Atmospheric BTEX-concentrations in an area with intensive street traffic

The major threat to clean air in developed and industrializing countries is now posed by traffic emissions. The effects of traffic road modifications on the air quality are, however, rarely reported in the literature. The aim of this study was to determine the influence of the modernization and renovation of a traffic artery in the region of Mortsel (Antwerp, Belgium) on the concentration of volatile organic compounds such as: benzene, toluene, ethylbenzene and m-, p-, o-xylenes (BTEX). The original goal of the reconstruction works was to reduce the traffic lanes of one of the busiest streets in Antwerp, in order to discourage the road traffic and in consequence also to improve the air quality in this region. The average concentrations of BTEX before these works in 2003 were: 1.6, 7.0, 0.9, 2.3, and 0.9 μg/m³, for benzene, toluene, ethylbenzene, m + p xylenes, and o-xylene, respectively. However, after the completion of the works, in 2005, they were slightly higher: 2.5, 9.5, 1.6, 3.4, and 1.3 μg/m³, respectively. The scatter plots of benzene against toluene, ethylbenzene and xylenes in 2003 and 2005 showed very good correlations. This fact indicated that all of the measured compounds originated from the same source, namely the road traffic. Moreover, the data obtained from an air-monitoring station at less than 6 km distance from the sampling site (operated by the Flemish Environment Agency, and located in Borgerhout, Antwerp), confirmed the lack of influence of background concentrations of BTEX. The obtained results led to the conclusion that the reduction of the number of traffic lanes had apparently increased the traffic jams and also increased the emission from cars. Therefore, these modernization works had even a negative impact on the local concentration of traffic-related pollutants as BTEX.     

Complying with Executive Order 13148 using the Enterprise Environmental Safety And Occupational Health Management Information System

All U.S. Department of Defense (DoD) facilities are required under Executive Order (EO) 13148, "Greening the Government through Leadership in Environmental Management," to establish quality-based environmental management systems (EMSs) that support environmental decision-making and verification of continuous environmental improvement by December 31, 2005. Compliance with EO 13148 as well as other federal, state, and local environmental regulations places a significant information management burden on DoD facilities. Cost-effective management of environmental data compels DoD facilities to establish robust database systems that not only address the complex and multifaceted environmental monitoring, record-keeping, and reporting requirements demanded by these rules but enable environmental management decision-makers to gauge improvements in environmental performance. The Enterprise Environmental Safety and Occupational Health Management Information System (EESOH-MIS) is a new electronic database developed by the U.S. Air Force to manage both the data needs associated with regulatory compliance programs across its facilities as well as the non-regulatory environmental information that supports installation business practices. The U.S. Air Force, which has adopted the Plan-Do-Check-Act methodology as the EMS standard that it will employ to address EO 13148 requirements.     

A pipette method for rapid karyotyping in prenatal diagnosis

The 'pipette method' is introduced as a method of prenatal diagnosis which is in competition with the 'in situ' and the 'trypsinization' technique. It is sufficiently standardized for routine diagnosis and the banding techniques currently used in prenatal diagnosis (G, Q, C-banding and NOR) have been adapted for it. In 180 cases from 27 different centres, the 'pipette method' was employed for chromosomal harvesting in order to save time. An average of 6·6 days was taken to achieve a result. There was a pathological karyotype in 28 cases (16·1 per cent) and this high proportion can be related to cases where ultrasound scan has led to a diagnosis of 'suspected chromosomal abnormality'. This technique is also of use in advanced stages of pregnancy. The early recognition of the fetal karyotype can contribute to the future management of the pregnancy. The 'pipette method' can also be used in chromosomal harvesting of tumour cells and fibroblast cultures.     

