Editorial

Environmental Geochemistry and Health -     

Air concentrations of polybrominated diphenyl ethers (PBDEs) in 2002–2004 at a rural site in the Great Lakes

Atmospheric PBDEs were measured on a monthly basis in 2002–2004 at Point Petre, a rural site in the Great Lakes. Average air concentrations were 7.0 ± 13 pg m^?3 for Σ₁₄BDE (excluding BDE-209), and 1.8 ± 1.5 pg m^?3 for BDE-209. Concentrations of 3 dominant congeners (i.e., BDE-47, 99, and 209) were comparable to previous measurements at remote/rural sites around the Great Lakes, but much lower than those at urban areas. Weak temperature dependence and strong linear correlations between relatively volatile congeners suggest importance of advective inputs of gaseous species. The significant correlation between BDE-209 and 183 implies their transport inputs associated with particles. Particle-bound percentages were found greater for highly brominated congeners than less brominated ones. These percentages increase with decreasing ambient temperatures. The observed gas/particle partitioning is consistent with laboratory measurements and fits well to the Junge–Pankow model. Using air mass back-trajectories, atmospheric transport to Point Petre was estimated as 76% for BDE-47, 67% for BDE-99, and 70% for BDE-209 from west–northwest and southwest directions. During the same time period, similar congener profiles and concentration levels were found at Alert in the Canadian High Arctic. Different inter-annual variations between Point Petre and Alert indicate that emissions from other regions than North America could also contribute PBDEs in the Arctic. In contrast to weak temperature effect at Point Petre, significant temperature dependence in the summertime implies volatilization emissions of PBDEs at Alert. Meanwhile, episodic observations in the wintertime were likely associated with enhanced inputs through long-range transport during the Arctic Haze period.     

Cooperative prey capture by young subsocial spiders: II. Behavioral mechanism

Subsocial spiders demonstrate an intermediate stage in the evolution of permanent sociality. Cooperative hunting is an important attribute of their sociality, but has not been documented in subsocial arthropods. After cannibalizing their mother, young of the subsocial spider Amaurobius ferox (Araneae, Amaurobiidae) remain together for several instars and feed communally. We monitored the collective prey capture behavior of the spiderlings. All the clutches showed collective capturing sequence (latency–orientation–moving–touching–seizing–feeding) toward the prey that was 10 times more massive than each individual. The first three individuals that exhibited attacking behavior were responsible for 90% of the total number of attacks, while 68% of the individuals within the group never exhibited attacks during the first 10 min following the introduction of prey into the communal web. First arriving individuals at the prey most often seized the antennae and legs of the prey, which probably facilitate access to the prey for subsequent individuals. The spiderlings that arrived later occupied more likely the abdomen and thorax, which contain more nutrition than the extremities occupied earlier. The individual apportionment of collective hunting behavior suggests a coordinated teamwork among individuals.     

Evaluation of a Three‐Dimensional Hydrodynamic Model Applied to Chesapeake Bay Through Long‐Term Simulation of Transport Processes

A numerical model, the Curvilinear Hydrodynamics in 3‐Dimensions, Waterway Experiment Station version (CH3D‐WES), was applied to represent transport processes of the Chesapeake Bay. Grid resolution and spatial coverage, tied with realistic bathymetry, ensured dynamic responses along the channel and near the shoreline. The model was run with the forcing ranges from high frequency astronomical tides to lower frequency meteorological forcing, given by surface wind and heat flux, as well as hydrological forcing given by fresh water inflows both from upstream and distributed sources along the shoreline. To validate the model, a long‐term simulation over seven‐year time period between 1994 and 2000 was performed. The model results were compared with existing observation data including water level time series, which spans over a wide spectrum of time scales, and long‐term variations in salinity structures over varying parts of the Bay. The validated model is set to provide an appropriate transport mechanism to the water quality model through linkage, warranting that the model takes into account the complexity in time and spatial scales associated with the dynamic processes in the Chesapeake.     

Development of extended speech act coding scheme to observe communication characteristics of human operators of nuclear power plants under abnormal conditions

Communication problems have long been regarded as one of the biggest causes of trouble in many workplaces. Consequently, as a part of human error analysis, extensive research has been conducted into communication. The existing research indicates that maintaining reliable communication is essential to securing the safety of a large and complex process or system. To observe the characteristics of communication, verbal protocol analysis using speech act coding schemes have been widely used in much of the related research. However, as existing speech act coding schemes do not provide a sufficient analysis information other than the distribution rate of each pattern, the development of extended communication categories is essential to overcoming the weaknesses of protocol analysis. The objective of this study is to suggest an extended speech act coding scheme and to elucidate the communication pattern characteristics of an operator’s conversation during a simulated abnormal condition in a nuclear power plant (NPP). The expected results are that conversation between operators using Multi-Way communication can increase the accuracy of information delivery and eliminate the possibility of improper operation. Therefore, communication quality control can be regarded as an important research area to minimize the occurrence of human error during communication. From this perspective, the results of this study would be a good starting point to improving the quality of communications in the workplace.     

