Co-treatment of hydrogen sulfide and methanol in a single-stage biotrickling filter under acidic conditions

Biofiltration of waste gases is cost-effective and environment-friendly compared to the conventional techniques for treating large flow rates of gas streams with low concentrations of pollutants. Pulp and paper industry off-gases usually contain reduced sulfur compounds, such as hydrogen sulfide and a wide range of volatile organic compounds (VOCs), e.g., methanol. It is desirable to eliminate both of these groups of compounds. Since the co-treatment of inorganic sulfur compounds and VOCs in biotrickling filters is a relatively unexplored area, the simultaneous biotreatment of H2S and methanol as the model VOC was investigated. The results showed that, after adaptation, the elimination capacity of methanol could reach around 236 g m(-3) h(-1) with the simultaneous complete removal (100%) of 12 ppm H2S when the empty bed residence time is 24 s. The pH of the system was around 2. Methanol removal was hardly affected by the presence of hydrogen sulfide, despite the low pH. Conversely, the presence of the VOC in the waste gas reduced the efficiency of H2S biodegradation. The maximal methanol removal decreased somewhat when increasing the gas flow rate. This is the first report on the degradation of methanol at such low pH in a biotrickling filter and on the co-treatment of H2S and VOCs under such conditions.     

Binding affinity of proanthocyanidin from waste Pinus radiata bark onto proline-rich bovine achilles tendon collagen type I

Binding affinity of proanthocyanidin (PA) purified from Pinus radiata bark waste onto bovine Achilles tendon collagen (type I) was studied. Adsorption of PA onto the collagen was optimized by examining pH, contact time and temperature. The adsorption was pH-dependent. The maximum adsorption capacity (Q(0)) of PA on collagen was found to be 211 mg g(-1) using the Langmuir isotherm. Comparison between two adsorbents also showed that collagen had higher adsorptivity of approximately 20% more than PVPP (polyvinyl polypyrrolidone). The high affinity between PA and collagen was further confirmed in solvent solubility experiments. The observed solvent resistance was thought to be mainly due to a hydrophobic stacking mechanism reinforced by hydrogen bonding. FT-IR spectra clearly indicated the presence of PA adsorbed on collagen. The results have interesting implications that PA can be a good protective agent for collagen against collagenase and other enzymes.     

Estrogenic activity associated with organochlorine compounds in fish extracts from European mountain lakes

Fish muscle extracts from ten European mountain lakes were analyzed for organochlorine compounds (OCs) and estrogenic activity, the latter by a recombinant yeast assay based on the human estrogen receptor. Seventy percent of the samples showed estrogenic activity above detection limits and a subset of five samples showed estrogenic activities, equivalent to more than 10,000 pg/g of estradiol. These highly estrogenic samples occurred in two lakes, Velké Hin?ovo in the Tatra Mountains and Redon in the Pyrenees. Principal component analysis correlated estrogenic activity of muscle extracts to fish age and concentrations of the more chlorinated polychlorobiphenyls (PCBs). This is consistent with previously observed correlations of these PCBs with fish age. In addition, most fish with high estrogenic activity were found in lakes containing high OC levels in the sediments, which gives further ground to atmospheric deposition of anthropogenic pollutants as main process leading to the observed endocrine disruption effects.     

Management of MSW in Spain and recovery of packaging steel scrap

Packaging steel is more advantageously recovered and recycled than other packaging material due to its magnetic properties. The steel used for packaging is of high quality, and post-consumer waste therefore produces high-grade ferrous scrap. Recycling is thus an important issue for reducing raw material consumption, including iron ore, coal and energy. Household refuse management consists of collection/disposal, transport, and processing and treatment - incineration and composting being the most widely used methods in Spain. Total Spanish MSW production exceeds 21 million tons per year, of which 28.1% and 6.2% are treated in compost and incineration plants, respectively. This paper presents a comprehensive study of incineration and compost plants in Spain, including a review of the different processes and technologies employed and the characteristics and quality of the recovered ferrous scrap. Of the total amount of packaging steel scrap recovered from MSW, 38% comes from compost plants and 14% from incineration plants. Ferrous scrap from incineration plants presents a high degree of chemical alteration as a consequence of the thermal process to which the MSW is subjected, particularly the conditions in which the slag is cooled, and accordingly its quality diminishes. Fragmentation and magnetic separation processes produce an enhancement of the scrap quality. Ferrous scrap from compost plants has a high tin content, which negatively affects its recycling. Cleaning and detinning processes are required prior to recycling.     

