Organochlorine contaminants in seabird eggs from the Pacific coast of Canada, 1971–1986

Eggs were collected from seven seabird species at colonies on the British Columbia coast from 1983 to 1986 and analyzed for organochlorine contaminants. Total PCB levels (wet weight) were highest in double-crested cormorants (Phalacrocorax auritus) from the Fraser estuary (2.91 mg kg^-1) and the Strait of Georgia (3.79 mg kg^-1). Highest DDE levels were in fork-tailed storm-petrels (Oceanodroma furcata) from the Queen Charlotte Islands (1.68 mg kg^-1). Organochlorine levels were generally lower in eggs from the mid 1980s than in those collected in the early 1970s. Organochlorine levels in Pacific alcids and hydrobatids foraging in offshore locations were compared to those in the same or ecologically similar species from the Canadian Atlantic coast. DDT- and HCH-related compounds were higher in Pacific populations while levels of dieldrin, oxychlordane, and HCB were generally lower. With the exception of -HCH, levels of all measured organochlorines were lower in cormorants breeding in the Fraser River estuary than in cormorants from the St. Lawrence River estuary on the Atlantic coast.     

An application of circular-linear correlation analysis to the relationship between Freon concentration and wind direction in Woods Hole,Massachusetts

Two statistical tests for correlation between a circular variate and a linear variate are presented. The tests are applied to a small data set concerning Freon-12 concentration and wind direction in Woods Hole, Massachusetts during the summer of 1987. A significant correlation is found. Further analysis suggests that this directional effect is related to onshore Freon-12 release.Woods Hole Oceanographic Institution Contribution Number 6750     

Exploring data quality for some inorganic and organic constituents of inhalable particulate matter (PM10)

Quality assurance (QA) assessments of air pollution data sets provide a basis for evaluating the significance of various substances in the atmosphere. For non-criteria pollutants, QA results are seldom reported in the technical literature and are often difficult to estimate. The present report provides a summary of QA results such as recovery, precision and accuracy data. Of the six trace elements and nine organic constituents compared in detail, recoveries, laboratory precision and laboratory accuracy values were 100%, ±3% to ±19% and-2 to-13% for the former group and 69% to 98%, ±7% to 23% and-15 to-34% for the later group. System precision varied from ±22% to ±47% for the trace elements and ±42% to ±83% for the organic constituents. Limitations in the interpretation of non-criteria particulate-phase pollutant data bases are discussed with some emphasis placed on receptor-modelling and risk assessment applications. Finally, the relevance of NBS certified materials for QA estimates in non-criteria air pollutant studies is also reviewed.     

Changes in levels of organochlorines in woodcock wings from 1971 to 1975

Wings from woodcock (Philohela minor) were first monitored for organochlorine pesticides and polychlorinated biphenyls (PCBs) in the eastern U.S. in 1971. Regional differences in these compounds were clearly demonstrated and baseline residue levels were obtained for later comparisons. An expanded sampling of wings in 1972 revealed that residues in wings of adult woodcock may differ significantly from those in immatures, and that residues of several important agricultural insecticides and PCBs had declined significantly. More extensive sampling was undertaken in 1975 to determine if changes in residue levels had taken place in the intervening years. PCBs, mirex, and heptachlor epoxide increased significantly between 1972 and 1975 in adult woodcock wings. In immature woodcock wings mirex, dieldrin, and PCBs increased significantly between 1972 and 1975, but DDT residues decreased significantly.     

Survey of the occurrence of residues of methyl tertiary butyl ether (MTBE) in Dutch drinking water sources and drinking water

An indicative survey has been carried out in The Netherlands investigating the presence of methyl tertiary butyl ether (MTBE) in drinking water and the corresponding sources. In total, 71 different sites used for the preparation of drinking water in The Netherlands were sampled in two successive seasons in 2001 involving the analysis of 156 samples. (ground water (n = 88), surface water (n = 17), bank filtrate water (n = 6) and drinking water (n = 45)). To combine high sample throughput with high selectivity and sensitivity, off-line purge and trap for sampling and gas chromatography mass spectrometry equipped with an automated thermal desorption sampler (TDS-GC-MS) was selected as the preferred analytical methodology. The developed procedure enabled the analysis of at least 40 samples per day and provided a limit of quantification of 2 ng l(-1). In the first period 63 samples of raw water were analyzed. Concentrations ranged between < 10 ng l(-1) and 420 ng l(-1) with a median concentration below 10 ng l(-1). The second period was focused at the re-sampling of positive locations (MTBE > 10 ng l(-1)) and a few additional drinking water utilities of which both the raw and drinking water of the utilities were analyzed. The median concentration of MTBE in the selected set of drinking water samples was 20 ng l(-1) (n = 45). At one location MTBE was found at a level of 2900 ng l(-1) caused by point source contamination of the ground water (11 900 ng l(-1)). Special attention has been paid to the quality of the results by analyzing all samples in duplicate and the analysis of control samples during each series of analyses.     

Water quality test based on dielectrophoretic measurements of fresh water algae Selenastrum capricornutum

A method is described whereby dielectrophoresis of algal cells is used to perform rapid water quality analysis, specifically detecting the presence of CuSO4. The dielectric collection spectrum of the fresh water alga Selenastrum capricornutum was determined for a range of concentrations of CuSO4 from 25 mg L(-1) to 0.25 mg L(-1) for exposure times of 15 min and 18 h. In all cases increasing the concentration of CuSO4 reduced cell collection, but a step reduction was observed in collection between 2 mg L(-1) and 5 mg L(-1). This method has potential for forming a rapid, low-cost test for water quality with broad specificity and significantly reduced analysis time compared to current methods.     

Sequential extractions of selenium soils from Stewart Lake: total selenium and speciation measurements with ICP-MS detection

Different techniques have been employed in order to evaluate the most efficient procedure for the extraction of selenium from soil as required for speciation. Selenium contaminated sediments from Stewart Lake Wetland, California were used. A strong acid mineralization of the samples gives quantitative total selenium, which is then used to estimate recoveries for the milder extraction methods. The different extraction methodologies involve the sequential use of water, buffer (phosphate, pH 7) and either acid solution (e.g. HNO3 or HCl) or basic solutions (e.g. ammonium acetate, NaOH or TMAH). Pyrophosphate extraction was also evaluated and showed that selenium was not associated with humic acids. The extractants were subsequently analyzed by size exclusion chromatography (SEC) with UV (254 and 400 nm) and on-line ICP-MS detection; anion exchange chromatography, and ion-pair reversed phase chromatography with ICP-MS detection. For sequential extractions the extraction efficiencies showed that the basic extractions were more efficient than the acidic. The difference between the acidic and the basic extraction efficiency is carried to the sulfite extraction, suggesting that whatever is not extracted by the acid is subsequently extracted by the sulfite. The species identified with the different chromatographies were selenate, selenite, elemental selenium and some organic selenium.     

The occurrence of acid precipitation on the west coast of the United States

Compilation of published and unpublished data shows acid precipitation to be more widespread in the Pacific coastal states than is generally recognized. Although information is scattered and discontinuous, precipitation is definitely acidic in the Los Angeles Basin and north-central california, and in the Puget Sound region in Washington. Acid rain occurrences have been observed in western and eastern Oregon, but data are inadequate for regional generalization. New stations currently being established in Washington and Oregon, largely in resposnse to the recently renewed activity of Mount St. Helens, will greatly facilitate assessment of precipitation acidity in the Northwest.     

Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.