Atrazine and alachlor transport in claypan soils as influenced by differential antecedent soil water content

Increased attention to ground water contamination has encouraged an interest in mechanisms of solute transport through soils. Few studies have investigated the effect of the initial soil water content on the transport and degradation of herbicides for claypan soils. We investigated the effect of claypan soils at initial field capacity vs. permanent wilting level on atrazine and alachlor transport. The soil studied was Mexico silt loam (fine, smectitic, mesic Aeric Vertic Epiaqualf) with a subsoil clay content, primarily montmorillonite, of >40%. Strontium bromide, atrazine, and alachlor were applied to plots; half were at field capacity (Wet treatment), and half were near the permanent wilting point (Dry treatment). Soil cores were removed at selected depths and times, and cores were analyzed for bromide and herbicide concentrations. Bromide, atrazine, and alachlor were detected at the 0.90-m depth in dry plots within 15 d after experiment initiation. Bromide was detected 0.15 m deeper (P < 0.05) in the Dry compared with the Wet treatment at 1, 7, and 60 d after application and >0.30 m deeper (P < 0.01) in the Dry treatment at 15 and 30 d after application; similar treatment results were found for atrazine and alachlor, although on fewer dates with significant differences. The mobility order of the applied chemicals was bromide > atrazine > alachlor. The atrazine apparent half-life was significantly longer in the Dry plots compared with the Wet plots. The retardation factor determined from the relative velocity of each herbicide to that of bromide was higher for alachlor than for atrazine. This study identifies the impact that shrinkage cracks have for different moisture conditions on preferential transport of herbicides in claypan soils.     

Occurrence and fate of pesticides in four contrasting agricultural settings in the United States

Occurrence and fate of 45 pesticides and 40 pesticide degradates were investigated in four contrasting agricultural settings--in Maryland, Nebraska, California, and Washington. Primary crops included corn at all sites, soybeans in Maryland, orchards in California and Washington, and vineyards in Washington. Pesticides and pesticide degradates detected in water samples from all four areas were predominantly from two classes of herbicides--triazines and chloroacetanilides; insecticides and fungicides were not present in the shallow ground water. In most samples, pesticide degradates greatly exceeded the concentrations of parent pesticide. In samples from Nebraska, the parent pesticide atrazine [6-chloro-N-ethyl-N'-(1-methylethyl)-1,3,5-triazine-2,4-diamine] was about the same concentration as the degradate, but in samples from Maryland and California atrazine concentrations were substantially smaller than its degradate. Simazine [6-chloro-N,N'-diethyl-1,3,5-triazine-2,4-diamine], the second most detected triazine, was detected in ground water from Maryland, California, and Washington. Metolachlor [2-chloro-N-(2-ethyl-6-methylphenyl)-N-(2-methoxy-1-methylethyl)acetamide] rarely was detected without its degradates, and when they were detected in the same sample metolachlor always had smaller concentrations. The Root-Zone Water-Quality Model was used to examine the occurrence and fate of metolachlor at the Maryland site. Simulations accurately predicted which metolachlor degradate would be predominant in the unsaturated zone. In analyses of relations among redox indicators and pesticide variance, apparent age, concentrations of dissolved oxygen, and excess nitrogen gas (from denitrification) were important indicators of the presence and concentration of pesticides in these ground water systems.     

European monitoring for raptors and owls: state of the art and future needs

Sixty-four percent of the 56 raptor and owl species that occur in Europe have an unfavorable conservation status. As well as requiring conservation measures in their own right, raptors and owls function as useful sentinels of wider environmental "health," because they are widespread top predators, relatively easy to monitor, and sensitive to environmental changes at a range of geographical scales. At a time of global acknowledgment of an increasing speed of biodiversity loss, and new, forward-looking and related European Union biodiversity policy, there is an urgent need to improve coordination at a pan-European scale of national initiatives that seek to monitor raptor populations. Here we describe current initiatives that make a contribution to this aim, particularly the current "MEROS" program, the results of a questionnaire survey on the current state of national raptor monitoring across 22 BirdLife Partners in Europe, the challenges faced by any enhanced pan-European monitoring scheme for raptors, and some suggested pathways for efficiently tapping expertise to contribute to such an initiative.     

