The comparison of fossil carbon fraction and greenhouse gas emissions through an analysis of exhaust gases from urban solid waste incineration facilities

In this study, in order to understand accurate calculation of greenhouse gas emissions of urban solid waste incineration facilities, which are major waste incineration facilities, and problems likely to occur at this time, emissions were calculated by classifying calculation methods into 3 types. For the comparison of calculation methods, the waste characteristics ratio, dry substance content by waste characteristics, carbon content in dry substance, and ¹²C content were analyzed; and in particular, CO₂ concentration in incineration gases and ¹²C content were analyzed together. In this study, 3 types of calculation methods were made through the assay value, and by using each calculation method, emissions of urban solid waste incineration facilities were calculated then compared. As a result of comparison, with Calculation Method A, which used the default value as presented in the IPCC guidelines, greenhouse gas emissions were calculated for the urban solid waste incineration facilities A and B at 244.43 ton CO₂/day and 322.09 ton CO₂/day, respectively. Hence, it showed a lot of difference from Calculation Methods B and C, which used the assay value of this study. It is determined that this was because the default value as presented in IPCC, as the world average value, could not reflect the characteristics of urban solid waste incineration facilities. Calculation Method B indicated 163.31 ton CO₂/day and 230.34 ton CO₂/day respectively for the urban solid waste incineration facilities A and B; also, Calculation Method C indicated 151.79 ton CO₂/day and 218.99 ton CO₂/day, respectively.

Implications: This study intends to compare greenhouse gas emissions calculated using ¹²C content default value provided by the IPCC (Intergovernmental Panel on Climate Change) with greenhouse gas emissions calculated using ¹²C content and waste assay value that can reflect the characteristics of the target urban solid waste incineration facilities. Also, the concentration and ¹²C content were calculated by directly collecting incineration gases of the target urban solid waste incineration facilities, and greenhouse gas emissions of the target urban solid waste incineration facilities through this survey were compared with greenhouse gas emissions, which used the previously calculated assay value of solid waste.     

Risk of serious injury of occupants involved in frontal crashes of cab-over-type trucks

Objectives: Truck vehicles (TVs) have a different structure and stiffness than non-TVs and are used commercially for transporting goods. This study aimed to analyze whether truck occupants have a greater risk of serious injury than those of other types of vehicles.

Methods: Crash data were obtained from the Korean In-Depth Data Analysis Study (KIDAS) for calendar years 2011–2016. Vehicles involved in frontal crash were included and classified into TVs and non-TVs (passenger cars and sports utility vehicles). We compared the demographic characteristics and serious injuries by body region between the 2 groups and analyzed factors that contributed to the serious injury severity from frontal crashes.

Results: The analysis was based on 884 occupants; 177 (20.0%) were in TVs and 707 (80.0%) were in non-TVs. Non-TVs had more frontal airbags deployments than TVs (50.9% vs. 3.4%, P <.01). TV occupants were 4.8 times more likely to have a serious lower extremity (LE) injury (adjusted odds ratio [AOR] = 4.820; 95% confidence interval [CI], 2.407–9.653) and 2.5 times to have a serious abdominal injury (AOR = 2.465; 95% CI, 1.108–5.487) compared to non-TV occupants.

Conclusions: Truck occupants had more serious LE and abdominal injuries than those of other types of vehicles in frontal crashes. Structural improvement and legislative efforts to develop safety systems are necessary to improve the safety of truck occupants.     

Congener-specific accumulation and environmental risk assessment of polybrominated diphenyl ethers in diverse Korean sewage sludge types

Industrial, domestic wastewater, and livestock sludge samples were collected from 23 wastewater treatment plants in Korea and analyzed for polybrominated diphenyl ethers (PBDEs). The concentrations of Σ₁₉PBDE ranged from 4.01 to 10,400 ng/g dry weight. The average Σ₁₉PBDE concentrations in industrial, domestic wastewater, and livestock sludge were 1,560?±?3,610, 402?±?148, and 27.6?±?50.4 ng/g dry weight, respectively. The composition of PBDEs differed according to the type of sludge. Among the PBDE congeners, BDE 209 was dominant in all sludge samples. After BDE 209, relatively high levels were found for BDE 28 and 47 from industrial sludge, BDE 47 and 99 from domestic wastewater sludge, and BDE 206, 207, and 208 from livestock sludge. Using hierarchical cluster analysis, sludges were divided into three groups according to PBDE congener composition. A risk assessment of PBDEs in sludge used for soil amendment was carried out. Preliminary results indicated that the potential risk of soil exposed to PBDEs in sludge was relatively low.     

