RPB-O3/H2O2法处理硝基苯模拟废水

在超重力场中,研究了硝基苯模拟废水的臭氧/双氧水(O3/H2O2)法处理效果,考察了超重力因子β、H2O2浓度、初始p H、液体流量及处理时间等因素对硝基苯去除率的影响。结果表明,硝基苯去除率随超重力因子β和处理时间的增加而增大,而随H2O2浓度、初始p H和液体流量的增加呈先增大后降低的趋势。当硝基苯初始浓度300 mg/L,工艺条件β=80、p H=10.0、臭氧质量浓度约为40 mg/L、H2O2浓度为4.9 mmol/L、液体流量为120 L/h时,循环处理35 min硝基苯去除率可达96.7%。处理时间60 min后,废水中硝基苯含量1.4 mg/L,COD为39 mg/L,达国家一级排放标准(GB 8978-1996)。在此条件下,硝基苯的降解过程符合准一级反应动力学。     

改性硅胶对水溶液中Pd2+的吸附

采用氨基硫脲对硅胶进行改性并表征,探讨了改性硅胶(SG-TSC)对水溶液中Pd2+的吸附性能。实验考察了p H值、吸附剂质量、吸附时间以及Pd2+初始浓度等因素对吸附的影响,并探讨了SG-TSC对Pd2+吸附动力学及等温吸附特性。结果表明:在p H为3~6范围内,吸附效果最好。吸附平衡时间为90 min,吸附动力学符合二级速率方程,颗粒内扩散与液膜扩散共同影响着吸附过程。Langmuir等温吸附方程能较好地描述Pd2+在SG-TSC上的吸附特性,298 K时静态饱和吸附容量为0.105 mmol/g。热力学参数计算结果表明,SG-TSC吸附水溶液中的Pd2+是自发、吸热和熵值增加的过程。     

絮团粘性分维数的概念及其分析模型

水处理中的絮团具有复杂的形态结构,分维数是描述这种结构的有力工具。通过分析固液体系的粘度与絮团分维数之间的关系,提出了絮团粘性分维数的新概念及粘性分维数测定的数学物理模型,并进行了实验验证。与常用的质量分维数、边界分维数、面积分维数、体积分维数、表面积分维数等相比,絮团的粘性分维数及其测定模型具有易于测量、可同时表征不同类型絮团、可定量分析絮凝产品组成等特点,从而为絮团形态结构的定性及定量研究开辟了新的途径。     

路面径流的大肠菌群污染及其雨水花园处理

调查了上海市区路面径流中大肠菌群的污染状况,分析了径流中大肠菌群含量的主要影响因素,采用雨水花园模拟柱,考察雨水花园对城市路面径流中大肠菌群的去除效果。结果表明,上海市区地面道路径流中总大肠菌群、粪大肠菌群的均值分别为2.28×106、9.48×105 cfu/100 mL,污染较严重,径流中大肠菌群含量与气温呈正相关;雨水花园对径流中大肠菌群具有良好的去除效果,不同模拟柱平均去除率范围在92.4%~99.5%。填料深度和水力停留时间是影响雨水花园对大肠菌群去除效果的主要因素。长期运行后,填料中没有大肠菌群的积累,雨水花园对大肠菌群的去除效果可保持长期稳定。     

改性丝瓜络纤维对水体日落黄的吸附特性

采用化学改性的方法将丝瓜络制备为阴离子吸附剂,并将其用于水体日落黄(SY)染料的吸附,分别考察了吸附剂的用量、日落黄染料的初始浓度(C0)、pH值、温度(K)、时间(T)5个因素对吸附效果的影响。通过模拟吸附等温曲线、吸附动力学以及热力学方程并通过比表面积(BET)和红外光谱(FTIR)分析改性丝瓜络吸附染料前后和丝瓜络改性前后的变化情况以此探究其吸附机理。结果表明,pH对吸附效果影响不明显;最大吸附量随温度升高而增大,在298 K温度时最大吸附量达到137 mg/g,是未改性丝瓜络的9.78倍。Langmuir方程拟合吸附过程描述最好,吸附类别为化学吸附。吸附过程符合伪二级动力学,是一个自发和吸热的过程。改性丝瓜络可以有效去除水体中的日落黄染料。     

硅藻土固定化颗粒污泥对海水养殖废水除氨性能

针对实际海水养殖废水低碳高氮的特点,采用间歇式活性污泥法(SBR)和好氧活性污泥添加硅藻土载体的方式,考察硅藻土载体和活性污泥共同作用下的好氧曝气系统对海水养殖废水中氨态氮(NH4+-N)、亚硝酸态氮(NO2--N)和化学耗氧量(COD)的去除效果,以及对污泥沉降性能和硝化细菌特征的影响。实验结果表明,常温条件下,溶解氧(DO)≥ 4.5 mg/L,pH控制在7.0 ~ 8.0,HRT为11 h,沉降时间10 min,反应器可以处理NH4+-N浓度在50 mg/L左右的海水养殖废水,NH4+-N和COD去除率分别达到98.93%左右和76.62%以上,NO2--N出水浓度低于0.028 mg/L。载体污泥颗粒照片和扫描电镜结果表明,添加硅藻土载体内核后,颗粒污泥的成熟期缩短,颗粒的稳固度和沉降性能提高。在系统启动成功稳定运行后,通过FISH分析表明,在氨氧化菌(AOB)与亚硝酸盐氧化菌(NOB)成为优势菌群后,AOB大约占总菌群的33.5%,并且AOB与NOB菌群数量约为1:1.33,AOB和NOB两大类菌群之和约占总菌群的77.2%,成为系统中优势菌群。     

