Intra-monsoonal variation of zooplankton population in the Sundarbans Estuarine System,India

The present study was conducted during July 2013 (early phase of monsoon or EM) and September 2013 (later phase of monsoon or LM) to ascertain the intra-monsoonal variation on zooplankton, by selecting 15 study stations in the river Saptamukhi, one of the main estuaries in the Sundarbans Estuarine System (SES). In 2013, SES experienced an unusually high monsoonal rainfall also exacerbated by cloud burst event at Himalayan region (upper stretches of SES) which tremendously increased the river runoff. The present work was aimed to decipher the effect of this unusual precipitation during the monsoon season on zooplankton assemblages along with different hydrological parameters. The abundance of zooplankton was recorded as lower during EM compared to LM. Altogether, 56 zooplankton taxa were identified with copepods forming the predominant population. Thirty-three copepod species were reported with 25 calanoid species forming the bulk of the biomass followed by 5 and 3 species of cyclopoids and harpacticoid, respectively. A combination of multivariate cluster analysis, biotic indices, and canonical correspondence analysis revealed noticeable alterations in the zooplankton community structure across the spatio-temporal scale. Furthermore, significant intra-monsoonal changes in zooplankton population correlated with several hydrological parameters were clearly noticed. Paracalanus parvus, Bestiolina similis and Oithona similis were observed to be the most dominant copepod species in both sampling periods. The result of the present study provides new insight on estuarine zooplankton community after unusual rainfall during monsoon season, and provides further evidence to support the conservation and management of the SES ecosystem.     

Reservoir water quality: a case from Jordan

Jordan relies heavily on reservoirs building and development to cope with water supply challenges, where monitoring and assessment of reservoir water quality are critically important for the sustainable use of these water supplies. Mujib Dam is an important water supply source in central western Jordan. Evaluation of water quality parameters and their spatial distributions (vertical and horizontal) showed near-neutral pH values with nearly similar values from surface to bottom. The vertical profile of DO and TDS in the dammed reservoir showed slight decreasing trends with increasing depth. Although Ca, Mg, Na, and K concentrations varied slightly with depths, their variations showed no trends. Similarly, the vertical and horizontal distribution patterns of Cl, SO₄, HCO₃, NO₃, and PO₄ in Mujib reservoir water showed insignificant variations in surface water layer and relatively unchanged values or decreasing trends through the water column. Higher values of TN have been observed, especially in the western part, suggesting that agricultural activities and livestock farming in the upstream catchment are impacting water quality. Results revealed that weathering and dissolution of rocks are the major source of water chemistry. The majority of trace metal levels (Cd, Cr, Cu, Fe, Mn, Pb, Zn, Co, Ni, Sr, and B) in water showed relatively similar surface and bottom values. The concentrations of COD and BOD₅ in surface water were relatively low with higher concentrations observed in the northwestern corner, coincided with higher levels of chlorophyll a. The average ratio of TN to TP in surface water suggests that phosphorus is the limiting factor for the algal blooms, whereas the average chlorophyll a level in surface water indicates oligo-mesotrophic water.     

Estimation of soil specific surface area using some mechanical properties of soil by artificial neural networks

Soil specific surface area (SSA) is an important property of soil. Depending on the measurement techniques, determination of the SSA is costly and time consuming. Hence, a limited number of studies have been conducted to predict the SSA from the soil variables. In this study, the soil samples were taken from the literature. Fractal parameters (FP) were calculated by the model of Bird et al. (European Journal of Soil Science 51, 55–63, 2000) used as the input variables to predict the SSA. Some studies have been carried out on the prediction capability of the different parameters using the artificial neural networks (ANNs). The ANNs were further used and 20 models were developed to investigate the value of input variables to predict the SSA. The results showed that the PTF13 (RMSE?=?0.13) and PTF18 (RMSE?=?0.13) with the input variables of particle-size distribution and Atterberg limits revealed better performance than the other PTFs (in the training step). It is because of the fact that free swelling index (FSI) and Atterberg limits were closely correlated to the soil clay mineralogy as one of the important factors controlling the SSA. In general, this results demonstrated that the PTF9 with the variables of sand, clay, plastic limit (PL), liquid limit (LL), and FSI showed the best (RMSE?=?0.37) results in the estimation of the SSA. In conclusion, there was not a strong correlation between the soil mechanical properties and SSA but also ANNs were a suitable method to predict the SSA from the soil variables.     

