高气速间歇式生物过滤去除高负荷H2S

采用生物过滤法,以鸡粪堆肥和PE混合物为填料,在高气速条件下间歇式处理高负荷H2S废气。空床停留时间为20、15、10、6.7和5 s时,入口浓度3 000 mg/m3下的平均去除率分别为100%、100%、96.5%、89.2%和90.5%。高气速EBRT为5 s时,高入口负荷2 147 g/(m3.h)时的去除负荷为2 023 g/(m3.h),去除率达94%。采用Michaelis-Ment-en模型进行生物降解宏观动力学研究,其中Ks为550 mg/m3,Vm为6.8×104g/(m3.d)。结果表明,在实验温度17～24℃,湿度30%～50%下,生物过滤法间歇式处理高气速高负荷H2S的去除性能好。     

高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

Effect of humic acids on physicochemical property and Cd(II) sorption of multiwalled carbon nanotubes

Zinc pyrithione is used as an antifouling agent. However, the environmental impacts of zinc pyrithione have recently been of concern. Zinc induces diverse actions during oxidative stress; therefore, we examined the effect of zinc pyrithione on rat thymocytes suffering from oxidative stress using appropriate fluorescent probes. The cytotoxicity of zinc pyrithione was not observed when the cells were incubated with 3 μM zinc pyrithione for 3 h. However, zinc pyrithione at nanomolar concentrations (10 nM or more) significantly increased the lethality of cells suffering from oxidative stress induced by 3 mM H₂O₂. The application of zinc pyrithione alone at nanomolar concentrations increased intracellular Zn²⁺ level and the cellular content of superoxide anions, and decreased the cellular content of nonprotein thiols. The simultaneous application of nanomolar zinc pyrithione and micromolar H₂O₂ synergistically increased the intracellular Zn²⁺ level. Therefore, zinc pyrithione at nanomolar concentrations may exert severe cytotoxic action on cells simultaneously exposed to chemicals that induce oxidative stress. If so, zinc pyrithione leaked from antifouling materials into surrounding environments would be a risk factor for aquatic ecosystems. Alternatively, zinc pyrithione under conditions of oxidative stress may become more potent antifouling ingredient.     

Toxicological effect of MPA-CdSe QDs exposure on zebrafish embryo and larvae

Cadmium selenium (CdSe) quantum dots (QDs) are semiconductor nanocrystals that hold wide range of applications and substantial production volumes. Due to unique composition and nanoscale properties, their potential toxicity to aquatic organisms has increasingly gained a great amount of interest. However, the impact of CdSe QDs exposure on zebrafish embryo and larvae remains almost unknown. Therefore, the lab study was performed to determine the developmental and behavioral toxicities to zebrafish under continuous exposure to low level CdSe QDs (0.05-31.25 mg L⁻¹) coated with mercaptopropionic acid (MPA). The results showed MPA-CdSe exposure from embryo to larvae stage affected overall fitness. Our findings for the first time revealed that: (1) The 120 h LC₅₀ of MPA-CdSe for zebrafish was 1.98 mg L⁻¹; (2) embryos exposed to MPA-CdSe resulted in malformations incidence and lower hatch rate; (3) abnormal vascular of FLI-1 transgenic zebrafish larvae appeared after exposure to MPA-CdSe including vascular junction, bifurcation, crossing and particle appearance; (4) larvae behavior assessment showed during MPA-CdSe exposure a rapid transition from light-to-dark elicited a similar, brief burst and a higher basal swimming rate; (5) MPA-CdSe induced embryos cell apoptosis in the head and tail region. Results of the observations provide a basic understanding of MPA-CdSe toxicity to aquatic organisms and suggest the need for additional research to identify the toxicological mechanism.     

Optimization of photo-Fenton process parameters on carbofuran degradation using central composite design

Carbofuran, one of the most toxic and biorefractory carbamate compounds, is widely used in insecticides in Taiwan (9-18% of total insecticides production per year). In the present study, a central composite design experiment was used to study the effect of photo-Fenton treatment on carbofuran solution and to optimize the process variables such as carbofuran concentration (1-100 mg L(-1)), H(2)O(2) dosage rate (0.25-6 mg L(-1) min(-1)) and Fe(3+) dosage (1-50 mg L(-1)), which influenced the efficiency of carbofuran degradation and mineralization. The results indicated that all the variables investigated in this study had significant roles in the degradation and mineralization of carbofuran in solution. The carbofuran degradation and mineralization efficiencies were increased with increase in H(2)O(2) dosage rate and Fe(3+) dosage, and with decrease in carbofuran concentration. Furthermore, optimum values of both H(2)O(2) dosage rate and Fe(3+) dosage were found to shift to higher values as carbofuran concentration increased. Based on the model obtained in this study, optimum H(2)O(2) dosage rate and Fe(3+) dosage were found to be 4 mg L(-1) min(-1) and 20 mg L(-1), respectively, for 51 mg L(-1) of carbofuran concentration. Under these conditions, carbofuran was completely removed within 30 min and coupled with 78% mineralization at the end of experiment.     

