Quantifying trace gas emissions from composite landscapes: A mass-budget approach with aircraft measurements

Quantifying trace gas emissions and the influence of surface exchange processes on the atmosphere is a necessary step towards the control of global greenhouse gas emissions and reliability of air quality models. This paper proposes a procedure based on the mass balance method and implemented on highly resolved aircraft data. It allows one to estimate surface exchanges on areas of several km² and heterogeneous features exploiting the characteristics of convective boundary layer during steady state conditions that permit the estimation of emission/absorption terms as functions of advective fluxes only. A nonparametric approach is adopted and the fluxes on the surface of a virtual box surrounding the area of interest are reconstructed on the basis of scalar densities and wind vectors using Shepard functions. Two different techniques are also proposed to face lack of data on the top surface of the box. The method has been applied to experimental data coming from measurement campaigns on two different sites. It provides realistic estimates of the CO₂ emission/absorption in the considered areas that are in good agreement with CO₂ fluxes evaluated by Airborne Eddy Covariance and confirm the suitability of the proposed approach for the assessment of turbulent exchange of trace gases by composite landscapes. Uncertainties on the estimated emissions due to both propagation of the experimental error and interpolation have been quantified by bootstrap analysis as 6%.     

Sea salt concentrations across the European continent

The oceans are a major source for particles that play an important role in many atmospheric processes. In Europe sea salt may contribute significantly to particulate matter concentrations. We have compiled sodium concentration data as a tracer for sea salt for 89 sites in Europe to provide more insight in the distribution of sea salt across Europe. The annual average sea salt concentrations above land were estimated to range between 0.3 and almost 13 μg m^?3. Maximum concentrations are found at the Irish coast. At coastal sites along the Atlantic and North Sea coast concentrations tend to be around 5 μg m^?3. More inland locations up to about 300 km away from the coast tend to show concentrations between 2 and 5 μg m^?3, whereas sites further away from the coast are characterized by lower concentrations. An analysis of the representativity of the data with respect to a long term average showed that the long average is associated with a standard deviation of around 15%. The compilation of observations provides an improved overview of sea salt concentrations in Europe as well as an improved basis for model validation. Verification of the results of the LOTOS-EUROS model learned that the model represents well the spatial variability of the observed sea salt concentrations very well. However, the absolute concentrations are significantly overestimated due to large uncertainties in the emission and dry deposition parameterizations. Using the high explained variability in the gradients across Europe, the bias-corrected modelled distribution serves as a best estimate of the sea salt distribution across Europe for 2005.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

Plant availability of bound anilazine residues in a degraded loess soil

Abstract

The relative biological availability of [benzene ring‐U‐¹⁴C] and Ctriazine‐U‐¹⁴C] anilazine for maize plants was studied in a degraded loess soil in a standardized microecosystem. The total uptake of radiocarbon in the course of the 4‐week experiment was 3.1 and 4 % respectively of the radioactivity applied if anilazine was uniformly mixed into the soil immediately before beginning the experiment. However, if anilazine was subjected to a degradation at 65 % of the maximum water holding capacity of the soil and temperatures varying daily between 16 and 27°C for 100 days before the plant experiment then the uptake was reduced to 0.4 or 0.7 % respectively. The uptake from soil with non‐extractable (bound) anilazine residues was similarly low. The mineralization rate of aged and bound anilazine residues was below 0.1 % of the radioactivity applied. Up to 2/3 of the radioactivity present in the soil after the plant experiment remained in the humic fraction.     