FIA-coupled spectrophotometric method for determination of Cr (VI) traces in natural waters: application of in-line dissolution of 1,5-diphenylcarbazide after heat treatment and activated alumina as adsorbent for preconcentration

This work proposes the quantification of Cr (VI) ions in natural waters in trace level, using activated alumina (Al₂O₃) as preconcentration support, controlled in-line dissolution of the solidified chromophore diphenylcarbazide after heat treatment and spectrophotometric detection. The manifold ensures high sensitivity of analytical response, good repeatability, and stability. In this work, optimization of experimental conditions of a flow injection system was chosen as the parameters for greater sensitivity and better selectivity. The selected optimized conditions were 0.30 mol L^?1 for H₂SO₄ concentration, system flow rate as 0.40 mL min^?1, sample injection volume of 192.50 μL, 2 min for preconcentration time, and 0.10 mol L^?1 for eluent concentration. The analytical curves obtained for real sample analysis show linear range from 0.192 to 0.961 μM, linear correlation coefficient R?=?0.9997 and LOD?=?0.024 μM. The preconcentration factor of about four times was obtained through the passage of 800 μL of a standard solution containing 0.961 μM of Cr (VI) through mini-column of preconcentration followed by elution at 192.5 μL of NH₄OH 0.1 mol L^?1 solution. The solid chromogenic reagent presented high durability (weeks in daily use with mass of 0.0993 g) and good reproducibility in analytical signal. The reactivation of the mini-column of alumina should be executed after ten injections of eluent, using 800 μL of HCl 0.02 mol L^?1 solution in flow through the same. Each cycle of injection and elution of the sample takes about 5 min on the proposed terms. Despite the length of each cycle still be high, low concentrations can be detected using a technique of relatively low cost. This is due in part, the association dissolution of the chromogenic reagent directly in the line and the preconcentration step. Another important factor is the economy of reagent chromogenic, low generation of reject contributing to better quality of the environment, and the high potential for applications to work in field.     

液液萃取-气相色谱法测定水质可萃取性石油烃C10~C40

建立了以环己烷为萃取剂、气相色谱法(氢火焰离子化检测器,FID)测定水质样品中可萃取性石油烃(C_(10)～C_(40))的分析方法。以正构烷烃混合标准溶液为定性和定量校准标准,以色谱峰面积总和与混合标准溶液总浓度建立校准曲线进行外标法定量。方法检出限为0.01 mg/L,经验证方法精密度和准确度良好。同时,分别以气相色谱法和红外光度法测定了地表水、污水处理厂出水、海水和化工废水等实际样品,对比实验结果表明,在可萃取性石油烃C_(10)～C_(40)的碳数范围内,气相色谱法的测试结果与红外光度法无明显差异,有较好的可比性。     

Assessment using CFD of the wind direction on the air discharges caused by natural ventilation of a poultry house

Air inside poultry houses must be removed on a regular basis to prevent excess of heat, particles and noxious gases that can imperil animals. To cope with this issue, natural ventilation could be an effective method when assisted by accurate predictions. This study investigates air discharges caused by natural ventilation of a poultry house by means of a three-dimensional computational fluid dynamics (CFD) model. It solves the governing equations of momentum, heat and mass transport, radiative transfers and animal-generated heat. Wind directions of 0°, 36° and 56° (0° corresponds to a wind blowing perpendicular to the ridgeline) were investigated; the CFD model predictions achieved a RMSE of 1.2 °C and 0.6 g[H₂O] kg^?1 [dry air] for internal temperature and absolute humidity, respectively, when air blew with an angle of 36°. Air renewal rates (ARR) were 39.5 (±?1.9), 34.9 (±?2.2) and 33.6 (±?1.7) volumes of the building per hour, when air blew at 0°, 36° and 56°, respectively. Such ARR predictions served to know how the gases contained in air would likely spread downstream from the building in order to define regions of potentially high gas concentration that could endanger neighbouring habitable facilities.     

