Dry FGD at United Power Association’s Stanton Station

The United Power Association’s dry FGD system at Stanton, North Dakota was the first utility-operated lime spray dryer to be put into service in the United States. At 60 MW in size, it utilizes a single spray dryer vessel with three rotary atomizers and a ten-compartment fabric filter. It is currently operating at better than expected efficiency and Is meeting state and federal air quality requirements. Start-up and operation have shown that certain areas of design and operating conditions are critical to reliable operation. Flue gas, slurry, and water distribution and mixing must be carefully controlled if reliable, long term operation is to be achieved. Likewise, water chemistry Is Important in the reagent preparation equipment. Start-up of the system was accomplished In a step-wise fashion to bring the baghouse on line first, followed by the spray dryer. The spray dryer was operated at gradually lower outlet temperatures until design conditions were met. Measures taken since start-up to ensure reliable operation, and operation over an eighteen month period are discussed. Both particulate and SO₂ emission performance are evaluated.     

耐低温贫营养好氧反硝化菌群脱氮特性及安全性

针对微污染水体强化原位生物脱氮技术同时面临低温、贫营养及好氧问题,对实验室已分离筛选的贫营养好氧反硝化菌和耐低温好氧反硝化菌进行菌源重组,构建出高效耐低温贫营养好氧脱氮功能菌群T1(Y3+F3+H8)和T2(Y3+F4)。研究不同投菌量条件下菌群的脱氮特性,结果表明,投菌量对T1脱氮效果有一定影响,0.1、0.2和1.0 mg/L投量对NO3--N去除率为71%、91%和100%,总氮去除率为56%、34%和52%;T2菌群,当投量为0.2 mg/L时,对NO3--N、总氮去除率最大可达66%和59.48%。对菌群T1、T2进行生物安全性分析,采用次氯酸钠进行消毒,其生物灭活率均达到99.9%以上。     

Assessment of Uncertainty in Long-Term Mass Balances for Acidification Assessments: A MAGIC Model Exercise

Long-term (1860–2010) catchment mass balance calculations rely on models and assumptions which are sources of uncertainty in acidification assessments. In this article, we report on an application of MAGIC to model acidification at the four Swedish IM forested catchments that have been subject to differing degrees of acidification stress. Uncertainties in the modeled mass balances were mainly associated with the deposition scenario and assumptions about sulfate adsorption and soil mass. Estimated base cation (BC) release rates (weathering) varied in a relatively narrow range of 47–62 or 42–47 meq m⁻² year⁻¹, depending on assumptions made about soil cation exchange capacity and base saturation. By varying aluminum solubility or introducing a dynamic weathering feedback that allowed BC release to increase at more acidic pHs, a systematic effect on predicted changes in acid neutralizing capacity (ΔANC ca. 10–41 μeq l⁻¹) and pH (ca. ΔpH = 0.1–0.6) at all sites was observed. More robust projections of future changes in pH and ANC are dependent on reducing uncertainties in BC release rates, the timing, and extent of natural acidification through BC uptake by plants, temporal changes in soil element pools, and fluxes of Al between compartments.     

Speciation and transport of arsenic in an acid sulfate soil-dominated catchment, eastern Australia

Factors controlling the transport of geogenically-derived arsenic from a coastal acid sulfate soil into downstream sediments are identified in this study with both solid-phase associations and aqueous speciation clearly critical to the mobility and toxicity of arsenic. The data from both sequential extractions and X-ray adsorption spectroscopy indicate that arsenic in the unoxidised Holocene acid sulfate soils is essentially non-labile in the absence of prolonged oxidation, existing primarily as arsenopyrite or as an arsenopyrite-like species, likely arsenian pyrite. Anthropogenically-accelerated pedogenic processes, which have oxidised this material over time, have greatly enhanced the potential bioavailability of arsenic, with solid-phase arsenic almost solely present as As(V) associated with secondary Fe(III) minerals present. Analyses of downstream sediments reveal that a portion of the arsenic is retained as a mixed As(III)/As(V) solid-phase, though not at levels considered to be environmentally deleterious. Determination of arsenic speciation in pore waters using high performance liquid chromatography/Inductively Coupled Plasma-Mass Spectrometry shows a dominance of As(III) in upstream pore waters whilst an unidentified As species reaches comparative levels within the downstream, estuarine locations. Pore water As(V) was detected at trace concentrations only. The results demonstrate the importance of landscape processes to arsenic transport and availability within acid sulfate soil environments.     

The effects of dietary nickel on the detoxification enzymes, innate immunity and resistance to the fungus Beauveria bassiana in the larvae of the greater wax moth Galleria mellonella

In this study, we tested the effects of dietary nickel on the activity of glutathione S-transferase (GST), esterases, phenoloxidase, and encapsulation in the haemolymph of larvae of the greater wax moth Galleria mellonella. We also explored the effects of dietary nickel on larval resistance to infection by the fungus Beauveria bassiana. Larvae fed a low dose of nickel (10 μg g⁻¹) had significantly higher GST, phenoloxidase activity and encapsulation responses than controls fed on a nickel-free diet. We also found that larvae fed a sublethal dose of nickel (50 μg g⁻¹) had increased GST, esterase activity and encapsulation rates but decreased phenoloxidase activity. Although, a sublethal dose of dietary nickel enhanced innate immunity, we found that this reduced resistance against the real pathogen. Our results suggest that enhanced immunity and detoxification enzyme activity of insects may not be beneficial to resistance to fungal infection. It appears that there is a trade off between different resistance mechanisms in insects under different metal treatments.     

