On-road ultrafine particle concentration in the M5 East road tunnel,Sydney, Australia

The human health effects following exposure to ultrafine (<100 nm) particles (UFPs) produced by fuel combustion, while not completely understood, are generally regarded as detrimental. Road tunnels have emerged as locations where maximum exposure to these particles may occur for the vehicle occupants using them. This study aimed to quantify and investigate the determinants of UFP concentrations in the 4 km twin-bore (eastbound and westbound) M5 East tunnel in Sydney, Australia. Sampling was undertaken using a condensation particle counter (CPC) mounted in a vehicle traversing both tunnel bores at various times of day from May through July, 2006. Supplementary measurements were conducted in February, 2008. Over three hundred transects of the tunnel were performed, and these were distributed evenly between the bores. Additional comparative measurements were conducted on a mixed route comprising major roads and shorter tunnels, all within Sydney. Individual trip average UFP concentrations in the M5 East tunnel bores ranged from 5.53 × 10⁴ p cm^?3 to 5.95 × 10⁶ p cm^?3. Data were sorted by hour of capture, and hourly median trip average (HMA) UFP concentrations ranged from 7.81 × 10⁴ p cm^?3 to 1.73 × 10⁶ p cm^?3. Hourly median UFP concentrations measured on the mixed route were between 3.71 × 10⁴ p cm^?3 and 1.55 × 10⁵ p cm^?3. Hourly heavy diesel vehicle (HDV) traffic volume was a very good determinant of UFP concentration in the eastbound tunnel bore (R² = 0.87), but much less so in the westbound bore (R² = 0.26). In both bores, the volume of passenger vehicles (i.e. unleaded gasoline-powered vehicles) was a significantly poorer determinant of particle concentration. When compared with similar studies reported previously, the measurements described here were among the highest recorded concentrations, which further highlights the contribution road tunnels may make to the overall UFP exposure of vehicle occupants.     

Approaches for quantifying reactive and low-volatility biogenic organic compound emissions by vegetation enclosure techniques - part B: applications

The focus of the studies presented in the preceding companion paper (Part A: Review) and here (Part B: Applications) is on defining representative emission rates from vegetation for determining the roles of biogenic volatile organic compound (BVOC) emissions in atmospheric chemistry and aerosol processes. The review of previously published procedures for identifying and quantifying BVOC emissions has revealed a wide variety of experimental methods used by various researchers. Experimental details become increasingly critical for quantitative emission measurements of low volatility monoterpenes (MT) and sesquiterpenes (SQT). These compounds are prone to be lost inadvertently by uptake to materials in contact with the sample air or by reactions with atmospheric oxidants. These losses become more prominent with higher molecular weight compounds, potentially leading to an underestimation of their emission rates. We present MT and SQT emission rate data from numerous experiments that include 23 deciduous tree species, 14 coniferous tree species, 8 crops, and 2 shrubs. These data indicate total, normalized (30 degrees C) basal emission rates from <10 to 5600ngCg(-1)h(-1) for MT, and from <10 to 1150ngCg(-1)h(-1) for SQT compounds. Both MT and SQT emissions have exponential dependencies on temperature (i.e. rates are proportional to e(betaT)). The inter-quartile range of beta-values for MT was between 0.12 and 0.17K(-1), which is higher than the value commonly used in models (0.09K(-1)). However many of the MT emissions also exhibited light dependencies, making it difficult to separate light and temperature influences. The primary light-dependent MT was ocimene, whose emissions were up to a factor of 10 higher than light-independent MT emissions. The inner-quartile range of beta-values for SQT was between 0.15 and 0.21K(-1).     

Development and application of microwave assisted extraction (MAE) for the extraction of five polycyclic aromatic hydrocarbons in sediment samples in Johannesburg area, South Africa

A microwave-assisted extraction (MAE) method was verified and applied for the extraction of polycyclic aromatic hydrocarbons (PAHs) in sediment samples. Soxhlet extraction was used as the reference method. The optimum MAE was carried out with 20 mL of hexane/acetone (1:1, v/v) mixture in a 1-g sample at 250 W for 20 min. Soxhlet extraction was carried out with 250 mL of dichloromethane:hexane (1:1, v/v) mixture in a 15-g sample for 24 h in a water bath maintained at 60 °C. The collected extracts were both cleaned up, reduced to 1 mL under nitrogen and then injected into an HPLC fluorescence. To increase the sample throughput, simultaneous MAE was performed. The obtained percentage recoveries ranged from 61 to 93 and 88–98 for MAE and SE, respectively. The optimised MAE method was validated using certified reference material. It was then applied to real sediment samples from in and around the greater Johannesburg area. The sediments from Jukskei River were found to be the most polluted while Hartbeespoort Dam sediments were found to be least polluted. The overall order of concentrations for the studied PAHs per site was as follows: Jukskei River?>?Kempton Park?>?Centurion Dams?>?Natalspruit River (PIT)?>?Hartbeespoort Dam.     

