Authentication of emission monitoring data and optimization of desulfurization in the molybdenum roasting process based on BAT-OOPN and the response surface method

Environmental Science and Pollution Research - This paper presents a quantitative pollutant discharge model for a typical molybdenum roasting plant, which combines the best available technology and...     

A comparison of antibiotics,antibiotic resistance genes,and bacterial community in broiler and layer manure following composting

Animal manure is an important source of antibiotics and antibiotic resistance genes (ARGs) in the environment. However, the difference of antibiotic residues and ARG profiles in layer and broiler manure as well as their compost remains unexplored. In this study, we investigated the profiles of twelve antibiotics, seventeen ARGs, and class 1 integrase gene (intI1) in layer and broiler manure, and the corresponding compost at large-scale. Compared with layer manure, broiler manure exhibited approximately six times more residual tetracyclines, especially chlortetracycline. The relative abundances of qnrS and ermA genes in broiler manure were significantly higher than those in layer manure. The concentration of tetracyclines not only had a significantly positive correlation with tetracycline resistance genes (tetA and tetC) but was also positively correlated with quinolone resistance (qepA, qnrB, and qnrS) and macrolide resistance (ermA and ermT). Most ARGs in manure were reduced after composting. However, the relative abundance of sulfonamide resistance gene sul1 increased up to 2.41% after composting, which was significantly higher than that of broiler (0.41%) and layer (0.62%) manure. The associated bacterial community was characterized by high-throughput 16S rRNA gene sequencing. The relative abundances of thermophilic bacteria had significant positive correlations with the abundance of sul1 in compost. The composting has a significant impact on the ARG-associated gut microbes in poultry manure. Variation partitioning analysis indicated that the change of bacterial community compositions and antibiotics contributed partially to the shift in ARG profiles. The results indicate that at industry-scale production broiler manure had more antibiotics and ARGs than layer manure did, and composting decreased most ARG abundances in poultry manure except for sulfonamide resistance genes.

     

Biocatalyst physiology and interplay: a protagonist of MFC operation

Environmental Science and Pollution Research - Microbial fuel cells (MFC) have been foreseen as a sustainable renewable energy resource to meet future energy demand. In the past, several studies...     

Uptake and distributions of polycyclic aromatic hydrocarbons in cultivated plants around an E-waste disposal site in Southern China

Environmental Science and Pollution Research - Polycyclic aromatic hydrocarbons (PAHs) in air, soil, and cultivated plants at e-waste disposal sites in Taizhou, Zhejiang Province, were determined...     

Fenton法处理竹制品废水生化出水的研究

采用Fenton法对竹制品废水生化出水的脱色和有机物去除进行了研究.在综合考虑经济性和去除效果的基础上,起始COD质量浓度为430 mg·L-1、色度为1 500倍的废水,在反应条件:t=30℃,pH为3.5,ρ(H2O2)=1 665 mg·L-1,c(Fe2+)/c(H2O2)=0.072,反应时间3 h的情况下,Fenton氧化处理后,COD和色度的去除率分别高达87.5%和94.4%.研究发现,色度的去除率要优于有机物(以COD计)的去除率,且受外界因素影响小.GC-MS分析结果表明:经过Fenton处理后,废水中的发色团和助色团基本上完全被去除.中间产物主要是脂类衍生物,副产品有1-碘十三烷和正辛基醚等.     

桑沟湾表层沉积物性质及对磷的吸附特征

通过研究桑沟湾表层沉积物对磷的吸附动力学曲线和吸附等温线,并结合沉积物的表面电荷性质及磷的形态分析,考察了沉积物对磷的吸附性能和吸附机制.结果表明,桑沟湾表层沉积物对磷的吸附过程包括快吸附过程和慢吸附过程,可用快慢二段一级动力学方程描述,等温线符合Langmuir交叉式模型.夏季沉积物样品的最大吸附量高于春季样品,粒级较小的沉积物吸附能力较强.沉积物样品对磷的最大吸附量Qm在0.047 1~0.123 0 mg·g-1之间,吸附/解吸平衡磷浓度(EPC0)范围在0.059 6~0.192 7 mg·L-1,沉积物充当"磷源"的作用.不同站位表层沉积物中无机磷(IP)是磷在沉积物中的主要赋存形态,吸附后的沉积物样品中弱吸附态磷(Ex-P)、铁结合态磷(Fe-P)明显增加.吸附过程包括物理吸附和化学吸附,以物理吸附为主.     

