Estimates of soil erosion using cesium-137 tracer models

The soil erosion was studied by ¹³⁷Cs technique in Yatagan basin in Western Turkey, where there exist intensive agricultural activities. This region is subject to serious soil loss problems and yet there is not any erosion data towards soil management and control guidelines. During the soil survey studies, the soil profiles were examined carefully to select the reference points. The soil samples were collected from the slope facets in three different study areas (Kırtas, Peynirli and Kayısalan Hills). Three different models were applied for erosion rate calculations in undisturbed and cultivated sites. The profile distribution model (PDM) was used for undisturbed soils, while proportional model (PM) and simplified mass balance model (SMBM) were used for cultivated soils. The mean annual erosion rates found using PDM in undisturbed soils were 15 t ha⁻¹ year⁻¹ at the Peynirli Hill and 27 t ha⁻¹ year⁻¹ at the Kırtas Hill. With the PM and SMBM in cultivated soils at Kayışalan, the mean annual erosion rates were obtained to be 65 and 116 t ha⁻¹ year⁻¹, respectively. The results of ¹³⁷Cs technique were compared with the results of the Universal Soil Loss Equation (USLE).     

The effects of heavy metal pollution on enzyme activities and basal soil respiration of roadside soils

In this study, soil samples (0-5 cm depth) were taken from ten different roadside fields of intensive traffic regions of Van-Turkey in order to determine the effects of heavy metal pollution on enzymes and microbial activities of soils. Basal soil respiration (BSR), arylsulphatase (ASA), alkaline phosphatase (APA) and urease (UA) enzyme activities, and heavy metal contents (Pb, Cr, Ni, Cd, Fe, Mn, Cu and Zn) of soils significantly changed with 5, 25 and 45 m from the roadside of soil sampling positions. BSR, ASA, APA and UA activities significantly increased while the heavy metal contents generally decreased from the sampling position of 5 m through 25 and 45 m. Significant positive correlations were found among BSR, ASA, APA and UA. Chromium, Mn and Pb contents gave the significant negative correlation with ASA, APA and UA.     

Characterization of the Leachate in an Urban Landfill by Physicochemical Analysis and Solid Phase Microextraction-GC/MS

The aim of this study is to evaluate extensively the characterization and identification of major pollutant parameters by paying attention to the organic chemical pollution for unregulated dumping site leachate in Eskişehir/Turkey. The study that is first and only one research has been very important data related with before new sanitary landfill site in Eskişehir city. For this purpose, in this study leachate samples were collected in-situ at monthly interval for a period of 8 months. Firstly, thirty three physicochemical parameters were monitored. Secondly, SPME technique was used for identification of organic pollutants. Meteorological data were also recorded for the same sampling period to correlate meteorological data and physicochemical parameters. Mean values are used in the correlation analysis. Correlation is shown only for the relationship between air temperature and NO₃ ⁻. No correlation has been found between rain and leachate quality parameters since the amount of rain was very low during the sampling period. However, analysis results were generally decreased in winter season when each parameter and each sampling point are examined separately. According to correlation between every parameter, especially solid content and dissolved oxygen concentration of leachate is affecting to other parameters. Also, sodium and potassium are changing proportionally with same parameters (suspended solids, fixed solids, dissolved oxygen) and high correlation between chloride and heavy metal concentration is showing. The results were statistically evaluated by use of SPSS 10.0 program. Second part of the study, the leachate was extracted by Solid Phase Microextraction (SPME) technique and then analyzed. Of the methodologies tested in this study, the best one selected was based on 100 μ m polydimethylsiloxane coated fiber (PDMS), headspace with heating (Δ HS) sampling mode and an extraction time of 15 min. at a temperature of 50 ^o C. Thirty three organic compounds in leachate were identified by GC/MS.     

Guluronic acid content as a factor affecting turbidity removal potential of alginate

Alginates are natural polymers composed of mannuronic and guluronic acid residues. They are currently extracted from brown algae; however, alginate can also be synthesized by some species of Azotobacter and Pseudomonas. Alginates with different proportion of mannuronic and guluronic acids are known to have different characteristics and form gels at different extents in the presence of calcium ions. The aim of this work was to investigate the usefulness of alginate as a non-toxic coagulant used in purification of drinking water. This study utilized alginates from Azotobacter vinelandii having different guluronic acid levels. These were obtained partly by changing the cultivation parameters, partly by epimerizing a purified alginate sample in vitro using the A. vinelandii mannuronan C-5 epimerase AlgE1. The different alginates were then used for coagulation together with calcium. The results showed that turbidity removal capability was dependent on the content of guluronic acid residues. For the best performing samples, the turbidity decreased from 10 NTU to 1 NTU by the use of only 2 mg/L of alginate and 1.5 mM of calcium chloride.