Ozone Artifacts and Carbonyl Measurements Using Tenax GR,Tenax TA,Carbopack B,and Carbopack X Adsorbents

Abstract

Four popular thermally desorbable adsorbents used for air sampling (Tenax TA, Tenax GR, Carbopack B, and Carbopack X) are examined for the potential to form artifacts with ozone (O₃) at environmental concentrations. The performance of these adsorbents for the ketone and alde-hyde species identified as O₃-adsorbent artifacts was also characterized, including recovery, linearity, and method detection limits (MDLs). Using gas chromatography/mass spectrometry, 13 different artifacts were identified and confirmed for both Tenax TA and Tenax GR, 9 for Carbopack B, but none for Carbopack X. Several O₃ artifacts not reported previously were identified, including: pentanal, 3-hexanone, 2-hexanone, hexanal, 3-heptanone, and heptanal with Tenax TA; pentanal, 3-hexanone, 2-hexanone, hexanal, and 3-heptanone on Tenax GR; and 1-octene and 1-nonene with Carbopack B. Levels of straight-chain aldehyde artifacts rapidly diminished after a few cycles of adsorbent conditioning/O₃ exposure, and concentrations could be predicted using a first-order model. Phenyl-substituted carbonyl artifacts (benzalde-hyde and acetophenone) persisted on Tenax TA and GR even after 10 O₃ exposure-conditioning cycles. O₃ breakthrough through the adsorbent bed was most rapid in adsorbents that yielded the highest levels of artifacts. Overall, artifact composition and concentration are shown to depend on O₃ concentration and dose, conditioning method, and adsorbent type and age. Calibrations showed good linearity, and most compounds had reasonable recoveries, for example, 90 ±15% for Tenax TA, 97 ±23% for Tenax GR, 101 ±24% for Carbopack B, and 79 ±25% (91 ±9% for n-aldehydes) for Carbopack X. Benzeneacetaldehyde recovery was notably poorer (22–63% across the four adsorbents). MDLs for several compounds were relatively high, up to 5 ng. By accounting for both artifact formation and method performance, this work helps to identify which carbonyl compounds can be measured using thermally desorbable adsorbents and which may be prone to bias because of the formation of O_3- adsorbent artifacts.     

pH-gradient real-time aeration control for nitritation community selection in a non-porous hollow fiber membrane biofilm reactor (MBfR) with dilute wastewater

Nitritation (ammonium to nitrite) as a pre-treatment of Anammox (anaerobic ammonium oxidation) is a key step for an energy-efficient nitrogen-removal alternative from dilute wastewaters, e.g. anaerobically-treated sewage, with which limited study has achieved sustainable nitritation at ambient temperature and short hydraulic retention times. To this end, pH-gradient real-time aeration control in an oxygen-based membrane biofilm reactor was observed at 20 °C in the sequencing batch mode. An optimum oxygen supply via diffusion for ammonium-oxidizing bacteria (AOB) was established, but nitrite-oxidizing bacteria (NOB) could be inhibited. The system achieved nitrite accumulation efficiencies varying from 88% to 94% with the aeration control. Mass balance and rate performance analyses indicate that this aeration control is able to supply an oxygen rate of 1.5 mol O₂ mol^?1 ammonium fed, the benchmark oxygenation rate based on stoichiometry for nitritation community selection. Microbial analyses confirmed AOB prevalence with NOB inhibition under this aeration control.     

