Carbon and nitrogen mineralization in Vertisol as mediated by type and placement method of residue

Selection of appropriate residue application method is essential for better use of biomass for soil and environmental health improvement. A laboratory incubation experiment was conducted for 75 days to investigate C and N mineralization of residues of soybean (Glycine max L.), chickpea (Cicer arietinum L.), maize (Zea mays L.), and wheat (Triticum aestivum L.) placed on the soil surface and incorporated into the soil. The residue of soybean and chickpea had a greater decomposition rate than that of maize and wheat, despite of their placements. Higher rate of decomposition of the residue of soybean and chickpea was recorded when it was kept on the soil surface while soil incorporation of residue of wheat and maize resulted in faster decomposition. Therefore, these findings could be used as guidelines for management of crop residue application in farmland to improve soil and environmental quality.     

The probabilistic tsunami hazard assessment along Karnataka Coast from Makran Subduction Zone,west coast of India

Coastal tsunami amplitudes were calculated to identify areas susceptible to tsunami hazard at selected locations of the coast of Karnataka, west of India, due to earthquakes in the Makran Subduction Zone. This is the first time that the probabilistic tsunami hazard assessment along this study area has been attempted. A series of earthquake source scenarios with magnitudes of Mw 8.0, Mw 8.5, and a mega thrust of Mw 9.1 were modeled by using the Community Model Interface for Tsunami interface with the MOST model of Titov and Synolakis (J. Waterway, Port, Coastal and Ocean Engineering, 121(6), 308–316, 1995). As per the previous occurrences, the two least magnitudes are probable, while Mw 9.1 is a worst-case scenario as described by Heidarzadeh et al. (Ocean Engineering, 36(5), 368–376, 2009) and the same is reported by Burbidge et al. (Geoscience Australia Professional Opinion No. 2009/11) as high magnitude. These are not at all historical earthquakes or specifically from historical catalogues. The results of modeling show that all the seven coastal locations are inundated barely in our worst-case scenario with maximum water levels in the range of 100–200 cm. The first tsunami wave strikes the coast within 4–5 h of earthquake occurrence.     

Real<Emphasis Type="Bold">-</Emphasis>time water quality monitoring using Internet of Things in SCADA

Water pollution is the root cause for many diseases in the world. It is necessary to measure water quality using sensors for prevention of water pollution. However, the related works remain the problems of communication, mobility, scalability, and accuracy. In this paper, we propose a new Supervisory Control and Data Acquisition (SCADA) system that integrates with the Internet of Things (IoT) technology for real-time water quality monitoring. It aims to determine the contamination of water, leakage in pipeline, and also automatic measure of parameters (such as temperature sensor, flow sensor, color sensor) in real time using Arduino Atmega 368 using Global System for Mobile Communication (GSM) module. The system is applied in the Tirunelveli Corporation (Metro city of Tamilnadu state, India) for automatic capturing of sensor data (pressure, pH, level, and energy sensors). SCADA system is fine-tuned with additional sensors and reduced cost. The results show that the proposed system outperforms the existing ones and produces better results. SCADA captures the real-time accurate sensor values of flow, temperature, and color and turbidity through the GSM communication.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

Assessment of the uncertainty of using an inverse-dispersion technique to measure methane emissions from animals in a barn and in a small pen

Dispersion techniques are useful for assessing the effectiveness of management practices in mitigating methane (CH₄) emissions from animal operations. In this paper, the accuracy of an inverse-dispersion technique was examined for two common situations: 1) emissions from animals in a barn and 2) emissions from animals in a pen. For both situations, the accuracy of emission estimates generally increased with increasing fetch (scaled to barn height, h, or to pen width, X_s) between the source and the concentration measurement. The gas recovery ratio increased from 0.66 at 5 h to 0.93–1.03 at 10 h–25 h for the barn, and decreased from 1.59 at 0 X_s to 0.99 at 5 X_s and from 1.54 at 0 X_s to 1.09 at 5 X_s for the two small pen scenarios, due to the declining sensitivity of the dispersion model to errors in wind complexity and errors in the assumed source configuration. However, the relative uncertainty of the measured concentration increased with fetch due to the decreasing gas concentrations. Hence, improving the accuracy of emission estimates is a compromise between the source configuration sensitivity and the concentration measurement sensitivity. Fetches of about twice the size of the pen and about 10 times the height of the barn are suggested.     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Assimilation of conventional and satellite wind observations in a mesoscale atmospheric model for studying atmospheric dispersion

A mesoscale atmospheric model PSU/NCAR MM5 is used to provide operational weather forecasts for a nuclear emergency response decision support system on the southeast coast of India. In this study the performance of the MM5 model with assimilation of conventional surface and upper-air observations along with satellite derived 2-d surface wind data from QuickSCAT sources is examined. Two numerical experiments with MM5 are conducted: one with static initialization using NCEP FNL data and second with dynamic initialization by assimilation of observations using four dimensional data assimilation (FDDA) analysis nudging for a pre-forecast period of 12 h. Dispersion simulations are conducted for a hypothetical source at Kalpakkam location with the HYSPLIT Lagrangian particle model using simulated wind field from the above experiments. The present paper brings out the differences in the atmospheric model predictions and the differences in dispersion model results from control and assimilation runs. An improvement is noted in the atmospheric fields from the assimilation experiment which has led to significant alteration in the trajectory positions, plume orientation and its distribution pattern. Sensitivity tests using different PBL and surface parameterizations indicated the simple first order closure schemes (Blackadar, MRF) coupled with the simple soil model have given better results for various atmospheric fields. The study illustrates the impact of the assimilation of the scatterometer wind and automated weather stations (AWS) observations on the meteorological model predictions and the dispersion results.     