     

Removal of AOX, total nitrogen and chlorinated lignin from bleached Kraft mill effluents by UV oxidation in the presence of hydrogen peroxide utilizing TiO2 as photocatalyst

Background, aim, and scope  The pulp and paper industry is the sixth largest polluter discharging a variety of gaseous, liquid, and solid wastes into the environment. Effluents from bleached Kraft mill effluents (BKME) are polluting waters to a great extent These effluents cause considerable damage to the receiving waters if discharged untreated since they have high levels of biological oxygen demand (BOD), chemical oxygen demand (COD), chlorinated compounds (measured as AOX), suspended solids (mainly fibers), fatty acids, tannins, resin acids, lignin and its derivatives, sulfur and sulfur compounds, etc. This study aimed to remove adsorbed organic halogen (AOX), total nitrogen, and lignin-degrading products in the wastewater (4,500 m³/h) from the paper mill in the pulp and paper industry, which is discharged to sea from a plant located in western Turkey. Materials and methods  The photocatalytic degradation of AOX, total nitrogen, and chlorinated lignin in BKME have been investigated in different parameters, such as time, H₂O₂ and TiO₂ concentration. In addition, for investigating the effect of chlorine on the removal of lignin, pure lignin solution was prepared in equal amounts to chlorinated lignin degradation products found in BKME. The same experiments were conducted for this solution. Experiments were carried out in photocatalytic reactor made of Pyrex glass. The mercury lamp was used as a radiation source. All irradiation was carried out under constant stirring. The existence of dissolved O₂ is an important factor which increases the photocatalytic degradation. Hence, we used an air pump for the aeration of the wastewater solutions. The temperature of the wastewater was controlled and adjusted to 25°C by thermostat pump in conjunction with a cooler. At the end of all experiments, AOX, total nitrogen and lignin concentrations were analyzed according to standard methods. All experiments were performed in duplicate and average values were used. Results and discussion  When the effect of H₂O₂ and time were investigated, it was observed that the AOX concentration increased from 3.0 to 11.0 mg/L by only UV. However, when H₂O₂ was added, AOX concentration decreased from approximately 3.0 to 0.0 mg/L. The optimal conditions for the removal of AOX appear to be an initial H₂O₂ concentration of 20.0 mL/L and reaction time of 50 min. In addition, at the same experiment conditions, it was seen that the total nitrogen concentration decreased from 23.0 to 15.0 mg/L by only UV and by increasing H₂O₂ concentration, the concentration of 20.0 mL/L H₂O₂ appears to be optimal (9.0 mg/L). The AOX, total nitrogen and lignin degradation products and pure lignin go through a minimum when the concentration of H₂O₂ and TiO₂ increases at constant pH and UV intensity. The kinetics for the degradation of AOX, total nitrogen and lignin degradation products followed a pseudo-first order law with respect to the products, and the degradation rates (min⁻¹) for the UV/TiO₂/H₂O₂ system were higher than that of the corresponding values for the UV/H₂O₂ system. Conclusions  The AOX, total nitrogen and lignin concentration go through a minimum when the concentration of H₂O₂ and TiO₂ increases at constant pH and UV intensity. It was found that the UV/TiO₂/H₂O₂ system has proved capable of the degradation of total nitrogen as well as chlorinated and degraded lignin in BKME. Recommendations and perspectives  The photocatalytic process can be considered a suitable alternative for the remove of some compounds from the BKME. Nevertheless, further studies should be carried out to confirm the practical feasibility of BKME. Another result obtained from the study is that pre-purification carried out with UV/TiO₂/H₂O₂ photocatalytic process may constitute an important step for further purification processes such as adsorption, membrane processes, etc.     

