Spectral trend of vegetation with rainfall in events of El Niño-Southern Oscillation for Atlantic Forest biome,Brazil

This study aimed to analyze the spectral trend of vegetation with rainfall in El Niño-Southern Oscillation events (ENSO) in the Atlantic Forest, Brazil. Monthly rainfall data were collected from 85 conventional meteorological stations (EMC), data from the Enhanced Vegetation Index 2 (EVI2) and ENSO events (El Niño, La Niña, and Neutral) in the period from 2001 to 2013. Afterwards, state cluster analysis was performed using the results of non-parametric tests. The Mann-Kendall (MK) non-parametric test did not identify a trend pattern in rainfall distribution in the Atlantic Forest. The results for EVI2 by state and region showed that the trend is decreasing in the Northeast Region, except for the states of Alagoas and Pernambuco. Southeast region showed an increasing trend of EVI2 (except for Rio de Janeiro and São Paulo), while the South region showed a decreasing trend. In the Midwest, the trend was significantly decreasing. In the prognosis elaborated for the future, the regions with significant declines of the vegetation were the Northeast and Midwest. This study shows that the Atlantic Forest in some regions of Brazil has been suffering from the growing urbanization process and there is a trend of soil degradation.     

FIA-coupled spectrophotometric method for determination of Cr (VI) traces in natural waters: application of in-line dissolution of 1,5-diphenylcarbazide after heat treatment and activated alumina as adsorbent for preconcentration

This work proposes the quantification of Cr (VI) ions in natural waters in trace level, using activated alumina (Al₂O₃) as preconcentration support, controlled in-line dissolution of the solidified chromophore diphenylcarbazide after heat treatment and spectrophotometric detection. The manifold ensures high sensitivity of analytical response, good repeatability, and stability. In this work, optimization of experimental conditions of a flow injection system was chosen as the parameters for greater sensitivity and better selectivity. The selected optimized conditions were 0.30 mol L^?1 for H₂SO₄ concentration, system flow rate as 0.40 mL min^?1, sample injection volume of 192.50 μL, 2 min for preconcentration time, and 0.10 mol L^?1 for eluent concentration. The analytical curves obtained for real sample analysis show linear range from 0.192 to 0.961 μM, linear correlation coefficient R?=?0.9997 and LOD?=?0.024 μM. The preconcentration factor of about four times was obtained through the passage of 800 μL of a standard solution containing 0.961 μM of Cr (VI) through mini-column of preconcentration followed by elution at 192.5 μL of NH₄OH 0.1 mol L^?1 solution. The solid chromogenic reagent presented high durability (weeks in daily use with mass of 0.0993 g) and good reproducibility in analytical signal. The reactivation of the mini-column of alumina should be executed after ten injections of eluent, using 800 μL of HCl 0.02 mol L^?1 solution in flow through the same. Each cycle of injection and elution of the sample takes about 5 min on the proposed terms. Despite the length of each cycle still be high, low concentrations can be detected using a technique of relatively low cost. This is due in part, the association dissolution of the chromogenic reagent directly in the line and the preconcentration step. Another important factor is the economy of reagent chromogenic, low generation of reject contributing to better quality of the environment, and the high potential for applications to work in field.     

Environmental copper: Behaviour when involved in physical adsorption at several interfaces

From a literature-based assessment of the current knowledge about both the toxic or salutary properties of copper, this study focused on the determination, at 25 °C, of the interfacial properties of CuCl_2, either alone or in mixture with carbofuran used, here, as a model of organics and/or pesticide. The interfaces under study were: i) the air/solution interface and ii) the silica/solution interface. The former is considered as a path for volatilization, whereas the latter permits a modelling of physical adsorption upon solids, which is the first and unavoidable step in any adsorption process. One should note that it can also mimic adsorption on some sandy soils. Coadsorption was clearly identified as implicated in an enhancement of the surface content of both solutes at both interfaces. However, at the two interfaces under study, the way the surface became structured led to opposite adsorption mechanisms for the organic compounds and the salt. A rough theory about ionic adsorption is also proposed.     

