally very high for the here relevant capture zone scale (<20 m). However, regardless of both longitudinal and transverse concentration gradients, we further show through a counter-example that IPT results are unbiased as long as the concentration attenuation along the flow direction is linear over the capture zone extent.