PCDD/Fs, dioxin-like PCBs and marker PCBs in eggs of peregrine falcons from Germany

Thirty one egg samples of peregrine falcons were collected in different regions of Germany (South-West, North and East) and analysed for PCDD/Fs, PCBs and marker PCBs. Altogether, 37 PCB congeners were determined, allowing a more detailed discussion of different aspects of the relative importance of these individual congeners. For comparison with dioxin data from other studies, differences between toxic equivalency factors (TEF) have to be taken into consideration. The results of this study are discussed on the basis of WHO-TEFs for birds published in 1998. All samples showed high levels of PCDD/Fs (median of all samples: 368 pg WHO-PCDD/F-TEQ/g fat; range 137-1453) and even higher levels of PCBs (median 967 pg WHO-PCB-TEQ/g fat; range 243-7482). The upper range of these levels reach concentrations found at the beginning of the Belgian dioxin crisis when a significant reduction in hens' egg hatchability was observed. The relative contribution of PCBs to the total TEQ is on average 71% (range 55-92%) with a tendency to higher values in South-West Germany compared to different sites in East Germany or one site in northern Germany. Within a region, a wide range of contamination can be found. Even in the same cities (Stuttgart and Ludwigshafen), results derived from eggs collected in the same year (2003) varied by factors 5-10. These findings show the high degree of variation occurring even within the same kind of biological matrix. Therefore, to allow for comparison of regions or time trends, a considerable number of samples has to be analysed.     

Laboratory and field evaluation of crystallized DOW 704 oil on the performance of the Well Impactor Ninety-Six fFine particulate matter fractionator

Subsequent to the 1997 promulgation of the Federal Reference Method (FRM) for monitoring fine particulate matter (PM2.5) in ambient air, U.S. Environmental Protection Agency (EPA) received reports that the DOW 704 diffusion oil used in the method's Well Impactor Ninety-Six (WINS) fractionator would occasionally crystallize during field use, particularly under wintertime conditions. Although the frequency of occurrence on a nationwide basis was low, uncertainties existed as to whether crystallization of the DOW 704 oil may adversely affect a sampling event's data quality. In response to these concerns, EPA and the State of Connecticut Department of Environmental Protection jointly conducted a series of specialized tests to determine whether crystallized oil adversely affected the performance of the WINS fractionator. In the laboratory, an experimental setup used dry ice to artificially induce crystallization of the diffusion oil under controlled conditions. Using primary polystyrene latex calibration aerosols, standard size-selective performance tests of the WINS fractionator showed that neither the position nor the shape of the WINS particle size fractionation curve was substantially influenced by the crystallization of the DOW 704 oil. No large particle bounce from the crystallized impaction surface was observed. During wintertime field tests, crystallization of the DOW 704 oil did not adversely affect measured PM2.5 concentrations. Regression of measurements with crystallized DOW 704 versus liquid dioctyl sebacate (DOS) oil produced slope, intercept, and R2 values of 0.98, 0.1, and 0.997 microg/m3, respectively. Additional field tests validated the use of DOS as an effective impaction substrate. As a result of these laboratory and field tests, DOS oil has been approved by EPA as a substitute for DOW 704 oil. Since the field deployment of DOS oil in 2001, users of this alternative oil have not reported any operational problems associated with its use in the PM2.5 FRM. Limited field evaluation of the BGI very sharp cut cyclone indicates that it provides a viable alternative to the WINS fractionator.     

Synthesis of polyhydroxyalkanoates in municipal wastewater treatment.

Biologically derived polyesters known as polyhydroxyalkanoates (PHAs) represent a potentially "sustainable" replacement to fossil-fuel-based thermoplastics. However, current commercial practices that produce PHA with pure microbial cultures grown on renewable, but refined, feedstocks (i.e., glucose) under sterile conditions do not represent a sustainable commodity. Here, we report on PHA production with a mixed microbial consortium indigenous to an activated sludge process on carbon present in municipal wastewaters. Reactors operated under anaerobic/aerobic and aerobic-only mode and fed primary solids fermenter liquor maintained a mixed microbial consortium capable of synthesizing PHA at 10 to 25% (w/w), while reducing soluble COD by approximately 62 to 71%. More critically, an aerobic batch reactor seeded from the anaerobic/aerobic reactor and fed fermenter liquor achieved approximately 53% PHA (w/w). Results presented suggest that environmentally benign production of biodegradable polymers is feasible. We further used PHA-rich biomass to produce a natural fiber-reinforced thermoplastic composite that can be used to offset advanced wastewater treatment costs.     

The World Needs a New Energy Paradigm

During 19–20 October 2009, the Royal Swedish Academy of Sciences arranged the international symposium Energy 2050 in Stockholm. The symposium was held in association with the Swedish EU presidency in autumn 2009. Internationally renowned scientists assessed the energy issue in a broad perspective, with particular emphasis on the possibilities of a fossil-free future. The symposium focused on key topics emanating from the in-depth energy studies carried through by the Academy´s Energy Committee since 2005. The world community is facing a challenge of historic proportions to define a new energy paradigm based on fossil-energy substitutes. This article gives an overview of the current global energy situation (2007) and of the technologies which have the major potential for supplying energy up to year 2050 without jeopardizing the CO₂ emission targets.     