Testing the Norwegian phosphorus index at the field and subcatchment scale

Simple risk assessment tools for agricultural phosphorus (P) losses, like the P index, have been developed in the U.S.A. and in some European countries. Despite its popularity, there have been surprisingly few studies, which try to test the index close to the field scale. For Norway, the P index approach comprises the risk related to both the source of P (soil P status, amount of fertilizer and manure as well as method of application, plant P release by freezing and P balance) and the risk related to transport of P (erosion, flooding, surface runoff, contributing distance, modified connectivity, soil profile, subsurface drainage). In this paper, we have applied the Norwegian P index to farmer fields within a small agricultural catchment, the Skuterud catchment (450 ha), in southeastern Norway. The Norwegian P index was tested for two agricultural fields (0.3–0.4 ha) and nine subcatchments (6–65 ha). Total P concentrations in runoff from the 11 study areas were measured during the year from May 2001 to April 2002. Results from the testing showed that the Norwegian P index described 66% of the variation in measured relative total P concentration for fields and subcatchments included in this study. Additionally, the P index was able to detect fields and subcatchments with the highest measured P concentrations. Results also showed that the source factor contributed most to the variation between fields and hence were important for the identification of high-risk areas in Skuterud catchment. It was found that the soil P status described 66% of the variation in the source factor. Among the transport variables, it was found that both erosion risk and contributing distance had an important influence on the transport factor. Overall, the study illustrated the potential of the P index to detect areas with the highest risk of P loss.     

Aufnahme und Verteilung von Trichloressigsäure in Trieben Norwegischer Fichte

To elucidate the uptake of TCA by roots and its distribution in Norway spruce shoots, experiments with [¹⁴C]TCA were carried out in combination with radioactivity measurements after combustion, and with autoradiographic detection methods. It was shown that the uptake of TCA by spruce shoots is faster during the growth period in June than in the post-growth period in September. A high uptake of radioactivity was observed in the current-year needles, especially in the top of them, and in the corc cambium of the one-year-old wooden parts of the spruce shoots. The results of our experiments suggest uptake of TCA into spruce needles from the soil water with the transpiration stream.     

Reproductive consequences of maternal care patterns during estrus among free-ranging rhesus monkeys

Summary We examined the hypothesis that among free-ranging rhesus monkeys (Macaca mulatta), maternal care patterns during estrus influence chances of conception independently of variation in the timing of the postpartum resumption of mating. We observed 24 multiparous mothers and their infants before and during the 1990 mating season. When mothers resumed mating, they abruptly sought less contact with their infants. Infants responded by increasing the rates with which they emitted distress calls and attempted to make nipple contact. High levels of maternal rejection and low levels of maternal nipple contact initiation during the mother's first estrus were associated with low suckling frequencies and high chances of conception. Although demanding infants had some success in gaining access to the nipples of reluctant mothers during estrus, mothers' chances of conception were unrelated to measures of infant demand or distress calling. Individual differences in maternal behavior regulating access to the nipple during estrus were unrelated to those shown previously. During estrus, mothers appeared to regulate nipple contact according to their infant's age and perhaps other factors related to its vulnerability. Correspondence to: C.M. Berman     

Determination of isocyanates, aminoisocyanates and amines in air formed during the thermal degradation of polyurethane

An air sampling method for the determination of isocyanates, aminoisocyanates and amines formed during the thermal degradation of polyurethane (PUR) is presented. The method is based on the collection of air samples using impinger flasks containing di-n-butylamine (DBA) in toluene with a glass fibre filter in series. Isocyanates are derivatized with DBA to urea derivatives, and amines are derivatized in a subsequent work-up procedure with ethyl chloroformate (ET) to carbamate esters. Amine, aminoisocyanate and isocyanate derivatives were characterized using liquid chromatography-time of flight mass spectrometry (LC-TOFMS) and liquid chromatography-chemiluminescent nitrogen detection (LC-CLND). Quantification was performed by LC-MS, monitoring molecular ions [MH]+ in the electrospray mode. The instrumental detection limits for amines, aminoisocyanates and isocyanates were in the ranges 30-40, 2-3 and 3-70 fmol, respectively. Thermal degradation products of PUR were observed in high concentrations during welding in district heating pipes and PUR-coated metal sheets. Eleven isocyanates, three amines and five aminoisocyanates were identified. The concentrations of isocyanates, aminoisocyanates and amines in samples collected in the smoke close to the welding spot were in the ranges 150-650, 4-290 and 1-70 ppb, respectively. In samples collected in the breathing zone, isocyanates and aminoisocyanates were observed in the ranges 9-120 and 4-19 ppb, respectively. The compounds were present in both gas and particle phases. Volatile compounds dominated in the gas phase, whereas less volatile compounds dominated in the particle phase. The method presented makes it possible to sample and determine amines and aminoisocyanates, in addition to isocyanates. The need to monitor these compounds is clearly illustrated by the high concentrations found during the thermal degradation of PUR.     

