Characterization of PM2.5 aerosols dominated by local pollution and Asian dust observed at an urban site in Korea during aerosol characterization experiments (ACE)--Asia Project

Daily fine particulate matter (PM2.5) samples were collected at Gwangju, Korea, during the Aerosol Characterization Experiments (ACE)-Asia Project to determine the chemical properties of PM2.5 originating from local pollution and Asian dust (AD) storms. During the study period, two significant events occurred on April 10-13 and 24-25, 2001, and a minor event occurred on April 19, 2001. Based on air mass transport pathways identified by back-trajectory calculation, the PM2.5 dataset was classified into three types of aerosol populations: local pollution and two AD aerosol types. The two AD types were transported along different pathways. One originated from Gobi desert area in Mongolia, passing through Hunshandake desert in Northern Inner Mongolia, urban and polluted regions of China (AD1), and the other originated in sandy deserts located in the Northeast Inner Mongolia Plateau and then flowed southward through the Korean peninsula (AD2). During the AD2 event, a smoke plume that originated in North Korea was transported to our study site. Mass balance closures show that crustal materials were the most significant species during both AD events, contributing -48% to the PM2.5 mass; sulfate aerosols (19.1%) and organic matter (OM; 24.6%) were the second greatest contributors during the AD1 and AD2 periods, respectively, indicating that aerosol properties were dependent on the transport pathway. The sulfate concentration constituted only 6.4% (4.5 microg/m3) of the AD2 PM2.5 mass. OM was the major chemical species in the local pollution-dominated PM2.5 aerosols, accounting for 28.7% of the measured PM2.5 mass, followed by sulfate (21.4%), nitrate (15%), ammonium (12.8%), elemental carbon (8.9%), and crustal material (6.5%). Together with substantial enhancement of the crustal elements (Mg, Al, K, Ca, Sc, Ti, Mn, Fe, Sr, Zr, Ba, and Ce), higher concentrations of pollution elements (S, V, Ni, Zn, As, Cd, and Pb) were observed during AD1 and AD2 than during the local pollution period, indicating that, in addition to crustal material, the AD dust storms also had a significant influence on anthropogenic elements.     

Evaluation of the relationship between two different methods for enumeration fecal indicator bacteria： Colony-forming unit and most probable number

Most probable number (MPN) and colony-forming unit (CFU) estimates of fecal indicator bacteria (FIB) concentration are common measures of water quality in aquatic environments. Thus, FIB intensively monitored in Yeongsan Watershed in an attempt to compare two di erent methods and to develop a statistical model to convert from CFU to MPN estimates or vice versa. As a result, the significant di erence was found in the MPN and CFU estimates. The enumerated Escherichia coli concentrations in MPN are greater than those in CFU, except for the measurement in winter. Especially in fall, E. coli concentrations in MPN are one order of magnitude greater than that in CFU. Contrarily, enterococci bacteria in MPN are lower than those in CFU. However, in general, a strongly positive relationship are found between MPN and CFU estimates. Therefore, the statistical models were developed, and showed the reasonable converting FIB concentrations from CFU estimates to MPN estimates. We expect this study will provide preliminary information towards future research on whether di erent analysis methods may result in di erent water quality standard violation frequencies for the same water sample.     

Effect of arsenic species on the growth and arsenic accumulation in Cucumis sativus

The effects of arsenic (As) species, such as As(III), As(V) and dimethylarsinic acid (DMA), on the accumulation of As in cucumber (Cucumis sativus), as well as on its growth in a soil mesocosm were evaluated. When Cucumis sativus was cultivated in soils contaminated with 20 and 50 mg/kg of As(III), As(V) or DMA for 40 days, the growth was markedly inhibited by the inorganic As (As(III) and As(V)) rather than the organic As (DMA). Irrespective of the As species, the As concentrations accumulated in Cucumis sativus increased with increasing As concentration in the soil. The As bioaccumulation factors from soil into the tissue of Cucumis sativus were 17.5-35.4, 29.3-42.7 and 17.6-25.7 for As(III), As(V) and DMA, respectively. In addition, the As translocation factors from the roots to shoots were 0.025-0.031, 0.018-0.032 and 0.014-0.026 for As(III), As(V) and DMA, respectively. In conclusion, Cucumis sativus mainly accumulated As in its roots rather than its shoots and easily accumulated inorganic rather than organic As from the soil into its tissue.     

A new approach to characterize biodegradation of organics by molecular mass distribution in landfill leachate

This study provides biodegradability of organics in leachate according to their molecular mass distributions (<0.5, 0.5 to 1, 1 to 3, 10, and >10 KDa). Organics with molecular mass values lower than 0.5 KDa were the predominant species in the raw leachate filtrate, and the aerated lagoon process was very effective in treating these highly biodegradable organics; the Fenton's oxidation process was very effective in treating not-so-biodegradable organics with molecular mass values higher than 0.5 KDa, but a portion of these organics were converted into organics <0.5 KDa after Fenton's oxidation. An oxygen uptake measurement using a respirometer was more sensitive than a conventional biochemical oxygen demand measurement to evaluate bioactivities, especially when bioactivities were low.     