PUMP-CTD-System for trace metal sampling with a high vertical resolution. A test in the Gotland Basin, Baltic Sea

It is a great challenge to sample seawater across interfaces, for example the halocline or the redoxcline, to investigate trace metal distribution. With the use of 10l sampling bottles mounted to a wire or a CTD-Rosette it is possible to obtain a maximum vertical resolution of 5m. For the detection of small vertical structures in the vertical distribution of trace metals across the redoxcline, the CTD-Bottle-Rosette is not sufficient. Therefore, a PUMP-CTD-System was developed, which enables water sampling with high resolution (1m maximum) along a vertical profile. To investigate the suitability and possible contamination sources of this device two experiments were carried out in the Gotland Basin. The first experiment consisted of two separate profiles. The first profile was obtained with the CTD-Bottle-Rosette and the second with the PUMP-CTD-System. Both were taken from the bottom to the surface water layer. The second experiment was a combined profile obtained from the surface to the bottom with the PUMP-CTD-System attached to the CTD-Bottle-Rosette. Concentrations of dissolved Pb, Cd, Cu, Zn, Fe, Mn, Co and Ni from the "Niskin Bottles" and from the PUMP were measured and compared for each investigation. We demonstrate that it is useful to perform vertical sampling from lower to higher concentrations, e.g. surface to bottom in this environment, and that a longer flushing is required for sampling seawater in the anoxic bottom water. A comparison of the two systems for oxygen and hydrogen sulphide measurements showed an improvement of the precision and the quality of the sampling when using the PUMP. Thus, metal speciation at the oxic-anoxic gradient zone and on a high vertical resolution will be accessible. As concentrations of dissolved Pb, Cd, Cu, Zn, Co, Ni, Fe and Mn in seawater sampled with both devices were in the same range, we conclude that the PUMP-CTD-System is well suited to sample seawater for trace metal analyses.     

Removal and degradation of aromatic compounds from a highly polluted site by coupling soil washing with photocatalysis

The possible application of two environmental remediation technologies - soil washing and photocatalysis - to remove and decompose various aromatic pollutants present in excavated soils of a contaminated industrial site has been investigated. Aqueous solutions containing the non-ionic surfactant Brij 35 were used to extract the contaminants from the soil samples. The photocatalytic treatment of the obtained washing wastes, performed in the presence of TiO(2) suspensions irradiated with simulated sunlight, showed a slow abatement of the toxic compounds due to the relevant concentrations of organics in the waste. A neat improvement of the process performances, obtained by operating in the presence of added potassium peroxydisulfate, suggests a feasible treatment route.     

Leaf accumulation of trace elements and polycyclic aromatic hydrocarbons (PAHs) in Quercus ilex L

Quercus ilex L. leaves were collected four times in one year at six urban sites and one remote area in order to determine trace element and PAH accumulation through concomitant analyses of unwashed and water-washed leaves. Both unwashed and washed leaves showed the highest amounts of trace elements and PAHs in the urban area. Unwashed leaves showed greater differences between urban and remote areas and among the urban sites than washed leaves for trace element and PAH concentrations. Water-washing resulted in a significant (P<0.001) decrease in leaf concentrations of Cr, Cu, Fe, Pb, V and Zn. By contrast, Cd and total PAH concentrations showed no differences between unwashed and washed leaves.     

