Effects of copper (I) oxide on growth and biochemical compositions of two marine microalgae

In copper based antifouling (AF) paints Cu (I) oxide was largely used as booster biocide. In this study effect of Cu (I) oxide on two marine microalgae, Tetraselmis suecica and Dunaliella tertiolecta was demonstrated. EC50 (96 hr) concentrations estimated for T. suecica and D. tertiolecta were 1.3 mg l(-1) and 1.34 mg l(-1), respectively. Copper (I) oxide induced changes in growth, chlorophyll, carbohydrate and protein contents were observed in T. suecica and D. tertiolecta. At low concentration of 0.0625 mg l(-1), 3-26% and 1-16% growth stimulation was observed in T. suecica and T. tertiolecta respectively. Increasing Cu (I) oxide concentrations proportionately decreased the carbohydrate and protein contents. This study clearly indicates the toxicity of excessive Cu (I) oxide on growth and biochemical compositions of T. suecica and D. tertiolecta.     

Comparative assessment of coal tars obtained from 10 former manufactured gas plant sites in the eastern United States

A comparative analysis was performed on eleven coal tars obtained from former manufactured gas plant sites in the eastern United States. Bulk properties analyzed included percent ash, Karl Fisher water content, viscosity and average molecular weight. Chemical properties included monocyclic- and polycyclic-aromatic hydrocarbon (PAH) concentrations, alkylated aromatic concentrations, and concentrations of aliphatic and aromatic fractions. It was found that there was at least an order-of-magnitude variation in all properties measured between the eleven coal tars. Additionally, two coal tars obtained from the same manufactured gas plant site had very different properties, highlighting that there can be wide variations in coal tar properties from different samples obtained from the same site. Similarities were also observed between the coal tars. The relative chemical distributions were similar for all coal tars, and the coal tars predominantly consisted of PAHs, with naphthalene being the single-most prevalent compound. The C(9-22) aromatic fraction, an indicator of all PAHs up to a molecular weight of approximately 276 gmole(-1), showed a strong power-law relationship with the coal tar average molecular weight (MW (ct)). And the concentrations of individual PAHs decreased linearly as MW (ct) increased up to ca. 1000 gmole(-1), above which they remained low and variable. Implications of these properties and their variation with MW (ct) on groundwater quality are discussed. Ultimately, while these similarities do allow generalities to be made about coal tars, the wide range of coal tar bulk and chemical properties reported here highlights the complex nature of coal tars.     

A comparative assessment of heavy metal accumulation in soft parts and byssus of mussels from subarctic, temperate, subtropical and tropical marine environments

Existing data on metal concentrations in mussels from subarctic, temperate, subtropical and tropical waters were analyzed using multivariate statistics in order to assess regional variations in metal contamination. Potential errors were reduced by only analyzing data from surveys that employed the same protocols, analytical methodologies and analysts. Factor analysis demonstrated that mussels inhabiting extremely contaminated areas (e.g. from Japanese and Swedish metallurgy sources) could be separated from mussels from other contaminated areas, and that metals such as Cd, Pb, Cu and Zn could be used to identify heavily contaminated samples while Co, Fe, Cr and Ni concentrations were good markers for exposure to inputs from different industrial sources. Furthermore byssus, like soft tissue, selectively and sensitively reflects variations of certain metal concentrations in ambient waters and thus serves as a reliable biomonitor for these contaminants in a variety of coastal and estuarine areas.     

Determination of biodegradation potential by two culture-independent methods in PAH-contaminated soils

Biodegradation potentials of polycyclic aromatic hydrocarbons (PAHs) were determined with soil samples collected from various depths of a PAH-contaminated site and of a site nearby where PAHs were not found. Putative dioxygenase genes were amplified by a primer set specific for initial dioxygenases and identified by web-based database homology search. They were further categorized into several groups of which four dioxygenases were selected as probes for DNA hybridization. The hybridization signals according to the presence of putative dioxygenases were positively related to the extent of PAH contamination. However, the signal intensities varied depending on the probes hybridized and moreover were not consistent with PAH biodegradation activities determined by CO2 evolution. Despite widely accepted advantages of molecular biodegradation assessment, our data clearly present the variations of assessment results depending on the genetic information used and suggest that the methodology may tend to underestimate the real biodegradation capacity of a site probably due to the limited dioxygenase database available at the moment. Therefore, the molecular assessment of biodegradation potential should involve a very careful primer and probe design and an extensive microbiological examination of a site of interest to accurately delineate the biodegradation potential of the site.     

Biodegradation of methoxychlor and its metabolites by the white rot fungus Stereum hirsutum related to the inactivation of estrogenic activity

The white rot fungus Stereum hirsutum was used to degrade methoxychlor [2,2,2-trichloro-1,1-bis(4-methoxyphenyl)ethane] in culture and the degraded products were extensively determined. The estrogenic activity of the degraded products of methoxychlor was examined using cell proliferation and pS2 gene expression assays in MCF-7 cells. S. hirsutum showed high resistance to methoxychlor 100 ppm, and the mycelial growth was fully completed within 8 days of incubation at 30 degrees C. Methoxychlor in liquid culture medium was gradually converted into 2,2-dichloro-1,1-bis(4-methoxyphenyl)ethane, 2,2-dichloro-1,1-bis(4-methoxyphenyl)ethylene, 2-chloro-1,1-bis(4-methoxyphenyl) ethane, 2-chloro-1,1-bis(4-methoxyphenyl) ethylene, and 1,1-bis(4-methoxyphenyl)ethylene, indicating that methoxychlor is dominantly degraded by dechlorination and dehydrogenation. MCF-7 cells were demonstrated to proliferate actively at the 10-5 M concentration of methoxychlor. However, cell proliferation was significantly inhibited by the incubation with methoxychlor culture media containing S. hirsutum. In addition, the expression level of pS2 mRNA was increased at the concentration (10-5 M) of methoxychlor. The reductive effect of S. hirsutum for methoxychlor was clear but not significant as in the proliferation assay.     