Inactivation of Ascaris eggs in soil by microwave treatment compared to UV and ozone treatment

This study reports on the effect of microwave radiation for inactivation of Ascaris lumbricoides eggs in 25 g of soil compared to ultraviolet irradiation and ozone expose. Microwave radiation at 700 W with 14% water content (w/w) achieved approximately 2.5 log inactivation of eggs in soil within 60 s. On the other hand, UV irradiation at 3 mW cm⁻² with and without shaking soil for 3600 s achieved approximately 0.32 and 0.01 log inactivation of eggs, respectively. In ozone treatment, 0.13 log inactivation of eggs was achieved with 5.8 ± 0.7 mg L⁻¹ of dissolved ozone dose for 30 min in a continuous diffusion reactor. In addition, the inactivation of eggs by three disinfection techniques was conducted in water in order to compare the inactivation efficiency of eggs in soil. The inactivation efficiency of microwave radiation was found to be no significant difference between in soil and water. However, the inactivation efficiency of UV irradiation was significantly increased in water while in ozone expose there was no significant difference between in soil and water. Microwave treatment thus proved to be the most efficient method in controlling A. lumbricoides eggs in soil.     

Element associations in ash from waste combustion in fluidized bed

The incineration of MSW in fluidized beds is a commonly applied waste management practice. The composition of the ashes produced in a fluidized bed boiler has important environmental implications as potentially toxic trace elements may be associated with ash particles and it is therefore essential to determine the mechanisms controlling the association of trace elements to ash particles, including the role of major element composition. The research presented here uses micro-analytical techniques to study the distribution of major and trace elements and determine the importance of affinity-based binding mechanisms in separate cyclone ash particles from MSW combustion. Particle size and the occurrence of Ca and Fe were found to be important factors for the binding of trace elements to ash particles, but the binding largely depends on random associations based on the presence of a particle when trace elements condensate in the flue gas.     

Hydrogen sulfide effects on ammonia removal by a biofilter seeded with earthworm casts

Ammonia (NH3) removal efficencies were evaluated when hydrogen sulfide (H2S) and NH3 in binary mixture gases were supplied to a ceramic biofilter seeded with earthworm (Lumbricus terrestris) casts. The effect of inlet H2S concentration and space velocity (SV) on the removal of NH3 was investigated after the acclimation of the biofilter with NH3 gas. When NH3 was singly supplied to the biofilter, NH3 removal was maintained at almost 100% until inlet NH3 concentration was increased up to 600 microL L(-1) and SV up to 330 h(-1), at which the elimination capacity of NH3 was 148 g N m(-3) h(-1). When H2S was supplied simultaneously, however, the accumulation of toxic sulfide ions showed dual effects on NH3 removal efficiencies. First, no effects were observed at inlet H2S loading below 60 g S m(-3) h(-1); however, inhibition by H2S at higher loading was observed above 60 g S m(-3) h(-1). The point at which loading achieved a maximum of more than 99% NH3 removal efficiency was 139 g N m(-3) h(-1), when inlet H2S concentration was held under 100 microL L(-1), but it dropped to 76 and 30 g N m(-3) h(-1) when the inlet H2S concentration increased to 220 and 460 microL L(-1), respectively. The critical points of inlet H2S loading that guaranteed over 99% NH3 removal were determined as 100, 100, 60, and 40 g S m(-3) h(-1) at inlet NH3 concentrations of 100, 200, 400, and 600 microL L(-1), respectively. Inlet NH3 loading had synergic effects of increasing the inhibition of inlet H2S loading on the NH3 removability of the biofilter.     

Concentrations and analysis of health risks of ambient air metallic elements at Longjing site in central Taiwan

Environmental Geochemistry and Health - The concentrations of particulates and metallic elements that were bound to total suspended particulates in ambient air at Long Cyuan Elementary School...     

ARCGIS‐SWAT: A GEODATA MODEL AND GIS INTERFACE FOR SWAT1

This paper presents ArcGIS‐SWAT, a geodata model and geographic information system (GIS) interface for the Soil and Water Assessment Tool (SWAT). The ArcGIS‐SWAT data model is a system of geodatabases that store SWAT geographic, numeric, and text input data and results in an organized fashion. Thus, it is proposed that a single and comprehensive geodatabase be used as the repository of a SWAT simulation. The ArcGIS‐SWAT interface uses programming objects that conform to the Component Object Model (COM) design standard, which facilitate the use of functionality of other Windows‐based applications within ArcGIS‐SWAT. In particular, the use of MS Excel and MATLAB functionality for data analysis and visualization of results is demonstrated. Likewise, it is proposed to conduct hydrologic model integration through the sharing of information with a not‐model‐specific hub data model where information common to different models can be stored and from which it can be retrieved. As an example, it is demonstrated how the Hydrologic Modeling System (HMS) ‐ a computer application for flood analysis ‐ can use information originally developed by ArcGIS‐SWAT for SWAT. The application of ArcGIS‐SWAT to the Seco Creek watershed in Texas is presented.