Seasonal Variation of Toxic Benzene Emissions in Petroleum Refinery

Petroleum refineries are largest chemical industries that are responsible for the emission of several pollutants into the atmosphere. Benzene is among the most important air pollutants that are emitted by petroleum refineries, since they are involved in almost every refinery process. Volatile organic compounds (VOCs) are a major group of air pollutants, which play a critical role in atmospheric chemistry. These contribute to toxic oxidants, which are harmful to ecosystem, human health and atmosphere. The variability of pollutants is an important factor in determining human exposure to these chemicals. The ambient air concentrations of benzene were measured in several sites around the Digboi petroleum refinery, near the city of Gowahati in northeast India, during winter and summer 2004. The seasonal and spatial variations of the ambient air concentrations of this benzene were investigated and analyzed. An estimation of the contribution of the refinery to the measured atmospheric levels of benzene was also performed. The ambient air mixing ratios of benzene in a large area outside the refinery was generally low, in ppbv range, much lower than the ambient air quality standards. This article presents the temporal and spatial variation of air pollution in and around petroleum refinery and showed that no health risk due to benzene is present in the areas adjacent to the refinery.     

Impact of continental margins in the Mediterranean Sea: Hints from the surface colour and temperature historical record

The surface colour and temperature fields of the Mediterranean Sea, as appearing in time series, of basin-wide images available in the CZCS (1979–1985) and AVHRR (1982–1991) historical archives, differentiate between basin interior and continental margins affected by coastal patterns, river plumes, and mesoscale features. The original data were processed to apply calibration factors, to correct for atmospheric contamination, and to estimate chlorophyll-like pigment concentration and surface temperature. Composites were derived, as monthly and annual means, using a fixed equal-area projection with a 1-km² pixel grid. Enhanced pigment values and lower temperatures along the northern coastal areas (i.e. the Ligurian, Provençal and Balearic basins, as well as the Adriatic, and Aegean Seas) have been associated with the impact of runoff from continental margins (i.e. both a direct impact due to the sediment load and one induced on the planktonic flora by the associated nutrient load) and with vertical mixing due to the prevailing winds (i.e. the Mistral in the northwest, the Bora in the Adriatic, the Etesians in the Aegean). The pattern of increasing pigments and decreasing temperatures in seen to develop in the monthly images from the coastal zone towards the open sea from summer to winter, and then back from winter to summer. The southern coastal areas show different values, namely lower pigments and higher temperatures (except in areas where the data are altered by signal contamination). It is suggested that differences in geomorphology and meteorology of the basin margins have an impact on both water biogeochemistry and dynamics, influencing the biooptical and thermal properties of the various sub-basins, and of the entire Mediterranean region.     

Elemental (C, N and P) analysis of metamorphosing bonefish (Albula sp.) leptocephali: relationship to catabolism of endogenous organic compounds, tissue remodeling, and feeding ecology

Whole-body carbon (C), nitrogen (N) and phosphorus (P) content, and stable-isotope composition (¹³C:¹²C and ¹⁵N:¹⁴N), were followed during metamorphosis of bonefish (Albula sp.) larvae (leptocephali). Metamorphosing larvae depend entirely on endogenous carbon compounds (some of which contain N and P) as an energy source. Two fundamental questions are (1) Do the demands of extensive tissue remodeling during metamorphosis require the efficient retention of N and P during the catabolism of carbon compounds? (2) What effect does the lack of feeding have on stable-isotope composition? Our results showed that both C and N decreased by ～35 to 40%, reflecting the utilization of neutral lipid (triacylglycerols) and N-containing compounds (phosphatidylethanolamine and keratan sulfate glycosaminoglycan) as energy sources, and indicating that larvae have little or no capacity to retain N. Evidence suggested that collagen breakdown, measured as a loss of hydroxyproline content, also contributed to N loss. Stable-isotope ratios, expressed as ¹³C and ¹⁵N, showed no statistically significant differences in early and advanced metamorphosing larvae. In contrast to C and N, phosphorus was conserved during metamorphosis and most probably is utilized in the increased bone mineralization occurring in advanced larvae. We show, however, that advanced larvae are P-limited and that normal ossification is dependent upon a supply of exogenous P obtained after the resumption of feeding. The N:P ratio of 12.3 in early larvae decreased to 8.1 in advanced larvae owing to the conservation of P as N was lost. The mean ¹⁵N value in early metamorphic larvae (11.6‰) is consistent with results from other studies, and provides further support for the view that premetamorphic leptocephali feed at a very low trophic level.