凹凸棒石粘土固定辣根过氧化物酶处理含酚废水

采用凹凸棒石粘土、可溶性淀粉和工业水玻璃作为制备凹凸棒石粘土基颗粒的材料,并将制备的凹凸棒石粘土基颗粒进行改性,得到了改性后的凹凸棒石基多孔材料,并将其作为固定辣根过氧化物酶的载体,再应用于含酚废水的处理研究,取得了良好的效果。实验结果表明,辣根过氧化物酶的最佳固定化条件为:单位酶活载体量1 mg、固定化时间1.5小时、固定pH值5。并且在固定化酶循环使用6次后,苯酚去除率仍能达到62.3%。     

微波诱导AC/Cu、AC/Fe催化非均相Fenton 反应催化降解垃圾渗滤液

采用活性炭载体负载Cu、Fe为催化剂,在微波诱导作用下,对垃圾渗滤液污染物进行降解。实验结果表明,活性炭负载金属前经适当浓度硝酸浸泡处理后,催化剂对COD去除率提高可超过15%,过高硝酸盐浓度对COD去除有不利影响;催化剂对COD去除率随Cu、Fe金属负载量增加呈先增加后降低的趋势,催化剂对Cu、Fe的最佳负载量分别为质量百分比2.11%和1.12%。对于AC-Cu体系,在初始pH=3,H2O2投加量为4.98×103mg/L,催化剂用量为5.0×103mg/L,420 W功率下微波辐射10 min时,垃圾渗滤液COD去除率可达到84.13%;对于AC-Fe体系,当H2O2投加量为0.33×103mg/L,催化剂AC-Fe用量为2.0×104mg/L,420 W功率下微波作用10 min时,垃圾渗滤液COD去除率为60.16%。分析2种催化剂对COD去除差异的原因,可能是催化剂AC-Cu表面单分子分布的阈值比AC-Fe高。降解液的pH值对AC-Cu体系、AC-Fe体系COD去除影响存在拐点,最高COD去除率点对应的降解液pH值为3。微波辐射功率较低时,体系COD去除率随辐射功率增加而增加;辐射功率较高时,高温下垃圾渗滤液中有机硫化物分解成小分子硫化物,对催化剂活性存在一定抑制作用。     

模拟阳光下Ag／I-TiO2光催化预处理山核桃加工废水

研究了在模拟太阳光下,采用银修饰的碘掺杂二氧化钛光催化剂（Ag／I—TiO2）对某食品厂山核桃加工废水进行光催化预处理的效果。结合x射线衍射（XRD）、比表面积分析（BET）、紫外-可见漫反射光谱（uV—Vis）的表征结果,来分析催化剂结构对于废水处理效果的影响。探讨了Ag含量、废水初始pH（pHi）和光照时间等因素对化学需氧量（COD）去除及水质可生化性（B／C）提高的影响。并得出适宜的反应参数为：3％Ag含量;pHi为6;光照时间为240min。在最佳条件下,COD去除率45％,废水B／C比由0．17上升到0．31。光催化氧化法能够有效降低山核桃加工废水的COD含量,并达到显著提高废水可生化性的目的。     

Generation of solid wastes in typhoon disasters and their emergent cleaning and treatment means

In Taiwan, typhoons usually result in a large amount of waste that needs to be removed in a short time from July to October. This study reviewed the relevant regulations on the clean-up of typhoon waste, including emergency response regulations, organizations and information systems; and we also discuss different typhoon waste clean-up and disposal methods. The results indicate that the parameters other than the maximum wind speed, such as the maximum accumulated rainfall, flooded area, waste output, sludge output, disinfected area and government dispatched attendance reached statistical significance (p < 0.05). Waste, tree branches and bird carcasses were primarily incinerated, while silt and building materials were buried, and pig and cattle carcasses were placed in a landfill with the tertiary treatment of wastewater. This study also reports on the relevant regulations for prevention of epidemics among personnel working in disaster areas. The results can provide important references for the disposal of typhoon waste in developing countries. As Asian countries have similar life styles and are often attacked by typhoons, the results of this study provide Asian countries with the operating experience of Taiwan in emergency treatment of solid waste resulting from typhoons as a reference for them to plan response systems and operation.