Effect of pre-treatment and supporting media on Ni(II), Cu(II), Al(III) and Fe(III) sorption by plant root material

In this work Paspalum notatum root material was used to elucidate the influence of acid leaching pre-treatment and of sorption medium on metal adsorption. Ground P. notatum root was leached with 0.14M HNO(3). Leached root material (LRM) and non-leached root material (NLRM) were employed to flow sorption of Ni(II), Cu(II), Al(III) and Fe(III) in 0.5M CH(3)COONH(4) medium at pH 6.5. For LRM the sorption was also studied in 0.5M KNO(3) medium. The acid pre-treatment increased the sorption capacity (SC) for all ions studied. For the KNO(3) medium, Cu(II) and Fe(III) sorption was higher than in CH(3)COONH(4) and the type of the Ni(II) isotherm's model changed. The Freundlich model was the most representative isotherm model to describe metallic ions sorption. The (1)H NMR spectra showed differences between LRM and NLRM and the acid-basic potentiometric titration elucidated that acid-leaching procedure affected the root material sorption sites once only two predominant sorption sites were found for LRM (phenolic and amine, both able cations sorption) and five sorption sites (two carboxylic, amine and two phenolic) were founded for NLRM.     

Removal of dinitrotoluenes from water via reduction with iron and peroxidase-catalyzed oxidative polymerization: a comparison between Arthromyces ramosus peroxidase and soybean peroxidase

A two-step process for the removal of dinitrotoluene from water is presented: zero-valent iron reduction is coupled with peroxidase-catalyzed polymerization of the resulting diaminotoluenes (DAT). The effect of pH was examined in the reduction step: at pH 6 the reaction occurred much more rapidly than at pH 8. In the second step, optimal pH and substrate ratio, minimal enzyme concentration and effect of polyethylene glycol (PEG) as an additive for greater than 95% conversion of DAT, over a 3h reaction period were determined using high performance liquid chromatography. Two enzymes were investigated and compared: Arthromyces ramosus peroxidase (ARP) and soybean peroxidase (SBP). The optimal pH values were 5.4 and 5.2 for ARP and SBP, respectively, but SBP was more resistant to mild acid whereas ARP was more stable in neutral solutions. SBP was found to have a greater hydrogen peroxide demand (optimal peroxide/DAT molar ratio for SBP: 2.0 and 3.0 for 2,4-diaminotoluene (2,4-DAT) and 2,6-diaminotoluene (2,6-DAT), respectively; for ARP: 1.5 and 2.75 for 2,4-DAT and 2,6-DAT, respectively) but required significantly less enzyme (0.01 and 0.1 U ml(-1) for 2,4-DAT and 2,6-DAT, respectively) to convert the DAT than ARP (0.4 and 1.5 U ml(-1) for 2,4-DAT and 2,6-DAT, respectively). PEG was shown to have no effect upon the degree of substrate conversion for either enzyme.     

Biochemical responses in Salmo salar muscle following exposure to ethynylestradiol and tributyltin

This study investigated the effects of nominal concentrations of two endocrine-disrupting chemicals (EDCs) on fish physiology. The effects of the synthetic pharmaceutical estrogen ethynylestradiol (EE(2)) and the antifoulant tributyltin (TBT) were investigated in exposure studies with immature Atlantic salmon, Salmo salar. Fish were exposed for 7 days to waterborne EE(2), TBT, or a combination of both. The activities of lactate dehydrogenase (LDH), acetylcholinesterase (AchE) and glutathione S-transferase (GST), and lactate and glycogen content were determined in samples of fish muscle. Fish exposed to EE(2) for 3 days responded rapidly with increasing AchE and GST activities and increasing lactate content. These responses were limited to the first 3 days of exposure and had disappeared by day 7, indicating that the fish had adapted to EE(2) exposure. Compared to the controls, TBT increased AchE and LDH activity, inhibited GST activity and had no effect on lactate content. When mixed, the highest concentration of EE(2) increased the effect of TBT on lactate content. However, fish exposed to a lower concentration of EE(2) in combination with TBT had the lowest lactate content. Effects on AchE and LDH activities were smaller when TBT was combined with EE(2) compared to TBT alone. This suggests that TBT and EE(2) influence biochemical processes in fish muscle, acting on different organizational levels, by antagonistic and synergistic mechanisms.     

