Chlorobiphenyl contaminants at Pladda and Garroch Head in the Firth of Clyde in relation to sewage sludge input

Sewage sludge dumped at Garroch Head in the Firth of Clyde contains significant quantities of chlorinated hydrocarbons, such as polychlorinated biphenyls (CBs). These compounds are lipophilic and resistant to degradation. They accumulate in the biota either from the water column or through the food chain, particularly in tissue with a high lipid content. Bottom dwelling fish, such as plaice, in the vicinity of the dump site will accumulate CBs from their environment. Eighteen of the 209 CBs were measured in plaice livers from the Garroch Head dump site and from Pladda, a site reasonably remote from the dump site but also in the Clyde, over a 7 year period prior to the cessation of dumping in December 1998. Concentrations of the congeners in the liver of fish caught at the dump site were, in general, higher than those in the liver of fish caught at Pladda. Concentrations in the plaice livers for the sum of 18 CBs ranged from 1611 to 8471 micrograms kg-1 lipid for Garroch Head samples and from 336.9 to 2635 micrograms kg-1 lipid for samples from Pladda. The data were evaluated using principal component analysis (PCA). Pattern analysis was undertaken by normalising to the recalcitrant CB 153. Livers from the dump site were found to have a higher proportion of the lower chlorinated CBs. CB patterns were similar at the Garroch Head dump site from year to year, but multivariate techniques showed that there were differences in pattern when normalised to CB 153.     

A ten channel fibre-optic device for distributed sensing of underground hydrocarbon leakage

With millions of fuel storage tanks and oil pipelines installed around the world, there is inevitably frequent leakage of potentially hazardous hydrocarbons. As many of these installations are below ground, it can often be many years before the extent of the leak is discovered. We have previously reported the development of a sensor for the detection of such subterranean leaks, using infrared reflectometry to interrogate a hydrocarbon sensitive membrane. However, a single sensor cannot provide any information about the flow rate or direction of the leak. This paper describes the extension of the technology to a multi-channel distributed sensing system, using optical fibres capable of distributing the sensors over large subterranean areas. Results are reported from the evaluation of the device, which consisted of monitoring the movement of different hydrocarbons (gasoline, diesel and insulating oil) through a vertical sand-filled vessel.     

Adsorption characteristics of a phenoxy acetic acid herbicide on activated carbon

The adsorption of 2,4-dichlorophenoxyacetic acid (2,4-D) by two powdered coal activated carbons was studied in aqueous solution. The modelling of the adsorption equilibrium showed that the adsorption of 2,4-D fitted a Langmuir isotherm. Adsorption was influenced by the activated carbon type, adsorbent concentration and solution characteristics. The adsorption was found to decrease with an increase in pH over the range 1.5-9. Maximum adsorption occurred at pH approximately 2.5, which corresponds to the 2,4-D pKa value. The amount of 2,4-D adsorbed was also found to depend on the NaCl concentration.     

A novel sensor for monitoring leakage of petroleum and other liquid hydrocarbons into soil environments

This paper describes the use of a potentially implantable infrared reflectometer for the qualitative detection of petroleum and a number of other hydrocarbon solvents. A rugged, low-power, re-useable sensor was evaluated in the laboratory for its ability to detect petrol in soil. A hydrophobic fluoropolymer was used as the sensing surface due to its high selectivity for petroleum hydrocarbons. The photocurrent reflected by this surface from a near IR source was measured to test for petroleum saturation within the membrane, which in turn was an indicator of petroleum in the surrounding soil. The simplicity in the sensor design enabled a stable, low cost detection method for petroleum and other hydrocarbons, ideal for use in sub-surface applications.     

Indoor and outdoor formaldehyde concentrations in homes in residential areas in Greater Cairo

Indoor and outdoor measurements of formaldehyde were conducted at seven flats located in residential areas in Greater Cairo, during spring and summer seasons 1999. The mean daytime formaldehyde concentrations in kitchens, bedrooms and living rooms were 89, 100 and 100 ppb, respectively, in the seven flats. Significant positive correlations were found between the concentrations of formaldehyde found in these three rooms. On the other hand, no significant differences were found between the mean formaldehyde concentrations in these three rooms. The maximum mean concentration of formaldehyde (147 ppb) was recorded in a new flat, while the minimum concentration (43 ppb) was observed in an old flat. The maximum hourly and daytime concentrations were 350 and 225 ppb, respectively. Air temperature, relative humidity and the age of the flat are factors affecting the emission and concentration of formaldehyde. The maximum indoor and outdoor formaldehyde concentrations were recorded during the summer season. During the spring, 38% of the samples indicated that the concentration of formaldehyde in the seven flats exceeded 0.1 ppm, the American Society of Heating, Refrigerating, and Air Conditioning Engineers' (ASHRAE) standard; in the summer, this figure increased to 53%.     

Evaluation of airborne lead in the welding working environment

Manual and automatic welding machines (which use leaded alloys) are considered to be important sources of the emission of lead fumes into the general air of the working environment. Three workplaces at a television factory were selected for the present study, to determine the control class of the working unit. The concentrations of conventional measurements ("A" sampling points) were lower than the administrative control level (statutory standard of lead, 150 microg m(-3)), whereas the maximum concentration of 264.1 microg m(-3) ("B" sampling point) was higher at one working unit than the administrative control level. However, the control classes varied between class III (bad) and class I (good).     

Temporal variation in a coral reef community at Pattaya Bay,Gulf of Thailand

Changes in the fringing coral reef community of a small island (Ko Nok) at Pattaya Bay, Gulf of Thailand, were examined at the beginning and at the end of a 3-year period using 7m×7m permanent quadrats for benthic organisms, and visual census along 100m transects for fish. The coral community was dominated by Porites lutea in terms of colony number and areal cover throughout the period. Variations in the community structure parameters on opposite sides of the island indicated increasing dissimilarity with time. Little variation in live coral cover was noted, but colony number and species diversity declined on both sides. The abundance of edible fish species dropped while that of non-edible species increased over the 3-year period, indicating selective removal of the former category through fishing. Impacts from both human and natural influences are implicated in these changes.     

Organochlorine and mercury residues in Swainson's and ferruginous hawk eggs collected in North and South Dakota, 1974–79

Residues of organochlorine pesticides, polychlorinated biphenyls (PCBs), and mercury were measured in eggs of Swainson's hawks (Buteo swainsoni) and ferruginous hawks (B. regalis) collected in North and South Dakota during 1974–79. DDE was the most common compound detected in the eggs, but residues were below levels known to have adverse effects on reproduction. Other organochlorine compounds and mercury were found at low levels. Eggs of ferruginous hawks tended to contain more compounds with higher residues than eggs of Swainson's hawks.     

The characteristics of size distribution of suspended particulates in the air for sulphates and selected metals in different areas and seasons

The characteristics of the distribution of particles by size were investigated for sulphates and selected metals (Pb, Fe, Mn, and Cu) in the air in two urban and an industrial area during the winter and summer periods using an Andersen cascade impactor.In the case of metals, but not sulphates, the character of the area affected the value of mass median diameter. Lowest values were obtained in a sparsely populated urban area, whereas in a densely populated urban area and in the industrial area the values were higher.In the industrial area a high correlation coefficient was found between sulphate and manganese, and between sulphate and lead, as well as a high value of the equivalent Mn²⁺/SO _inf4 ^sup2- ratio for the total sample. It may therefore be assumed that in the industrial area manganese produces a catalytic effect on SO₂ conversion to sulphate. Among the investigated metals lead stands out as a dominant cation which binds to the sulphate ion in the industrial and densely populated areas.