没食子酸生产废炭渣的处理

采用热水洗涤法回收没食子酸生产废炭渣中的没食子酸,过滤炭渣经热再生处理得到热再生活性炭。研究了热水洗涤法回收没食子酸和热再生法再生活性炭的最佳工艺条件。实验结果表明,热水洗涤法回收没食子酸的优化工艺条件:废炭渣质量与热水体积比为0.15g/mL,热水洗涤时间为60min,热水洗涤温度为60℃。在此最佳工艺条件下,没食子酸回收量达52mg/g。热再生法再生活性炭的最佳工艺条件为:热再生温度500℃,热再生时间120min。在此条件下制备的热再生活性炭对亚甲基蓝的吸附量达168mg/g,热再生活性炭平均得率为57.1%。     

采油废水的深度处理回用

采用溶气气浮—生物接触氧化—膜分离组合工艺深度处理采油废水。实验结果表明,出水水质满足热采锅炉进水要求。该法可年处理废水1.3×105m3,产水率按50%计,年节约新鲜水和废水回灌费用共计77.88万元,年节水效益为21.71万元。     

磁絮凝处理废水工艺条件的响应曲面法优化研究

以聚硅硫酸铁(PFSS)为絮凝剂、磁流体为磁种,采用磁絮凝法处理模拟废水。在正交实验基础上,利用Matlab软件进行响应曲面分析,研究磁絮凝法处理模拟废水的各因素间具有的交互作用关系。回归拟合结果表明最佳工艺条件为:PFSS加入量36.8g/L,模拟废水pH7.4,磁种加入量14.7mg/L,搅拌转速266r/min。在最佳工艺条件下进行实验,TP去除率为97.70%。     

固定化白腐真菌反应器与接触氧化反应器联用处理癸二酸生产废水

采用固定化白腐真菌(WRF)反应器与接触氧化反应器联用处理癸二酸废水。在WRF反应器中,以汽曝玉米秸秆为载体,并添加铜、铁促进白腐真菌生长和产酶作用,载体的使用寿命约为45 d。在进水苯酚平均质量浓度为69.36 mg/L、平均进水COD为1 648.81 mg/L的条件下,经WRF反应器处理后,苯酚平均质量浓度降至7.59 mg/L,平均出水COD降至478.03 mg/L;再经接触氧化反应器处理后,苯酚平均质量浓度降至1.65 mg/L,平均出水COD降至297.31 mg/L。     

外循环厌氧处理工艺中布水和三相分离的改进研究

污水处理中的布水设备和三相分离设备存在很多缺点,通过旋流配水装置和传统配水装置、小间距斜板三相分离装置和传统三相分离装置的比较试验,研究了旋流配水装置和小间距斜板三相分离装置的性能.研究结果表明:在相同膨胀率的条件下,旋流配水装置所需的回流量小,能耗相对较少;在水力上升流速为8 m/h时,采用旋流配水装置进水时,污泥分布曲线较平缓,污泥在高度上分布较均匀,而采用传统配水装置进水时,污泥主要分布在反应器底部,污泥浓度分布不均匀;在上升流速相同的情况下,采用小间距三相分离装置的反应器出水携带的颗粒污泥浓度较小;在相同的进水COD浓度时,小间距三相分离装置分离的沼气量较多.改进的布水和三相分离装置的性能明显优于传统的布水和三相分离装置.     

脱硫脱硫弧菌转化二氧化硫气体的研究

运用连续处理工艺研究了SO_2进气摩尔流速和去除率的关系,并对主要转化产物硫化氢和硫化物进行了测定,研究了亚硫酸盐的积累情况及其对脱硫脱硫弧菌生长的影响,同时还对碳源的消耗及转化产物进行了定量研究.实验结果表明,随着SO_2流速的提高(4·975~20·149mmol·h~(-1))菌体对二氧化硫的去除率没有发生明显的变化,始终保持在93%以上,在SO2摩尔流速低于5·034mmol·h~(-1)时产物以硫化氢为主,而随着SO_2摩尔流速的提高,液相中硫化物和亚硫酸盐开始累积;当SO_2摩尔流速增大至20·149mmol·h~(-1)时,亚硫酸盐累积浓度达到74·23mg·L~(-1),该浓度对菌体生长不会产生抑制作用;系统在SO_2摩尔流速为14·063mmol·h~(-1)下运行时较为稳定,乳酸盐全部转化为乙酸盐,每还原1mmol SO_2消耗0·4mmol CH_3CHOHCOO~-.     

Characteristics of large cooking oil pool fires and their extinguishment by water mist

Large cooking oil pool fires, occurring in industrial oil cookers, present a severe hazard to food processing plants due to their size and the large amount of hot oil involved. This paper reports a series of full-scale fire experiments conducted in a large industrial oil cooker mock-up. The characteristics of large cooking oil pool fires and the effect of oil depth and hood position in the oil cooker on fire growth were studied. The use of water mist for extinguishing large oil pool fires and their extinguishing performance under different discharge pressure and with different types of water mist systems were investigated. Experimental results showed that the cooking oil underwent a substantial expansion in volume during heating. The fires developed quickly once the oil auto-ignited. The fire growth rate was affected by the oil depth in the pan and the hood position in the oil cooker. The water mist fire suppression systems effectively extinguished large cooking oil fires and prevented them from re-igniting. Their extinguishing performance was determined by the type of water mist system, discharge pressure and hood position in the oil cooker.     

Occupational hazards to health of port workers

Objectives. The aim of this article is to reduce the risk of occupational hazards and improve safety conditions by enhancing hazard knowledge and identification as well as improving safety behavior for freight port enterprises. Methods. In the article, occupational hazards to health and their prevention measures of freight port enterprises have been summarized through a lot of occupational health evaluation work, experience and understanding. Results. Workers of freight port enterprises confront an equally wide variety of chemical, physical and psychological hazards in production technology, production environment and the course of labor. Such health hazards have been identified, the risks evaluated, the dangers to health notified and effective prevention measures which should be put in place to ensure the health of the port workers summarized. Discussion. There is still a long way to go for the freight port enterprises to prevent and control the occupational hazards. Except for occupational hazards and their prevention measures, other factors that influence the health of port workers should also be paid attention to, such as age, work history, gender, contraindication and even the occurrence and development rules of occupational hazards in current production conditions.     

RETRACTED:

Jianfeng Li  Sandra M.Y. Lee  Wenmao Liu 《Process Safety and Environmental Protection》2013,91(3):213-220

Environmental risk mapping of accidental pollution and its zonal prevention in a city

Accidental releases of pollution can have severe environmental, societal, economic, and institutional consequences. This paper considers the use of risk mapping of accidental pollution events, and zonal prevention measures for alleviating the impact on large urban areas. An Environmental Pollution Accident Risk Mapping (EPARM) model is constructed according to a mapping index system supported by quantitative sub-models dedicated to evaluating the risk arising from different sources of potential accidental pollution. The EPARM approach consists of identifying suitable indexes, assessment of environmental risk at regional and national scales based on information on previous pollution accidents and the prevailing environmental and social conditions, and use of GIS to map the overall risk. A case study of pollution accidents in Minghang District, Shanghai, China is used to demonstrate the effectiveness of the model. The paper also proposes a systemic framework for accidental environmental pollution risk prevention, and detailed countermeasures for specific risk zones.