PM2.5 and PM10: The influence of sugarcane burning on potential cancer risk

In Brazil, sugarcane fields are often burned to facilitate manual harvesting, and this burning causes environmental pollution from the large amounts of soot released into the atmosphere. This material contains numerous organic compounds such as PAHs. In this study, the concentrations of PAHs in two particulate-matter fractions (PM_2.5 and PM₁₀) in the city of Araraquara (SE Brazil, with around 200,000 inhabitants and surrounded by sugarcane plantations) were determined during the sugarcane harvest (HV) and non-harvest (NHV) seasons in 2008 and 2009. The sampling strategy included four campaigns, with 60 samples in the NHV season and 220 samples in the HV season. The PM_2.5 and PM₁₀ fractions were collected using a dichotomous sampler (10 L min^?1, 24 h) with Teflon? filters. The filter sets were extracted (ultrasonic bath with hexane/acetone (1:1 v/v)) and analyzed by HPLC/Fluorescence. The median concentration for total PAHs (PM_2.5 in 2009) was 0.99 ng m^?3 (NHV) and 3.3 ng m^?3 (HV). In the HV season, the total concentration of carcinogenic PAHs (benz(a)anthracene, benzo(b)fluoranthene, benzo(k)fluoranthene, and benzo(a)pyrene) was 5 times higher than in the NHV season. B(a)P median concentrations were 0.017 ng m^?3 and 0.12 ng m^?3 for the NHV and HV seasons, respectively. The potential cancer risk associated with exposure through inhalation of these compounds was estimated based on the benzo[a]pyrene toxic equivalence (BaP_eq), where the overall toxicity of a PAH mixture is defined by the concentration of each compound multiplied by its relative toxic equivalence factor (TEF). BaP_eq median (2008 and 2009 years) ranged between 0.65 and 1.0 ng m^?3 and 1.2–1.4 ng m^?3 for the NHV and HV seasons, respectively. Considering that the maximum permissible BaP_eq in ambient air is 1 ng m^?3, related to the increased carcinogenic risk, our data suggest that the level of human exposure to PAHs in cities surrounded by sugarcane crops where the burning process is used is cause for concern.     

Biomonitoring perfluorinated compounds in Catalonia,Spain: concentrations and trends in human liver and milk samples

Background, aim and scope  

Perfluorinated compounds (PFCs) are global environmental pollutants that bioaccumulate in wildlife and humans. Laboratory experiments have revealed toxic effects such as delayed development, humoral suppression, and hepatotoxicity. Although numerous human blood levels have been reported, little is known about distribution in the human body. Knowledge about PFC distribution and accumulation in the human body is crucial to understanding uptake and subsequent effects as well as to conduct risk assessments. The present study reports PFC levels in human liver and breast milk from a general population living in Catalonia, Spain. Liver and milk levels are compared to previously reported levels in blood from the same geographic area as well as to other existing reports on human liver and milk levels in other countries.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Characterisation of particulate exposure during fireworks displays

Little is known about the level and content of exposure to fine particles (PM_2.5) among persons who attend fireworks displays and those who live nearby. An evaluation of the levels of PM_2.5 and their elemental content was carried out during the nine launches of the 2007 Montréal International Fireworks Competition. For each event, a prediction of the location of the firework plume was obtained from the Canadian Meteorological Centre (CMC) of the Meteorological Service of Canada. PM_2.5 was measured continuously with a photometer (Sidepak?, TSI) within the predicted plume location (“predicted sites”), and integrated samples were collected using portable personal samplers. An additional sampler was located on a nearby roof (“fixed site”). The elemental composition of the collected PM_2.5 samples from the “predicted sites” was determined using both a non-destructive energy dispersive ED-XRF method and an ICP-MS method with a near-total microwave-assisted acid digestion. The elemental composition of the “fixed site” samples was determined by the ICP-MS with the near-total digestion method. The highest PM_2.5 levels reached nearly 10 000 μg m^?3, roughly 1000 times background levels. Elements such as K, Cl, Al, Mg and Ti were markedly higher in plume-exposed filters. This study shows that 1) persons in the plume and in close proximity to the launch site may be exposed to extremely high levels of PM_2.5 for the duration of the display and, 2) that the plume contains specific elements for which little is known of their acute cardio-respiratory toxicity.     

