Derivation of synthetic fuel from waste plastic: investigation of engine operating characteristics on DI diesel engine

The utilization of plastic in day to day life is ever-increasing and has generated a large amount of plastic garbage that needs proper disposal to save the environment from harmful pollution. The plastic waste management becomes a pressing concern in the present scenario in developing countries like India. This research article evaluates the potential of synthetic fuel (SF) derived from waste plastics collected from the local shops. In this current investigation, the SF blends are tested in a direct injection diesel engine to analyze the performance and emission characteristics of the engine. Three different blends were made namely SF20, SF40, and SF60 on a volumetric basis and the tests were carried out. From the experimental results, it was found that brake thermal efficiency (BTE) of the fuel blends was reduced as compared with neat diesel operation regardless of loads whereas SF20 showed a similar trend as that of diesel operation. The analysis of the emission characteristics revealed that the SF20 blends reduced dangerous smoke and carbon monoxide emission as compared with other test fuels. From the overall results, SF20 showed superior performance and emission aspects as compared with other SF blends whereas the engine operated smoothly up to 60% of SF blending at all loading conditions.

     

Delayed association of acute particulate matter 2.5 air pollution exposure with loss of complexity in cardiac rhythm dynamics: insight from detrended fluctuation analysis

Environmental Science and Pollution Research - There is a delayed (lag 1 to 2 days) correlation between acute PM 2.5 (particulate matter <?2.5 μm in aerodynamic...     

Tissue distribution of perfluoroalkyl acids and health status in wild Mozambique tilapia (Oreochromis mossambicus) from Loskop Dam, Mpumalanga, South Africa

This study examined concentrations of 15 perfluoroalkyl acids (PFAAs) in tissues from male Mozambique tilapia (Oreochromis mossambicus) collected at Loskop Dam, Mpumalanga, South Africa in 2014 and 2016. Nine of the 15 PFAAs were detected frequently and were included in statistical analysis and included two of the most commonly known PFAAs, perfluorooctanesulfonic acid (PFOS) (median, 41.6 ng/g) and perfluorooctanoic acid (PFOA) (median, 0.0825 ng/g). Of the tissues measured, plasma (2016 and 2014 median, 22.2 ng/g) contained the highest PFAA burden followed by (in descending order): liver (median, 11.6 ng/g), kidney (median, 9.04 ng/g), spleen (median, 5.92 ng/g), adipose (median, 2.54 ng/g), and muscle (median, 1.11 ng/g). Loskop Dam tilapia have been affected by an inflammatory disease of the adipose tissue known as pansteatitis, so this study also aimed to investigate relationships between PFAA tissue concentrations and incidence of pansteatitis or fish health status. Results revealed that healthy tilapia exhibited an overall higher (p-value < 0.05) PFAA burden than pansteatitis-affected tilapia across all tissues. Further analysis showed that organs previously noted in the literature to contain the highest PFAA concentrations, such as kidney, liver, and plasma, were the organs driving the difference in PFAA burden between the two tilapia groups. Care must be taken in the interpretations we draw from not only the results of our study, but also other PFAA measurements made on populations (human and wildlife alike) under differing health status.     

Development of a biaxial loading frame for sheet metal

Characterization of the evolving yield loci and forming limit diagrams for sheet materials under biaxial loading is necessary for the development of accurate sheet metal forming process simulations. Biaxial tension testing has been shown to have significant advantages over the current computational and experimental methods for such material characterization; however, the few commercially available loading frames are far too large and expensive to be practical for most metal forming research laboratories. In this paper, the design of a practical servohydraulic biaxial loading frame is presented. The design, control, and operation of the loading frame are discussed in detail, and experimental data is provided to validate the effectiveness of the control system with respect to specimen center shifting.     

Secondary analysis of time of day on simulated driving performance

PROBLEM: Age and gender are frequently controlled for in studies of driving performance, but the effects of time of day or circadian cycles on performance are often not considered. Previous research on time of day effects of simulated driving is contradictory and provides little guidance for understanding the impact of these variables on results. METHODS: Using driving simulator data from 79 subjects ages 18 to 65, this paper focuses on the impact of age, gender, and time of day on the simulated driving performance of subjects who self-selected the time of participation. RESULTS: Time of day effects were consistently evident for drivers' speed overall and across different simulated environments. Drivers in the late afternoon period consistently drove significantly slower than drivers in other time periods. Age and gender affected speed such that women and those participants 50 and older tended to drive more slowly. Time of day also had an effect on reaction time and on speed variability measures. Gender did not have significant effects on reaction time or variability measures, but age effects were present. SUMMARY: Taken together, the results suggest that time of day effects should be considered as part of simulated driving performance, and that interactions between time of day and other variables, notably age, should be controlled for as part of future research. IMPACT ON INDUSTRY: Implications of these findings on current efforts for older driver testing are discussed.     

Origin of major ions in monthly rainfall events at the Bamenda Highlands, North West Cameroon