重庆市夏秋季VOCs对臭氧和二次有机气溶胶生成潜势的估算

为估算重庆市夏秋季VOCs（挥发性有机物）对O₃和SOA（二次有机气溶胶）的生成潜势,利用在线GC-MS/FID在2015年8月22日-9月23日对重庆市区点和郊区点VOCs开展了为期一个月的实时观测,获得市区点和郊区点$ \varphi $（TVOCs）（总挥发性有机物）分别为41.35×10-9和22.72×10-9,其中市区点以烷烃（35.2%）和烯炔烃（25.2%）为主,郊区点以含氧挥发性有机物（oxygenated volatile organic compounds,OVOCs）（30.6%）和烷烃（26.0%）为主.结合最大增量反应活性量化市区点和郊区点VOCs的OFPs（臭氧生成潜势）分别为149.11×10-9和71.09×10-9,市区点OFPs最大的是乙烯、丙烯、甲苯、C8和C9的芳香烃等,郊区点OFPs最大的VOCs是丙烯醛、异戊二烯和甲基乙烯基酮.结合气溶胶生成系数量化郊区点和市区点VOCs对SOA的生成贡献分别为0.36和1.26 μg/m3,相比国内其余城市VOCs的SOAP（二次有机气溶胶生成潜势）较小,主要以甲基环己烷、正壬烷、正葵烷和十一烷等高碳烷烃,以及甲苯、苯、二甲苯和乙苯等芳香烃的SOAP为主.研究显示,控制烯炔烃和芳香烃的浓度有助于控制重庆市O₃的生成,控制高碳烷烃和芳香烃则有助于控制重庆市SOA的生成.      

新型重金属絮凝剂巯基乙酰化羟甲基聚丙烯酰胺的优化制备

为提高含铜废水的处理效果及简化处理流程,以聚丙烯酰胺(PAM)、甲醛、氢氧化钠、巯基乙酸(TGA)为原料,先经羟甲基化反应制备中间产物羟甲基聚丙烯酰胺(MPAM),再通过酰胺化反应将巯基接枝到MPAM分子链上,制备出新型重金属絮凝剂巯基乙酰化羟甲基聚丙烯酰胺(MAMPAM).以水样中Cu(Ⅱ)的去除率为考察目标,采用Plackett-Burman实验、最陡爬坡实验和响应面法中CCD实验优化MAMPAM的制备条件.结果表明,MAMPAM最优制备条件为:MPAM浓度0.31%、MPAM与TGA物质的量比为1∶3.2、反应介质p H值为4.76、反应温度为25℃、反应时间为2 h,在此条件下制备的MAMPAM对Cu(Ⅱ)的去除率为95.30%,与模型的理论预测值94.47%接近,相对偏差仅为0.83%,模型合理可靠.红外分析表明MPAM分子链上成功接上了巯基.MAMPAM对不同初始浓度的含Cu(Ⅱ)水样具有很好的去除效果,Cu(Ⅱ)去除率均能达到90%以上.MAMPAM有望成为一种有效的含铜废水处理剂,具有一定的应用前景.     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

自适应智能电磁防护材料测试方法研究

目的在强电磁场环境下研究自适应智能电磁防护材料的相变特性。方法针对自适应智能电磁防护材料相变前后电导率的变化范围大、需要强场激励状况,考虑测试系统强场生成、大动态范围、测试精度以及相应的绝缘性和较高的安全性要求,采用电容充放电原理设计强场激励测试电路,搭建绝缘环境,确保操作的安全性和测试数据的可靠性。结果利用测试系统对现有商业化电阻器进行验证试验,得到的特性曲线与理论相一致。结论测试系统能够满足自适应智能电磁防护材料相变特性试验的需求,可获取有效且可靠的测试数据。