Effects of sewage sludge blending on the coal combustion: a thermogravimetric assessment

Combustion of urban sewage sludge together with coal in existing infrastructures may be a sustainable management option energetically interesting for these materials, usually considered wastes. Thermogravimetric analysis was used to study the combustion of a semianthracite coal and the modifications undergone when adding a small percentage (2%, 5%, 10%) of sewage sludge. Both Differential Scanning Calorimetric analysis and Differential Thermogravimetry burning profiles showed differences between coal and sewage sludge combustion. However, the effects of adding a percentage of sewage sludge equal or smaller than 10% was hardly noticeable in terms of heat release and weight loss during the coal combustion. This was further proved by non-isothermal kinetic analysis, which was used to evaluate the Arrhenius activation energy corresponding to the co-combustion of the blends. This work shows that thermogravimetric analysis may be used as an easy rapid tool to asses the co-combustion of sewage sludge together with coal.     

Integrated catalytic wet air oxidation and aerobic biological treatment in a municipal WWTP of a high-strength o-cresol wastewater

This study examines the feasibility of coupling a Catalytic Wet Air Oxidation (CWAO), with activated carbon (AC) as catalyst, and an aerobic biological treatment to treat a high-strength o-cresol wastewater. Two goals are pursued: (a) To determine the effect of the main AC/CWAO intermediates on the activated sludge of a municipal WasteWater Treatment Plant (WWTP) and (b) To demonstrate the feasibility of coupling the AC/CWAO effluent as a part of the influent of a municipal WWTP. In a previous study, a high-strength o-cresol wastewater was treated by AC/CWAO aiming to establish the distribution of intermediates and the biodegradability enhancement. In this work, the biodegradability, toxicity and inhibition of the most relevant intermediates detected in the AC/CWAO effluent were determined by respirometry. Also, the results of a pilot scale municipal WWTP study for an integrated AC/CWAO-aerobic biological treatment of this effluent are presented. The biodegradation parameters (i.e. maximum oxygen uptake rate and oxygen consumption) of main AC/CWAO intermediates allowed the classification of the intermediates into readily biodegradable, inert or toxic/inhibitory compounds. This detailed study, allowed to understand the biodegradability enhancement exhibited by an AC/CWAO effluent and to achieve a successful strategy for coupling the AC/CWAO step with an aerobic biological treatment for a high-strength o-cresol wastewater. Using 30%, as COD, of AC/CWAO effluent in the inlet to the pilot scale WWTP, the integrated AC/CWAO-biological treatment achieved a 98% of total COD removal and, particularly, a 91% of AC/CWAO effluent COD removal without any undesirable effect on the biomass.     

Evaluation of natural and anthropogenic influences on the Guadalquivir River (Spain) by dissolved heavy metals and nutrients

To evaluate both the natural and anthropogenic influences on surface waters of Guadalquivir River (SW-Spain), concentrations of dissolved trace metals (Mn, Co, Ni, Cu, Cd, Zn, and Pb), inorganic nutrients (N-NH(4)(+), N-NO(3)(-), N-NO(2)(-), and P-PO(4)(3-)) and other variables as conductivity, pH, dissolved oxygen (DO) and suspended solids (SS) were measured during a three-years period (2001-2003). Samples were taken at 26 stations twice a year, during rain and dry periods. The analysis of variance (ANOVA) suggested that temporal variations within the period of study were statistically negligible. Spatial distributions identified three different zones, mainly influenced by sewage (Eastern Zone), agriculture runoffs (Central Zone), and estuarine processes (Western Zone), respectively. Principal Component and Cluster Analysis allowed to identify the variables controlling the water quality of each zone as: N-NH(4)(+), N-NO(2)(-), Mn, and Co, (Eastern Zone), SS, and P-PO(4)(3-) (Central Zone), and Cd, pH and conductivity (Western Zone). Other variables such as Ni, Cu, Zn or N-NO(3)(-), influenced two different zones, while Pb presented a singular behavior.     