Determination of technical grade isocyanates used in the production of polyurethane plastics

A method for determination of technical grade isocyanates used in the production of polyurethane (PUR) is presented. The isocyanates in technical grade products were characterised as di-n-butylamine (DBA) derivatives using LC-MS and LC-chemiluminescent nitrogen detection (CLND) and the total isocyanate content was compared to a titration assay. For collection of isocyanates in air, an impinger-filter sampling technique with DBA as derivatisation reagent was used. Characterised DBA and nonadeuterium labelled DBA derivatives of isocyanates in technical products were used as calibration standards and internal standards, respectively, in the analysis of air samples. Three workplaces were studied where PUR products were produced either by spraying or by moulding. In both technical products and in air samples, a number of monomeric, oligomeric and prepolymeric isocyanates of e.g. methylenebisphenyl diisocyanate (MDI) and hexamethylene diisocyanate (HDI) were characterised. Several of these have not previously been described in workplace atmospheres. In the technical isocyanate products, between 69 and 102% of the NCO content determined by titration was accounted for by LC-CLND. Quantifications of a wide range of isocyanates in air samples were performed with correlation coefficients in the range 0.988-0.999 (n= 8) and the instrumental detection limits were 0.7-25 pg. At the two workplaces where MDI- and HDI isocyanurate-based products were sprayed, the isocyanate composition in the air reflected the composition in the technical product. At the workplace where a MDI-based product was used in a moulding process, only the monomeric isocyanates were found in the air. The advantage of using characterised technical grade isocyanates as analytical standards was clearly demonstrated and the possibility of using index compounds when monitoring isocyanate exposure is discussed.     

A TEST OF SEVERAL EVAPORATION EQUATIONS FOR WATER TEMPERATURE SIMULATIONS IN LAKES1

ABSTRACT: Evaporative heat loss is an essential component of any heat budget used for the modeling of lake water temperatures. Seven evaporative heat loss equations were tested in a year-round, physically-based temperature and dissolved oxygen model for lakes. Deciding which equation to choose for use in the year-round model was based on the goodness of fit of the simulated vs. measured surface temperatures, which were taken at a depth of 1 m below the water surface. An equation which includes free and forced convection components and which was previously used for cooling ponds gave the best fit between temperature simulations and measurements.     

Northern hemisphere concentrations of methane and nitrous oxide since 1800: Results from the Mt. Logan and 20D ice cores

Concentrations of CH₄ and N₂O have been determined in bubbles extracted from the Mt. Logan (Yukon) and 20D (south Greenland) ice cores. The enclosure dates of the trapped gas samples range from 1802 to 1960; thus these data help to document the anthropogenic increases of these two greenhouse gases in the Northen Hemisphere atmosphere. In general, the new data are in accord with previous ice core studies showing accelerating increases in concentration of both gases since 1900. The Mt. Logan records appear to be the first for any trace gases from alpine glacial ice. The present data set is too sparse to be conclusive, but suggests generally higher CH₄ concentrations over south Greenland than Mt. Logan, particularly for the 1850 - 1900 period.