Chemical speciation,transport and contribution of biomass burning smoke to ambient aerosol in Guangzhou,a mega city of China

Intensive measurements of aerosol (PM₁₀) and associated water-soluble ionic and carbonaceous species were conducted in Guangzhou, a mega city of China, during summer 2006. Elevated levels of most chemical species were observed especially at nighttime during two episodes, characterized by dramatic build-up of the biomass burning tracers levoglucosan and non-sea-salt potassium, when the prevailing wind direction had changed due to two approaching tropical cyclones. High-resolution air mass back trajectories based on the MM5 model revealed that air masses with high concentrations of levoglucosan (43–473 ng m^?3) and non-sea-salt potassium (0.83–3.2 μg m^?3) had passed over rural regions of the Pearl River Delta and Guangdong Province, where agricultural activities and field burning of crop residues are common practices. The relative contributions of biomass burning smoke to organic carbon in PM₁₀ were estimated from levoglucosan data to be on average 7.0 and 14% at daytime and nighttime, respectively, with maxima of 9.7 and 32% during the episodic transport events, indicating that biomass and biofuel burning activities in the rural parts of the Pearl River Delta and neighboring regions could have a significant impact on ambient urban aerosol levels.     

Economic damages of ozone air pollution to crops using combined air quality and GIS modelling

This study aims at presenting a combined air quality and GIS modelling methodological approach in order to estimate crop damages from photochemical air pollution, depict their spatial resolution and assess the order of magnitude regarding the corresponding economic damages. The analysis is conducted within the Greater Thessaloniki Area, Greece, a Mediterranean territory which is characterised by high levels of photochemical air pollution and considerable agricultural activity. Ozone concentration fields for 2002 and for specific emission reduction scenarios for the year 2010 were estimated with the Ozone Fine Structure model in the area under consideration. Total economic damage to crops turns out to be significant and estimated to be approximately 43 M€ for the reference year. Production of cotton presents the highest economic loss, which is over 16 M€, followed by table tomato (9 M€), rice (4.2 M€), wheat (4 M€) and oilseed rape (2.8 M€) cultivations. Losses are not spread uniformly among farmers and the major losses occur in areas with valuable ozone-sensitive crops. The results are very useful for highlighting the magnitude of the total economic impacts of photochemical air pollution to the area’s agricultural sector and can potentially be used for comparison with studies worldwide. Furthermore, spatial analysis of the economic damage could be of importance for governmental authorities and decision makers since it provides an indicative insight, especially if the economic instruments such as financial incentives or state subsidies to farmers are considered.     

Analysis of 3-year observations of CFC-11, CFC-12 and CFC-113 from a semi-rural site in China

In-situ measurements of atmospheric chlorofluorocarbons (CFCs) can be used to the assess their global and regional emissions and to check for compliance with phase-out schedules under Montreal protocol and its amendments. The atmospheric mixing ratios of CFC-11 (CCl₃F), CFC-12 (CCl₂F₂) and CFC-113 (CCl₂F–CClF₂) have been measured by an automated in-situ GC-ECDs system at the regional Chinese Global Atmosphere Watch (GAW) station Shangdianzi (SDZ), from November 2006 to October 2009. The time series for these three principal CFCs showed large episodic events and background conditions occurred for approximately 30% (CFC-11), 52% (CFC-12) and 56% (CFC-113) of the measurements. The mean background mixing ratios for CFC-11, CFC-12 and CFC-113 were 244.8 ppt (parts per trillion, 10^?12, molar) 539.6 ppt and 76.8 ppt, respectively, for 2006–2009. The enhanced CFC mixing ratios compared to AGAGE sites such as Trinidad Head (THD), US and Mace Head (MHD), Ireland suggest regional influences even during background conditions at SDZ, which is much closer to highly-populated areas. Between 2006 and 2009 background CFCs exhibited downward trends at rates of ?2.0 ppt yr^?1 for CFC-11, ?2.5 ppt yr^?1 for CFC-12 and ?0.7 ppt yr^?1 for CFC-113. De-trended 3-year average background seasonal cycles displayed small fluctuations with peak-to-trough amplitudes of 1.0 ± 0.02 ppt (0.4%) for background CFC-11, 1.3 ± 2.1 ppt (0.3%) for CFC-12 and 0.2 ± 0.4 ppt (0.3%) for CFC-113. On the other hand, during pollution periods these CFCs showed much larger seasonal cycles of 11.2 ± 10.7 ppt (5%) for CFC-11, 7.5 ± 6.5 ppt (2%) for CFC-12 and 1.0 ± 1.2 ppt (1.2%) for CFC-113, with apparent winter minima and early summer maxima. This enhancement was attributed to prevailing wind directions from urban regions in summer and to enhanced anthropogenic sources during the warm season. In general, horizontal winds from northeast showed negative contribution to atmospheric CFCs loading, whereas South Western advection (urban sector: Beijing) had positive contributions.