A test of sequential extractions for determining metal speciation in sewage sludge-amended soils

Sequential extraction procedures are widely used to estimate the quantity of trace metals bound to different solid fractions in contaminated soils. However, reliability of speciation of trace metals by these procedures remains largely unexamined. In the present study, the selectivity of each extraction step was tested by observing the effect of reversing the extraction order in the procedure. Two different sequential extraction methods and their reversed modes were used for metal fractionation in sewage sludge-amended soils. Significantly increased amounts of extractable metals (Cd, Cu, Pb and Zn) were evident in the sludge-amended soils compared to control soil by all extraction schemes; however, the amounts of metals extracted by each step were strongly dependent on the order of extraction, the type of reagents and the nature of the individual metals. Caution is advised in deducing the forms of soil metals from sequential extraction results from metal-contaminated soils.     

Sources of fine particulate species in ambient air over lake Champlain Basin, VT

This study is a part of an ongoing investigation of the types and locations of emission sources that contribute fine particulate air contaminants to Underhill, VT. The air quality monitoring data used for this study are from the Interagency Monitoring of Protected Visual Environments network for the period of 2001-2003 for the Underhill site. The main source-receptor modeling techniques used are the positive matrix factorization (PMF) and potential source contribution function (PSCF). This new study is intended as a comparison to a previous study of the 1988-1995 Underhill data that successfully revealed a total of 11 types of emission sources with significant contributions to this rural site. This new study has identified a total of nine sources: nitrate-rich secondary aerosol, wood smoke, East Coast oil combustion, automobile emission, metal working, soil/dust, sulfur-rich aerosol type I, sulfur-rich aerosol type II, and sea salt/road salt. Furthermore, the mass contributions from the PMF identified sources that correspond with sampling days with either good or poor visibility were analyzed to seek possible correlations. It has been shown that sulfur-rich aerosol type I, nitrate aerosol, and automobile emission are the most important contributors to visibility degradation. Soil/dust and sea salt/road salt also have an added effect.     

The adsorptive capacity of vapor-phase mercury chloride onto powdered activated carbon derived from waste tires

Injection of powdered activated carbon (PAC) upstream of particulate removal devices (such as electrostatic precipitator and baghouses) has been used effectively to remove hazardous air pollutants, particularly mercury-containing pollutants, emitted from combustors and incinerators. Compared with commercial PACs (CPACs), an alternative PAC derived from waste tires (WPAC) was prepared for this study. The equilibrium adsorptive capacity of mercury chloride (HgCl2) vapor onto the WPAC was further evaluated with a self-designed bench-scale adsorption column system. The adsorption temperatures investigated in the adsorption column were controlled at 25 and 150 degrees C. The superficial velocity and residence time of the flow were 0.01 m/sec and 4 sec, respectively. The adsorption column tests were run under nitrogen gas flow. Experimental results showed that WPAC with higher Brunauer-Emmett-Teller (BET) surface area could adsorb more HgCl2 at room temperature. The equilibrium adsorptive capacity of HgCl2 for WPAC measured in this study was 1.49 x 10(-1) mg HgCl2/g PAC at 25 degrees C with an initial HgCI2 concentration of 25 microg/m3. With the increase of adsorption temperature < or = 150 degrees C, the equilibrium adsorptive capacity of HgCl2 for WPAC was decreased to 1.34 x 10(-1) mg HgCl2/g PAC. Furthermore, WPAC with higher sulfur contents could adsorb even more HgCl2 because of the reactions between sulfur and Hg2+ at 150 degrees C. It was demonstrated that the mechanisms for adsorbing HgCl2 onto WPAC were physical adsorption and chemisorption at 25 and 150 degrees C, respectively. Experimental results also indicated that the apparent overall driving force model appeared to have the good correlation with correlation coefficients (r) > 0.998 for HgCl2 adsorption at 25 and 150 degrees C. Moreover, the equilibrium adsorptive capacity of HgCl2 for virgin WPAC was similar to that for CPAC at 25 degrees C, whereas it was slightly higher for sulfurized WPAC than for CPAC at 150 degrees C.     

Characteristics of Asian dust transport based on synoptic meteorological analysis over Korea

Classification of synoptic patterns and their correlation with dust events over East Asia were performed by means of cluster analysis. The average linkage and K-means clustering techniques were used to identify two major weather types during Asian dust events (ADEs; total 26 ADEs with 47 dusty days) of six spring seasons from 1996 to 2001. The first weather type mainly influenced neighboring Asian countries and frequently occurred with ADEs (approximately 23% of ADE cases). It mostly occurred under a surface high (low)-pressure system over the west (east) of the Korean peninsula coupled with an upper-level trough and cutoff low passage over the center of the Korean peninsula. It showed strong advection in the middle/ upper troposphere with both a high aerosol index and enhanced coarse particulate matter (PM) loading over Korea. In contrast, the second weather type was mostly associated with long distance or continental-scale transport and occurred less frequently with ADEs (approximately 15%). It appeared with an upper-level trough and a cutoff low vertically connected with a surface low system that was formed by a strong cyclonic vortex over the north of the Korean peninsula. There were weak advection, low aerosol index, and low coarse PM concentration over the Korean peninsula during the second weather type. In addition, it was found to be mostly associated with the trans-Pacific transport of Asian dust to the western coast of North America.