Loss of PM2.5 nitrate from filter samples in central California

Evaporative loss of particulate matter (with aerodynamic diameter < 2.5 microm, [PM2.5]) ammonium nitrate from quartz-fiber filters during aerosol sampling was evaluated from December 3, 1999, through February 3, 2001, at two urban (Fresno and Bakersfield) and three nonurban (Bethel Island, Sierra Nevada Foothills, and Angiola) sites in central California. Compared with total particulate nitrate, evaporative nitrate losses ranged from < 10% during cold months to > 80% during warm months. In agreement with theory, evaporative loss from quartz-fiber filters in nitric acid denuded samplers is controlled by the ambient nitric acid-to-particulate nitrate ratio, which is determined mainly by ambient temperature. Accurate estimation of nitrate volatilization requires a detailed thermodynamic model and comprehensive chemical measurements. For the 14-month average of PM2.5 acquired on Teflon-membrane filters, measured PM2.5 mass was 8-16% lower than actual PM2.5 mass owing to nitrate volatilization. For 24-hr samples, measured PM2.5 was as much as 32-44% lower than actual PM2.5 at three California Central Valley locations.     

Biological variation in sensitivity to N-heterocyclic PAHs; effects of acridine on seven species of micro-algae

The toxicity of the nitrogen (N) heterocyclic polyaromatic hydrocarbon (PAH) acridine was tested for seven species of microalgae: Scenedesmus acuminatus, Selenastrum capricornutum, Chlamydomonas eugametos, Staurastrum chaetoceras, Staurastrum manfeldtii, Navicula salinarum and Nitzschia sigma. The effect of acridine on the algae was studied in a 96-h growth test, in which growth rates were determined using cell numbers and biovolume. The obtained EC50 values (for growth rates based on cell numbers) ranged from 0.08 mg litre(-1) for N. sigma to 0.78 mg litre(-1) for C. eugametos and N. salinarum. Effect concentrations based on biovolume were slightly higher for most species. Metabolism of acridine was observed for one species (S. capricornutum), but this capacity did not result in a very different tolerance. Acridine toxicity was neither related to taxonomical background (green algae versus diatoms) nor to original habitat of the species (planktonic or benthic, eutrophic or oligo-mesotrophic). The presence of near-UV radiation during the incubation might explain the higher toxicity of acridine than is expected on basis of QSAR derived narcotic toxicity.     

Surface catalyzed formation of polychlorinated dibenzo-p-dioxins/dibenzofurans during municipal waste incineration

A series of reactions was carried out on different surfaces using carbon and CuCl₂, and KCl or HCl as a Cl-source. The PCDD/PCDF congener distribution was seen to vary to a great extent but the isomer distribution remained fairly constant. It is concluded that thermodynamic properties are largely responsible for the PCDD/PCDF isomer distribution. With pentachlorobenzene Cl₂ elimination, assisted by oxygen, appears to be the major pathway for PCDD/PCDF formation.     

Formation of mutagenic activity during surface water preozonization and its removal in drinking water treatment

The influence of preozonization, coagulation and double layer filtration on formation and removal of mutagenic activity was studied using XAD-8 extracts collected from neutral and acidic solutions and assaying them in the Salmonella typhimurium microsomal assay.Preozonization of surface water produced direct acting frame shift mutagens which were adsorbed on XAD-8 from neutral solutions. This phenomenon was shown to be dependent on the ozone dose applied. Coagulation with different chemicals and subsequent direct filtration partially reduced the mutagenic activity.     

Analyse statistique correlative de l'influence des proprietes des sols sur l'adsorption d'herbicides et insecticides

A statistical correlative study (simple and multiple) between 14 herbicides and insecticides and composition of 51 soil samples has been performed by considering top- and sub-soil horizons, separately. Results point out the suitability of these regression models as a predictive tool to determine quantitatively the adsorption of numerous pesticides in soils mainly the more soluble compounds.     

Analysis of Ah receptor pathway activation by brominated flame retardants

Brominated flame-retardants (BFRs) are used as additives in plastics to decrease the rate of combustion of these materials, leading to greater consumer safety. As the use of plastics has increased, the production and use of flame-retardants has also grown. Many BFRs are persistent and have been detected in environmental samples, raising concerns about the biological/toxicological risk associated with their use. Most BFRs appear to be non-toxic, however there is still some concern that these compounds, or possible contaminants in BFRs mixtures could interact with cellular receptors. In this study we have examined the interaction of decabromodiphenyl ether, Firemaster BP4A (tetrabromobisphenol A), Firemaster PHT4 (tetrabromophthalic anhydride), hexabromobenzene, pentabromotoluene, decabromobiphenyl, Firemaster BP-6 (2,2^′,4,4^′,5,5^′-hexabromobiphenyl) and possible contaminants of BFR mixtures with the Ah receptor. Receptor binding and activation was examined using the Gel Retardation Assay and increased expression of dioxin responsive genes was detected using the reporter gene based CALUX assay. The results demonstrate the ability of BFRs to activate the AhR signal transduction pathway at moderate to high concentrations as assessed using both assays. AhR-dependent activation by BFRs may be due in part to contaminants present in commercial/technical mixtures. This was suggested by our comparative analysis of Firemaster BP-6 versus its primary component 2,2^′,4,4^′,5,5^′-hexabromobiphenyl. Some technical mixtures of brominated flame-retardants contain brominated biphenyls, dioxins or dibenzofurans as contaminants. When tested in the CALUX assay these compounds were found to be equivalent to, or more active than their chlorinated analogues. Relative effective potency values were determined from dose response curves for these brominated HAHs.     

