Edaphic factors affecting the vertical distribution of radionuclides in the different soil types of Belgrade, Serbia

The specific activities of natural radionuclides ((40)K, (226)Ra and (232)Th) and Chernobyl-derived (137)Cs were measured in soil profiles representing typical soil types of Belgrade (Serbia): chernozems, fluvisols, humic gleysols, eutric cambisols, vertisols and gleyic fluvisols. The influence of soil properties and content of stable elements on radionuclide distribution down the soil profiles (at 5 cm intervals up to 50 cm depth) was analysed. Correlation analysis identified associations of (40)K, (226)Ra and (137)Cs with fine-grained soil fractions. Significant positive correlations were found between (137)Cs specific activity and both organic matter content and cation exchange capacity. Saturated hydraulic conductivity and specific electrical conductivity were also positively correlated with the specific activity of (137)Cs. The strong positive correlations between (226)Ra and (232)Th specific activities and Fe and Mn indicate an association with oxides of these elements in soil. The correlations observed between (40)K and Cr, Ni, Pb and Zn and also between (137)Cs and Cd, Cr, Pb and Zn could be attributed to their common affinity for clay minerals. These results provide insight into the main factors that affect radionuclide migration in the soil, which contributes to knowledge about radionuclide behaviour in the environment and factors governing their mobility within terrestrial ecosystems.     

The determination of the extractability of selected elements from agricultural soil

Concentrations of Ag, Al, Ba, Cd, Co, Cr, Cu, Fe, K, Mn, Na, Ni, Pb, Sr, and Zn—isolated by sequential extraction steps from apple orchard soil—were analyzed by inductively coupled plasma-atomic emission spectroscopy and compared to the total amount of metal in soil determined by XRF. The extractable amount of each metal was calculated by the extraction yields of the four steps. The LODs of the different elements in all extracts ware below 3 μg/L except for Ba (steps 1 and 2), Cu (step 1), Fe (all steps), K (steps 1–3), Mn (step 2), Na (steps 1–3), Ni (step 1), Pb (steps 1 and 4), and Zn (steps 1 and 2). The highest LOD (>10 μg/L) was found for Fe, K, and Na (step 1). The recovery of all metals after four sequential extraction steps was 90–112%. The repeatability (<1.1%), the intermediate precision (<5.3%), the day-to-day reproducibility (<6.2%), and the overall uncertainty of measurement (approximately 4–8.5%) for all analyzed metals supports the choice of the method used.     

The assessment and prediction of temporal variations in surface water quality—a case study

In order to optimize the processes of sampling, monitoring, and management, the initial aim of this paper was to develop a model for the definition and prediction of temporal changes of water quality. In the case of the Morava River Basin (Serbia), the patterns of temporal changes have been recognized by applying different multivariate statistical techniques. The results of the conducted cluster analysis are the indicators of the existence of the three monitoring periods: the low-water, transitional, and high-water periods, which is in accordance with changes in the water flow in the analyzed river basin. A possibility of reducing the initial data set and recognizing the main pollution sources was examined by carrying out the principal component/factor analysis. The results indicate that the natural factor has a dominant influence in temporal groups. In order to recognize the discriminatory water quality parameters, a discriminant analysis (DA) was carried out. Conducting the DA enabled a significant reduction in the data set by the extraction of two parameters (the water temperature and electrical conductivity). Furthermore, the artificial neural network technique was used for testing the possibility of predicting changes in the values of the discriminant factors in the monitoring periods. The reliability of this method for the prediction of temporal variations of both extracted parameters within all temporal clusters has been proven.     

