气相分子吸收光谱法测定印染废水中氨氮的影响因素

采用气相分子吸收法光谱测定印染废水中的氨氮,并对相关影响因素进行探讨。结果证实,硫化物和尿素会对氨氮的测定产生负干扰,硫化物干扰可用乙酸锌-乙酸钠固定液沉淀法去除,尿素干扰可以用稀释法去除,但仅适用于氨氮质量浓度0.10 mg/L且稀释后尿素质量浓度≤100 mg/L的水样;苯胺、浊度和色度对测定无干扰,可直接检测。     

Effect of air-drying and oven-drying treatment on Cr(VI) content and Cr bond forms in soil

Air-drying and oven-drying are pretreatment processes often used before testing and analyzing various soil characteristics in the laboratory. This study selected three kinds of soil, including red soil, entisol, and alluvial soil, and examined the variation of the Cr(VI) content and Cr bond forms in these soils during air-drying and oven-drying. The results show that when the soil is air-dried in natural environment, the Cr(VI) content decreases with air-drying time. On day 10 of air-drying, the Cr(VI) content in these soils is 22.8～47.9 % of the initial value. When the soil is oven-dried, the Cr(VI) concentration decays faster; on day 8, the Cr(VI) is no longer detected in these soil samples. When the Cr(VI)-contaminated soil is treated by air-drying and oven-drying, the Cr bond form converts into a more stable form. After oven-drying, the Cr mainly exists in Fe–Mn oxide form, organic bond form, and residual form. The air-drying and oven-drying pretreatment processes of soil reduce the Cr(VI) content and stabilize the Cr bond form. If the laboratory analytic results are applied to risk analysis or remediation strategy planning for chromium-contaminated soil, the toxicity, bioavailability, and mobility of Cr in soil may be underrated.     

建设项目竣工验收现场平行样控制指标研究

依据建设项目竣工环境保护验收中污水监测的要求,通过积累大量验收监测质量检查的实验数据,运用数理统计的方法,以化学需氧量和氨氮两个项目为例,建立了质控数据的评价方法,并确定了现场平行样偏差指标的限値。     

改性沸石分离富集-火焰原子吸收光谱法测定长江水中镉

采用改性沸石分离富集-火焰原子吸收光谱法测定长江水中微量镉,优化了富集和洗脱条件,讨论了干扰离子的影响。方法在0μg~4.00μg范围内线性良好,检出限为0.214μg/L,长江水平行测定的RSD为1.8%,加标回收率为99.0%~104%。     

Chlorinated and brominated dibenzo-p-dioxins and dibenzofurans in surface sediment from Taihu Lake, China

Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) and polybrominated dibenzo-p-dioxins and dibenzofurans (PBDD/Fs) in surface sediment samples from Taihu Lake--an important water supply of the Yangtze River Delta, China--were investigated in the present study. Concentrations of PCDD/Fs ranged from 0.91 to 4.8 pg TEQ g(-1) dw (mean: 2.9 pg TEQ g(-1) dw, TEQ: Toxic Equivalent), which were all higher than the threshold effect level established by interim sediment quality guidelines in Canada (0.85 pg TEQ g(-1) dw). The levels of PBDD/Fs ranged from 0.16 to 1.6 pg TEQ g(-1) dw (mean: 0.52 pg TEQ g(-1) dw) and accounted for 5-33% (mean: 14%) of the total PCDD/Fs and PBDD/Fs TEQ. Comparatively, the abundance of sedimentary PCDD/Fs in the three regions (Meiliang Bay, Gonghu Bay, and Xukou Bay) showed a decreasing trend from the inflow region to the outflow region, while no significant difference was observed among their 2,3,7,8-PBDD/Fs levels, which suggested that the sources of PCDD/Fs and PBDD/Fs differed in this area. Principal component analysis suggested that the historical production/usage of pentachlorophenol and sodium pentachlorophenate was the dominant source of PCDD/Fs in the sediment of these regions. Although the specific sources of PBDD/Fs in the sediment of Taihu Lake were unclear, it was suspected to be due to atmospheric deposition; however, an additional study is needed to confirm this.     

