Geotechnical properties of municipal solid waste at different phases of biodegradation

This paper presents the results of laboratory investigation conducted to determine the variation of geotechnical properties of synthetic municipal solid waste (MSW) at different phases of degradation. Synthetic MSW samples were prepared based on the composition of MSW generated in the United States and were degraded in bioreactors with leachate recirculation. Degradation of the synthetic MSW was quantified based on the gas composition and organic content, and the samples exhumed from the bioreactor cells at different phases of degradation were tested for the geotechnical properties. Hydraulic conductivity, compressibility and shear strength of initial and degraded synthetic MSW were all determined at constant initial moisture content of 50% on wet weight basis. Hydraulic conductivity of synthetic MSW was reduced by two orders of magnitude due to degradation. Compression ratio was reduced from 0.34 for initial fresh waste to 0.15 for the mostly degraded waste. Direct shear tests showed that the fresh and degraded synthetic MSW exhibited continuous strength gain with increase in horizontal deformation, with the cohesion increased from 1 kPa for fresh MSW to 16–40 kPa for degraded MSW and the friction angle decreased from 35° for fresh MSW to 28° for degraded MSW. During the triaxial tests under CU condition, the total strength parameters, cohesion and friction angle, were found to vary from 21 to 57 kPa and 1° to 9°, respectively, while the effective strength parameters, cohesion and friction angle varied from 18 to 56 kPa and from 1° to 11°, respectively. Similar to direct shear test results, as the waste degrades an increase in cohesion and slight decrease in friction angle was observed. Decreased friction angle and increased cohesion with increased degradation is believed to be due to the highly cohesive nature of the synthetic MSW. Variation of synthetic MSW properties from this study also suggests that significant changes in geotechnical properties of MSW can occur due to enhanced degradation induced by leachate recirculation.     

Spatial distribution of aerosol black carbon over India during pre-monsoon season

Aerosol black carbon (BC) mass concentrations ([BC]), measured continuously during a mutli-platform field experiment, Integrated Campaign for Aerosols gases and Radiation Budget (ICARB, March–May 2006), from a network of eight observatories spread over geographically distinct environments of India, (which included five mainland stations, one highland station, and two island stations (one each in Arabian Sea and Bay of Bengal)) are examined for their spatio-temporal characteristics. During the period of study, [BC] showed large variations across the country, with values ranging from 27 μg m^?3 over industrial/urban locations to as low as 0.065 μg m^?3 over the Arabian Sea. For all mainland stations, [BC] remained high compared to highland as well as island stations. Among the island stations, Port Blair (PBR) had higher concentration of BC, compared to Minicoy (MCY), implying more absorbing nature of Bay of Bengal aerosols than Arabian Sea. The highland station Nainital (NTL), in the central Himalayas, showed low values of [BC], comparable or even lower than that of the island station PBR, indicating the prevalence of cleaner environment over there. An examination of the changes in the mean temporal features, as the season advances from winter (December–February) to pre-monsoon (March–May), revealed that: (a) Diurnal variations were pronounced over all the mainland stations, with an afternoon low and a nighttime high; (b) At the islands, the diurnal variations, though resembled those over the mainlands, were less pronounced; and (c) In contrast to this, highland station showed an opposite pattern with an afternoon high and a late night or early morning low. The diurnal variations at all stations are mainly caused by the dynamics of local Atmospheric Boundary Layer (ABL). At the entire mainland as well as island stations (except HYD and DEL), [BC] showed a decreasing trend from January to May. This is attributed to the increased convective mixing and to the resulting enhanced vertical dispersal of species in the ABL. In addition, large short-period modulations were observed at DEL and HYD, which appeared to be episodic. An examination of this in the light of the MODIS-derived fire count data over India along with the back-trajectory analysis revealed that advection of BC from extensive forest fires and biomass-burning regions upwind were largely responsible for this episodic enhancement in BC at HYD and DEL.     

Assessing links between crop diversity and food self-sufficiency in three agroecological regions of Nepal

Increasing on-farm crop diversity is one agroecological approach to enhancing food self-sufficiency that helps small-scale farmers keep their food systems stable by reducing risks associated with stressors, such as a pest outbreaks or droughts. But understanding how crop diversity and food self-sufficiency are related is unknown. To explore this complex relation, this study presents household data (n = 1664) from Nepal to test the hypothesis that families with high crop diversity enjoy greater household food self-sufficiency. Data are presented for three districts that are representative of three distinct agroecological regions of the country: (1) Sarlahi, which is affluent, market-oriented, and on the plains; (2) Makwanpur District in the hills, which has well-developed integrated farm production; and (3) the mountainous District of Humla, which has the poorest quality environment and is the most remote. Results show that in the Humla District, families with greater crop diversity were more self-sufficient. In contrast, farmers in Makwanpur, who have already established a high degree of crop diversity based on vegetable production, do not benefit from additional crop diversity in terms of their ability to provide for themselves. Finally, data from Sarlahi show that families’ food self-sufficiency benefits from crop diversification. We conclude that boosting crop diversity is a viable strategy for maintaining stability in food systems, but this varies depending on the accessibility of a farm and, in particular, access to markets.     