Column study of Cr(VI) removal by cationic hydrogel for in-situ remediation of contaminated groundwater and soil

Column experiments were conducted for examining the effectiveness of the cationic hydrogel on Cr(VI) removal from groundwater and soil. For in-situ groundwater remediation, the effects of background anions, humic acid (HA) and pH were studied. Cr(VI) has a higher preference for being adsorbed onto the cationic hydrogel than sulphate, bicarbonate ions and HA. However, the adsorbed HA reduced the Cr(VI) removal capacity of the cationic hydrogel, especially after regeneration of the adsorbents, probably due to the blockage of adsorption sites. The Cr(VI) removal was slightly influenced by the groundwater pH that could be attributed to Cr(VI) speciation. The 6-cycle regeneration and reusability study shows that the effectiveness of the cationic hydrogel remained almost unchanged. On average, 93% of the adsorbed Cr(VI) was recovered in each cycle and concentrated Cr(VI) solution was obtained after regeneration. For in-situ soil remediation, the flushing water pH had an insignificant effect on the release of Cr(VI) from the soils. Multiple-pulse flushing increased the removal of Cr(VI) from the soils. In contrast, more flushing water and longer operation may be required to achieve the same removal level by continuous flushing.     

Chemical composition of burnt smell caused by accidental fires: environmental contaminants

The chemical composition of the odors typical of fires has recently been deciphered. Basically the constituents are mixtures of acetophenone, benzyl alcohol, hydroxylated derivatives of benzaldehyde, methoxylated and/or alkylated phenols and naphthalene. This finding makes it possible to develop objective, practical analytic measurement methods for the burnt smell as a contribution to improving fire damage assessment and remediation monitoring. With the aid of an artificially produced burnt smell and a panel of testers the odor detection threshold of a test mixture was determined olfactometrically to 2 μg m⁻³. Using a defined burnt-smell atmosphere in a test chamber, analytical methods with active sampling, the adsorbents XAD 7 and TENAX TA, and GC/MS measurement were then optimized and tested with a view to being able to carry out sensitive quantitative measurement of burnt smells. A further practical method with particular application to the qualitative characterization of this odor is based on the use of a new SPME (solid-phase microextraction) field sampler with DVB/CAR/PDMS (divinylbenzene/Carboxen™/polydimethylsiloxane) fibers.     

Effects of C60 nanoparticle exposure on earthworms (Lumbricus rubellus) and implications for population dynamics

Effects of C₆₀ nanoparticles (nominal concentrations 0, 15.4 and 154 mg/kg soil) on mortality, growth and reproduction of Lumbricus rubellus earthworms were assessed. C₆₀ exposure had a significant effect on cocoon production, juvenile growth rate and mortality. These endpoints were used to model effects on the population level. This demonstrated reduced population growth rate with increasing C₆₀ concentrations. Furthermore, a shift in stage structure was shown for C₆₀ exposed populations, i.e. a larger proportion of juveniles. This result implies that the lower juvenile growth rate due to exposure to C₆₀ resulted in a larger proportion of juveniles, despite increased mortality among juveniles. Overall, this study indicates that C₆₀ exposure may seriously affect earthworm populations. Furthermore, it was demonstrated that juveniles were more sensitive to C₆₀ exposure than adults.     

Cocaine and other illicit drugs in airborne particulates in urban environments: a reflection of social conduct and population size

Levels of cocaine and other psychoactive substances in atmospheric particulate matter (PM) were determined in urban environments representing distinct social behaviours with regard to drug abuse: night-life, university and residential areas. Three cities (with population >1 million and <0.3 million inhabitants) were selected. Mean daily levels of drugs in PM were 11-336 pg/m³ for cocaine, 23-34 pg/m³ for cannabinoids, and 5-90 pg/m³ for heroin. The highest levels were recorded on weekends, with factors with respect to weekdays of 1-3 for cocaine, 1-2 for cannabinoids and 1.1-1.7 for heroin. Higher levels were detected in the night-life areas, pointing towards consumption and trafficking as major emission sources, and possibly ruling out drug manufacture. The similarities in temporal trends at all sites suggested a city-scale transport of psychoactive substances. Correlations were detected between cocaine and amphetamine consumption (r² = 0.98), and between heroin and cannabinoids (r²>0.82).     

Stepwise calibration of the activated sludge model no. 1 at a partially denitrifying large wastewater treatment plant

Activated sludge modeling technology is maturing; however, currently, there exists a great need to increase its use in daily engineering practice worldwide. A good way for building the capacities of the practitioners is to promote good modeling practices and standardize the protocols. In this study, a systematic procedure was proposed to calibrate the Activated Sludge Model No. 1 (ASM1) at a large wastewater treatment plant, by which the model adequately predicted the quality of the effluent and the sludge quantities. A hydraulics model was set up and validated through a tracer test. The Vesilind settling constants were measured and combined with the default value of the flocculent zone settling parameter, to calibrate the clarifiers. A virtual anoxic tank was installed in the return activated sludge to mimic the denitrification occurring in the settlers. In ASM1, the calibrated parameters were only two influent chemical oxygen demand fractions and one kinetic constant (oxygen half-saturation coefficient).