Plant availability of bound anilazine residues in a degraded loess soil

Abstract

The relative biological availability of [benzene ring‐U‐¹⁴C] and Ctriazine‐U‐¹⁴C] anilazine for maize plants was studied in a degraded loess soil in a standardized microecosystem. The total uptake of radiocarbon in the course of the 4‐week experiment was 3.1 and 4 % respectively of the radioactivity applied if anilazine was uniformly mixed into the soil immediately before beginning the experiment. However, if anilazine was subjected to a degradation at 65 % of the maximum water holding capacity of the soil and temperatures varying daily between 16 and 27°C for 100 days before the plant experiment then the uptake was reduced to 0.4 or 0.7 % respectively. The uptake from soil with non‐extractable (bound) anilazine residues was similarly low. The mineralization rate of aged and bound anilazine residues was below 0.1 % of the radioactivity applied. Up to 2/3 of the radioactivity present in the soil after the plant experiment remained in the humic fraction.     

Field application of evaluated methodology for determining 1,2‐dibromoethane,EDB, in ambient air

Abstract

EDB (ethylene dibromide) is of regulatory interest because it has cancer inducing properties and is a causative agent of aspermia. Previously evaluated methodology was used to determine the extent of exposure of workers to EDB in citrus fumigation stations and a warehouse used as a holding site before shipment. The purpose of this effort was to carry out environmental sampling, and to determine the exposure level of workers and related administrative personnel at two citrus fumigation centers and at a warehouse     

Diflubenzuron residue and persistence on an oak forest after aerial application

Abstract

A twenty hectare forest block in central Pennsylvania was aerially sprayed with diflubenzuron (Dimilin 25W®) at the dose of 33.23g A.I./ha in 9.4 litres/ha. Leaf samples were collected from the upper and lower canopies of 27 oaks and understory within this block on the day of spray, May 29, 1991. Canopy leaves were also collected on May 31, June 10, July 29 and September 26, 1991.

Recovery of diflubenzuron residues on fortified canopy‐leaf and litter‐leaf samples using analytical techniques employed in this study averaged 87.4% (SE = 7.5%) and 66.2% (SE = 8.2%), respectively.

On the day of spray, diflubenzuron residues on the upper canopy, lower canopy and understory averaged 81.18, 39.65 and 8.35 ng/cm², respectively. Diflubenzuron residues on canopy‐leaf samples collected 2, 12, 61 and 120 days post‐spray averaged 14.83 (SE = 10.19), 16.75 (SE = 9.95), 12.84 (SE = 8.25) and 11.20 (SE = 7.52) ng/cm², respectively. Diflubenzuron residues on litter‐leaf samples collected after leaf senescence ‐ 169 and 323 days post spray contained measurable amounts of diflubenzuron in 51 and 59% of the samples, respectively. Of the samples with measurable amounts of diflubenzuron, residues averaged 1.36 (SE = 2.44) and 0.65 ng/cm² (SE = 0.73) respectively.     

Minimizing drift and exposure from knapsack sprayers

Abstract

An improved drift shield for attaching to the lance of conventional knapsack sprayer to reduce wind induced drift and operator exposure was designed and tested. The drift shield consists of a conical wire frame covered with polythene and has an annular opening at the point of attachment to the lance which allows air to be drawn into the shield while spraying. Tests conducted with winds in the range of 1.25–5.75 m/s show that wind can increase the width of spray swath from an unshielded lance, up to 4.3 times the normal swath in no‐wind condition. Use of a conventional shield contained the swath width within 3.5 times and the improved shield restricted the swath width to 3.1 times the normal swath. Spray deposit from an unshielded lance, within the normal swath decreased to as low as 45%, due to wind effects. However, use of the conventional, and the improved shields enhanced the spray deposit to 54.2% and 68%, respectively. The improved drift shield improved the spray pattern displacement (SPD) significantly (P<0.05) compared with the conventional shield and the unshielded lance when the wind speed exceeded 1.25 m/s. The improved shield decreased the off target drift by as much as 63% compared with the unshielded spray. It also decreased the quantity of pesticide deposit on the operator's body by 41–84% and thereby reduced exposure and improved safety.     