Periphyton Developed on Artificial Substrates: Effect of Substrate Type and Incubation Depth

The aim of this study was to assess the effect of substrate type and incubation depth on periphyton that had developed on artificial substrates. Uniform rectangular tiles made out of artificial substrates: glass, ceramic, willow tree and yew tree, were fixed on a floating buoy and deployed at three different depths in a photic zone of the Sava Lake (Belgrade, Serbia). Non-taxonomic attributes in the developed biofilm were estimated week-by-week from the start of the experiment in July, until its end in September 2014. Through assessment of substrate type and depth of incubation effect we concluded that these parameters for the fact influence periphyton development and composition. Glass was preferred by autotrophic component over ceramic and wooden substrates. In general, substrate type effect was diminished by increasing incubation depth. When non-taxonomic parameters are to be used in biomonitoring studies, our results suggest that glass substrate and shallow layer of water column (up to 50 cm) for incubation should be preferred.     

Highly active photocatalytic coatings prepared by a low-temperature method

Photocatalytic properties of titanium (IV) oxide (TiO₂) in anatase form can be used for various purposes, including photocatalytic purification of water. For such an application, suspended or fixed photocatalytic reactors are used. Those with fixed phase seem to be preferred due to some advantages, one of which is the avoidance of photocatalyst filtration. To avoid leaching and exfoliation of the fixed phase, an immobilization procedure leading to a good adhesion of a catalyst to a substrate is crucial. Within this work, we present physical and photocatalytic characterization results of five commercially available TiO₂ photocatalysts (P25, P90, PC500, KRONOClean 7000, VPC-10) and one pigment (Hombitan LO-CR-S-M), which were successfully immobilized on glass slides by a “sol suspension” procedure. Different mechanical tests and characterization methods were used to evaluate the stability and morphology of the layers. Evaluation of photocatalytic activity was done by tests under UVA and UV–vis irradiation, using a method based on the detection of the fluorescent oxidation product of terephthalic acid (TPA), i.e., hydroxyterephthalic acid (HTPA). Aeroxide® P90 incorporated into the silica-titania binder was the most photocatalytically active layer and, unlike the others, showed significant increase of photocatalytic activity through the entire range of tested UVA irradiation intensities (2.3 mW/cm²–6.1 mW/cm²). The high mechanical stability of some photocatalytic layers allows using them in water photocatalytic purification reactions.     

Evaluation and validation of two different chromatographic methods (HPLC and LC-MS/MS) for the determination and confirmation of ochratoxin A in pig tissues

This study was undertaken to compare two different analytical methods for the determination and confirmation of ochratoxin A (OTA) in blood serum, kidney and liver of pigs. Sample clean-up was based on liquid-liquid phase extraction. The detection of OTA was accomplished with high-performance liquid chromatography (HPLC) combined either with fluorescence detection (FL) or electro spray ionization (ESI+) tandem mass spectrometry (MS–MS). Comparative method evaluation was based on the investigation of 90 samples of blood serum, kidney and liver per animal originating from different regions of Serbia. The analytical results are discussed in view of the respective method validation data and the corresponding experimental protocols. In general, analytical data obtained with (LC–MS–MS) liquid chromatography electro spray tandem mass spectro metry detection offered comparable good results at the sub-ppb concentration level. The results indicate that the liquid chromatography electro spray tandem mass spectrometric (LC-MS/MS) method was more specific and sensitive for the analysis and confirmation of ochratoxin A in pig tissues then high pressure liquid chromatography (HPLC) method after methylation of OTA.     

Assumptions of the Deficit Model Type of Thinking: Ignorance, Attitudes, and Science Communication in the Debate on Genetic Engineering in Agriculture

This paper spells out and discusses four assumptions of the deficit model type of thinking. The assumptions are: First, the public is ignorant of science. Second, the public has negative attitudes towards (specific instances of) science and technology. Third, ignorance is at the root of these negative attitudes. Fourth, the public’s knowledge deficit can be remedied by one-way science communication from scientists to citizens. It is argued that there is nothing wrong with ignorance-based explanations per se. Ignorance accounts at least partially for many cases of opposition to specific instances of science and technology. Furthermore, more attention needs to be paid to the issue of relevance. In regard to the evaluation of a scientific experiment, a technology, or a product, the question is not only “who knows best?,” but also “what knowledge is relevant and to what extent?.” Examples are drawn primarily from the debate on genetic engineering in agriculture.     

