Analysis of an APCA Baghouse Operation and Maintenance Survey

Baghouse operation and maintenance is probably the most serious problem area of fabric filter operations. Committee TC-1 (Particulates) of the Air Pollution Control Association recently surveyed baghouse installations in'the United States for the purpose of gathering information on operation and maintenance procedures and problems. One hundred thirty-three questionnaires were completed and returned. In this paper, the results of a comprehensive analysis of these data are described and interpreted. A multiple-choice type of compilation of the responses has been used to permit statistical interpretation of the results. Due to the length of the questionnaire and the tables which resulted from the analysis, these are described but not included in the following paper. They are available from the TC-1 Committee c/o APCA.     

Factors Influencing the Emissions of Nitrated-Polynuclear Aromatic Hydrocarbons(Nitro-PAH) from Diesel Engines

The potential problem of 1-nitropyrene (1-NP) formation during filter sampling of diesel emissions from dilution tubes is assessed. Rates of formation are calculated using data generated from several independent filter exposure studies. A portion of the 1-NP (12% average) found in participates collected from light-duty (LDD) and heavy-duty diesels (HOD) was found to be due to formation on the filter under average sampling conditions of 10-15/1 dilution at 44°C with 3 ppm NO₂ for 23 min. On the average, the concentration of 1-NP in participates emitted from HDD is 16 times less than that found in LDD run under similiar transient conditions. The average emission rate of 1-NP generated from the LDD and HDD was 4.7 μg/km and 1.5 μg/km, respectively for the vehicles operating under Federal Test Procedure (FTP)-transient conditions. Under operating conditions which increase exhaust temperature (increased speed and load), the concentration of nitro-PAH is significantly reduced with a concurrent increase in the concentration of partially oxidized nitro-PAH and dinitro-PAH. The concentration of 1-NP in the particulates measured from HDD in these dilution tube studies (0.33-0.95 ppm, depending upon engine load) is comparable to that measured in highway tunnel experiments (0.54 ppm average).     

ESP Bus Section Failures: Design Considerations

This paper addresses a common operation and maintenance problem encountered with sectionalized electrostatic precipitators—bus section failure. ESPs are normally designed to meet a specific minimum collection efficiency in order to comply with emission standards; the loss of several bus sections may cause the unit to be out of compliance. In this paper, the effect of bus section failure on precipitator performance is analyzed. The study is presented in two parts. First, a simplified procedure to estimate the effect of bus section failure on the overall collection efficiency is developed. An illustrative example is presented to demonstrate the use of the technique. Secondly—and this is the main thrust of this study—the technique is extended to include calculations on whether a unit is out of compliance due to the failure of a given number of bus sections. This development clearly shows that this latter effect can only be expressed in terms of a probability. Two additional examples, based on a field unit using actual test data, complement the presentation and illustrate this probability calculation.     

Forecasting COH Levels at Six Outlying Sampling Stations in Allegheny County Using Statistical Correlations Derived from the Downtown Station

Verification of forecasts of COH levels at the Downtown Sampling Station using our objective forecast method developed in conjunction with the Allegheny County Bureau of Air Pollution Control gave excellent results. The next step was to expand the area of forecast coverage.

COH data taken from July 1968 through June 1969 from six sampling stations located roughly in a large concentric arc around the Downtown Station were studied. Three of the stations are located in river valleys near large industrial plants and the other three are located on higher terrain in suburban areas.

COH levels of Low, Moderate, High, and Very High (where Low = 0–0.9, Moderate = 1.0–1.9, High = 2.0–3.0, and Very High = >3.0) were used.

The total number of occurrences of High and Very High COHS at the Downtown Station was 10.7% of the total data sample. This was more than twice the frequency of any of the outlying stations.

An evaluation of the statistical frequencies indicate the Downtown Station can safely be used as a “control station” in forecasting Low or Moderate COH levels for the six surrounding stations. However, the occurrence of High or Very High COH levels at the six outlying stations do not occur with a high enough statistical consistency to be predicted by using the forecast value of the Downtown Station.

The valley stations exhibit the characteristics of separate sub air basins particularly during a period in which morning inversions occur for two or more consecutive days and the average daily wind speed does not exceed 4 m/sec.

The results show it is possible to forecast only Low or Moderate COH levels for each of the six outlying stations by using statistical correlations derived from the Downtown Station. Separate objective forecasts which relate the pollution buildup in each valley sub air basin must be used when High or Very High COHS are forecast at the Downtown Station.     

New Approaches to the Design of Afterburners for Varnish Cookers

The best method of controlling varnish kettle emissions is by thermal incineration. Two new approaches have been developed; these utilize the integral-blower burner and the non-powered raw gas burner. Both of these new approaches offer significant advantages over conventional methods of incineration. Installation, operating, and maintenance costs are substantially reduced when either approach is utilized.

When compared to conventional methods, the new approaches achieve an increase of 100% in mixing velocity or turbulence. This results in a reduction of 20% in fuel consumption. Residence time is reduced by 29% via the non-powered raw gas burner approach. An average reduction of 65% is obtained in the length to diameter ratio. Choice of which approach depends upon several factors, primarily the type of fuel available and the minimum oxygen concentration in the fume stream.     

Ambient Air Monitoring for Sulfur Compounds

The role of sulfur compounds in our environment has been the subject of much speculation during the past two decades. An evaluation of the effect of man-made contributions to the biogeochemical sulfur cycle requires a comprehensive examination of source magnitudes, atmospheric concentrations and removal processes. Many voids exist in our present knowledge of these parameters despite the contributions of numerous researchers. Adequate information is needed concerning the various forms of sulfur as well as other critical constituents which exist in our biosphere so that their interrelationship and role in the mechanisms of the sulfur cycle may be more fully understood.     

Surface Air Pollutant Concentration Frequency Distributions: Implications for Urban Modeling

With the development of ambient air quality standards (AAQS), the need arises to describe the characteristics of regional surface air-pollutant concentration frequency distributions. In the evaluation of land use plans, numerous agencies will be concerned with evaluating the effectiveness of emission zoning and/or control actions. On a regional basis, one means of performing this assessment lies in determining the changes in the pollutant frequency distributions resulting from control actions.

This study presents new data concerning the surface air-pollutant concentration frequency distributions observed for area sources and continuous point sources, and compares these distributions with those of the pertinent meteorological variables describing the transport and diffusion of the pollutant. The observed surface air pollutant frequency distributions are compared to those corresponding to simple modeling concepts from either an urban area source or a continuous point source. For an urban source and a relatively inert pollutant like CO, we found that the observed frequency distribution for CO surface air concentration parallels the approximately log-normal frequency distribution of the reciprocal of the wind speed. We show that the constant relating these two well-correlated frequency distributions can be determined either experimentally or with a numerical simulation model of air pollution. The usefulness of numerical models in air pollution is discussed.