Spatial mapping of city-wide PBDE levels using an exponential decay model

Passive air samplers (PAS) consisting of polyurethane foam (PUF) disks were deployed at 6 outdoor air monitoring stations in different land use categories (commercial, industrial, residential and semi-rural) to assess the spatial distribution of polybrominated diphenyl ethers (PBDEs) in the Brisbane airshed. Air monitoring sites covered an area of ~1143 km(2) and PAS were allowed to accumulate PBDEs in the city's airshed over three consecutive seasons commencing in the winter of 2008. The average sum of five (∑(5)) PBDEs (BDEs 28, 47, 99, 100 and 209) levels were highest at the commercial and industrial sites (12.7 ± 5.2 ng PUF(-1)), which were relatively close to the city center and were a factor of 8 times higher than residential and semi-rural sites located in outer Brisbane. To estimate the magnitude of the urban 'plume' an empirical exponential decay model was used to fit PAS data vs. distance from the CBD, with the best correlation observed when the particulate bound BDE-209 was not included (∑(5)-209) (r(2) = 0.99), rather than ∑(5) (r(2) = 0.84). At 95% confidence intervals the model predicts that regardless of site characterization, ∑(5)-209 concentrations in a PAS sample taken between 4-10 km from the city centre would be half that from a sample taken from the city centre and reach a baseline or plateau (0.6 to 1.3 ng PUF(-1)), approximately 30 km from the CBD. The observed exponential decay in ∑(5)-209 levels over distance corresponded with Brisbane's decreasing population density (persons/km(2)) from the city center. The residual error associated with the model increased significantly when including BDE-209 levels, primarily due to the highest level (11.4 ± 1.8 ng PUF(-1)) being consistently detected at the industrial site, indicating a potential primary source at this site. Active air samples collected alongside the PAS at the industrial air monitoring site (B) indicated BDE-209 dominated congener composition and was entirely associated with the particulate phase. This study demonstrates that PAS are effective tools for monitoring citywide regional differences however, interpretation of spatial trends for POPs which are predominantly associated with the particulate phase such as BDE-209, may be restricted to identifying 'hotspots' rather than broad spatial trends.     

An agenda for assessing and improving conservation impacts of sustainability standards in tropical agriculture

Sustainability standards and certification serve to differentiate and provide market recognition to goods produced in accordance with social and environmental good practices, typically including practices to protect biodiversity. Such standards have seen rapid growth, including in tropical agricultural commodities such as cocoa, coffee, palm oil, soybeans, and tea. Given the role of sustainability standards in influencing land use in hotspots of biodiversity, deforestation, and agricultural intensification, much could be gained from efforts to evaluate and increase the conservation payoff of these schemes. To this end, we devised a systematic approach for monitoring and evaluating the conservation impacts of agricultural sustainability standards and for using the resulting evidence to improve the effectiveness of such standards over time. The approach is oriented around a set of hypotheses and corresponding research questions about how sustainability standards are predicted to deliver conservation benefits. These questions are addressed through data from multiple sources, including basic common information from certification audits; field monitoring of environmental outcomes at a sample of certified sites; and rigorous impact assessment research based on experimental or quasi‐experimental methods. Integration of these sources can generate time‐series data that are comparable across sites and regions and provide detailed portraits of the effects of sustainability standards. To implement this approach, we propose new collaborations between the conservation research community and the sustainability standards community to develop common indicators and monitoring protocols, foster data sharing and synthesis, and link research and practice more effectively. As the role of sustainability standards in tropical land‐use governance continues to evolve, robust evidence on the factors contributing to effectiveness can help to ensure that such standards are designed and implemented to maximize benefits for biodiversity conservation.     

Thermal tolerance of early development in tropical and temperate sea urchins: inferences for the tropicalization of eastern Australia

The thermal envelope of development to the larval stage of two echinoids from eastern Australia was characterized to determine whether they fill their potential latitudinal ranges as indicated by tolerance limits. The tropical sand dollar, Arachnoides placenta, a species that is not known to have shifted its range, was investigated in Townsville, northern Australia (19°20′S, 146°77′E), during its autumn spawning season (May 2012). The subtropical/temperate sea urchin, Centrostephanus rodgersii, a species that has undergone poleward range expansion, was investigated in Sydney, southern Australia (33°58′S, 151°14′E), during its winter spawning season (August 2012). The thermal tolerance of development was determined in embryos and larvae reared at twelve temperatures. For A. placenta, the ambient water temperature near Townsville and experimental control were 24 °C and treatments ranged from 14 to 37 °C. For C. rodgersii, ambient Sydney water temperature and experimental control were 17 °C, and the treatment range was 9–31 °C. A. placenta had a broader developmental thermal envelope (14 °C range 17–31 °C) than C. rodgersii (9 °C range 13–22 °C). Both species developed successfully at temperatures well below ambient, suggesting that cooler water is not a barrier to poleward migration for either species. Both species presently live near the upper thermal limits for larval development, and future ocean warming could lead to contractions of their northern range limits. This study provides insights into the factors influencing the realized and potential distribution of planktonic life stages and changes to adult distribution in response to global change.     

A pore-scale investigation of mass transport from dissolving DNAPL droplets

Spheres and pendular rings of trichloroethylene and tetrachloroethylene are observed dissolving in an artificial porous medium consisting of a single layer of glass beads. Given the simple geometry of the droplets, pore-scale mass transfer coefficients are calculated. For dissolving spheres, mass transfer coefficients are found to be constant over time. However, coefficients for pendular rings are found to decrease as the rings shrink in size. This is consistent with the concept of diffusion-controlled mass transfer in low-flow zones. Sherwood numbers measured at Reynolds numbers between 0.0033 and 8.33 show a similar trend to empirical relationships established by previous researchers using other techniques. As in previous experiments, considerable scatter in mass transfer rates is observed at a given mean flux. It is hypothesized that this variation in local mass transfer rates is caused by variations in local pore velocity.     