Water quality index for agricultural systems in Northwest Uruguay

Agricultural systems have experienced rapid expansion and intensification in the last several decades. In Uruguay, since the beginning of 2000, the most common cropping systems have included soybeans. Currently, this crop is expanding towards lowlands traditionally occupied by rice in rotation with pastures. However, the environmental effects of agricultural intensification and diversification are not well known. Thus, some indices have been proposed to quantify the changes in agricultural production systems and assess water quality. The main goal of this study was to develop a water quality index (WQI) to assess the impacts of the diversification of rice production systems in northwest Uruguay. The study was carried out in an agricultural basin where other summer crops have been incorporated in the rice-pasture sequence. Agriculture intensification and crop diversification indices were calculated using information provided by farmers. Water samples were collected downstream of the production area before crop sowing and after crop harvest (2008–2009 to 2010–2011 and 2016–2017 to 2017–2018). Biochemical oxygen demand, nitrates, total phosphorus, fecal coliforms, and total suspended solids were the variables that mainly explained the effects of the agricultural activities on water quality. The proposed water quality index included these unweighted variables, which allowed for the pre-sowing and post-harvest to be differentiated, as well as the degree of diversification. Therefore, the proposed WQI constitutes a tool that can be used to evaluate the water quality in an agricultural basin. Likewise, it can be used to select agricultural sequences that generate the least possible impacts on the associated water resources.     

Bioremediation of tannery effluent by Cr- and salt-tolerant bacterial strains

Microorganisms have great potential to control environmental pollution, particularly industrial sources of water pollution. Currently, leather industry is regarded as the most polluting and suffering from negative impacts due to the pollution it adds to the environment. Chromium, one of the hazardous pollutants discharged from tanneries, is highly toxic and carcinogenic in nature. Effective treatment of tannery effluent is a dire need of the era as a part of environmental management. Among all the wastewater treatment technologies, bioremediation is the most effective and environment-friendly tool to manage the water pollution. The present study evaluated the potential of 11 previously isolated bacterial strains, tolerant to high concentrations of salts and Cr for the bioremediation of tannery effluent. Among all the tested strains, Enterobacter sp. HU38, Microbacterium arborescens HU33, and Pantoea stewartii ASI11 were found most effective in reducing biological oxygen demand (BOD), chemical oxygen demand (COD), total dissolved solids (TDS), total suspended solids (TSS), and chromium (Cr) 70, 63, 57, 87, and 54%, respectively, of tannery effluent and proliferated well under highly toxic conditions, at 9 days of incubation. The pollutant removal efficacy of these bacterial strains can be improved by extending the incubation period or by increasing the amount of inoculum.     

Use of water quality index and multivariate statistical techniques for the assessment of spatial variations in water quality of a small river

Rapid urban development has led to a critical negative impact on water bodies flowing in and around urban areas. In the present study, 25 physiochemical and biological parameters have been studied on water samples collected from the entire section of a small river originating and ending within an urban area. This study envisaged to assess the water quality status of river body and explore probable sources of pollution in the river. Weighted arithmetic water quality index (WQI) was employed to evaluate the water quality status of the river. Multivariate statistical techniques namely cluster analysis (CA) and principal component analysis (PCA) were applied to differentiate the sources of variation in water quality and to determine the cause of pollution in the river. WQI values indicated high pollution levels in the studied water body, rendering it unsuitable for any practical purpose. Cluster analysis results showed that the river samples can be divided into four groups. Use of PCA identified four important factors describing the types of pollution in the river, namely (1) mineral and nutrient pollution, (2) heavy metal pollution, (3) organic pollution, and (4) fecal contamination. The deteriorating water quality of the river was demonstrated to originate from wide sources of anthropogenic activities, especially municipal sewage discharge from unplanned housing areas, wastewater discharge from small industrial units, livestock activities, and indiscriminate dumping of solid wastes in the river. Thus, the present study effectively demonstrates the use of WQI and multivariate statistical techniques for gaining simpler and meaningful information about the water quality of a lotic water body as well as to identify of the pollution sources.     

O／W型乳化液的处理

采用药剂破乳－电解破乳工艺处理Ｏ／Ｗ型乳化液，药剂破乳选用聚合硫酸铁为破乳剂，破乳时最佳ＰＨ为８，聚合硫酸铁的最佳投量为１５００ｍｇ／Ｌ，电解破乳选用铁作阳极，铝作阴极，电流密度０．８６Ａ／ｄｍ＾２，极距２５ｍｍ，电解时间３ｈ。在上述条件下，破乳效果良好，出水清澈透明，ＣＯＤ总去除率可达到９６－９７％。