Material cycle realization by hazardous phosphogypsum waste,ferrous slag,and lime production waste application to produce sustainable construction materials

Journal of Material Cycles and Waste Management - The article presents data from new compositions of construction materials developed from three types of Kazakhstan enterprises’ industrial...     

Fenton试剂催化氧化法处理模拟酸性红B染料废水

采用Fenton试剂催化氧化处理用酸性红B配制的模拟偶氮染料废水,考察了影响处理效果的主要因素,并探讨了酸性红B降解的动力学.实验结果表明,Fenton试剂催化氧化处理酸性红B废水的最佳工艺条件为:H2O2加入量49.0 mmol/L,Fe2+加入量2.0 mmol/L,反应温度25℃,初始废水pH 3～6.在此最佳工艺条件下反应5min时,酸性红B去除率为99.8％,COD去除率为62.3％;反应60 min后,酸性红B去除率为99.9％,COD去除率为80.0％.Fenton试剂催化氧化降解酸性红B的反应符合二级反应动力学规律.     

Response of marine phytoplankton to nitrogen deficiency: Decreased nitrate uptake vs enhanced ammonium uptake

The uptake of nitrate and ammonium was measured separately in uni-algal, nitrogen-deficient cultures of four species of marine phytoplankton. Nitrogen-deficient phytoplankton took up ammonium at initial rates which greatly exceeded those measured for nitrogen-sufficient phytoplankton. However, nitrate uptake by nitrogendeficient cultures was generally much slower than either nitrate or ammonium uptake by nitrogen-sufficient cultures or ammonium uptake by nitrogen-deficient cultures. Considerable species differences were observed in the degree to which nitrogen deficiency increased ammonium uptake or decreased nitrate uptake. Loss of ability to take up nitrate, but enhanced ability to take up ammonium, as a result of nitrogen deficiency may be an adaptation to the different mechanisms by which nitrate and ammonium are supplied to the euphotic zone. In areas with an intermittent supply of nitrogen, changes in the ability of some species to take up nitrogen as a result of nitrogen starvation will influence species composition and complicate interpretations of measurements of nitrogen uptake.Contribution no. 1249 from the Department of Oceanography, University of Washington, and contribution no. 82006 from the Bigelow Laboratory for Ocean Sciences     

Assessment of lead contamination of the general environment through blood lead levels

More than 2000 blood samples were collected at random from full-time middle school teachers in 9 cities of China and analyzed for lead concentration with strict quality assurance procedures. Questionnaries about the smoking habits, alcohol consumption, residence condition, and fuel used at home were filled out by each person, and information about traffic, and lead concentration in different areas of the environment was also collected as far as possible. The result showed that the geometric mean of blood lead levels of teachers in different cities was ranging between 59–82 g l^–1 among them the lowest levels were found in Nanjing and the highest in Shanghai. The difference between the lowest and the highest value was only 23 g l^–1. Comparing with the results of WHO/UNEP and CEC projects. The overall geometric average blood level in China is lower than in all the other countries except Japan. It indicates that the lead pollution in the general environment of China was not as severe as in the participating countries of WHO/UNEP and CEC projects. This may be attributed by the following factors: The less automobile triffic, the larger proportion of non-leaded gasoline used and the less canned food consumption. Factors influencing the lead levels in blood were also analyzed and the normal value (95% upper limit) of blood lead was assessed to be 160 g l^–1.     

Effect of C/N on composting of pig manure with sawdust

The aim of this composting trial was to evaluate the effect of C/N on the composting process of pig manure with the purpose of reducing the amount of sawdust normally used as co-composting materials. Two aerobic static piles were prepared consisting of pig manure mixed with sawdust at an initial C/N of 30 (pile A) and 15 (pile B), respectively. Pile B containing larger amount of pig manure showed a slower rise in temperature, lower maximum temperature, and shorter thermophilic phase than pile A. It also resulted in higher pH and electrical conductivity (EC) values, and even higher contents of soluble NH4-N and volatile solids throughout the composting period. Chemical and biological parameters including dissolved organic carbon (DOC) (4932 mg kg(-1)), soluble NH4-N (371 mg kg(-1)), C/Nsolid (18.3), C/Naquoeus (5.8) and seed germination index (GI) (66.5%) indicated that pile A achieved maturity after 49 days of composting. After 63 days of composting, pile B contained 5352 and 912 mg kg(-1) of DOC and soluble NH4-N content, respectively, which was much higher than the criterion of 5% and 400 mg kg(-1), indicating its immature nature. Pile B showed a relatively low GI value of 46%, which may be due to its high indigenous EC value as a result of larger amount of pig manure. Therefore, co-composting of pig manure with sawdust at a low initial C/N would require a composting longer than 63 days, and, the high salinity due to the large amount of pig manure would pose a potential inhibition on plant growth.     