Electrochemical and FTIR studies of the mutual influence of lead(II) or iron(III) and phenol on their adsorption from aqueous acid solution by modified activated carbons

Cyclic voltammetry and spectral FTIR studies of the influence of activated carbon surface modification on the co-adsorption of metal cation (lead or iron) and phenol from aqueous acidic solution were carried out. The diversity in surface chemical structure was achieved by applying different procedures of inorganic matter removal and by modifying the carbon samples in various ways: heating under vacuum, aminoxidation in an ammonia-oxygen atmosphere, oxidation with concentrated nitric acid. The quantities of adsorbed metal ions (Pb(2+) or Fe(3+)) and phenol from solutions containing cation or phenol separately or in a mixture were determined. The adsorption capacity from acidic aqueous acidic solution depends on the chemical properties of the activated carbon surface (e.g., decrease in phenol adsorption with relative lower basicity of the adsorbent). The electrochemical parameters of electrodes made from the carbon samples were estimated, and some possible electrochemical reactions were determined from voltammograms recorded in acid electrolyte solution containing adsorbed species (separately or as a mixture). Relationships were found between metal ion adsorption and electrochemical behavior of Pb(2+)/Pb(4+) and Fe(3+)/Fe(2+) couples on the one hand, and the presence of phenol in the solutions tested and the influence of surface chemistry of the carbon electrodes on electrochemical processes on the other. The changes in adsorption capacity with respect to the adsorbates used and the changes in FTIR spectra of the carbons as a result of adsorption and/or coupling phenol molecules are discussed.     

Biodegradability and ecotoxicity of amine oxide based surfactants

The aerobic and anaerobic biodegradability as well as the aquatic toxicity of two fatty amine oxides and one fatty amido amine oxide were investigated. Aerobic biodegradation was evaluated using the CO(2) headspace test (ISO 14593) and biodegradation under anaerobic conditions was assessed employing a standardised batch test. The three amine oxide based surfactants tested were readily biodegradable under aerobic conditions but only the alkyl amido amine oxide was found to be easily biodegradable under anaerobic conditions. Toxicity to Photobacterium phosphoreum and Daphnia magna was evaluated. Bacteria (EC(50) from 0.11 to 11 mg l(-1)) proved to be more sensitive to the toxic effects of the amine oxide based surfactants than crustacea (IC(50) from 6.8 to 45 mg l(-1)). The fatty amido amine oxide showed the lowest aquatic toxicity.     

Exposure to specific polychlorinated biphenyls and some chlorinated pesticides via breast milk in Poland

The aim of our study was to obtain the data on the exposure of breast-fed infants to polychlorinated biphenyls (PCBs) and selected organochlorine pesticides (OCPs) in the Wielkopolska province (Poland). The levels of indicator PCBs, and selected OCPs, including two DDT metabolites (HCB, p,p'-DDT, p,p'-DDD, p,p'-DDE and alpha,beta,gamma-HCH) were determined in 27 human milk samples, collected in 2000-2001, according to WHO protocol. Estimated daily intakes (EDIs) of all analytes were calculated. Our results were compared with those obtained by an analysis of human milk samples from other European and non-European countries, collected in the same period time. We have stated that median exposure of Wielkopolska first breast-fed infants to OCPs is comparable (EDI(HCB) = 0.086 microg/kgbw/day; EDI(beta-HCH)=0.063 microg/kgbw/day) or higher (EDI(p,p'-DDE) = 3.495 microg/kgbw/day) than in other European countries, while exposure to PCBs (EDI(Sigma7PCB) = 0.364 microg/kgbw/day) is situated at the low end of the intake of these xenobiotics by breast-fed infants from different regions of Europe.