Destruction of VOCs by combination of corona discharge and catalysis techniques

The catalytic effect of alumina on the destruction of toluene, benzene, acetone and methanol, in DC pulsed corona discharge reactor was studied. In the presence of alumina the inlet concentration of the VOCs was varied from 5 x 10-6 mol/L to 80% x 10-6 mol/L, and their decomposition efficiency (conversion %) was found to be 99%-80% for toluene, 99%-97% for benzene, 95%-92% for acetone, and 72%-85% for methanol. Corresponding decomposition in the absence of alumina was 90%-38% for toluene, 89%-57% forbenzene, 42%-30% for acetone, and 47%-19% for methanol. Feed gas flow rate was 400 cm3/min and power reading from DC source was 7.4 W in all of the experiments. Alumina also shifted the CO/CO2 ratio in the by-products in favor of CO2. Ozone concentration at the reactor outlet was higher in the presence of alumina. Enhancement in VOCs decomposition by alumina was explained on the basis of higher concentration of ozone and its precursor atomic oxygen [O].Decomposition efficiency (conversion %) for individual compounds was found to be inversely proportional to the ionization potential of the compound, under identical conditions. Double DC high voltage sources pulse generator was tested and found to improve VOCs decomposition compared with the conventional single DC high voltage source.     

Overcoming growing water scarcity: Exploring potential improvements in water productivity in India

Improvements in water productivity (WP) are often suggested as one of the alternative strategies for overcoming growing water scarcity in India. This paper explores the potential improvements in WP of food grains at district level, which currently varies between 0.11 and 1.01 kilogram per cubic metre (kg/m³), in the 403 districts that account for 98% of the total production of food grains. The paper first finds the maximum yield function conditional on consumptive water use (CWU) and then explores the potential improvements in WP by: (a) bridging the gap between actual and maximum yield while keeping CWU constant; and (b) changing the maximum yield by adjusting the CWU using supplementary or deficit irrigation. Deficit irrigation in some areas may decrease yield but can increase production if land availability is not a constraint. A large potential exists for bridging the yield gap in irrigated areas with CWU between 300 and 475 mm. Of the 222 districts that fall under this category, a 50% reduction in yield gap alone could increase production by 100 million tonnes (Mt) without increasing CWU. Supplementary irrigation can increase yield and WP in rain‐fed and irrigated areas of 266 and 16 districts with CWU is below 300 mm. Deficit irrigation in irrigated areas of 185 districts with CWU above 475 mm could increase yield, WP and production. Decreasing CWU in irrigated areas with CWU between 425 and 475 mm reduces yield slightly, but if availability of land is not a constraint then the benefits due to water saving and production increases could exceed the cost.     

Fate of carbosulfan and monocrotophos in sandy loam soils of Pakistan under field conditions at different watertable depths

Information regarding pesticide mobility is critical for the evaluation of pesticide management practices. For this purpose, lysimetric studies were conducted to develop assessment schemes to protect groundwater from unacceptable effects caused by pesticide use. By using these studies, specific monitoring actions and prevention measures for the protection of waters can be studied, and the results thus obtained can provide the local authorities and the decision makers with an identification tool for demarcating risk areas. Pesticide residues were found at the bottom of lysimeters in the following pattern i.e., 1.52 > 2.1 > 2.74 m which could represent an "index of risk" for groundwater pollution. Regressions built for carbofuran and monocrotophos against watertable depths showed a decreasing trend of pesticide in higher watertable treatments. These findings support the existence of a significant role for chromatographic flow in sandy texture soil. Moreover, the higher values of pesticide residue at the bottom of lysimeters reflect that chromatographic flow as well as preferential flow pattern prevails during higher precipitation events. The precipitation received during the study was higher than the 10 year average and can be considered relatively as a worst case scenario. Finally, the authors have recommended a standardized pesticide monitoring scheme for groundwater in accordance with the already validated generic schemes in developed countries.     