The effect of solvent concentration on the use of palladized-iron for the step-wise dechlorination of polychlorinated biphenyls in soil extracts

This report describes the application of palladized iron (Pd/Fe) to the dechlorination of polychlorinted biphenyls (PCBs) at ambient temperature. Experiments supported by congener-specific analyses demonstrated that dechlorination occurs in a step-wise fashion with the meta-chlorines being more reactive than ortho-chlorines. Over the course of the laboratory experiments, complete conversion to biphenyl was observed. The process was also tested with PCBs dissolved in high (40-60%) concentrations of ethanol and isopropanol as a means of simulating solutions generated by commercial soil and solid waste extraction processes. The reaction rate was sensitive to the percentage of solvent but complete dechlorination was still indicated. Tests with soil extracts from a contaminated site demonstrated that there were no apparent interferences from asphalt and other miscellaneous debris. Short-duration tests with highly contaminated PCB solutions from a hazardous waste site demonstrated efficient dechlorination although there was a reduction in reaction rate with time.     

Retention of nitrogen and phosphorous from liquid swine and poultry manures using highly characterized peats

This paper reports on research designed to test the hypothesis that differences in peat composition will cause differences in amounts of N and P retained during contact with liquid swine manure (LSM) and liquid poultry manure (LPM). Peat types representing a wide range of properties were tested in order to establish which chemical and physical properties might be most indicative of their capacities to retain N and P from LSM and LPM. Eight-percent slurries (peat/LSM and peat/LPM) were measured for total nitrogen (TKN) and total phosphorous (TP) after 6, 24 and 96 hours. Tests were done to determine the TKN and TP contents of these peats, the LSM, and the LPM, both before and after they were mixed together. The N and P retention results revealed that most peats worked reasonably well at retaining N and P from either LSM or LPM. However, some peats were more effective than others. These peats also decreased the N and P levels in the liquid portion of the LSM. Peats with higher N retention capacities tended to have lower ash contents, but higher macroporosities and total cellulose contents. Peats with higher P retention capacities tended to have lower bulk densities, ash contents, total guaiacyl lignins contents, fulvic acids contents, but higher microporosities, macroporosities, H contents, and total cellulose contents. Peats with higher N and P retention capacities also had humic acid contents between 5-7%. The results of this study suggest that if these peats are used to reduce odors and N and P contamination, possible byproducts could be the production of odorless fertilizers.     

Degradation of soil fumigants as affected by initial concentration and temperature

Soil fumigation using shank injection creates high fumigant concentration gradients in soil from the injection point to the soil surface. A temperature gradient also exists along the soil profile. We studied the degradation of methyl isothiocyanate (MITC) and 1,3-dichloropropene (1,3-D) in an Arlington sandy loam (coarse-loamy, mixed, thermic Haplic Durixeralf) at four temperatures and four initial concentrations. We then tested the applicability of first-order, half-order, and second-order kinetics, and the Michaelis-Menten model for describing fumigant degradation as affected by temperature and initial concentration. Overall, none of the models adequately described the degradation of MITC and 1,3-D isomers over the range of the initial concentrations. First-order and half-order kinetics adequately described the degradation of MITC and 1,3-D isomers at each initial concentration, with the correlation coefficients greater than 0.78 (r2> 0.78). However, the derived rate constant was dependent on the initial concentration. The first-order rate constants varied between 6 and 10x for MITC for the concentration range of 3 to 140 mg kg(-1), and between 1.5 and 4x for 1,3-D isomers for the concentration range of 0.6 to 60 mg kg(-1), depending on temperature. For the same initial concentration range, the variation in the half-order rate constants was between 1.4 and 1.7x for MITC and between 3.1 and 6.1x for 1,3-D isomers, depending on temperature. Second-order kinetics and the Michaelis-Menten model did not satisfactorily describe the degradation at all initial concentrations. The degradation of MITC and 1,3-D was primarily biodegradation, which was affected by temperature between 20 and 40 degrees C, following the Arrhenius equation (r2 > 0.74).