Uptake and accumulation of mercury from dental amalgam in the common goldfish,Carassius auratus

In this study, the bioavailability and accumulation of mercury from external environmental exposure to mixed, cured, milled, sieved and proportioned dental amalgam was examined in the common goldfish, Carassius auratus. Fish were exposed to dental amalgam (particle size range from < 0.10 to 3.15 mm) in order to represent the particle size and distribution of that found within the typical dental office wastewater discharge stream. Experimental amalgam water loadings were 0 g/l, 0.5 g/l and 1 g/l in glass aquaria at 15 degrees C for 28 days. Fish tissues were sampled at 5 min and 28 days of exposure, and the liver, brain, muscle and whole body analyzed for total mercury using cold vapor atomic fluorescence spectroscopy. Mercury was found in several tissues examined and generally increased with exposure to higher amounts of dental amalgam. The highest levels were found in the whole body (17.68 +/- 5.73 microg/g) followed by the liver (0.80 +/- 0.16 microg/g) and muscle (0.47 +/- 0.16 microg/g). The lowest concentrations were seen in the brain (0.28 +/- 0.19 microg/g). Compared to controls, concentrations in the whole body, muscle and liver in fish exposed for 28 days to the highest concentration of amalgam were 200-, 233-, and 40-fold higher, respectively. This study shows that mercury from an environmental exposure to representative samples of dental amalgam typically found within the dental wastewater discharge stream is bioavailable to fish and may accumulate in internal tissues.     

Parasite load predicts mate choice in guppies

Summary The influence of parasites on mate selection and on a secondary sexual character was studied in guppies (Poecilia reticulata). In fish infected with Camallanus cotti or Gyrodactylus, females were found to prefer males with relatively few parasites, and this preference was associated with a higher display rate in less parasitised males.     

Gas-phase reaction of CCl2F2 (CFC-12) with methane

Gas-phase reaction of CFC-12 (CCl2F2) with methane was carried out in a plug flow reactor over the temperature range of 873-1123 K. The major organic halocarbons formed during the reaction were C2F4, C2H2F2, CHClF2, CH3Cl, C3H2F6 and CCl3F. The formation of all products except C2H2F2 decreased with temperature, while the selectivity to C2H2F2 (difluoroethylene) increased with temperature and reached approximately 80% at 1123 K. Under these reaction conditions, methane acts as hydrogen and carbon source, resulting in the formation of an unsaturated C2 hydrofluorocarbon from two C1 precursors.     

Sorption and desorption kinetics of diuron, fluometuron, prometryn and pyrithiobac sodium in soils

The sorption and desorption characteristics of four herbicides (diuron, fluometuron, prometryn and pyrithiobac-sodium) in three different cotton growing soils of Australia was investigated. Kinetics and equilibrium sorption and desorption isotherms were determined using the batch equilibrium technique. Sorption was rapid (> 80% in 2 h) and sorption equilibrium was achieved within a short period of time (ca 4 h) for all herbicides. Sorption isotherms of the four herbicides were described by Freundlich equation with an r2 value > 0.98. The herbicide sorption as measured by the distribution coefficient (Kd) values ranged from 3.24 to 5.71 L/kg for diuron, 0.44 to 1.13 L/kg for fluometuron, 1.78 to 6.04 L/kg for prometryn and 0.22 to 0.59 L/kg for pyrithiobac-sodium. Sorption of herbicides was higher in the Moree soil than in Narrabri and Wee Waa soils. When the Kd values were normalised to organic carbon content of the soils (Koc), it suggested that the affinity of the herbicides to the organic carbon increased in the order: pyrithiobac-sodium < fluometuron < prometryn < or = diuron. The desorption isotherms were also adequately described by the Freundlich equation. For desorption, all herbicides exhibited hysteresis and the hysteresis was stronger for highly sorbed herbicides (diuron and prometryn) than the weakly sorbed herbicides (fluometuron and pyrithiobac-sodium). Hysteresis was also quantified as the percentage of sorbed herbicides which is not released during the desorption step (omega = [nad/nde - 1] x 100). Soil type and initial concentration had significant effect on omega. The effect of sorption and desorption properties of these four herbicides on the off-site transport to contaminate surface and groundwater are also discussed in this paper.     

Enhancement of batch waste activated sludge digestion by microwave pretreatment.

Batch anaerobic digesters were used to stabilize microwave (MW)-irradiated waste activated sludge (WAS). A low temperature range (50-96 degrees C) MW irradiation was applied. Effects of pretreatment temperature (T) and intensity (I), concentration (C) and percentage of sludge pretreated (PT) were investigated in a multilevel factorial statistical design containing 54 mesophilic batch reactors by monitoring cumulative biogas production (CBP). Variance analysis (ANOVA) determined that the most important factors affecting WAS solubilization were temperature, intensity, and sludge concentration. Improvements in CBP from WAS were significantly affected by sludge percentage pretreated, temperature, and concentration. Pretreatment resulted in 3.6 +/- 0.6 and 3.2 +/- 0.1 fold increases in soluble to total chemical oxygen demand (SCOD/TCOD) at high and low sludge concentrations, respectively. WAS, microwaved to 96 degrees C, produced the greatest improvement in CBP with 15 +/- 0.5 and 20 +/- 0.3% increases over controls after 19 d of digestion at low and high WAS concentrations. Dewaterability of microwaved sludge was enhanced after anaerobic digestion.