3种组合工艺处理农村生活污水

进行了厌氧折流板反应器-垂直潜流人工湿地(ABR-VSFCW)、复合厌氧反应器-水平潜流人工湿地(HAR-HSFCW)、膨胀颗粒污泥床-人工快速渗滤系统(EGSB-CRI)3种组合工艺处理农村生活污水的研究。结果表明,在温度为10~29℃,进水COD为325.3~386.5 mg/L的条件下,3种组合工艺对COD均有较高的处理效果,当厌氧段HRT大于16 h时,3种组合工艺出水COD浓度均达到了我国《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级B标准;EGSB-CRI、HAR-HSFCW对TP的去除效果较好,出水TP浓度均达到了我国《城镇污水处理厂污染物排放标准》(GB 18918-2002) 一级B标准, 且显著优于ABR-VSFCW,ABR-VSFCW出水TP浓度达到了二级标准; ABR-VSFCW、HAR-HSFCW、EGSB-CRI出水NH4+-N浓度分别为25.24~42.20、29.59~41.60和9.80~15.35 mg/L,其出水NH4+-N浓度达到了我国《城镇污水处理厂污染物排放标准》(GB 18918-2002)二级标准;3种组合工艺对TN的去除效果无明显差异,去除率仅为23.9%~46.4%。因此,EGSB-CRI对农村生活污水的处理效果最好,HAR-HSFCW次之,ABR-VSFCW较差。     

复合钙基固硫添加剂对煤固硫与燃烧的影响

利用程序升温燃烧反应技术,考察了高岭土复合的CaO、Fe2O3-CaO、CoO-CaO添加剂对无烟煤的燃烧以及固硫的影响。实验发现,这些添加物质对煤的裂解产物的燃烧都具有促进作用,除了Fe2O3-CaO-高岭土复合添加剂对煤焦的燃烧有一定阻碍作用之外,其余都具有对煤焦燃烧的促进作用,尤以CoO-CaO-高岭土复合添加剂的效果最为显著。高岭土复合的硫酸钙本应具有较高的热稳定性,但受到高温下煤焦与CO的还原而分解,所以添加对煤焦具有明显催化燃烧作用的氧化钴,因减少了还原性气氛,稳定了硫酸钙产物而促进了固硫。     

Classification and comparison of municipal solid waste based on thermochemical characteristics

Municipal solid waste (MSW) has been normally sorted into six categories, namely, food residue, wood waste, paper, textiles, plastics, and rubber. In each category, materials could be classified further into subgroups. Based on proximate and ultimate analysis and heating value, statistical methods such as analysis of variance (ANOVA) and cluster analysis were applied to analyze the characteristics of MSW in every subgroup and to try to distinguish their relative properties. The chemical characteristics analysis of MSW showed that polyethylene (PE), polypropylene (PP), and polystyrene (PS) had the highest volatile matter content, with almost no ash and fixed carbon, while polyethylene terephthalate (PET) had high carbon content but low hydrogen content. Bones and vegetables had the highest ash content, while nutshells and rubber had the highest fixed carbon content. Paper and starch food had the highest oxygen content, and wool and bones had the highest nitrogen and sulfur content. Polyvinyl chloride (PVC) had the highest chlorine content at about 55%. PE, PP, and PS had the highest heating value, followed by chemical products such as rubber and chemical fiber. Conversely, paper, vegetables and bones had the lowest heating value. The results of cluster analysis of MSW components showed that fruit peel, weeds, wood, bamboo, leaves and nutshells could be classified as the lignocellulose category; starch food, cotton, toilet paper, printing paper and cardboard could be classified as the glucose monomer category; wood and chemical fiber could be classified as the high nitrogen and sulfur category; and PE, PP, and PS could be cluster as the polyolefin category.

Implications: The yield of municipal solid waste (MSW) is constantly increasing and waste to energy (WTE) has been used extensively all over the world. During the processes of incineration, pyrolysis, or gasification, the impact of physical and chemical properties of MSW is of great significance. However, the traditional classification of MSW is too general to provide more detailed information in many investigations. It is necessary to perform the investigation of characteristics of combustible MSW to distinguish different categories of MSW and find out their subclassification.     

Heavy metal pollution in vegetables grown in the vicinity of a multi-metal mining area in Gejiu,China: total concentrations,speciation analysis,and health risk

A field survey was conducted to investigate the present situation and health risk of arsenic (As), lead (Pb), cadmium (Cd), copper (Cu), and zinc (Zn) in soils and vegetables in a multi-metal mining area, Gejiu, China. Furthermore, three vegetables (water spinach, potato, and summer squash) containing high metal concentrations were selected to further analyze metal speciation. The results showed that the average concentrations of five metals in soil exceeded the limiting values, and their bioavailable concentrations were significantly positively correlated to the total ones. Heavy metals in the edible parts of vegetables also exceeded the corresponding standards. The leaves of pakchoi, peppermint, and coriander had a strong metal-accumulative ability and they were not suitable for planting. Except the residue forms, the main forms of metals in the edible parts of three selected vegetables were ethanol-, NaCl-, and HAc-extractable fractions for As, Pb, and Cd, respectively; however, Cu was mainly presented as NaCl-extractable and Zn as HAc-extractable fractions. A high proportion of ethanol-extractable As showed that As bioactivity and toxic effects were the highest. Although the total and bioavailable Cd were high in soil, its speciation in vegetables was mainly presented as HAc-extractable fraction, which has a relatively low bioactivity. Lead and arsenic were imposing a serious threat on the local residents via vegetable consumption.