The evaluation of dioxin and dioxin-like contaminants in selected food samples obtained from the Belgian market: comparison of TEQ measurements obtained through the CALUX bioassay with congener specific chemical analyses

A limited number of different foods were analysed for dioxin-like compounds by the CALUX bioassay which is an in vitro luciferase reporter gene assay measuring chemical activation of the aryl hydrocarbon receptor. Sixty-two milk samples were obtained from a surveillance campaign, 34 meat samples and 34 fishery products were purchased from the Belgian market. Bio-analytical and chemo-analytical dioxin toxicity equivalents (TEQ) values of the same milk samples were compared. Spearman's Rank correlation coefficients of 0.72, 0.67, 0.73 were obtained respectively between CALUX-TEQ and PCDD/F-TEQ, DL-PCB-TEQ and PCDD/F+DL-PCB-TEQ. The bioassay limit of detection was 0.1 pg TEQ from 1 g animal lipid, the limit of quantification was 0.4 pg TEQ. The repeatability of the CALUX bioassay (variability of butter fat samples analysed in the same run) showed a coefficient of variation (CV) of 10%, intra laboratory reproducibility based on independent runs of the same butter fat samples showed more variation (CV of 26% for samples above 2 pg TEQ/g lipid). All milk samples with a chemical TEQ value above the current limit value in Belgium showed an elevated CALUX-TEQ concentration, above 6 pg TEQ/g lipid. No false negative results were obtained. Based on the good correlation between CALUX-TEQ and chemically measured TEQ levels, the CALUX bioassay can be recommended as a screening tool for routine measurement of potentially toxic PHAHs in milk samples. Chemical analyses could then largely be restricted to positive samples, in order to identify the nature and to quantify the concentration of the chemicals that give the positive signal. Meat samples showed lower CALUX-TEQ values per gram lipid compared to fish samples. The fish samples showed a wider range of CALUX-TEQ values than the meat samples.     

Diffusion of HTO, Cl and I in Opalinus Clay samples from Mont Terri: Effect of confining pressure

Diffusion coefficients (T=23±2 °C) and accessible porosities for HTO, ³⁶Cl⁻ and ¹²⁵I⁻ were measured on Opalinus Clay (OPA) samples from the Mont Terri Underground Rock Laboratory (URL) using the through-diffusion technique. The direction of transport (diffusion) was perpendicular to bedding. Special cells that allowed the application of confining pressure were designed and constructed. The pressures ranged from 1 to 5 MPa, the latter value simulating the overburden at the Mont Terri URL (about 200 m). The test solution used in the experiments was a synthetic version of the Opalinus Clay pore water, which has Na⁺ and Cl⁻ as the main components (I=0.42 M).The measured values of the effective diffusion coefficients (D_e) and rock capacity factors (α) are: D_e=1.2–1.5×10⁻¹¹ m² s⁻¹ and α=0.09–0.11 for HTO, D_e=4.0–5.5×10⁻¹² m² s⁻¹ and α=0.05 for ³⁶Cl⁻ and D_e=3.2–4.6×10⁻¹² m² s⁻¹ and α=0.07–0.10 for ¹²⁵I⁻. For non-sorbing tracers (HTO, ³⁶Cl) the rock capacity factor α is equal to the diffusion-accessible porosity . The experimental results showed that pressure only had a small effect on the value of the diffusion coefficients. Increasing the pressure from 1 to 5 MPa resulted in a decrease of the diffusion coefficient of 17% for HTO, 28% for ³⁶Cl⁻ and 30% for ¹²⁵I⁻. Moreover, the diffusion coefficients for ³⁶Cl⁻ and ¹²⁵I⁻ are smaller than for HTO, which is consistent with an effect arising from anion exclusion.The diffusion coefficients of HTO and ¹²⁵I⁻ measured in this study are in good agreement with recent measurements at three other laboratories performed within the framework of a laboratory comparison exercise. The values of the diffusion-accessible porosities show a larger degree of scatter.     

Base cation deposition in europe-part I. Model description, results and uncertainties

Deposition of base cations (Na⁺, Mg²⁺, Ca²⁺, K⁺) in Europe was mapped for 1989 with a spatial resolution of 10 x 20 km using the so-called inferential modeling technique. Deposition fields resembled the geographic variability of sources, land-use and climate. Dry deposition constituted on average 45% of the total base cation deposition in Europe. Modeled deposition estimates compared reasonably well with deposition estimates derived from throughfall and bulk-precipitation measurements made at 174 sites scattered over Europe. Using error propagation, the random and systematic error in total deposition for an average grid cell of 10 x 20 km was estimated to equal 35–50% and 25–40%, respectively. Within individual grids a relatively large variability in deposition is expected.     

Discrimination of factors influencing biota of a stream receiving multiple-source perturbations

Blaine Creek is a fifth-order stream located in eastern Kentucky that has been subject to contamination by oil brines, surface mining, and a coal fly ash settling pond discharge. Toxicity tests, effluent and receiving water chemical monitoring, and Blaine Creek benthic sampling were used to evaluate the effect of the ash pond effluent on the creek. Reproductive impairment of Ceriodaphnia was demonstrated at effluent concentrations ranging from 30 to 100%, but no instream impact on benthic invertebrates could be found at effluent flows that provided up to 65% of the creek's discharge. Correlation and regression analysis of physicochemical versus benthic monitoring data indicated that upstream oil brine contamination and scouring of the creek's predominately shifting sand substrate during rainfall events were the primary factors affecting the benthic fauna, and appeared to override potential effects from other sources. These results demonstrated the value of integrated field/laboratory investigations for effluent impact assessments.