Rainwater characteristics can reveal emissions from various anthropogenic and natural sources into the atmosphere. The physico-chemical characteristics of 44 monthly rainfall events （collected between January and December 2012） from 4 weather stations （Bamenda, Ndop plain, Ndawara and Kumbo） in the Bamenda Highlands （BH） were investigated. The purpose was to determine the sources of chemical species, their seasonal inputs and suitability of the rainwater for drinking. The mean pH of 5 indicated the slightly acidic nature of the rainwater. Average total dissolved solids （TDS） were low （6.7 mg/L）, characteristic of unpolluted atmospheric moisture/air. Major ion concentrations （mg/L） were low and in the order K＋ 〉 Ca2＋ 〉 Mg2~ 〉 Na＋ for cations and NO3 〉〉 HCO3 〉 SO] 〉 CI- 〉 PO3- 〉 F- for anions. The average rainwater in the area was mixed Ca-Mg-SO4-CI water type. The CI-/Na＋ ratio （1.04） was comparable to that of seawater （1.16）, an indication that N a＋ and CI originated mainly from marine （Atlantic Ocean） aerosols. High enrichments of Ca2＋, Mg2＋ and SO2- to Na＋ ratios relative to seawater ratios （constituting 44% of the total ions） demonstrated their terrigenous origin, mainly from Saharan and Sahelian arid dusts. The K＋/Na＋ ratio （2.24）, which was similar to tropical vegetation ash （2.38）, and NO3 was essentially from biomass burning. Light （〈 100 mm） pre-monsoon and post-monsoon convective rains were enriched in major ions than the heavy （〉 100 mm） monsoon rains, indicating a high contribution of major ions during the low convective showers. Despite the acidic nature, the TDS and major ion concentrations classified the rainwater as potable based on the WHO guidelines.     

Comparison of surface emissions and subsurface distribution of cis- and trans-1,3-dichloropropene and chloropicrin in sandy field beds covered with four different plastic films

The purpose of this study was to conduct a field study at a Florida field site on surface emissions and subsurface distribution of cis-and trans-1,3-dichloropropene (1,3-D) and chloropicrin (CP) in raised beds injected with Telone C35 with four replications. A total of 16 beds were applied with Telone C35 by chisel injection and covered with four different plastic films, 4 beds for each film. Each bed was installed with five 20-cm long soil pore air probes and a surface air collection pan at arbitrarily locations along the length of each bed for sampling soil pore air and surface air, respectively, for analysis of the three biologically active compounds, cis- and trans-1,3-D and CP. We found that average concentrations of the three compounds at 20-cm depth among the beds covered with four different plastic films generally were not statistically different. Among the four beds covered with the same plastic film, average concentrations of the three compounds were statistically different only in the four metallic PE covered beds at 5 and 24 hours after injection. Volatilization rates of the three compounds among the beds covered with four different plastic films, with the exception of CP at 48 hours after injection, were not statistically different. It appeared that initial upward diffusion and volatilization flux were influenced by solar radiation. Initial subsurface concentrations of the three compounds and volatilization flux, especially cis-1,3-D, were greater in the beds on the east side of the field than that in the beds on the west side of the field. Whether or not difference in initial subsurface concentrations of the compounds between east side beds and west side beds may influence fumigant efficacy remains to be determined.     

Background levels and dietary intake of PCDD/Fs in domestic and imported meat in South Korea

A survey was conducted in South Korea to determine residual levels and dietary intake of polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs) from meat. Altogether 119 domestic and 164 imported samples of beef, pork, and chicken were examined. The mean levels of PCDD/Fs in upper bound were 0.21, 0.22, and 0.04pg WHO-TEQ/g fat for beef, pork, and chicken, respectively. The low level of PCDD/Fs in chicken probably resulted from the low fat content in the samples used. The samples were separated into domestic and imported products in order to investigate the sources of contamination. PCDFs were the more dominant congeners in domestic beef and were similar to those found from emission of incineration. However, the congener profiles of domestic beef and incineration were difficult to compare because the environmental fate and animal metabolism were involved. The upper bound dietary intake of PCDD/Fs from beef, pork and chicken was calculated to be 0.04pg/WHO-TEQ/kgbw/day. The combined consumption of beef, pork, and chicken was found to be 84.8g per day for a person weighing 60kg and represented 5.7% of their total daily food intake.     

Review of advances in the thin layer chromatography of pesticides: 2004-2006

Applications of thin layer chromatography and high performance thin layer chromatography for the separation, detection, and qualitative and quantitative determination of pesticides, other agrochemicals, and related compounds are reviewed for the period from July 1, 2004 to November 1, 2006. Analyses are covered for a variety of samples, such as food, crops, biological, environmental, pharmaceuticals, and formulations, and for residues of pesticides of various types, including insecticides, herbicides, and fungicides, belonging to different chemical classes. In addition to references on residue analysis, studies such as pesticide-structure relationships, metabolism, degradation, and lipophilicity are covered, many of which make use of thin layer radiochromatography.     

Organic pollutants in compost and digestate. Part 1. Polychlorinated biphenyls, polycyclic aromatic hydrocarbons and molecular markers

In Europe, 9.3 x 10(6) t(dry weight (dw)) of compost and digestate are produced per year. Most of this is applied to agricultural land, which can lead to considerable inputs of organic pollutants, such as polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH) to soil. This paper presents an inventory of the pollutant situation in source-separated composts, digestates and presswater in Switzerland by a detailed analysis of over 70 samples. PCB concentrations ( summation PCB 28, 52, 101, 118, 138, 153, 180) were significantly higher in urban (median: 30 microg kg(-1)dw, n = 52) than in rural samples (median: 14 microg kg(-1)dw, n = 16). Together with low concentrations in general, this points to aerial deposition on compost input material as the major contamination pathway. Enantiomeric fractions of atropisometric PCB were close to racemic. Median PAH concentration was 3010 microg kg(-1)dw( summation 15PAH, n = 69), and one quarter of the samples exhibited concentrations above the relevant Swiss guide value for compost (4000 microg kg(-1)dw). The levels were influenced by the treatment process (digestate > compost), the season of input material collection (spring-summer > winter > autumn), the particle size (coarse-grained > fine-grained), and maturity (mature > less mature). The main source of PAH in compost was pyrogenic, probably influenced mainly by liquid fossil fuel combustion and some asphalt abrasion, as suggested by multiple linear regression. This study, together with a companion paper reporting on other organic contaminates including emerging compound classes, provides a starting point for a better risk-benefit estimation of the application of compost and digestate to agricultural soil in Switzerland.