Effect of chelating agents and solubility of cadmium complexes on uptake from soil by Brassica juncea

Brassica juncea, or Indian mustard, was grown in soil artificially contaminated with either a soluble salt, CdCl(2), at 186mg Cdkg(-1), or alternately an insoluble, basic salt, CdCO(3), at 90mg Cdkg(-1). These experiments study the range of Cd uptake by Indian mustard from conditions of very high Cd concentration in a soluble form to the other extreme with an insoluble Cd salt. After plants were established, four different chelating agents were applied. Chelating agents increased plant uptake of Cd from the CdCl(2) soil but did not significantly increase plant uptake of Cd from the CdCO(3) contaminated soil. Addition of ethylenediaminetetraacetic acid (EDTA) increased the plant concentration of Cd by almost 10-fold in soils contaminated with CdCl(2), with a concentration of 1283mg Cdkg(-1) in the dried EDTA-treated plants over a concentration of 131mg Cdkg(-1) in plants without added chelate. However, EDTA increased the aqueous solubility of Cd by 36 times over the soil matrix without added chelator, and thereby, increased the possibility of leaching. Other chelators used in both experiments were ethylenebis(oxyethylenenitrilo)tetraacetic acid, trans-1,2-diaminocyclohexane-N,N,N',N'-tetraacetic acid, and diethylenetriaminepentaacetic acid (DTPA) increasing Cd in plants to 1240, 962, and 437mg Cdkg(-1), respectively. The other chelating agents increased the solubility of Cd in the leachate but not to the extent of EDTA. Comparing all chelating agents studied, DTPA increased plant uptake in terms of Cd in dried plant concentration most relative to the solubility of complexed Cd in runoff water.     

Challenges in quantifying biosphere-atmosphere exchange of nitrogen species

Recent research in nitrogen exchange with the atmosphere has separated research communities according to N form. The integrated perspective needed to quantify the net effect of N on greenhouse-gas balance is being addressed by the NitroEurope Integrated Project (NEU). Recent advances have depended on improved methodologies, while ongoing challenges include gas-aerosol interactions, organic nitrogen and N(2) fluxes. The NEU strategy applies a 3-tier Flux Network together with a Manipulation Network of global-change experiments, linked by common protocols to facilitate model application. Substantial progress has been made in modelling N fluxes, especially for N(2)O, NO and bi-directional NH(3) exchange. Landscape analysis represents an emerging challenge to address the spatial interactions between farms, fields, ecosystems, catchments and air dispersion/deposition. European up-scaling of N fluxes is highly uncertain and a key priority is for better data on agricultural practices. Finally, attention is needed to develop N flux verification procedures to assess compliance with international protocols.     

Comparison between the accumulation capacity of four lichen species transplanted to a urban site

The capacity to accumulate trace elements from the atmosphere of the lichens Hypogymnia physodes, Parmelia sulcata, Pseudevernia furfuracea and Usnea gr. hirta transplanted to an urban site of N Italy was compared. Twenty-nine elements (Al, As, Br, Ca, Cd, Ce, Cl, Co, Cr, Cs, Cu, Fe, Hg, I, K, La, Mg, Mn, Ni, Pb, Rb, Sb, Sc, Se, Sm, Th, Ti, V, Zn) were analyzed by Instrumental Neutron Activation Analysis (INAA) and Electro-Thermal Atomic Absorption Spectroscopy (ET-AAS). The ratio between the concentrations of each element in exposed samples to that of control samples (exposed-to-control ratio and EC ratio) was used to investigate the accumulation rates of lichen thalli. The results showed that in general elements did not exhibit well defined trends, but rather showed fluctuations, and indicated that H. physodes, P. furfuracea and U. gr. hirta have a similar accumulation capacity, while that of P. sulcata is lower.     

Using Lichen Chemistry to Assess Airborne Tungsten and Cobalt in Fallon, Nevada

This paper describes the use of lichen chemistry to assess airborne tungsten and cobalt in Fallon, Nevada, where a cluster of childhood leukemia has been on going since 1997. Lichens and their rock substrates were collected from Rattlesnake Hill within Fallon as well as from four different rock outcrops located north, east, south, and west of Fallon and at least 20 km away from the town center. In the lichens themselves, W and Co are significantly higher within Fallon than in the combined control site outside of Fallon. In the rock substrates of the lichens, no differences exist in W and Co. The W and Co differences in lichens cannot be attributed to substrate geochemistry. Fallon is distinctive in west central Nevada for high airborne W and Co, and given its cluster of childhood leukemia, it stands to reason that additional biomedical research is in order to test directly the leukogenicity of combined airborne W and Co.     