Numerical modeling on air quality in an urban environment with changes of the aspect ratio and wind direction

Due to heavy traffic emissions within an urban environment, air quality during the last decade becomes worse year by year and hazard to public health. In the present work, numerical modeling of flow and dispersion of gaseous emissions from vehicle exhaust in a street canyon were investigated under changes of the aspect ratio and wind direction. The three-dimensional flow and dispersion of gaseous pollutants were modeled using a computational fluid dynamics (CFD) model which was numerically solved using Reynolds-averaged Navier–Stokes (RANS) equations. The diffusion flow field in the atmospheric boundary layer within the street canyon was studied for different aspect ratios (W/H?=?1/2, 3/4, and 1) and wind directions (θ?=?90°, 112.5°, 135°, and 157.5°). The numerical models were validated against wind tunnel results to optimize the turbulence model. The numerical results agreed well with the wind tunnel results. The simulation demonstrated that the minimum concentration at the human respiration height within the street canyon was on the windward side for aspect ratios W/H?=?1/2 and 1 and wind directions θ?=?112.5°, 135°, and 157.5°. The pollutant concentration level decreases as the wind direction and aspect ratio increase. The wind velocity and turbulence intensity increase as the aspect ratio and wind direction increase.     

Emission characteristics of air pollutants from incense and candle burning in indoor atmospheres

Volatile organic compounds (VOCs) and particles emitted by incense sticks and candles combustion in an experimental room have been monitored on-line and continuously with a high time resolution using a state-of-the-art high sensitivity-proton transfer reaction-mass spectrometer (HS-PTR-MS) and a condensation particle counter (CPC), respectively. The VOC concentration–time profiles, i.e., an increase up to a maximum concentration immediately after the burning period followed by a decrease which returns to the initial concentration levels, were strongly influenced by the ventilation and surface interactions. The obtained kinetic data set allows establishing a qualitative correlation between the elimination rate constants of VOCs and their physicochemical properties such as vapor pressure and molecular weight. The emission of particles increased dramatically during the combustion, up to 9.1(±0.2)?×?10⁴ and 22.0(±0.2)?×?10⁴ part cm^?3 for incenses and candles, respectively. The performed kinetic measurements highlight the temporal evolution of the exposure level and reveal the importance of ventilation and deposition to remove the particles in a few hours in indoor environments.     

Emerging technologies for removing nonpoint phosphorus from surface water and groundwater: introduction

Coastal and freshwater eutrophication continues to accelerate at sites around the world despite intense efforts to control agricultural P loss using traditional conservation and nutrient management strategies. To achieve required reductions in nonpoint P over the next decade, new tools will be needed to address P transfers from soils and applied P sources. Innovative remediation practices are being developed to remove nonpoint P sources from surface water and groundwater using P sorbing materials (PSMs) derived from natural, synthetic, and industrial sources. A wide array of technologies has been conceived, ranging from amendments that immobilize P in soils and manures to filters that remove P from agricultural drainage waters. This collection of papers summarizes theoretical modeling, laboratory, field, and economic assessments of P removal technologies. Modeling and laboratory studies demonstrate the importance of evaluating P removal technologies under controlled conditions before field deployment, and field studies highlight several challenges to P removal that may be unanticipated in the laboratory, including limited P retention by filters during storms, as well as clogging of filters due to sedimentation. Despite the potential of P removal technologies to improve water quality, gaps in our knowledge remain, and additional studies are needed to characterize the long-term performance of these technologies, as well as to more fully understand their costs and benefits in the context of whole-farm- and watershed-scale P management.     