Sources of fine particles in the South Coast area,California

PM_2.5 (particulate matter less than 2.5 μm in aerodynamic diameter) speciation data collected between 2003 and 2005 at two United State Environmental Protection Agency (US EPA) Speciation Trends Network monitoring sites in the South Coast area, California were analyzed to identify major PM_2.5 sources as a part of the State Implementation Plan development. Eight and nine major PM_2.5 sources were identified in LA and Rubidoux, respectively, through PMF2 analyses. Similar to a previous study analyzing earlier data (Kim and Hopke, 2007a), secondary particles contributed the most to the PM_2.5 concentrations: 53% in LA and 59% in Rubidoux. The next highest contributors were diesel emissions (11%) in LA and Gasoline vehicle emissions (10%) in Rubidoux. Most of the source contributions were lower than those from the earlier study. However, the average source contributions from airborne soil, sea salt, and aged sea salt in LA and biomass smoke in Rubidoux increased.To validate the apportioned sources in this study, PMF2 results were compared with those obtained from EPA PMF (US EPA, 2005). Both models identified the same number of major sources and the resolved source profiles and contributions were similar at the two monitoring sites. The minor differences in the results caused by the differences in the least square algorithm and non-negativity constraints between two models did not affect the source identifications.     

Leaching behaviour of elements and evaluation of pre-treatment methods for municipal solid waste incinerator residues in column leaching tests.

Two new pre-treatment methods (water-washing/carbonation and carbonation/phosphate stabilization) of municipal solid waste (MSW) incinerator residues were evaluated by column leaching tests under aerobic conditions and anaerobic conditions (which were changed to aerobic conditions after 10 months). A mixture of bottom ash and fly ash (5:1 ratio) was pre-treated using each method. Shredded incombustible residues (SIR) were added to each ash preparation in proportions similar to the ratios present in landfills. For comparison, landfill wastes typical of Japan, namely, a mixture of bottom ash, chelating-pre-treated fly ash, and SIR, were also examined. Leachate samples were collected periodically and analysed over a 15-month period. When compared with chelating pretreatment, both water-washing/carbonation and carbonation/ phosphate stabilization reduced the leaching of Pb, Al, and Cu by about one to two orders of magnitude. Moreover, the initial concentrations of Ca and Pb in leachates from column of water-washing/carbonation were 56-57% and 84-96% less than those from the column of carbonation/phosphate stabilization. Therefore, water-washing/carbonation was considered to be a promising approach to obtain early waste stabilization and to reduce the release of heavy metals to near-negligible levels. The leaching behaviour of elements was also discussed.     

Application of zeolite-activated carbon macrocomposite for the adsorption of Acid Orange 7: isotherm, kinetic and thermodynamic studies

In this study, the adsorption behavior of azo dye Acid Orange 7 (AO7) from aqueous solution onto macrocomposite (MC) was investigated under various experimental conditions. The adsorbent, MC, which consists of a mixture of zeolite and activated carbon, was found to be effective in removing AO7. The MC were characterized by scanning electron microscopy (SEM), energy dispersive X-ray, point of zero charge, and Brunauer–Emmett–Teller surface area analysis. A series of experiments were performed via batch adsorption technique to examine the effect of the process variables, namely, contact time, initial dye concentration, and solution pH. The dye equilibrium adsorption was investigated, and the equilibrium data were fitted to Langmuir, Freundlich, and Tempkin isotherm models. The Langmuir isotherm model fits the equilibrium data better than the Freundlich isotherm model. For the kinetic study, pseudo-first-order, pseudo-second-order, and intraparticle diffusion model were used to fit the experimental data. The adsorption kinetic was found to be well described by the pseudo-second-order model. Thermodynamic analysis indicated that the adsorption process is a spontaneous and endothermic process. The SEM, Fourier transform infrared spectroscopy, ultraviolet–visible spectral and high performance liquid chromatography analysis were carried out before and after the adsorption process. For the phytotoxicity test, treated AO7 was found to be less toxic. Thus, the study indicated that MC has good potential use as an adsorbent for the removal of azo dye from aqueous solution.     

Non-destructive ultrasonic techniques on sequence error of carbon fiber/epoxy composite solid laminates

When propagating in the thickness direction of composite laminates, shear ultrasonic waves are particularly sensitive to layup sequence in the cured CF/Epoxy composite laminates manufactured from unidirectional prepregs and are interacting with the polarization direction of propagating through its thickness. The strength and stiffness in laminates often are attributable to the specific fiber orientation and layup sequence. So the layup orientation greatly influences its properties in a composite laminate. There is a good correlation between the model and the non-destructive ultrasonic technique developed to inspect the sequence error of cured symmetric layups of the laminates. The physical model is based on the decomposition and recombination of shear polarization. Non-destructive evaluation capabilities are highly desirable for reusing unidirectional prepreg sheets.     

Estimating the Lower Heating Values of Hazardous and Solid Wastes

ABSTRACT

A new equation is proposed to predict the lower heating value of hazardous and non-hazardous materials. The equation was developed by a statistical correlation of heating value and composition data for a variety of materials as reported in a number of sources. The model takes into account the carbon, hydrogen, oxygen, chlorine, and sulfur content of the material being combusted.