Relation between management's behavioural intentions toward the environment and environmental actions

Drawing on Ajzen's Theory of Planned Behaviour, this paper analyses whether there is a relation between management's behavioural intentions toward an environmental problem and the company's specific actions in this area, and also considers the impact of the company size on these actions. For the data, a questionnaire was sent to 184 managers employed in industrial companies located in Spain which belonged to the automobile industry. The empirical analysis produces positive and significant regression coefficients and provides support for the hypotheses proposed. Specifically, the results show that the environmental actions carried out in the company respond at least in part to management's behavioural intentions toward these issues and the size of the firm.     

High efficiencies in the electrochemical oxidation of an anthraquinonic dye with conductive-diamond anodes

Oxidation of anthraquinonic dye Acid Blue 62 by electrolysis with conductive-diamond electrodes is studied in this work. COD, TOC, and color have been selected to monitor the degradation of the molecule as a function of several operating inputs (current density, pH, temperature, and NaCl concentration). Results show that the electrochemical oxidation of this model of large molecules follows a first order kinetics in all the conditions assessed, and it does not depend on the pH and temperature. The occurrence of chloride ions in wastewaters increases the rate of color and COD removal as a consequence of the mediated oxidation promoted by the chlorinated oxidizing species. However, chloride occurrence does not have an influence on the mineralization rate. First-order kinetic-constants for color depletion (attack to chromophores groups), oxidation (COD removal), and mineralization (TOC removal) were found to depend on the current density and to increase significantly with its value. A single model was proposed to explain these changes in terms of the mediated oxidation processes. Rate of mineralization remained very close to that expected for a purely mass transfer-controlled process. This was explained assuming that mediated oxidation does not have a significant influence on the mineralization in spite it has some effect on intermediate oxidation stages. The efficiency of the oxidation was found to depend mainly on the concentration of COD being negligible the effect of the other inputs assessed except for the occurrence of chloride ions. Opposite, the efficiency of mineralization depends on concentration of TOC and current density and it did not depend on the chloride occurrence. This observation was found to have an important influence on the power required to remove a given percentage of the initial TOC or COD. To decrease COD efficiently, the occurrence of chloride in the solution is very important, while to remove TOC efficiently, it is more important to work at low current densities and chloride effect is negligible. Energy consumption could be decreased by folds using the proper conditions.     

Environmental monitoring of alcohol sulfates and alcohol ethoxysulfates in marine sediments

The study describes the environmental monitoring of anionic surfactants―alcohol sulfates (AS) and alcohol ethoxysulfates (AES)—in marine sediments. Concentration values were obtained after pressurised liquid extraction (PLE) and liquid chromatography–tandem mass spectrometry analysis (LC–MS/MS). Samples were collected from a range of wastewater discharge points along the coast of the provinces of Huelva, Málaga, Granada and Almería. Urban, agricultural and industrial wastewaters are discharged at the selected 38 sampling sites. Principal component analysis was carried out in order to evaluate the distribution and behaviour of these compounds in these coastal environments. Evaluation of the data revealed that the behaviour and sources of AS and AES in marine sediments are different, and that the distribution of AES depends on the length of the alkyl chain, while the number of ethoxylated units is not relevant. Additionally, the 38 sampling sites can be grouped into only two types of outfalls according to their AS distribution. The concentration of compounds in sediment samples ranged from 7.52 to 13.50 mg kg^?1 for AS, from 3.04 to 10.68 mg kg^?1 for AES–C₁₂E_x and from 3.83 to 11.56 mg kg^?1 for AES–C₁₄E_x.