Anaerobic and aerobic transformations affecting stability of dewatered sludge during long-term storage in a lagoon

The goal of this work was to study long-term behavior of anaerobically digested and dewatered sludge (biosolids) in a lagoon under anaerobic and aerobic conditions to determine the stability of the final product as an indicator of its odor potential. Field lagoons were sampled to estimate spatial and temporal variations in the physical-chemical properties and biological stability characteristics such as volatile solids content, accumulated oxygen uptake, and soluble protein content and odorous compound assessment. The analyses of collected data suggest that the surface layer of the lagoon (depth of above 0.15 m) undergoes long-term aerobic oxidation resulting in a higher degree of stabilization in the final product. The subsurface layers (depth 0.15 m below the surface and deeper) are subjected to an anaerobic environment where the conditions favor the initial rapid organic matter degradation within approximately the first year, followed by slow degradation.     

Spatio-Temporal Distribution of Polycyclic Aromatic Hydrocarbons (PAHs) in Atmospheric Air of Tamil Nadu,India, and Human Health Risk Assessment

This study analyzed the seasonal distribution and the possible sources of polycyclic aromatic hydrocarbons (PAHs) in the atmospheric environment of Tamil Nadu, India. Passive air sampling was performed at 32 locations during the period from April 2009 to January 2010, and PAHs were quantified using a gas chromatograph-mass spectrometer. Analysis showed that the concentrations of PAHs were in the range of 5–47.5 ng/m³ with uniform distribution in urban areas in all seasons. Pre-monsoon season showed the highest cumulative concentration of PAHs in both agricultural and coastal areas. Among PAHs, phenanthrene, fluoranthene, and pyrene levels were found to be predominant in all the samples, contributing up to 36%, 35.5%, and 24.5% of total PAHs, respectively. The signature of the PAHs obtained through diagnostic ratio and principal component analysis revealed that diesel emissions was the probable source of PAHs in all locations. Based on Word Health Organization guidelines, the human lung cancer risk due to observed level of PAH concentration (i.e., PAHs exposure) is meager. However, the risk is predicted to be more in the coastal area during summer (18 individuals among 0.1 million people). To the knowledge of these authors, this report is the first on the seasonal analysis of PAHs using passive air sampling in India.     

Stabilization and Solidification of Metal-Laden Wastes by Compaction and Magnesium Phosphate-Based Binder

ABSTRACT

Bench-scale and full-scale investigations of waste stabilization and volume reduction were conducted using spiked soil and ash wastes containing heavy metals such as Cd, Cr, Pb, Ni, and Hg. The waste streams were stabilized and solidified using chemically bonded phosphate ceramic (CBPC) binder, and then compacted by either uniaxial or harmonic press for volume reduction. The physical properties of the final waste forms were determined by measuring volume reduction, density, porosity, and compressive strength. The leachability of heavy metals in the final waste forms was determined by a toxicity characteristic leaching procedure (TCLP) test and a 90-day immersion test (ANS 16.1). The structural composition and nature of waste forms were determined by X-ray diffraction (XRD) and scanning electron microscopy (SEM), respectively.

CBPC binder and compaction can achieve 80-wt % waste loading and 39-47% reduction in waste volume. Compressive strength of final waste forms ranged from 1500 to 2000 psi. TCLP testing of waste forms showed that all heavy metals except Hg passed the TCLP limits using the phosphate-based binder. When Na₂S was added to the binder, the waste forms also passed TCLP limits for Hg. Long-term leachability resistance of the final waste forms was achieved for all metals in both soil and ash wastes, and the leachability index was ~14. XRD patterns of waste forms indicated vermiculite in the ash waste was chemically incorporated into the CBPC matrix. SEM showed that waste forms are layered when compacted by uniaxial press and are homogeneous when compacted by harmonic press.     

Bioavailability of dissolved organic nitrogen in treated effluents.

The research objective was to assess dissolved organic nitrogen (DON) bioavailability in wastewater effluents from a pilot-scale nitrification plant and a laboratory-scale total nitrogen (TN) removal plant. The DON bioavailability was assessed using a 14-day bioassay protocol containing bacterial and algal inocula. Nitrogen species, dissolved organic carbon, chlorophyll a, and biomass (as total suspended solids and culturable cell counts) concentrations were measured to assess DON bioavailability. The results showed an increase in algal chlorophyll a concentration, with a concurrent increase in algal biomass over time; increased bacterial counts and a decrease in DON concentration over time; and increased carbon-to-nitrogen ratio at the end of the 14-day bioassay, indicating effluent DON bioavailability to algae and bacteria. Approximately 18 to 61% of the initial DON in low-total-nitrogen wastewater effluent (TN = 4 to 5 mg/L) sample was bioavailable. The results show that bacteria and algae uptake and release DON during their growth.     

