建设项目竣工验收现场平行样控制指标研究

依据建设项目竣工环境保护验收中污水监测的要求,通过积累大量验收监测质量检查的实验数据,运用数理统计的方法,以化学需氧量和氨氮两个项目为例,建立了质控数据的评价方法,并确定了现场平行样偏差指标的限値。     

挥发性有机物污染土壤样品采样方法比较

以苯系物污染土壤样品的采集为例,比较了4种不同采样方法导致样品检测结果的差异。其中,方法 1将样品装填至广口瓶内并压实密封,方法2采用非扰动采样器采集10 g样品后转移至加有10 mL甲醇保护剂的Vial瓶中密封,方法 3用非扰动采样器采集10 g样品后直接将其密封于采样器内,方法 4用Encore采样器采样后将其密封于采样器内。结果表明,方法 2采集样品的检出率最高,其余3种方法的差异不明显,方法 2采集样品的检出结果 71%以上都大于其余3种方法。而且,对于挥发性较强的苯与甲苯,以方法 2采集的样品91%以上都大于其余3种方法,最大及平均检出浓度高出2~3个数量级。5种不同土质样品检测结果表明,对于有机质含量较低的细砂,方法2的最高及平均检出浓度均高于其余3种方法 1~3个数量级,差异随土壤有机质含量的升高而降低。可见,对于苯系物及挥发性强于苯系物的其他挥发性有机物污染土壤样品的采集,方法 2效果最优,可指定为VOCs污染场地土壤样品的采样方法。     

The general utilization of scrapped PC board

The traditional burning process is used to recover copper from scrapped PC board (printed circuit board) but it causes serious environmental problems. In this research a new process was developed which not only prevents pollution problems, but also maximizes the utility of all the materials on the waste board. First, the scrapped PC board was crushed and grounded, then placed in the NH₃/NH₅CO₃ solution with aeration in order to dissolve copper. After distilling the copper NH₃/NH₅CO₃ solution and then heating the distilled residue of copper carbonate, pure copper oxide was obtained with particle size of about 0.2 μm and the shape elliptical. The remaining solid residue after copper removal was then leached with 6 N hydrochloric acid to remove tin and lead. The last residue was used as a filler in PVC plastics. The PVC plastics with PC board powder as filling material was found to have the same tensile strength as unfilled plastics, but had higher elastic modulus, higher abrasion resistance, and was cheaper.     

Levels of black carbon and their relationship with particle number levels—observation at an urban roadside in Taipei City

Information on the relationship between black carbon (BC) and particle number levels in urban areas is limited. Therefore, investigating the relationship between BC and particle number levels in different particle size ranges at an urban area is worthwhile. This study used an aethalometer and scanning mobility particle sizer to measure the levels of BC and particle number simultaneously at an urban roadside in Taipei City. Measurement results show that hourly BC levels are 0.62–8.80 μg m^?3 (mean?=?3.50 μg m^?3) and hourly particle number levels are 4.21?×?10³–4.64?×?10⁴ particles cm^?3 (mean?=?2.00?×?10⁴ particles cm^?3) in Taipei urban area. The BC and particle number levels peak during morning (7:00–9:00) and evening (16:00–18:00) rush hours on weekdays. Low BC and particle number levels exist in the early morning hours. Time variations in BC levels are the same as those of particle number levels in this study, clearly indicating that BC and particles are likely released from the same emission source. Additionally, BC levels in the urban area are more strongly associated with ultrafine particle levels than with total particle number levels, particularly in the size range of 56–180 nm. According to measurement results, most BC in aerosols in urban areas can be in the ultrafine size range.     

Co-composting of green waste and food waste at low C/N ratio

In this study, co-composting of food waste and green waste at low initial carbon to nitrogen (C/N) ratios was investigated using an in-vessel lab-scale composting reactor. The central composite design (CCD) and response surface method (RSM) were applied to obtain the optimal operating conditions over a range of preselected moisture contents (45–75%) and C/N ratios (13.9–19.6). The results indicate that the optimal moisture content for co-composting of food waste and green waste is 60%, and the substrate at a C/N ratio of 19.6 can be decomposed effectively to reduce 33% of total volatile solids (TVS) in 12 days. The TVS reduction can be modeled by using a second-order equation with a good fit. In addition, the compost passes the standard germination index of white radish seed indicating that it can be used as soil amendment.     

Tidal influences on the habitat use of Indo-Pacific humpback dolphins in an estuary

This paper offers the first study of diurnal variations in the use of an estuarine habitat by Indo-Pacific humpback dolphins. Passive acoustic data loggers were deployed in the Xin Huwei River Estuary, Western Taiwan, from July 2009 to December 2010, to collect biosonar clicks. Acoustic encounter rates of humpback dolphins on the riverside of the estuary changed significantly over the four tidal phases, instead of the two diurnal phases based on the recordings from 268 days. Among the tidal phases, the encounter rates were lowest during ebb tides. Additionally, circling movements associated with the hunt for epipelagic fish significantly changed in temporal and spatial presence over the four tidal phases, matching the overall pattern of encounter rate changes in the focal estuary. Our findings suggest that the occurrence pattern and habitat utilization of humpback dolphins are likely to be influenced by the tidal-driven activity of their epipelagic prey.     

