Experimental research into effects of obstacle on methane-coal dust hybrid explosion

An experimental system including pressure transducer, data acquisition card, computer and electric spark ignition device was set up to research methane-coal dust hybrid explosions in closed tubes with different types of obstacles inside. Its dynamic response time was less than a millisecond and the test precision was 0.1%. The experimental results show that the obstacles had great effects on the explosion characteristics in the tube. Hollow obstacles linked with inner wall of the tube induced faster pressure rising than installed center blocked solid obstacles. Obstacles with more sharp corner induce more violent explosions. The most dangerous explosion occurred when spacing between obstacles almost equaled the inner diameter of the tube for the same size obstacle.     

Quantitative indicator of homeostatic risk perception in car following

Driving behavior is largely affected by the risk perception of drivers. On the basis of risk homeostasis theory, we regard that drivers may adjust car movement according to the perceived risks fluctuating around a target level. However, the manner by which risk perception is quantified remains unclear. We propose assumptions on the quantitative indicators of risk perception and identify a suitable quantitative indicator of risk perception in car-following process. Three risk indicators are discussed, i.e. time-to-collision (TTC), time headway (TH), and safety margin (SM). Using homeostatic features as bases, we found that SM more suitably quantifies homeostatic risk perception than TTC or TH does. Data collected from video drive recorders installed in taxis operating in Beijing are used to analyze the target risk level of SM (desired SM, or DSM) of professional drivers during the car-following process. The data collected by Ahn et al. (2004) to verify Newell’s model are converted into DSM data to further analyze the target risk level of general drivers. The DSM histogram of professional drivers shows that the standard deviation of the DSM value is 0.115, with a mean value of 0.862 and a total distribution close to the normal distribution. For a general driver, the mean value of DSM is 0.896, which is higher than that of professional drivers. This research may shed lights on the understanding of driving behavior.     

改良A~2/O氧化沟表曝与鼓风曝气能耗比较研究

城市污水处理厂曝气系统耗电量约占总能耗的40%～60%,正确选择曝气系统是污水处理厂节能的关键。以某城市污水处理厂改良A2/O工艺工程为例,对2010年一期氧化沟表面曝气工艺和二期氧化沟鼓风曝气工艺的实际处理效果及能耗进行了分析。结果表明,一期、二期污水处理都达到国家排放标准;二期单位污水处理电耗比一期节省25.35%,按每天10万m3的污水处理量计,二期鼓风曝气系统每年比一期表曝节省电能197.1万kW.h,节省电费134.82万元。     

双氧水热失控时的泄放面积评估

为了保证50％双氧水热失控时在储罐中的安全泄放,利用VSP2(Vent Sizing Package 2)模拟了50％双氧水在带放空测试池中绝热条件下的热失控过程,得到了过程的温度、压力、温升速率变化情况,利用DIERS通用方法计算了50％双氧水安全泄放所需的放空口面积,得到了放空口面积的计算公式.结果表明,储罐设置足够的放空口面积可保证双氧水的安全泄放,在充装系数为0.8时所需的放空面积为0.005 2 V/m.     

阻挡放电联合金属氧化物催化降解H2S的研究

采用介质阻挡放电联合金属氧化物催化降解气态H2S,考察了单组分及复合金属氧化物催化剂、催化剂与低温等离子体结合方式对H2S及副产物O3去除性能的影响,分析了等离子体联合Mn复合金属氧化物催化降解H2S机理。结果表明,金属负载量相同条件下,电压低于22kV时,Mn复合金属氧化物对H2S的催化活性高于单组分Mn金属氧化物,催化活性及对O3的分解能力从大到小依次为:Ag+Mn、Cu+Mn、Fe+Mn、Mn。当电压为18 kV时,Ag+Mn、Cu+Mn、Fe+Mn复合催化剂分别比单组分Mn催化剂对H2S的去除效率提高了近10%、6%、4%。等离子体后催化区域中Mn催化剂催化氧化H2S的效率明显低于等离子体催化区域。Mn催化剂在等离子体后催化区域中能有效催化分解O3。随着电压的升高,Mn金属氧化物在等离子体后催化区域对H2S催化作用逐渐增强。在电压22 kV时,等离子体联合后催化比单独等离子体作用时,H2S去除效率提高了近11%。     

高分子吸水树脂作为蓄冷材料的性能研究

本文研究了不同吸水倍率的高分子吸水树脂的相变温度、相变潜热及作为蓄冷材料在35℃环境下的相变时间,并与冰做了对比。结果显示：吸收不同倍率水的高分子树脂。相变温度和相变潜热基本与水相似,随着吸水倍率的增加,相变潜热越接近于水的潜热;在相同条件下放置于隔冷袋中的高分子吸水树脂．在35℃高温环境中,可以维持20℃以下低温5h,比冰多了将近1h,克服了渗漏的缺点,在蓄冷领域表现出了明显的优势。     

基于Matlab的火灾探测报警系统可靠度Monte Carlo仿真

介绍了火灾探测报警系统的结构,指出了火灾探测报警系统失效原因,针对火灾探测报警系统的特点,确定了蒙特卡洛可靠度分析法.给出了系统的概率模型,确定了在Matlab下应用Monte Carlo方法对火灾探测报警系统的可靠度进行仿真的具体步骤,得到火灾探测报警系统可靠度仿真曲线.将仿真结果与试验结果相比较,基本一致,验证了该仿真方法能正确描述火灾探测报警系统的可靠度随使用寿命的变化规律,为进一步应用该方法来分析火灾探测报警系统的的各可靠性指标提供了理论基础.     

“8·29”充装台充装现场氧气瓶爆炸事故原因分析

介绍了较为少见的充装台充装过程中氧气瓶爆炸事故,描述了事故爆炸后的现场。对爆炸气瓶碎片进行化学成分分析、机械性能、金相试验、内壁附着物化学成分分析和能谱分析。通过分析认定,由于误操作油脂混进氧气瓶,高压氧气和油脂接触发生剧烈的自燃氧化放热,使瓶内的氧气迅速升温升压,超出气瓶承压极限导致气瓶爆炸。结合工作经验,提出要严格气瓶充装前的检验,加强气瓶使用和经销单位的安全监管等防范措施和建议,对氧气瓶的安全管理具有参考价值和实际意义。     

蒙德法在火电厂液氨储罐评价单元的应用

火电厂液氨储罐单元存在大量高纯度的液氨,一旦发生火灾、爆炸,后果极其严重。为了研究液氨储罐的火灾爆炸危险性及毒性,在对火电厂液氨储罐危险性辨识的基础上,依据液氨储罐单元的主要参数,运用蒙德法分别确定评价中需要的各种危险性系数,从而进行各项指标计算,查询危险性等级表,将各项指标进行等级划分,结论表明各项危险等级都很高。在得出结论基础上,进行安全措施补偿评价,补偿后的各种危险等级均降低,可见采取补偿措施后能够一定程度的降低火灾、爆炸、毒性的危险性,防止事故的发生。     

旋转切向流聚丙烯管式膜微滤能耗分析

设计了一种新型旋转切向流聚丙烯管式膜器,实验研究了聚丙烯PA管式膜器的能耗通过建立的旋转切向流强化微滤实验装置系统,测定了聚丙烯PA管式膜器在旋转切向流和轴向流下的膜通量与能量有效利用率.实验结果表明,旋转切向流管式膜微滤比一般轴向流膜微滤的有效利用率要高得多,是一种非常有效的强化膜分离技术在实验条件下,直线切向流膜微滤和圆弧切向流膜微滤的稳态能量有效利用率比轴向流稳态能量有效利用率分别高11.185倍和14.591倍.