Modelling spills of water-reactive chemicals

This paper describes part of a programme of work undertaken at the Health and Safety Laboratory (HSL) to investigate the behaviour of selected water-reactive chemicals. Following an accidental release, such substances react exothermically with any water present, generating acidic vapours. The STAWaRS (Source Term Assessment of Water Reactive Substances) software was developed for the Health and Safety Executive (HSE) by ESR Technology to model this complex process. The aims of the study described here were to provide experimental validation of the heats of hydrolysis used within STAWaRS, and to perform sensitivity studies on selected STAWaRS input parameters.The heat of hydrolysis of acetyl chloride was measured and showed good correlation with the value used within STAWaRS. Some of the variables that influence the severity of acetyl chloride spills are examined, with reference to predictions made by the STAWaRS model. The heats of hydrolysis of titanium tetrachloride previously measured at HSL are also discussed, and the effect of adopting these experimentally derived values for modelling spills is shown for a hypothetical land use planning case. This study demonstrates the importance of using experimentally validated values for STAWaRS input parameters.     

Kinetic parameter estimation for decomposition of organic peroxides by means of DSC measurements

The thermal stability of organic peroxides (cumene hydroperoxide 80 wt% and dicumyl peroxide) was studied by means of calorimetric measurement (DSC, TA Q1000) in an isotherm mode and a dynamic mode. Analysis of power profiles released in the isothermal mode was combined with the analysis of the decomposed compounds by a gas chromatograph/mass spectrometer (GC/MS) to determine the reaction mechanisms corresponding to each of the two reactions. In this work, a methodology for estimating kinetic parameters was based on the comparison of the power profile (dynamic mode) given by the model to that obtained experimentally by changing the parameters values. Parameter estimation is achieved using the mixed estimation method where a genetic algorithm is combined with a locally convergent method.     

Extraction of DNA from amniotic fluid cells for the early prenatal diagnosis of genetic disease

Ten-ml samples of amniotic fluid were taken from pregnancies being terminated at 8–14 weeks' gestation. DNA was extracted from the amniotic cells by sequential centrifugation and analysed using the polymerase chain reaction (PCR). Fifteen samples were analysed for evidence of maternal contamination using Mfd5 oligo-nucleotide primers for repeat polymorphisms. Ten amniotic fluid samples were tested for the Delta-F₅₀₈ deletion characteristic of cystic fibrosis to demonstrate a diagnostic application for the technique. In each case, DNA extracted from fetal tissue from the same pregnancy was included in the controls. In 14 of the 15 cases tested with the Mfd5 primers, both the amniotic fluid DNA and the fetal DNA showed no evidence of contaminating DNA. In one case, neither the amniotic fluid cells nor the fetal cells yielded results. In nine of the ten cases tested with the Delta-F₅₀₈ primers, the amniotic fluid cell DNA provided accurate information about the genetic status of the fetus; in the tenth, the fetal DNA failed to amplify. The results indicate that adequate DNA can be extracted from amniotic fluid from 8 weeks' gestation onward and these samples are suitable for prenatal diagnosis using PCR.     

First-trimester diagnosis of an unusual case of α-mannosidosis

Chorionic villi obtained in the first trimester from a pregnancy at risk for α-mannosidosis were shown to have reduced α-mannosidase (EC 3.2.1.24) activity. The pregnancy was terminated and subsequent enzyme studies of the fetal tissues were consistent with the diagnosis of α-mannosidosis. Like the enzyme in the child's fibroblast, α-mannosidase of the chorionic villi from a pregnancy at risk for α-mannosidosis was activated by high substrate concentration and by Zn^{2 +}, and displayed a K_m value two-fold higher than normal. Our results confirm that chorionic villi can be used for early prenatal diagnosis of α-mannosidosis.     

Prenatal diagnosis for dystrophia myotonica using the polymerase chain reaction

The polymerase chain reaction has been used to detect an abundant class of short repeat DNA families of the form (dC-dA)n.(dG-dT)n, known as microsatellites. These units are found throughout the human genome and have been characterized for several loci including APOC2 on chromosome 19ql2-ql3.2. The locus APOC2 is linked to the gene for dystrophia myotonica and a microsatellite within this locus was used to derive polymorphisms in a family to predict the inheritance of the disease. Chorionic villus sampling (CVS) was performed at 151/2 weeks' gestation. Following DNA extraction from the CVS material and parental blood samples, microsatellite analysis was carried out by the polymerase chain reaction.     

An approach to preimplantation diagnosis of β-thalassaemia

Using the polymerase chain reaction (PCR), it was possible to amplify a single copy fragment of the β-globin gene from 2–32 human embryonic cells obtained from arrested preimplantation embryos. For the detection of β-thalassaemia mutations, allele specific priming of the PCR using nested primers was employed using approximately 10 pg of DN A from individuals known to carry these mutations. This approach was successful in detecting the presence or absence of five Asian Indian β-thalassaemia mutations that were selected for this study. In spite of meticulous precautions against contamination, false-positive amplification was observed, a problem that will have to be overcome before this approach can be used in clinical practice.