中型景观尺度下斑块类型和地理特征影响杨树人工林干部病害的发生——以河南省清丰县为例

景观病理学在开展病原扩散、病害发生及其严重程度方面以其全新的视角,为森林病害的区域控制提供了新的研究技术及理论支持。首次利用景观病理学原理和方法对河南省清丰县一个中型景观下杨树人工林干部病害发生特征开展了研究,目的是解析在大尺度下斑块类型和地理特征对杨树人工林病害发生的影响。在100 km2的调查区域,以种植方式和林分类型划分斑块类型,分析显示发病株率在不同斑块间差异显著：农田间作斑块的林木发病株率显著低于孤立斑块、纯林斑块、混交林等斑块的发病株率;但发病株率在孤立斑块、纯林斑块及混交林等斑块间无显著差异。抚育管理措施对预防和减轻杨树人工林干部病害的发生起到关键左右：精细管理林分（有修枝、施肥和锄草）的林木发病株率（p=0.001）和发病指数（p〈0.001）均显著低于粗放管理林分（无修枝、无施肥和锄草等）。人类活动,如无序修剪和放牧很可能是造成村落附近林分发病率显著高于其他地点林分的主要原因。采用logistic回归,以品种编号、树龄、树高、林分密度、林分郁闭度、林分类型、斑块类型、地理特征,等为自变量建立病害发生预测模型。方程拟合达到极显著水平（Wald=71.248,p〈0.001）。方程总的预测正确率为68.2%,发病的预测正确率为79.8%。     

CASS工艺脱氮影响因素分析

针对CASS工艺脱氮的效果不够理想、效率不高、出水不够稳定的现象，对脱氮的主要影响因素曝气时间、DO、温度、λ进行了生产性试验研究，分析结果表明，曝气时间3h，D02．5mg／L是本污水厂最合理的参数控制值，曝气时间3h时NH3-N和TN的平均去除率分别为89．7％和59．7％，D02．5mg／L时NH3-N和TN的平均去除率分别为94．5％和71．3％，脱氮效果良好；温度对脱氮的效果有很明显的影响，春季的脱氮效果明显好于冬季；脱氮效果随冲水比的增高而降低，但出水均达标说明CASS工艺有良好的抗冲击负荷的能力。     

An integrated method for safety pre-warning of complex system

In large-scale and complex industrial systems, unplanned outages and hazardous accidents cause huge economic losses, environmental contamination, and human injuries, due to component degradation, exogenous changes, and operational mistakes. In order to ensure safety and increase operational performance and reliability of complex system, this study proposes an integrated method for safety pre-warning to analyze the current safety state of each component and the whole system indicating hidden hazards and potential consequence, and furthermore predict future degradation trends in the long term.The work presented here describes the rationale and implementation of the integrated method incorporating HAZOP study, degradation process modeling, dynamic Bayesian network construction, condition monitoring, safety assessment and prognosis steps, taking advantage of the priori knowledge of the interactions and dependencies among components and the environment, the relationships between hazard causes and effects, and the use of historical failure data and online real-time data from condition monitoring.The application of the integrated safety pre-warning approach described here to the specific example of the gas turbine compressor system demonstrates how each phase of the presented method contributes to completion of the safety pre-warning system development in a systematic way.     

Review of recycling performance indicators: A study on collection rate in Taiwan

The Taiwan Environmental Protection Administration (Taiwan EPA) launched a national Extended Producer Responsibility (EPR) system after integrating eight private recycling organizations in 1998. After that, the environmental performance of the EPR system brought a lot of attention to policy makers. Many studies show positive environmental effects of the EPR system in Taiwan. However, there are controversial questions remained, such as whether the performance indicators used are the right choice to estimate the environmental effects of the recycling policy? Can those estimated results really reflect the performance of the system?This paper would therefore like to more accurately evaluate the performance indicators of the EPR system based on data observed over the past decade in Taiwan. In the process of evaluating the performance indicators, we have found that the collection rates for durable goods are often ignored in countries that pursue a zero waste policy. This may affect the actual recycling outcome and resource direction targeted by producers. However, in order for the collection rate to be adopted as a policy indicator, how to estimate the amounts of retired or waste products during a period is critical. In this paper, we estimate the collection rate for electrical and electronic waste by using the survival analysis and ownership data analysis approaches. We also provide a comparison of both approaches and put forward suggestions for directions in the future in solid waste management.