Dual poroelastic response of a coal seam to CO2 injection

Although the influence of gas sorption-induced coal deformation on porosity and permeability has been widely recognized, prior studies are all under conditions of no change in overburden stress and effective stress-absent where effective stresses scale inversely with applied pore pressures. Here we extend formalism to couple the transport and sorption of a compressible fluid within a dual-porosity medium where the effects of deformation are rigorously accommodated. This relaxes the prior assumption that total stresses remain constant and allows exploration of the full range of mechanical boundary conditions from invariant stress to restrained displacement. Evolution laws for permeability and related porosity are defined at the micro-scale and applied to both matrix and an assumed orthogonal, regular and continuous fracture system. Permeability and porosity respond to changes in effective stress where sorption-induced strains may build total stresses and elevate effective stresses. Gas accumulation occurs in both free- and adsorbed-phases and due to effective grain and skeletal compressibilities. A finite element model is applied to quantify the net change in permeability, the gas flow, and the resultant deformation in a prototypical coal seam under in situ stresses. Results illustrate how the CO₂ injectivity is controlled both by the competition between the effective stress and the gas transport induced volume change within the matrix system and by the dynamic interaction between the matrix system and the fracture system. For typical parameters, initial injection-related increases in permeability due to reduced effective stresses may endure for days to years but are ultimately countered by long-term reductions in permeability which may decline by an order of magnitude. Models suggest the crucial role of stresses and the dynamic interaction between matrix and fractures in correctly conditioning the observed response.     

Hospital solid waste management practices in Limpopo Province, South Africa: a case study of two hospitals

The shortcomings in the management practices of hospital solid waste in Limpopo Province of South Africa were studied by looking at two hospitals as case studies. Apart from field surveys, the generated hospital waste was weighed to compute the generation rates and was followed through various management practices to the final disposal. The findings revealed a major policy implementation gap between the national government and the hospitals. While modern practices such as landfill and incineration are used, their daily operations were not carried according to minimum standards. Incinerator ash is openly dumped and wastes are burned on landfills instead of being covered with soil. The incinerators used are also not environmentally friendly as they use old technology. The findings further revealed that there is no proper separation of wastes according to their classification as demanded by the national government. The mean percentage composition of the waste was found in the following decreasing order: general waste (60.74%)>medical waste (30.32%)>sharps (8.94%). The mean generation rates were found to be 0.60kg per patient per day.     

Slow recovery of tropical old‐field rainforest regrowth and the value and limitations of active restoration

There is current debate about the potential for secondary regrowth to rescue tropical forests from an otherwise inevitable cascade of biodiversity loss due to land clearing and scant evidence to test how well active restoration may accelerate recovery. We used site chronosequences to compare developmental trajectories of vegetation between self‐organized (i.e., spontaneous) forest regrowth and biodiversity plantings (established for ecological restoration, with many locally native tree species at high density) in the Australian wet tropics uplands. Across 28 regrowth sites aged 1–59 years, some structural attributes reached reference rainforest levels within 40 years, whereas wood volume and most tested components of native plant species richness (classified by species’ origins, family, and ecological functions) reached less than 50% of reference rainforest values. Development of native tree and shrub richness was particularly slow among species that were wind dispersed or animal dispersed with large (>10 mm) seeds. Many species with animal‐dispersed seeds were from near‐basal evolutionary lineages that contribute to recognized World Heritage values of the study region. Faster recovery was recorded in 25 biodiversity plantings of 1–25 years in which wood volume developed more rapidly; native woody plant species richness reached values similar to reference rainforest and was better represented across all dispersal modes; and species from near‐basal plant families were better (although incompletely) represented. Plantings and regrowth showed slow recovery in species richness of vines and epiphytes and in overall resemblance to forest in species composition. Our results can inform decision making about when and where to invest in active restoration and provide strong evidence that protecting old‐growth forest is crucially important for sustaining tropical biodiversity.     

Gametogenesis in Harmothoe imbricata (Polychaeta: Polynoidae)

The processes of gametogenesis in Harmothoe imbricata are described and illustrated. For most of their development the gametes are attached to the walls of segmental blood vessels. In males, only meiosis and sperm differentiation occur while the cells are free in the coelom. In females, oocytes are only released into the coelom briefly, after vitellogenesis has been completed. H. imbricata thus differs from most polychaete species so far described — where in males the spermatogonia divide mitotically to form rosettes after they have been released into the coelom, and in females the whole of vitellogenesis occurs after release of oocytes into the coelom. The oocytes of H. imbricata enter the first metaphase of meiosis before they are shed at spawning. The elongated head of the sperm in H. imbricata is atypical of polychaetes in general.     

Surface waves and roughness in self-aerated supercritical flow

In high-velocity open channel flows, free-surface aeration is commonly observed. The effects of surface waves on the air–water flow properties are tested herein. The study simulates the air–water flow past a fixed-location phase-detection probe by introducing random fluctuations of the flow depth. The present model yields results that are close to experimental observations in terms of void fraction, bubble count rate and bubble/droplet chord size distributions. The results show that the surface waves have relatively little impact on the void fraction profiles, but that the bubble count rate profiles and the distributions of bubble and chord sizes are affected by the presence of surface waves.