联合国建议的固体氧化物燃烧测试方法的研究

由于日本消防法中固体氧化物的燃烧试验方法,与联合国黄皮书中所建议的试验方法有所不同,在实际应用中经常出现矛盾.因此,本文对其中的一些不同之处进行了重新的研究考察.并与日本海事检定协会和代表联合国标准测试方法的荷兰应用科学研究组织进行合作,对比研究了联合国建议的关于固体氧化物燃烧试验的方法.并就其中发现的问题提出了相应的改进意见.具体有以下4方面的措施:(1)纤维素种类对于燃烧时间的影响;(2)环境湿度及纤维素含水量对燃烧时间的影响;(3)导火线材料与导火线破裂方式出现的问题;(4)联合国建议中的举例数据.     

A new rapid method for quantification of PCBs in transformer oil

In order to improve the efficiency and cost-effectiveness of the PCB analysis, the DMSO partition and SPE extraction were applied to clean up the PCB-contaminated transformer oils and PCB level was determined by means of the quadrupole GC/MS. The analysis data obtained from this method were compared statistically to that from the standard method.     

摇动床生物膜反应器处理生活污水

介绍了一种新型的生物膜反应器——摇动床反应器,并采用模拟生活污水进行了小试试验研究。试验结果表明,在HRT=6h,DO=3～4mg/L,T=20～25℃,pH=7～8,C/N=20的条件下,该工艺可以达到最佳运行状况,有机负荷为0.64～3.00kgCOD/(m3.d)下,COD去除率平均达到85%,出水TN≤10mg/L,达到国家一级排放标准。     

Feasible conditions for Japanese woody biomass utilization

Environmental Science and Pollution Research - There is an abundance of woody biomass in Japan. However, its economic feasibility is limited. There have been several discussions on whether...     

Report on hazardous household waste generation in Japan.

Surveys of over 2000 households in Japan were conducted to investigate the characteristics of hazardous household waste (HHW) generation. In Japan, about 2.5 to 4.3 kg of HHW are produced per tonne of the residential waste stream. The percentage of used batteries in HHW was over 50%. Every household using spray (aerosol) cans had more than seven cans on average. The generation of HHW, in terms of both quantities and type of waste produced, appeared to vary with dwelling type. Detached dwelling residents tended to store HHW such as used batteries, whereas apartment residents tended not to store waste. The amounts of discarded HHW were larger at the end of the year in comparison with other months. The data accumulated were used to estimate the quantities of HHW disposed off annually, and the quantities and type of waste that might be received by a typical depot collection programme in Japan.     

High (210)Po atmospheric deposition flux in the subtropical coastal area of Japan

Bulk atmospheric deposition fluxes of (210)Po and (210)Pb were measured at three coastal regions of Japan, the Pacific Ocean coastal area of the Japanese mainland (Odawa Bay), the Chinese continental side of Japanese coastal area (Tsuyazaki), and an isolated island near Okinawa (Akajima). Wet and dry fallout collectors were continuously deployed from September 1997 through August 1998 for periods of 3 to 31 days depending on the frequency of precipitation events. Annual (210)Pb deposition fluxes at Odawa Bay (35 degrees N 139 degrees E), Tsuyazaki (33 degrees N 130 degrees E) and Akajima (26 degrees N 127 degrees E) were 73.3+/-8.0, 197+/-35 and 78.5+/-8.0 Bqm(-2)y(-1), respectively. Higher (210)Pb deposition was observed at the Chinese continental side of Japanese coast than at the Pacific Ocean coastal site. The high (210)Pb atmospheric flux at the Chinese continental side coast was thought to be attributable to (222)Rn-rich air-mass transport from the Chinese continent during the winter monsoon. In contrast, the annual (210)Po deposition fluxes at the three study sites were 13.0+/-2.3 (Odawa Bay), 21.9+/-4.4 (Tsuyazaki) and 58.4+/-7.7 (Akajima)Bqm(-2)y(-1), respectively, indicating unusual high (210)Po deposition at Akajima during winter. Anomalous unsupported (210)Po input was observed during summer 1997, suggesting unknown source of (210)Po at this area.     