Dissipation pattern and risk quotients assessment of amisulbrom in Korean melon cultivated in plastic house conditions

Amisulbrom formulated as suspension concentrate was applied at the rate recommended for Korean melon to determine the dissipation pattern (at two different sites), the pre-harvest residue limit (PHRL), and risk assessments. Samples collected over 10 days were extracted using liquid-liquid extraction (LLE) and cleaned up with solid-phase extraction (SPE) Florisil cartridge. Residual concentrations were determined using liquid chromatography-ultraviolet detector (LC-UVD) and confirmed by liquid chromatography-tandem mass spectrometry (LC-MS/MS). The standard showed good instrument response linearity with a correlation coefficient (R ²) = 0.9999, and the recovery ranged from 87.5 to 93.7%. The dissipation half-life calculated from two different sites were found to be 7.0 and 8.8 days for sites 1 and 2, respectively. A PHRL graph constructed from the data indicated that if the residue levels were less than 0.55–0.59 mg/kg 3 days before harvest or less than 0.61–0.74 mg/kg 7 days before harvest, then they would be lower than the maximum residue limits (MRLs) at harvest. Risk assessments showed that the risk quotient (RQ) was 4.39–3.47% at 0 day, declined to 1.53–1.63% at 10 days. Therefore, the current data indicate that the amisulbrom can be applied safely to Korean melon; hence, it is unlikely to induce adverse health effects in consumers.     

Determination of Cadmium and Copper in Fish Samples from Sir And Menzelet Dam Lake Kahramanmaraş, Turkey

The cadmium and copper levels were determined in the total of 126 fish samples which belongs to five fish species collected from Sır and Menzelet Dam Lakes in Kahramanmaraş Province by Atomic Absorption Spectrophotometer. The concentrations of heavy metals were expressed as ppm wet weight of tissue. The mean levels of cadmium and copper in muscle, liver and gill tissues of Cyprinus carpiofrom the Menzelet Dam were found as 0.27, 0.91, 1.49 and 0.94, 1.2, 1.05, respectively. The mean levels of Cd in the muscle tissues of Leuciscus cephalusfrom the Menzelet Dam were found 0.32 ppm, Cd wasn't found in tissues of liver and gill. The mean levels of Cu in the muscle, liver and gill tissues were found as 3.17 ppm, 1.19 ppm, 0.96 ppm, respectively. The mean levels of the Cd and Cu in muscle and gill tissues of Acanthobrama marmid from the Sır Dam were found as 1.28, 2.64 and 0.72, 0.08, respectively. The levels of the Cd and Cu in muscle tissues of Cyprinus carpiofrom the Sır Dam were found 0.87 and 0.02 ppm, respectively. The mean levels of the Cd and Cu in the muscle and gill tissues of Chondrostoma regium from the Sır Dam were found to be 0.80, 2.62 and 0.67, 1.34 ppm, respectively. The mean levels of the Cd in the muscle tissues of the Silurus glanis was found as 0.60 ppm. In the muscle of the Silurus glanis from the Sır Dam, Cu was not found. The Sır Dam is more polluted than the Menzelet Dam from the point of Cd but less polluted than the Menzelet Dam From the point of Cu. A relationship was determined between species and their habitating region in terms of the levels reflected metal residues. In this study it was emphasized that the amounts of Cd and Cu in the samples were low, however, seas, lakes, rivers, soil, air and consumed foods etc. has to be controlled routinely.     

Nanoflower synthesis,characterization and analytical applications: a review

Environmental Chemistry Letters - The occurrence of contaminants in the environment requires very sensitive analytical techniques for their determination. For that, analytical techniques have been...     

黄土高原地区小麦生产潜力模拟研究

分析了作物生产潜力常规研究方法的不足,探讨了作物生长模型模拟方法的优势,在模型验证和气象、土壤和作物数据库组建的基础上,应用DSSAT3中的CERES小麦模型模拟研究了黄土高原地区28个代表点冬小麦和春小麦的光温生产潜力和气候生产潜力,统计计算了各点小麦产量潜力多年平均值、标准差、最高值和最低值,分析了潜力值年际变异与地区分布差异,并计算了小麦的水分满足率。黄土高原冬小麦光温生产潜力、气候生产潜力和水分满足率分别为7970～8647kg/hm²、2219～7545kg/hm²和0.278～0.872,春小麦分别为7436～9127kg/hm²、0～7598kg/hm²和0.192～0.961。