Biochar as low-cost sorbent of volatile fuel organic compounds: potential application to water remediation

Pyrolysis of waste materials to produce biochar is an excellent and suitable alternative supporting a circular bio-based economy. One of the properties attributed to biochar is the capacity for sorbing organic contaminants, which is determined by its composition and physicochemical characteristics. In this study, the capacity of waste-derived biochar to retain volatile fuel organic compounds (benzene, toluene, ethylbenzene and xylene (BTEX) and fuel oxygenates (FO)) from artificially contaminated water was assessed using batch-based sorption experiments. Additionally, the sorption isotherms were established. The results showed significant differences between BTEX and FO sorption on biochar, being the most hydrophobic and non-polar contaminants those showing the highest retention. Furthermore, the sorption process reflected a multilayer behaviour and a relatively high sorption capacity of the biochar materials. Langmuir and Freundlich models were adequate to describe the experimental results and to detect general differences in the sorption behaviour of volatile fuel organic compounds. It was also observed that the feedstock material and biochar pyrolysis conditions had a significant influence in the sorption process. The highest sorption capacity was found in biochars produced at high temperature (>?400 °C) and thus rich in aromatic C, such as eucalyptus and corn cob biochars. Overall, waste-derived biochar offers a viable alternative to be used in the remediation of volatile fuel organic compounds from water due to its high sorption capacity.

     

BIO_ALGAE 2: improved model of microalgae and bacteria consortia for wastewater treatment

Environmental Science and Pollution Research - A new set up of the integral mechanistic BIO_ALGAE model that describes the complex interactions in mixed algal-bacterial systems was developed to...     

Simultaneous removal of metronidazole and Pb(II) from aqueous solution onto bifunctional activated carbons

Environmental Science and Pollution Research - In this work, it was analyzed the behavior of three commercial activated carbons with different textural and chemical properties to adsorb...     

Recovering Food Commons in Post Industrial Europe: Cooperation Networks in Organic Food Provisioning in Catalonia and Norway

This paper explores food commoning through an ethnographic case study in Catalonia as our primary site while the Norwegian case is juxtaposed as a comparison, two agriculturally and economically different European countries. The ethnography analyses cooperation networks between organic food producers’ and consumers’ involving different nodes of community gardening initiatives, self-employed growers, local farmers and all of them under a unique cooperative integrating a community economy. The result it is a myriad of exchange practices ranging from reciprocity and barter to market exchange without intermediaries through on-line platforms. Along these exchanges different options of currency intervene giving rise to novel social and cooperative relations. Similar initiatives in Norway show less variation and are less experimental regarding forms of payment but share similarities in relation to material articulations, concerns and forms of alternative practice. Although these novel forms do not represent a complete break from the more standardized supply chains, and hence from the oppositions/contradictions of production and consumption, the participants see themselves as contributing to a more general process of de-commodification of food. We explore the extent to which the meaning and moral values are mutually constituted in relation to socioeconomic exchanges and environmental caring that each person experiences based on different forms of cooperation and reciprocity. Food, we suggest, is more than a commodity on the market that we may influence through our role as consumers. It is a significant focal point connecting our lives to those of others that articulates one’s relations to society in a political manner.     

Oxidative properties of ambient PM2.5 and elemental composition: Heterogeneous associations in 19 European cities

We assessed the extent to which constituents of PM_2.5 (transition metals, sodium, chloride) contribute to the ability to generate hydroxyl radicals (OH) in vitro in PM_2.5 sampled at 20 locations in 19 European centres participating in the European Community Respiratory Health Survey. PM_2.5 samples (n = 716) were collected on filters over one year and the oxidative activity of particle suspensions obtained from these filters was then assessed by measuring their ability to generate OH in the presence of hydrogen peroxide. Associations between OH formation and the studied PM constituents were heterogeneous. The total explained variance ranged from 85% in Norwich to only 6% in Albacete. Among the 20 centres, 15 showed positive correlations between one or more of the measured transition metals (copper, iron, manganese, lead, vanadium and titanium) and OH formation. In 9 of 20 centres OH formation was negatively associated with chloride, and in 3 centres with sodium. Across 19 European cities, elements which explained the largest variations in OH formation were chloride, iron and sodium.     

Characterization and sources assignation of PM2.5 organic aerosol in a rural area of Spain

The results from a year-long study of the organic composition of PM2.5 aerosol collected in a rural area influenced by a highway of Spain are reported. The lack of prior information related to the organic composition of PM2.5 aerosol in Spain, concretely in rural areas, led definition of the goals of this study. As a result, this work has been able to characterize the main organic components of atmospheric aerosols, including several compounds of SOA, and has conducted a multivariate analysis in order to assign sources of particulate matter. A total of 89 samples were taken between April 2004 and April 2005 using a high-volume sampler. Features and abundance of n-alkanes, polycyclic aromatic hydrocarbons (PAHs), alcohols and acids were separately determined using gas chromatography/mass spectrometry and high performance liquid chromatography analysis. The Σn-alkane and ΣPAHs ranged from 3 to 81 ng m^?3 and 0.1 to 6 ng m^?3 respectively, with higher concentrations during colder months. Ambient concentrations of Σalcohols and Σacids ranged from 21 to 184 ng m^?3 and 39 to 733 ng m^?3, respectively. Also, several components of secondary organic aerosol have been quantified, confirming the biogenic contribution to ambient aerosol. In addition, factor analysis was used to reveal origin of organic compounds associated to particulate matter. Eight factors were extracted accounting more than 83% of the variability in the original data. These factors were assigned to a typical high pollution episode by anthropogenic particles, crustal material, plant waxes, fossil fuel combustion, temperature, microbiological emissions, SOA and dispersion of pollutants by wind action. Finally, a cluster analysis was used to compare the organic composition between the four seasons.     