Heavy metals removal from aqueous solution using carbonaceous K_2S-impregnated adsorbent

A novel carbonaceous adsorbent for heavy metal removal was prepared from raw coal by one-step simple sulfur impregnation using K_2S. Raw coal was mixed with K_2S powder and then heated at 800℃ for 30 min in nitrogen to produce K_2S char. The sulfur content and form in K_2S char were determined, and the ability of K_2S char to adsorb Zn~(2+), Cd~(2+) and Pb~(2+) was examined. The K_2S impregnation was effective at impregnating sulfur into coal, especially in the form of elemental, thiophenic and sulfatic sulfur. The sulfur content of K_2S char was higher than those of raw coal and pyrolysis char. The Zn~(2+) removal in 2.4 mmol/L of Zn~(2+) solution by K_2S char was higher than raw coal with the removal rate of 100%. K_2S char adsorbed Pb~(2+) and Cd~(2+) in 24 mmol/L of Pb~(2+) and Cd~(2+) solution with the removal rate of 97 % and 35 %, respectively. The elution extents of adsorbed Pb~(2+) and Cd~(2+) were zero in distilled water and 27% in 0.1 mol/L HCl solution. These results indicated that an effective adsorbent for heavy metal ions was prepared from coal using K_2S sulfur impregnation, and that the adsorbed metals were strongly retained in K_2S char.     

Arsenic,selenium, and chromium speciation in fly ash

Journal of Material Cycles and Waste Management - Arsenic (As), selenium (Se), and chromium (Cr) are harmful to humans at certain concentrations, and can possibly be eluted from coal ash (fly ash)...     

Microbial community structure and dynamics of starch-fed and glucose-fed chemostats during two years of continuous operation

The microbial community structures of two mesophilic anaerobic chemostats, one fed with glucose, the other with starch as sole carbon sources, were studied at various dilution rates (0.05–0.25 d^–1 for glucose and 0.025–0.1 d^–1 for starch) during two years continuous operation. In the glucose-fed chemostat, the aceticlastic methanogen Methanosaeta spp. and hydrogenotrophic methanogen Methanoculleus spp. predominated at low dilution rates, whereas Methanosaeta spp. and the hydrogenotrophic Methanobacterium spp. predominated together when dilution rates were greater than 0.1 d^–1. Bacteria affiliated with the phyla Bacteroidetes, Spirochaetes, and Actinobacteria predominated at dilution rates of 0.05, 0.1, and 0.15 d^–1, respectively, while Firmicutes predominated at higher dilution rates (0.2 and 0.25 d^–1). In the starch-fed chemostat, the aceticlastic and hydrogenotrophic methanogens coexisted at all dilution rates. Although bacteria belonging to only two phyla were mainly responsible for starch degradation (Spirochaetes at the dilution rate of 0.08 d^–1 and Firmicutes at other dilution rates), different bacterial genera were identified at different dilution rates. With the exception of Archaea in the glucose-fed chemostat, the band patterns revealed by denaturing gradient gel electrophoresis (DGGE) of the microbial communities in the two chemostats displayed marked changes during long-term operation at a constant dilution rate. The bacterial community changed with changes in the dilution rate, and was erratic during longterm operation in both glucose-fed and starch-fed chemostats.     

Foliage profiles of individual trees determine competition,self-thinning,biomass and NPP of a Cryptomeria japonica forest stand: A simulation study based on a stand-scale process-based forest model

A simulation study was carried out to investigate simultaneously the effects of eco-physiological parameters on competitive asymmetry, self-thinning, stand biomass and NPP in a temperate forest using an atmosphere–vegetation dynamics interactive model (MINoSGI). In this study, we selected three eco-physiological relevant parameters as foliage profiles (i.e. vertical distribution of leaf area density) of individual trees (distribution pattern is described by the parameter η), biomass allocation pattern in individual tree growth (χ) and the maximum carboxylation velocity (V_max). The position of the maximal leaf area density shifts upward in the canopy with increasing η. For scenarios with η < 4 (foliage concentrated in the lowest canopy layer) or η > 12 (foliage concentrated in the uppermost canopy layer), a low degree of competitive asymmetry was produced. These scenarios resulted in the survival of subordinate trees due to a brighter lower canopy environment when η < 4 or the generation of spatially separated foliage profiles between dominant and subordinate trees when η > 12. In contrast, competition between trees was most asymmetric when 4 ≤ η ≤ 12 (vertically widespread foliage profile in the canopy), especially when η = 8. In such cases, vertically widespread foliage of dominant trees lowered the opportunity of light acquisition for subordinate trees and reduced their carbon gain. The resulting reduction in carbon gain of subordinate trees yielded a higher degree of competitive asymmetry and ultimately higher mortality of subordinate trees. It was also shown that 4 ≤ η ≤ 12 generated higher self-thinning speed, smaller accumulated NPP, litter-fall and potential stand biomass as compared with the scenarios with η < 4 or η > 12. In contrast, our simulation revealed small effects of χ or V_max on the above-mentioned variables as compared with those of η. In particular, it is notable that greater V_max would not produce greater potential stand biomass and accumulated NPP although it has been thought that physiological parameters relevant to photosynthesis such as V_max influence dynamic changes in forest stand biomass and NPP (e.g. the greater the V_max, the greater the NPP). Overall, it is suggested that foliage profiles rather than biomass allocation or maximum carboxylation velocity greatly govern forest dynamics, stand biomass, NPP and litter-fall.