Altered toxicity of organic pollutants in water originated from simultaneous exposure to UV photolysis and CdSe/ZnS quantum dots

The paper reports unforeseen results of increased toxicity of water, subsequent to interactions between CdSe/ZnS quantum dots (QDs), phenol and toluene under UV irradiation. The consistent pattern of changes in measured toxicity (TU) was observed and correlated with degradation of phenol and/or toluene. Spearman rank coefficients (SRCs) for data pairs sum-parameters vs. TU were calculated. The highest correlation between toxicity and degradation by-products was observed for hydroquinone (0.86) and catechol (0.89). The presence of QDs in tested concentration range in the absence of UV has shown low toxicity and no interactions with phenol and/or toluene. The leak of constituent core and shell metal ions was observed. The minor differences in physical characteristics of tested QDs of the same chemical composition led to rather different degradation patterns of phenol and toluene, and the amount of leak of the metal ions as well.     

Toxicity of metalaxyl, azoxystrobin, dimethomorph, cymoxanil, zoxamide and mancozeb to Phytophthora infestans isolates from Serbia

A study of the in vitro sensitivity of 12 isolates of Phytophthora infestans to metalaxyl, azoxystrobin, dimethomorph, cymoxanil, zoxamide and mancozeb, was conducted. The isolates derived from infected potato leaves collected at eight different localities in Serbia during 2005-2007. The widest range of EC(50) values for mycelial growth of the isolates was recorded for metalaxyl. They varied from 0.3 to 3.9 μg mL(-1) and were higher than those expected in a susceptible population of P. infestans. The EC(50) values of the isolates were 0.16-0.30 μg mL(-1) for dimethomorph, 0.27-0.57 μg mL(-1) for cymoxanil, 0.0026-0.0049 μg mL(-1) for zoxamide and 2.9-5.0 μg mL(-1) for mancozeb. The results indicated that according to effective concentration (EC(50)) the 12 isolates of P. infestans were sensitive to azoxystrobin (0.019-0.074 μg mL(-1)), and intermediate resistant to metalaxyl, dimethomorph and cymoxanil. According to resistance factor, all P. infestans isolates were sensitive to dimethomorph, cymoxanil, mancozeb and zoxamide, 58.3% of isolates were sensitive to azoxystrobin and 50% to metalaxyl. Gout's scale indicated that 41.7% isolates were moderately sensitive to azoxystrobin and 50% to metalaxyl.     

Effects of temperature on sorption-desorption processes of imidacloprid in soils of Croatian coastal regions

Sorption-desorption behavior of imidacloprid in six soils collected from five coastal regions in Croatia at 20, 30 and 40°C was investigated using batch equilibrium technique. Isothermal data were applied to Freundlich, Langmuir and Temkin equations, and the thermodynamic parameters ΔH°, ΔG°, ΔS° were calculated. The sorption isotherm curves were non-linear and may be classified as L-type, suggesting a relatively high sorption capacity for imidacloprid. Our results showed that the K( sor ) ( F ) values decreased for all the tested soils as the temperature increased, indicating that the temperature strongly influences the sorption. Values of ΔG° were negative (-4.65 to -2.00 kJ/mol) indicating that at all experimental temperatures the interactions of imidacloprid with soils were spontaneous processes. The negative and small ΔH° values (-19.79 to -8.89 kJ/mol) were in the range of weak forces, such as H-bonds, consistent with interactions and partitioning of the imidacloprid molecules into soil organic matter. The ΔS° values followed the range of -57.12 to -14.51 J/molK, suggesting that imidacloprid molecules lose entropy during transition from the solution phase to soil surface. It was found that imidacloprid desorption from soil was concentration and temperature-dependent, i.e. at lower imidacloprid concentrations and temperature, lower desorption percentage occurred. Desorption studies revealed that hysteretic behavior under different temperature treatments existed, and it was more pronounced at 20°C in the soils with higher OC content. The study results emphasize the importance of thermodynamic parameters in controlling soil pesticide mobility in different geographical locations, seasons and greenhouse conditions.