Phytoavailability and extractability of potassium,magnesium and manganese in calcareous soil amended with olive oil wastewater

Abstract

Land disposal of olive oil wastewater using it as a soil amendment requires a knowledge of the effects that its application may produce on the status of the mineral nutrients in the plant‐soil system. A pot experiment using calcareous soil was performed in a growth chamber to examine the effects of olive oil wastewater on the availability and postharvest soil extractability of K, Mg and Mn. The experiment included 6 treatments: two rates of olive oil wastewater, two mineral fertilizer treatments containing K (which supplied K in amounts equivalent to the K supplied by the olive oil wastewater treatments), a K‐free mineral fertilizer treatment, and a control. The pots were sown with ryegrass as the test plant, harvesting 3 times at intervals of one month. Olive oil wastewater has demonstrated a considerable capacity for supplying K that can be assimilated by the plant, tending in fact to surpass the mineral potassium fertilizer tested. The application of olive oil wastewater tends to reduce the concentration of Mg in the plant, similarly to the effect of adding mineral potassium fertilizer. An enhancement of Mn availability takes place in the soil amended with olive oil wastewater, which on occasion has produced Mn concentrations in plant that could be considered phytotoxic or at least excessive. After harvesting, we observed an increase in the amount of exchangeable K in soil with added industrial wastewater. However, these increases are lower than those in soil treated with mineral potassium fertilizer. The levels of exchangeable, carbonate‐bound, organic‐bound and residual Mg in soil were higher in treatments incorporating olive oil wastewater than in those with added mineral K, with the opposite tendency occurring in the amount of Fe‐Mn oxides‐bound Mg in soil. Treatments based on olive oil wastewater, especially in high doses, increased the amount of exchangeable and carbonate‐bound Mn in soil, in comparison with treatments adding mineral fertilizers with or without K. In contrast, the addition of industrial wastewater caused a drop in the amount of Fe‐Mn oxides‐bound and organic‐bound Mn in soil.     

A Multipurpose Flare Stack for Control of Chemical Process Wastes

Abstract

To test the effectiveness of California’s vehicle inspection/ maintenance (I/M) program, exclusive of vehicle-owner intervention, a fleet of more than 1,100 vehicles that previously had failed California’s Smog Check test were sent to randomly selected Smog Check stations in the Los Angeles area for covert inspections and repairs. The two-speed idle test was used for repairs. For those vehicles that were repaired at the first inspection, their FTP emission reductions were 25%, 14%, and 11% for hydrocarbons (HC), carbon monoxide (CO), and nitrogen oxides (NO_x), respectively, although emissions testing for NO_x was not performed at the Smog Check stations. Idle HC and CO emissions increased for 35% and 43% of the vehicles, respectively, after repairs. This data set shows that most vehicles that fail the Smog Check inspection are only marginal emitters, with 61% and 44% of the total potential for HC and CO emission reductions, respectively, coming from only 10% of the vehicles that currently fail the inspection. When the vehicles were rank-ordered by idle emissions from dirtiest to cleanest, emission reduction costs for the highest-emitting 10% of the fleet averaged $l,100/ton and $250/ton for HC and CO, respectively, attributing all the costs to each pollutant exclusively. For the remaining vehicles, costs increased dramatically.     

Sulfur Dioxide Removal and Recovery from Pulp Mill Power Plants

The use of soda ash liquor to scrub SO₂ rich power plant flue gases was studied using an Airetron pilot scrubber with a maximum capacity of 3000 cfm. The relative effects of the major operating variables— temperature, soda ash concentration, and the gas/liquid flow ratio—on the absorption phenomenon were determined. Orthogonal factorial experiments were used to derive a response function relating mass transfer values to operating variables. The economics of a full scale NSSC installation are discussed.     

Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.     

Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.     

Objective Evaluation of Emergency Plans for Oxidant Control

Emergency plans for oxidant controls provide the basis for taking preventive action to protect public health. Historic oxidant data (1970 to Sept. 1974) from the South Coast Air Basin (SCAB), were evaluated to assess episode characteristics in an area where emergency strategies are most likely to be enforced. These findings, together with an objective study of a test case episode (June 1974) using a photochemical air quality simulation model, suggest that the currently conceived emergency plans for oxidant control are unlikely to be effective. It is concluded that, because of the chemical and mefeorofogfcal complexities of the episodes, they are extremely difficult both to predict and concurrently to control over their short-lived duration.