Distribution of nitrogen species in groundwater aquifers of an industrial area in alluvial Indo-Gangetic Plains—a case study

The groundwater samples collected from the shallow and deep groundwater aquifers of an industrial area of the Kanpur city (Uttar Pradesh, India) were analyzed for the concentration levels and distribution pattern of nitrogenous species, such as nitrate-nitrogen (NO₃-N), nitrite-nitrogen (NO₂-N), ammonical-nitrogen (NH₄-N), organic-nitrogen (Org-N) and total Kjeldahl-nitrogen (TKN) to identify the possible contamination source. Geo-statistical approach was adopted to determine the distribution and extent of the contaminant plume. In the groundwater aquifers NO₃-N, NO₂-N, NH₄-N, TKN, Org-N and Total-N ranged from 0.10 to 64.10, BDL (below detection limit)-6.57, BDL-39.00, 7.84–202.16, 1.39–198.97 and 8.89–219.43 mg l⁻¹, respectively. About 42% and 26% of the groundwater samples of the shallow and deep groundwater aquifers, respectively, exceeded the BIS (Bureau of Indian Standards) guideline value of 10 mg l⁻¹ for NO₃-N and may pose serious health hazards to the people of the area. The results of the study revealed that the groundwater aquifers of the study area are highly contaminated with the nitrate and indicates point source pollution of nitrate in the study area.     

Assessing spatio-temporal trend of vector breeding and dengue fever incidence in association with meteorological conditions

Th aim of this study is to investigate spatio-temporal trends of dengue vector breeding and epidemic (disease incidence) influenced by climatic factors. The spatio-temporal (low-, medium-, and high-intensity periods) evaluation of entomological and epidemiological investigations along with climatic factors like rainfall (RF), temperature (T_max), relative humidity (RH), and larval indexing was conducted to develop correlations in the area of Lahore, Pakistan. The vector abundance and disease transmission trend was geo-tagged for spatial insight. The sufficient rainfall events and optimum temperature and relative humidity supported dengue vector breeding with high larval indices for water-related containers (27–37%). Among temporal analysis, the high-intensity period exponentially projected disease incidence followed by post-rainfall impacts. The high larval incidence that was observed in early high-intensity periods effected the dengue incidence. The disease incidence had a strong association with RF (r = 0.940, α = 0.01). The vector larva occurrence (r = 0.017, α = 0.05) influenced the disease incidence. Similarly, RH (r = 0.674, α = 0.05) and average T_max (r = 0.307, α = 0.05) also induced impact on the disease incidence. In this study, the vulnerability to dengue fever highly correlates with meteorological factors during high-intensity period. It provides area-specific understanding of vector behavior, key containers, and seasonal patterns of dengue vector breeding and disease transmission which is essential for preparing an effective prevention plan against the vector.     

Mutagenicity assessment of contaminated soil in the vicinity of industrial area

In the industrial area of Chinhat, Lucknow (India) wastewater coming from pesticide manufacturing and other industries is used to irrigate the agricultural crops. This practice has been polluting the soil and pollutants might reach the food chain. Gas chromatographic analysis revealed the presence of certain organochlorine pesticides in soil samples. Samples were extracted using different solvents, i.e., hexane, acetonitrile, methanol, chloroform, and acetone (all were HPLC-grade, SRL, India). Soil extracts were assayed for mutagenicity using Ames Salmonella/mammalian microsome test. Mutagenicity was observed in the test samples and TA98 was the most responsive strain for all the soil extracts (irrigated with wastewater) in terms of mutagenic index in the presence (+S9) and absence (−S9) of metabolic activation. In terms of slope (m) of linear dose–response curve for the most responsive strain TA98 exhibited highest sensitivity against the soil extracts in the presence and absence of S9 fraction. Hexane-extracted soil sample (wastewater) exhibited maximum mutagenicity in terms of net revertants per gram of soil in the presence and absence of S9 mix as compared to the other soil extracts. Groundwater-irrigated soil extracts displayed low level of mutagenicity as compared to wastewater-irrigated soil. The soil is accumulating a large number of pollutants due to wastewater irrigation and this practice of accumulation has an adverse impact on soil health.     

Mutagenicity and genotoxicity assessment of industrial wastewaters

The genotoxicity of industrial wastewaters from Jajmau (Kanpur), was carried out by Ames Salmonella/microsome test, DNA repair-defective mutants, and Allium cepa anaphase–telophase test. Test samples showed maximum response with TA98 strain with and without metabolic activation. Amberlite resins concentrated wastewater samples were found to be more mutagenic as compared to those of liquid–liquid extracts (hexane and dichloromethane extracts). The damage in the DNA repair defective mutants in the presence of Amberlite resins concentrated water samples were found to be higher to that of liquid–liquid-extracted water samples at the dose level of 20 μl/ml culture. Among all the mutants, polA exhibited maximum decline with test samples. Mitotic index (MI) of root tip meristematic cells of A. cepa treated with 5, 10, 25, 50, and 100 % (v/v) wastewaters were significantly lower than the control. Complementary to the lower levels of MI, the wastewaters showed higher chromosomal aberration levels in all cases investigated.     