Assessing spatial variability of SO2 field as detected by an air quality network using Self-Organizing Maps,cluster, and Principal Component Analysis

In Bilbao (Spain), an air quality network measures sulphur dioxide levels at 4 locations. The objective of this paper is to develop a practical methodology to identify redundant sensors and evaluate a network's capability to correctly follow and represent SO₂ fields in Bilbao, in the frame of a continuous network optimization process.The methodology is developed and tested at this particular location, but it is general enough to be useable at other places as well, since it is not tied neither to the particular geographical characteristics of the place nor to the phenomenology of the air quality over the area.To assess the spatial variability of SO₂ measured at 4 locations in the area, three different techniques have been used: Self-Organizing Maps (SOMs), cluster analysis (CA) and Principal Component Analysis (PCA). The results show that the three techniques yield the same results, but the information obtained via PCA can be helpful not only for that purpose but also to throw light on the major mechanisms involved. This might be used in future network optimization stages. The main advantage of cluster analysis and SOMs is that they provide readily interpretable results. All the calculations have been carried out using the freely available software R.     

Atmospheric nitrogen deposition in south-east Scotland: Quantification of the organic nitrogen fraction in wet,dry and bulk deposition

Water soluble organic nitrogen (WSON) compounds are ubiquitous in precipitation and in the planetary boundary layer, and therefore are a potential source of bioavailable reactive nitrogen. This paper examines weekly rain data over a period of 22 months from June 2005 to March 2007 collected in 2 types of rain collector (bulk deposition and “dry + wet” deposition) located in a semi-rural area 15 km southwest of Edinburgh, UK (N55°51′44″, W3°12′19″). Bulk deposition collectors are denoted in this paper as “standard rain gauges”, and they are the design used in the UK national network for monitoring precipitation composition. “Dry + wet” deposition collectors are flushing rain gauges and they are equipped with a rain detector (conductivity array), a spray nozzle, a 2-way valve and two independent bottles to collect funnel washings (dry deposition) and true wet deposition. On average, for the 27 weekly samples with 3 valid replicates for the 2 types of collectors, dissolved organic nitrogen (DON) represented 23% of the total dissolved nitrogen (TDN) in bulk deposition. Dry deposition of particles and gas on the funnel surface, rather than rain, contributed over half of all N-containing species (inorganic and organic). Some discrepancies were found between bulk rain gauges and flushing rain gauges, for deposition of both TDN and DON, suggesting biological conversion and loss of inorganic N in the flushing samplers.     

The stable carbon isotope composition of PM2.5 and PM10 in Mexico City Metropolitan Area air

The sources and distribution of carbon in ambient suspended particles (PM_2.5 and PM₁₀) of Mexico City Metropolitan Area (MCMA) air were traced using stable carbon isotopes (¹³C/¹²C). Tested potential sources included rural and agricultural soils, gasoline and diesel, liquefied-petroleum gas, volcanic ash, and street dust. The complete combustion of LP gas, diesel and gasoline yielded the lightest δ¹³C values (?27 to ?29‰ vs. PDB), while street dust (PM₁₀) represented the isotopically heaviest endmember (?17‰). The δ¹³C values of rural soils from four geographically separated sites were similar (?20.7 ± 1.5‰). δ¹³C values of particles and soot from diesel and gasoline vehicle emissions and agricultural soils varied between ?23 and ?26‰. Ambient PM samples collected in November of 2000, and March and December of 2001 at three representative receptor sites of industrial, commercial and residential activities had a δ¹³C value centered around ?25.1‰ in both fractions, resulting from common carbon sources. The predominant carbon sources to MCMA atmospheric particles were hydrocarbon combustion (diesel and/or gasoline) and particles of geological origin. The significantly depleted δ¹³C values from the industrial site reflect the input of diesel combustion by mobile and point source emissions. Based on stable carbon isotope mass balance, the carbon contribution of geological sources at the commercial and residential sites was approximately 73% for the PM₁₀ fraction and 54% for PM_2.5. Although not measured in this study, biomass-burning emissions from nearby forests are an important carbon source characterized by isotopically lighter values (?29‰), and can become a significant contributor (67%) of particulate carbon to MCMA air under the prevalence of southwesterly winds. Alternative sources of these ¹³C-depleted particles, such as cooking fires and municipal waste incineration, need to be assessed. Results show that stable carbon isotope measurements are useful for distinguishing between some carbon sources in suspended particles to MCMA air, and that wind direction has an impact on the distribution of carbon sources in this basin.