Living with nuclear power: Sense of place,proximity, and risk perceptions in local host communities

Previous research notes that sense of place may intensify, and that levels of public risk perception may decrease with proximity to an established hazardous or stigmatised site. In addition, the literature suggests that sense of place may act either to mediate or moderate community perceptions of risk in such localities. This study comprised a major household survey (n = 1326) and an interview study (n = 39) and was conducted close to the nuclear power stations at Oldbury and Hinkley Point, both in the UK. It investigated the roles of perceptions of place and hazard proximity in considering (a) perceptions of risk and (b) public attitudes towards the building of a new nuclear power station in the nearby area. In addition, a novel scale was developed to measure the perceived contribution of the nearby nuclear power station to sense of place. The results suggest first, that sense of place mediates (but does not moderate) perceptions of risk in very proximate communities, and second, that public attitudes to new build in communities situated very close to established nuclear sites may be largely dependent on the extent to which the existing facility is perceived to contribute towards sense of place. The implications of these results for existing theory are discussed.     

A Framework for Responding to Coral Disease Outbreaks that Facilitates Adaptive Management

Predicted increases in coral disease outbreaks associated with climate change have implications for coral reef ecosystems and the people and industries that depend on them. It is critical that coral reef managers understand these implications and have the ability to assess and reduce risk, detect and contain outbreaks, and monitor and minimise impacts. Here, we present a coral disease response framework that has four core components: (1) an early warning system, (2) a tiered impact assessment program, (3) scaled management actions and (4) a communication plan. The early warning system combines predictive tools that monitor the risk of outbreaks of temperature-dependent coral diseases with in situ observations provided by a network of observers who regularly report on coral health and reef state. Verified reports of an increase in disease prevalence trigger a tiered response of more detailed impact assessment, targeted research and/or management actions. The response is scaled to the risk posed by the outbreak, which is a function of the severity and spatial extent of the impacts. We review potential management actions to mitigate coral disease impacts and facilitate recovery, considering emerging strategies unique to coral disease and more established strategies to support reef resilience. We also describe approaches to communicating about coral disease outbreaks that will address common misperceptions and raise awareness of the coral disease threat. By adopting this framework, managers and researchers can establish a community of practice and can develop response plans for the management of coral disease outbreaks based on local needs. The collaborations between managers and researchers we suggest will enable adaptive management of disease impacts following evaluating the cost-effectiveness of emerging response actions and incrementally improving our understanding of outbreak causation.     

Determination of anti-anxiety and anti-epileptic drugs in hospital effluent and a preliminary risk assessment

In this study, an analytical methodology was developed for the determination of psycho-active drugs in the treated effluent of the University Hospital at the Federal University of Santa Maria, RS – Brazil. Samples were collected from point A (Emergency) and point B (General effluent). The adopted methodology included a pre-concentration procedure involving the use of solid phase extraction and determination by liquid chromatography coupled to mass spectrometry. The limit of detection for bromazepam and lorazepam was 4.9 ± 1.0 ng L⁻¹ and, for carbamazepine, clonazepam and diazepam was 6.1 ± 1.5 ng L⁻¹. The limit of quantification was 30.0 ± 1.1 ng L⁻¹, for bromazepam, clonazepam and lorazepam; for carbamazepine was 50.0 ± 1.8 ng L⁻¹ and was 40.0 ± 1.0 ng L⁻¹ for diazepam. The mean concentrations in the Emergency and General effluent treated currents were as follows: for bromazepam, 195 ± 6 ng L⁻¹ and 137 ± 7 ng L⁻¹; for carbamazepine, 590 ± 6 ng L⁻¹ and 461 ± 10 ng L⁻¹; for diazepam, 645 ± 1 ng L⁻¹ and 571 ± 10 ng L⁻¹; for lorazepam, 96 ± 7 ng L⁻¹ and 42 ± 4 ng L⁻¹; and for clonazepam, 134 ± 10 ng L⁻¹ and 57 ± 10 ng L⁻¹. A preliminary risk assessment was conducted: carbamazepine and diazepam require considerable attention owing to their environmental toxicity. The occurrence of these psychoactive-drugs and the environmental risks that they pose demonstrated the need for a more efficient treatment system. As far we are aware, there have been no comparable studies to this on the hazards of hospital effluents in Brazil, and very few that have carried out a risk assessment of psycho-active drugs in hospital effluent in general.