Adsorption of pesticides by salorthids and camborthids of Punjab,Pakistan

This study was conducted to examine adsorption of pesticides bifenthrin, carbosulfan, λ-cyhalothrin, cypermethrin, endosulfan, parathion methyl, monocrotophos and 4-nitrophenol by sandy clay loam (S.C.L) and sandy loam (S.L) soils (with varying organic content). There was no significant difference between the observed soil water partitioning coefficient values (K _d) derived from linear and nonlinear Freundlich isotherms. Adsorption of pesticides on S.C.L soils was higher than those on S.L soils. K _d values showed significant correlations (r ²?=?0.8???0.99 and 0.65???0.97) with soil organic carbon content (OC) and weak correlations (r ²?=?0.2???0.29 and 0.1???0.18) with clay contents of S.C.L and S.L soil at p?≤?0.05, respectively for all pesticides (except monocrotophos). Observed K _oc values (soil-water partitioning constants based on the organic C fraction of the soil) were in accordance with the literature values of Wauchope and Tomlin with a maximum deviation of less than 0.5 log units. Ten Quantitative Property-Property Relationships (QPPR) among water solubility, n-octanol water coefficient (K _ow) and K _oc were proposed for studied pesticides except monocrotophos. The models were considered acceptable when predicted-observed difference for log?K _ow and log?K _oc were ≤?0.3 and ≤?0.5?log units, respectively, during the validation procedure. This work indicates that the log?K _oc derived from the log K_ow, from some of existing relationships, may be a fair predictor where observed values (i.e., K _d and K _oc) are not available. Furthermore, predicted leaching potential by groundwater ubiquity scores (GUS) equation was solved by using observed K _oc values and literature reported half lives of pesticides. GUS ranked the mobility of nonvolatile compounds i.e., bifenthrin, λ-cyhalothrin, cypermethrin and endosulfan extremely low; methyl parathion very low; 4-nitrophenol low; carbofuran and monocrotophos very high in S.C.L and S.L soils, respectively. Results discussed in this paper provide background to prioritize pesticides or chemical groups that should be evaluated under field conditions with regard to their leaching potential to groundwater in arid climates.     

Levellised electricity cost for wind and PV–diesel hybrid system in Oman at selected sites

Solar and wind energy data available for Oman indicate that these two resources are likely to play an important role in the future energy generation in this country. In this paper, a model is designed to assess wind and solar power cost per kWh of energy produced using different sizes of wind machines and photovoltaic (PV) panels at two sites in Oman, which then can be generalised for other locations in Oman. Hourly values of wind speed and solar radiation recorded for several years are used for these locations. The wind profiles from Thumrait and Masirah island are modelled using the Weibull distribution. The cost of wind-based energy is calculated for both locations using different sizes of turbines. Furthermore, this paper presents a study carried out to investigate the economics of using PV only and PV with battery as an energy fuel saver in two villages. The results show that the PV energy utilisation is an attractive option with an energy cost of the selected PV ranges between 0.128 and 0.144 $/kWh at 7.55% discount rate compared to an operating cost of 0.128–0.558 $\kWh for diesel generation, considering the capital cost of diesel units as sunk.     

Development of controlled release formulations of carbofuran and imidacloprid and their bioefficacy evaluation against aphid,Aphis gossypii and leafhopper,Amrasca biguttula biguttula Ishida on potato crop

Controlled release (CR) formulations of carbofuran and imidacloprid were prepared employing polyvinyl chloride and carboxymethyl cellulose (CMC) and their bioefficacy was evaluated against the aphid, Aphis gossypii and leafhopper, Amrasca biguttula biguttula Ishida on potato crop. The CR formulations of carbofuran and imidacloprid provided better or equal control of the pests than commercial formulations. CMC-based formulation provided a superior control of both the pests. The Imida-CMC, which showed the lowest population of leaf hopper (10.50 leafhopper/100 cl), provided significantly superior control among all treatments after 35 days after germination (DAG). The residue of carbofuran and imidacloprid in potato tuber and soils were not detectable at the time of harvesting in any one of the formulations.