Locating pollutant emission sources with optical remote sensing measurements and an improved one-dimensional radial plume mapping technique

Previous studies have shown that there was a relatively large amount of uncertainty along the major wind direction in the results of locating emission sources using the one-dimensional radial plume mapping (RPM(1D)) technique based on optical remote sensing measurements. This paper proposes setting up an additional monitoring line that is perpendicular to the original scanning beam geometry to reduce this uncertainty. We first conducted a computer simulation study using the Gaussian dispersion model to generate the downwind concentrations of plumes from 400 source locations in a 201 m × 201 m spatial domain under various wind directions (n = 181). The optical remote sensing instrument was assumed to be at (0, 0) with two perpendicular monitoring lines, each of which had three beam segments of equal length. Each pair of the reconstructed downwind concentration profiles was then used to trace back to the source locations. The results showed that the accuracy of the method and its uncertainty were improved by using the proposed two-line RPM(1D) approach rather than the original one-line RPM(1D) approach at most simulated source locations. In a follow-up field experiment, a tracer gas was released at the coordinate of (100, 100). The release location was covered within the 0.25- to 0.5-probability area of the estimated results, and the distance between the actual and estimated source locations was 18.4 m (9.2% of the longest beam path).     

挥发性有机物污染土壤样品采样方法比较

以苯系物污染土壤样品的采集为例,比较了4种不同采样方法导致样品检测结果的差异。其中,方法 1将样品装填至广口瓶内并压实密封,方法2采用非扰动采样器采集10 g样品后转移至加有10 mL甲醇保护剂的Vial瓶中密封,方法 3用非扰动采样器采集10 g样品后直接将其密封于采样器内,方法 4用Encore采样器采样后将其密封于采样器内。结果表明,方法 2采集样品的检出率最高,其余3种方法的差异不明显,方法 2采集样品的检出结果 71%以上都大于其余3种方法。而且,对于挥发性较强的苯与甲苯,以方法 2采集的样品91%以上都大于其余3种方法,最大及平均检出浓度高出2~3个数量级。5种不同土质样品检测结果表明,对于有机质含量较低的细砂,方法2的最高及平均检出浓度均高于其余3种方法 1~3个数量级,差异随土壤有机质含量的升高而降低。可见,对于苯系物及挥发性强于苯系物的其他挥发性有机物污染土壤样品的采集,方法 2效果最优,可指定为VOCs污染场地土壤样品的采样方法。     

镇江地区土壤中重金属Cu和Pb污染状况与空间分布

为了锯镇江地区土壤中重金属Cu和Ph的污染状况与空间分布,对镇江地区表层土壤中的Cu和Pb进行了采样监测。结果表明,镇江地区表层土壤中cu的含量为19．2～273mg／kg,Pb的含量为20．6～3846mg／kg。与全省土壤背景值相比,均有一定程度的富集。对cu和Pb的相互关系进行分析可得出,镇江地区土壤在一定程度上受到农业面源的污染。     

Estimation of phosphorus flux in rivers during flooding

Reservoirs in Taiwan are inundated with nutrients that result in algal growth, and thus also reservoir eutrophication. Controlling the phosphorus load has always been the most crucial issue for maintaining reservoir water quality. Numerous agricultural activities, especially the production of tea in riparian areas, are conducted in watersheds in Taiwan. Nutrients from such activities, including phosphorus, are typically flushed into rivers during flooding, when over 90 % of the yearly total amount of phosphorous enters reservoirs. Excessive or enhanced soil erosion from rainstorms can dramatically increase the river sediment load and the amount of particulate phosphorus flushed into rivers. When flow rates are high, particulate phosphorus is the dominant form of phosphorus, but sediment and discharge measurements are difficult during flooding, which makes estimating phosphorus flux in rivers difficult. This study determines total amounts of phosphorus transport by measuring flood discharge and phosphorous levels during flooding. Changes in particulate phosphorus, dissolved phosphorus, and their adsorption behavior during a 24-h period are analyzed owing to the fact that the time for particulate phosphorus adsorption and desorption approaching equilibrium is about 16 h. Erosion of the reservoir watershed was caused by adsorption and desorption of suspended solids in the river, a process which can be summarily described using the Lagmuir isotherm. A method for estimating the phosphorus flux in the Daiyujay Creek during Typhoon Bilis in 2006 is presented in this study. Both sediment and phosphorus are affected by the drastic discharge during flooding. Water quality data were collected during two flood events, flood in June 9, 2006 and Typhoon Bilis, to show the concentrations of suspended solids and total phosphorus during floods are much higher than normal stages. Therefore, the drastic changes of total phosphorus, particulate phosphorus, and dissolved phosphorus in rivers during flooding should be monitored to evaluate the loading of phosphorus more precisely. The results show that monitoring and controlling phosphorus transport during flooding can help prevent the eutrophication of a reservoir.     

盲样考核浓度预判及稀释方法——以原子荧光法测定水中砷为例

以原子荧光法测定水中砷为例,探讨了实验室盲样考核浓度预判及稀释方法.分析了3个砷盲样考核实例,归纳了“直接稀释法”“系列稀释法”“最大稀释法”3种方法,分别适用于盲样浓度范围窄、适中、宽3种情况,检测人员可根据考核机构给定的浓度范围合理选用.