Comprehensive analysis of the carbon impacts of vehicle intelligent speed control

In recent years sophisticated technologies have been developed to control vehicle speed based on the type of road the vehicle is driven on using Global Positioning Systems and in-car technology that can alter the speed of the vehicle. While reducing the speed of road vehicles is primarily of interest from a safety perspective, vehicle speed is also an important determinant of vehicle emissions and thus these technologies can be expected to have impacts on a range of exhaust emissions. This work analyses the results from a very large, comprehensive field trial that used 20 instrumented vehicles with and without speed control driven almost 500,000 km measuring vehicle speed at 10 Hz. We develop individual vehicle modal emissions models for CO₂ for 30 Euro III and Euro IV cars at a 1-Hz time resolution. Generalized Additive Models were used to describe how emissions from individual vehicles vary depending on their driving conditions, taking account of variable interactions and time-lag effects. We quantify the impact that vehicle speed control has on-vehicle emissions of CO₂ by road type, fuel type and driver behaviour. Savings in CO₂ of ≈6% were found on average for motorway-type roads when mandatory speed control was used compared with base case conditions. For most other types of road, speed control has very little effect on emissions of CO₂ and in some cases can result in increased emissions for low-speed limit urban roads. We also find that there is on average a 20% difference in CO₂ emission between the lowest and highest emitting driver, which highlights the importance of driver behaviour in general as a means of reducing emissions of CO₂.     

Characterization of Fine Particulate Matter Produced by Combustion of Residual Fuel Oil

ABSTRACT

Combustion experiments were carried out on four different residual fuel oils in a 732-kW boiler. PM emission samples were separated aerodynamically by a cyclone into fractions that were nominally less than and greater than 2.5 |j.m in diameter. However, examination of several of the samples by computer-controlled scanning electron microscopy (CCSEM) revealed that part of the PM_2.5 fraction consists of carbonaceous cenospheres and vesicular particles that range up to 10 |j.m in diameter. X-ray absorption fine structure (XAFS) spectroscopy data were obtained at the S, V, Ni, Fe, Cu, Zn, and As K-edges and at the Pb L-edge. Deconvolution of the X-ray absorption near edge structure (XANES) region of the S spectra established that the dominant molecular forms of S present were sulfate (26-84% of total S) and thiophene (13-39% of total S). Sulfate was greater in the PM_2.5 samples than in the PM₂₅₊ samples. Inorganic sulfides and elemental sulfur were present in lower percentages. The Ni XANES spectra from all of the samples agreed fairly well with that of NiSO₄, while most of the V spectra closely resembled that of vanadyl sulfate (VO?SO₄?xH₂O). The other metals investigated (i.e., Fe, Cu, Zn, and Pb) also were present predominantly as sulfates. Arsenic was present as an arsen-ate (As⁺⁵). X-ray diffraction patterns of the PM_2.5 fraction exhibit sharp lines due to sulfate compounds (Zn, V, Ni, Ca, etc.) superimposed on broad peaks due to amorphous carbons. All of the samples contain a significant organic component, with the loss on ignition (LOI) ranging from 64 to 87% for the PM_2.5 fraction and from 88 to 97% for the PM_2.5+ fraction. Based on ¹³C nuclear magnetic resonance (NMR) analysis, the carbon is predominantly condensed in graphitic structures. Aliphatic structure was detected in only one of seven samples examined.     

The effects of triclopyr on 2,4‐D mineralization in two soils

Abstract

The effects of the herbicide triclopyr (3,5,6‐trichloro‐2‐pyridinyloxyacetic acid) on the mineralization of 2,4‐D (2,4‐dichlorophenoyxacetic acid) in two soils which differed in their histories of prior exposure to the two herbicides were investigated. The relative effects of triclopyr on 2,4‐D mineralization and most probable numbers of 2,4‐D degraders were dependent upon the soil. Triclopyr was shown to increase 2,4‐D mineralization rates in a soil which had been exposed to both 2,4‐D and triclopyr, but decreased the mineralization rate of 2,4‐D and inhibited the increase of most probable numbers of 2,4‐D degraders in a soil that had not been directly exposed to either herbicide.     

Integrating economic costs into the analysis of flexible conservation management strategies.

Flexible conservation management, where measures (e.g., mowing of meadows, removing invasive species) are selected in each decision period depending on the current state of the ecological system, is generally perceived as superior to fixed management, where the same measure is applied in each decision period independent of the current state of the system. In past comparisons of fixed and flexible conservation strategies the additional costs that arise only in flexible strategies have usually been ignored. In this paper, we present a framework to integrate costs of flexible management into the evaluation of flexible conservation strategies. Using the example of an endangered butterfly species we demonstrate that the costs of flexible management may reverse the rank order of flexible and fixed conservation strategies, such that fixed strategies may lead to better ecological results than flexible ones for the same financial budget.     

Parameterizing,evaluating and comparing metapopulation models with data from individual-based simulations

Due to the lack of sufficient data and appropriate ecological information parameterizing predictive population dynamical models usually is a difficult task. The approach proposed in this study is meant to overcome this problem by using detailed individual-based simulations to generate artificial data. With short-term data samples, the models to be investigated can be parameterized and their predictions be compared. The flexibility of individual-based simulations as experimental tools also facilitates the evaluation and comparison of different (aggregated) model types. The presented approach is a step towards unifying models of different complexity. As an example we applied it to two metapopulation models of insect species in a highly fragmented landscape: the well-known incidence function model with a patch-based representation of space and a grid-based analogue. The models are tested with respect to their data requirement and recommendations for a better data sampling are derived.