La chimie du plomb et du brome particulaire en atmosphere urbaine: I — Situation moyenne

Lead and Bromine aerosols are mainly abundant in the fine size fraction of atmospheric aerosol in Paris. Their time dependance concentration in relation with air trajectories at 850 mb can be explained if a mainly automotive contribution is assumed.Bromine to lead ratio is used to estimate the relative contribution of this important pollutant source.     

The assessment of water quality in the Lower Luján River (Buenos Aires,Argentina): phytoplankton and algal bioassays

The monitoring of river phytoplankton and several hydrological, physical and chemical variables, in combination with bioassays using Selenastrum capricornutum Printz, allowed the characterisation of three distinct reaches of the Lower River Luján. The upstream stretch, characterised by the lowest depth and discharge, registered the highest nutrient, dissolved heavy metal and chlorophyll a concentrations in accordance with low phytoplankton diversity and the occurrence of several species typical of organically polluted lowland rivers. A downstream improvement, concomitant to increasing river discharge, is revealed by a progressive decrease of organic pollution parameters even though algal toxicity is registered through bioassays. The water input from the Parana River through the G. Arias Channel plays an important role in the regulation of the limnology of the Lower Luján River. As a result of marked increasing discharge, depth and width, there is a decrease in nutrient concentration and phytoplankton density and an increase in dissolved oxygen concentration. Likewise, algal growth rates in the bioassays showed less toxic effect.     

Geochemical evidences of the anthropogenic alteration of trace metal composition of the sediments of Chiricahueto marsh (SE Gulf of California)

Seven sediment cores (60-80 cm) were collected at Chiricahueto marsh, a salt marsh influenced by agrochemical, domestic and industrial effluents. The concentrations of Ag, Al, Cd, Co, Cu, Fe, Li, Mn, Pb, V and Zn were studied in the solid phase at each 1-cm section. The profiles of Ag, Cd, Cu, Mn, Ni, Pb and Zn showed a slight recent pollution in the site with enrichment and anthropogenic factors higher than unity; and correlation analysis indicated a direct association with organic carbon. Al, Co, Cr, Fe, Li, and V concentration profiles displayed a negative correlation with organic C and positive with mud content and no consistent enrichment at surface. Based on the principal component analysis and correlation analysis, two principal groups of metals were identified. The first group includes Al, Co, Cr, Fe and Li, that are derived predominantly from the weathering of parent materials in the local bedrock; and the second group include most of the metals, which were relatively enriched at surficial sediments, that are produced mainly by anthropogenic activities such as agriculture (Cd, Cu and Zn), sewage effluents (Ag, Cd, Cu, Ni, Pb and Zn) and in lesser extent atmospheric deposition (Cd and Pb).     

The photocatalytic disinfection of urban waste waters

In this paper we present the results of the photocatalytic disinfection of urban waste water. Two microbial groups, total coliforms and Streptococcus faecalis, have been used as indexes to test disinfection efficiencies. Different experimental parameters have been checked, such as the effect of TiO2, solar or UV-lamp light and pH. Disinfection of water samples has been achieved employing both UV-lamp and solar light in agreement with data shown by other authors. The higher disinfection rates obtained employing an UV-lamp may be explained by the stronger incident light intensity. Nevertheless no consistent differences have been found between TiO2-photocatalysis and direct solar or UV-lamp light irradiation at natural sample pH (7.8). At pH 5 the presence of TiO2 increases the relative inactivation rate compared with the absence of the catalyst. After the photocatalytic bacterial inactivation, the later bacterial reappearance was checked for total coliforms at natural pH and pH 5, with and without TiO2. Two h after the photocatalytic treatment, CFU increment was almost nill. But 24 and 48 h later an important bacterial CFU increment was observed. This CFU increment is slower after irradiation with TiO2 at pH 5 in non-air-purged samples.     

Persistent organochlorines in beluga whales (Delphinapterus leucas) from the St Lawrence River estuary--I. Concentrations and patterns of specific PCBs, chlorinated pesticides and polychlorinated dibenzo-p-dioxins and dibenzofurans

Blubber samples from beluga whales (Delphinapterus leucas) in the St Lawrence River estuary were analysed for PCB congeners (ortho- and non-ortho-substituted) and other persistent organochlorines as well as chlorinated dibenzo-dioxins/furans (PCDD/Fs). Major individual components (mean concentrations > 1 microg g(-1)) were 4,4'-DDE, -DDD and -DDT, T12 (a toxaphene-related compound), trans-nonachlor, oxychlordane, mirex, HCB, tris(p-chlorophenyl) methane and dieldrin. Concentrations of SigmaPCBs (8.3-412 microg g(-1)), SigmaDDT (3.36-389 microg g(-1)) and mirex (0.18-6.8 microg g(-1)) were particularly elevated relative to other odontocetes in Canadian waters. SigmaDDT, PCBs (as Aroclor), mirex and T12 concentrations were positively correlated with age of adult females (> 10 years) but only weakly, or not significantly, correlated with age of adult males. PCDD/Fs were present at low ng kg(-1) levels and consisted mainly of penta- and hexachlorofurans, and hepta- and octachlorodioxin. CB126 (3,3',4,4',5-PCB) was the most prominent non-ortho-substituted PCB congener in beluga blubber. Total TCDD toxic equivalents averaged 330 ng kg(-1) in females and 1400 ng kg(-1) in males and were dominated by CB126, and the mono-ortho-substituted congeners CB105 and CB118. Biomagnification factors (BMFs) for mirex and SigmaPCB from fish to beluga ranged from 11 to 16, and were similar to BMFs in Arctic animals, indicating that elevated levels in St Lawrence animals are a consequence of relatively high levels of recalcitrant organochlorines in prey of the beluga in the St Lawrence river system.     