<Emphasis Type="Bold">Tracing lead contamination in foods in the city of Kolkata,India</Emphasis>

Lead isotopic ratios (LIR) of eight common food items, street dust, coal, diesel, sediments, lead ore and rainwater from India have been reported for the first time in this paper. This study characterized the source and extent of lead pollution in the different foodstuff consumed in Kolkata, a major metropolis of eastern India. The atmospheric lead input to the food items, sold openly in busy roadside markets of the city, has been quantified. The mean 207/206 and 208/206 LIRs of the eight food items ranged from 0.8847 to 0.8924 and 2.145 to 2.167, respectively. Diesel had the highest mean 207/206 and 208/206 values of 0.9015 and 2.1869, respectively, apart from the lead ore. The food items had a mean lead concentration between 3.78 and 43.35 mg kg^?1. The two ratio scatter plots of all the different environmental matrices were spread linearly between the uncontaminated Ichapur sediment and diesel. The 207/206 LIRs of the coal with a mean of 0.8777 did not fall in the linear trend, while the street dust and food samples overlapped strongly. The rainwater sample had a 207/206 LIR of 0.9007. Contaminated sediments in Dhapa, the repository of the city’s municipal garbage, had a mean 207/206 LIR of 0.8658. The corresponding value obtained from the sewage-fed vegetable grown there was 0.8058. The present study indicated that diesel was one of the main contributor to Pb pollution. The atmospheric lead contribution to the food items was in the range of 68.48–86.66 %.     

Biophysical and anthropogenic controls of forest fires in the Deccan Plateau, India

Forest fires constitute one of the most serious environmental problems in several forested regions of India. In the Indian sub-continent, relatively few studies have focused on the assessment of biophysical and anthropogenic controls of forest fires at a landscape scale and the spatial aspects of these relationships. In this study, we used fire count data sets from satellite remote sensing data covering 78 districts over four different states of the Deccan Plateau, India, for assessing the underlying causes of fires. Spatial data for explanatory variables of fires pertaining to topography, vegetation, climate, anthropogenic and accessibility factors have been gathered corresponding with fire presence/absence. A logistic regression model was used to estimate the probability of the presence of fires as a function of the explanatory variables. Results for fire area estimates suggested that, of the total fires covering 47,043km(2) that occurred during the year 2000 for the entire Indian region, 29.0% occurred in the Deccan Plateau, with Andhra Pradesh having 13.5%, Karnataka 14.7%, Kerala 0.1%, and Tamilnadu 1.15%. Results from the logistic regression suggest that the strongest influences on the fire occurrences were the amount of forest area, biomass densities, rural population density (PD), average precipitation of the warmest quarter, elevation (ELE) and mean annual temperature (MAT). Among these variables, biomass density (BD) and average precipitation of the warmest quarter had the highest significance, followed by others. These results on the best predictors of forest fires can be used both as a strategic planning tool to address broad scale fire risk concerns, and also as a tactical guide to help forest managers to design fire mitigation measures at the district level.     

Tillage management to mitigate herbicide loss in runoff under simulated rainfall conditions

Conservation tillage mitigates soil loss in cropland because plant residues help protect the soil, but effects on pesticide movement in surface runoff are not as straightforward. Effects of soil disturbance on surface runoff loss of chlorimuron and alachlor were evaluated utilizing runoff trays. Soil in the trays was either disturbed (tilled) and kept bare or was not tilled, and existing decomposed plant residue was left on the surface. Rainfall (25mm, 20min) was simulated 1d after alachlor (2.8kg ha(-1)) or chlorimuron (54g ha(-1)) application, and runoff was collected. Runoff fractions were analyzed for herbicide and sediment. Total alachlor loss from bare plots was greater than that in no-tillage plots (4.5% vs. 2.3%, respectively). More than one-third of total alachlor lost from bare plots occurred in the first l of runoff, while no-tillage plots had less runoff volume with a more even distribution of alachlor concentration in the runoff during the rainfall simulation and subsequent runoff period. In contrast, more chlorimuron was lost from no-tillage plots than bare plots (12% vs. 1.5%) even though total runoff volume was lower in the no-tillage plots (10.6mm vs. 13.6mm). This was attributed to dense coverage with partially decomposed plant residue in no-tillage plots (1652kg ha(-1)) that intercepted chlorimuron. It was likely that chlorimuron, a polar compound, was more easily washed off surface plant residues and transported in runoff.