Validation of a European standard for the determination of hexavalent chromium in solid material

A European standard for the determination of Cr(vi) in solid material has been elaborated in the framework of an international co-operation and finally validated in the course of an interlaboratory comparison. The procedure is based on the alkaline digestion prescribed by EPA method 3060A followed by ion chromatography and determines an operationally defined content of Cr(vi), including water-soluble and insoluble chromates. A preliminary robustness study was carried out in order to compare different extraction methodologies and to study the equivalency of different analytical methods for the determination of Cr(vi) in alkaline extracts of soil and waste materials. During an interlaboratory validation trial with 19 European laboratories a set of 4 samples (2 soil and 2 waste samples) was analysed to determine performance characteristics for different combinations of digestion and detection methods. With the procedures prescribed by the new European standard (EN 15192) acceptable results were obtained for both soil samples and one of the waste samples (sludge). However, for the second waste sample (fly ash) a large deviation in analytical results was observed. This indicates that particularly for waste materials a possible occurrence of strong matrix effects has to be considered and supplementary quality control data are needed in order to assess the validity of analytical results. The accuracy of the determination of Cr(vi) in solid matrices remains a challenging field in terms of maximum extraction efficiency and minimum species interconversion.     

Bioaccumulation of anthropogenic contaminants by detritivorous fish in the Río de la Plata estuary: 1-aliphatic hydrocarbons

The temporal variability and bioaccumulation dynamics of C_12–25 n-alkanes, isoprenoids and unresolved aliphatic hydrocarbons (UCM) were studied in a detritivorous fish (Sábalo: Prochilodus lineatus) collected from 1999 to 2005 in the sewage impacted Buenos Aires coastal area. Fish muscles contain huge amounts of n-C_12–25 (165 ± 93, 70 ± 48 or 280 ± 134 μg g⁻¹, dry, fresh and lipid weight, respectively) and UCM (931 ± 560, 399 ± 288 and 1567 ± 802 μg g⁻¹) reflecting the chronic bioaccumulation of fossil fuels from sewage particulates. On a temporal basis, lipid normalized aliphatic concentrations peaked by the end of 2001–2002 during the rainiest period over the last four decades (1750 vs. 1083 ± 4.6 mm in 1999, 2004 and 2005), reflecting an enhanced exposition due to massive anthropogenic fluxes from Metropolitan Buenos Aires in wet years. The hydrocarbon composition in fish muscles is enriched in n-C_15–17 and isoprenoids relative to a fresh crude oil and settling particulates, with fresher signatures during the 2001–2002 maxima. Fish/settling material bioaccumulation factors (BAFs: 0.4–6.4 dry weight or 0.07–0.94 lipid-organic carbon) plotted against K_ow showed a parabolic pattern maximizing at n-C_14–18 and isoprenoids. The optimal bioaccumulation window corresponds to highly hydrophobic (log K_ow: 7.2–9.9), intermediate-size C_14–18 n-alkanes and C_15–20 isoprenoids (MW: 198–282; length: 17.9 to 25.4 Å) with melting points ranging from −19.8 to 28 °C. The uptake efficiency is inversely correlated to melting points and increased from 75% for n-C₂₅ to above 90% for n-C_14–15 and isoprenoids.     

Elimination of endocrine disrupting chemicals nonylphenol and bisphenol A and personal care product ingredient triclosan using enzyme preparation from the white rot fungus Coriolopsis polyzona

The biocatalytic elimination of the endocrine disrupting chemicals (EDC) nonylphenol (NP) and bisphenol A (BPA) and the personal care product ingredient triclosan (TCS) by the enzyme preparation from the white rot fungus Coriolopsis polyzona was investigated. Analysis of variance methodology showed that the pH and the temperature are statistically significant factors in the removal of NP, BPA and TCS. The elimination of NP and TCS was best at a temperature of 50 degrees C and the disappearance of BPA at 40 degrees C, whereas the most suitable pH for all three micropollutants was 5. After a 4-h treatment of the three target compounds at concentrations of 5 mg l(-1) all of the NP and BPA were eliminated. In the case of TCS, 65% was removed after either a 4 or an 8-h treatment. The utilisation of 2,2'-azino-bis(3-ethylbenzthiazoline-6-sulfonic acid) in the laccase/mediator system significantly increased the efficiency of the enzymatic treatment. The elimination of NP and BPA was directly associated with the disappearance of the estrogenic activity. Mass spectrometry analysis showed that the enzymatic treatment produced high molecular weight metabolites through a radical polymerization mechanism of NP, BPA and TCS. These oligomers were produced through the formation of C-C or C-O bonds. The polymerization of NP produced dimers, trimers, tetramers and pentamers which had molecular weights of 438, 656, 874 and 1092 amu respectively. The polymerization of BPA produced dimers, trimers and tetramers which had molecular weights of 454, 680 and 906 amu. Finally, the polymerization of TCS produced dimers, trimers and tetramers which had molecular weights of 574, 859 and 1146 amu.