Examination of environmental quality of raw and composting de-inking paper sludge

Paper sludges were traditionally landfilled or burned. Over the years, the use of paper sludges on soils has increased, as well as the concerns about their environmental effects. Therefore, the chemical characterization of paper sludges and their young (immature) compost needed to be investigated, and over 150 inorganic and organic chemicals were analyzed in de-inking paper sludge (DPS). In general, nitrogen, phosphorus and potassium contents were low but variable in raw DPS and its young compost. The contents of arsenic, boron, cadmium, cobalt, chromium, manganese, mercury, molybdenum, nickel, lead, selenium, and zinc were also low and showed low variability. However, the copper contents were above the Canadian compost regulation for unrestricted use and required a follow-up. The fatty- and resin acids, and polycyclic aromatic hydrocarbons were the organic chemicals measured at the highest concentrations. For resinic acids, care should be taken to avoid that leachates reach aquatic life. For polycyclic aromatic hydrocarbons, naphthalene should be followed until soil content reaches 0.1 microg g(-1), the maximum allowed for soil use for agricultural purposes according to Canadian Environmental Quality Guidelines. In young compost, the concentration of these chemical families decreased over time and most compounds were below the detection limits after 24 weeks of composting. In raw DPS, among the phenol, halogenated and monoaromatic hydrocarbons, dioxin and furan, and polychlorinated biphenyl families, most compounds were below the detection limits. The raw DPS and its young compost do not represent a major threat for the environment but can require an environmental follow-up.     

Chemical fingerprinting applied to the evaluation of marine oil pollution in the coasts of Canary Islands (Spain)

Chemical fingerprinting approach to environmental assessment is illustrated in the evaluation of marine oil pollution in the coasts using two limpet species as bioindicator organisms, and based on profiles and concentrations of n-alkanes and aromatic hydrocarbons in their tissues. Accidental and chronic releases of hydrocarbons can contaminate the marine environment of the Canary Islands not only because of their geographical situation but also because of the very dense tanker traffic around. This situation affects coastal areas, fishing activities, tourism resort, etc. Concentrations of n-alkanes and aromatic hydrocarbons (polycyclic aromatic hydrocarbons and methyl-polycyclic aromatic hydrocarbons) in the soft tissues of the marine intertidal and subtidal limpets, Patella crenata and Patella ullysiponensis aspera, were evaluated. Limpet samples were collected at monthly intervals, at three locations on the southeast coast of Tenerife over a 3-year period (1991-93). Levels of hydrocarbons found in limpets are similar to concentrations found in unpolluted areas around the world. From application of principal component analysis, the interpretation of variable loading plots gives information on variable correlation and can be used to distinguish among potential sources of pollution and the ability of studied molluscs to be used as bioindicator organisms.     

Effect of sulfur dioxide and sulfite on photochemical energy storage of isolated chloroplasts--a photoacoustic study

Photoacoustic spectroscopy was used to study the effect of sulfite and SO(2) on isolated corn mesophyll chloroplasts by monitoring the photochemical energy storage. Sulfite incubation of isolated chloroplasts, either in light or in darkness, caused a decrease in photochemical energy storage. The more pronounced decrease in light indicates a light-dependent sulfite inhibitory site(s) in chloroplasts. Also diphenylcarbazide caused a partial recovery of energy storage in sulfite treated chloroplasts indicating a possible site of damage at the water oxidizing system. Although the chloroplast membranes were found to be insensitive to high concentrations of SO(2) for relatively short exposure periods (10 min) in light, exposure of chloroplasts to 28.5 ng cm(-3) SO(2) for 10 min caused a decrease in energy storage. An attempt was made to explain the mechanism of action of sulfite and SO(2) in chloroplasts.     

Influence of pre-treatment step on PAHs analyses in contaminated soils

There is no specific standardization for the pre-treatment of a soil sample for PAHs analyses. The ISO/FDIS 14507 method for soil quality gives a guidance for sample pre-treatment before measurement of organic contaminants in soil. It refers to cryogenic crushing which is not so easy to carry out. So, analysts lead to develop in house methods which can be very different from a laboratory to another and can involve deviations in the pollution quantification. This study has explored different ways of drying, grinding and sieving in order to determine the influence of the soil sample handling on the measured pollutant concentration. It appears that the influence of pre-treatment depends on the soil nature and on the PAHs distribution. As a conclusion, it is advised "light" drying ways like air drying or drying at 40 degrees C in a drying oven instead of more "drastic" ways (freeze-drying, cryogenic crushing) which can induce some losses. Crushing and sieving are also recommended for more reproducible measures.