Distribution features of biological hazardous pollutants in residential environments in Korea

This research has been conducted continuously since 2009 as part of a cohort of studies examining relationships between asthma and genetic factors, dietary habits, and environmental factors. Based on data from environmental research on house dust mites and endotoxins, which are widely known as pollutants in bedding that cause asthma in pregnant women and children, this work was conducted to obtain basic data that can be used in future cohort studies that analyze links between distribution of biological hazards and physical features of residential environments. The detection rates of house dust mite allergens, Der p1 and Der f1, were 52.7 and 86.5 %, respectively, indicating that Der f1 is a dominant species in domestic indoor environments. According to comparisons between concentrations of house dust mites and endotoxins in bedding of pregnant women and children, Der p1 and endotoxins showed significantly lower concentrations in bedding of pregnant women compared with those in bedding of children, whereas Der f1 showed no significant difference in concentration according to bedding.     

Source Profiles of Particulate Matter Emissions from a Pilot-Scale Boiler Burning North American Coal Blends

ABSTRACT

Recent awareness of suspected adverse health effects from ambient particulate matter (PM) emission has prompted publication of new standards for fine PM with aerodynamic diameter less than 2.5 μm (PM_2.5). However, scientific data on fine PM emissions from various point sources and their characteristics are very limited. Source apportionment methods are applied to identify contributions of individual regional sources to tropospheric particulate concentrations. The existing industrial database developed using traditional source measurement techniques provides total emission rates only, with no details on chemical nature or size characteristics of particulates. This database is inadequate, in current form, to address source-receptor relationships.

A source dilution system was developed for sampling and characterization of total PM, PM_2.5, and PM₁₀ (i.e., PM with aerodynamic diameter less than 10 μm) from residual oil and coal combustion. This new system has automatic control capabilities for key parameters, such as relative humidity (RH), temperature, and sample dilution. During optimization of the prototype equipment, three North American coal blends were burned using a 0.7-megawatt thermal (MW_t) pulverized coal-fired, pilot-scale boiler. Characteristic emission profiles, including PM_2.5 and total PM soluble acids, and elemental and carbon concentrations for three coal blends are presented.     

The characteristics of fatal occupational injuries in Korea’s construction industry, 1997–2004

This study is aimed at exploring the characteristics of fatal occupational injuries in Korea’s construction industry and comparing the causes in various occupations within that industry. There were 10,276 fatal occupational injury victims in Korea over 8 years (1997–2004). The mortality risk due to injuries in construction and non-construction industries was calculated, and their causes were compared. The number of victims of fatal occupational injuries in the construction industry was 4333 (42.2% of the total fatal occupational injuries), and the 1 year mortality risk was higher (23.7/100,000 persons) than in non-construction industries (10.4). Falling was the most frequent (52.7%) cause of fatal injuries. In addition, deaths due to structural collapse and electric shock were significantly higher than in other industries. When the distribution of the causal factors in various occupations within the construction industry was investigated, some factors appeared more frequently in certain occupations than in others. As the construction industry encompasses a large proportion of occupational injuries, a reduction in this field alone will substantially contribute to an overall reduction of occupational injuries in Korea. Further research for effective prevention is needed.     

Characteristics of contaminants in water and sediment of a constructed wetland treating piggery wastewater effluent

Constructed wetland (CW) is the preferred means of controlling water quality because of its natural treatment mechanisms and function as a secondary or tertiary treatment unit. CW is increasingly applied in Korea for secondary effluent of livestock wastewater treatment. This study was conducted to recognize the characteristics of contaminants in the accumulated sediment at the bottom soil layer and to reduce the phosphorus release from sediments of the free water surface CW for the treatment of secondary piggery wastewater effluent from a livestock wastewater treatment facility. The results revealed that the dominant phosphorus existence types at near the inlet of the CW were non-apatite phosphorus (59%) and residual phosphorus (32%) suggesting that most of the particles of the influent are made up of inorganic materials and dead cells. Sediment accumulation is important when determining the long-term maintenance requirements over the lifetime of CW. Continuous monitoring will be performed for a further assessment of the CW system and design.