Trace metals in soil and leaves of Jacaranda mimosifolia in Tshwane area,South Africa

Plant and soil have been identified as major sink of pollutants in the environment. We evaluated the reliability of biomonitoring of heavy metals in Tshwane area with the use of leaves of Jacaranda mimosifolia. The concentrations of heavy metals such as Ca, Mg, Fe, Pb, Zn, Cu, Sb were measured in leaves of J. mimosifolia and soils collected from 10 sites in the city of Tshwane during two sampling periods. The metals were analyzed with the use of ICP-MS. The result shows significant differences in the concentration of trace metals in all the sites (p < 0.01). The differences between the two sampling periods were statistically significant (p < 0.01). Concentration of metals from high traffic and industrial sites were significantly higher than in the residential areas (p < 0.01). Concentration factor suggests that translocation of metals from roots to leaves could be relevant only for some metals such as Ca, Mg and Sb. The study reveals an anthropogenic source for the trace metals. Leaves of J. mimosifolia were found to be a useful biomonitor of the determined trace metals.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

A 3D aerosol and visibility information system for urban areas using remote sensing and GIS

Currently, the depiction of urban air quality at boundary layer scale uses modelled climatic and land cover data. However, such models are difficult to verify, and only low to moderate accuracy may be achieved due to the complexity of the input data required and the reliance on assumptions about dispersion patterns. The provision of comprehensive air quality data to urban residents in city districts, at a level of detail commensurate with other Location-Based Services (LBS) which are time- and place-sensitive, has therefore not been possible. A method for urban air quality monitoring over cities at boundary layer scale, other than by the use of air quality models is presented here. The system presented uses empirical Aerosol Optical Thickness (AOT) data in near-real time, combining AOT data from AERONET with aerosol vertical profiles computed from twice-daily MODIS satellite images at 500 m resolution, to give three dimensional (3D) air quality data over the urban landscape. There has been no previous attempt to project the horizontal spatial distribution of aerosols from satellite image pixels into a vertical dimension to give a spatially comprehensive three dimensional record of air quality. The paper describes the sources and accuracy of the AOT data input to the system as well as its storage and retrieval on a Geographic Information System (GIS) platform, to provide air quality and visibility information according to user query at any 3D geographical location, including individual buildings or building floor.     

The seasonal cycles and photochemistry of C2–C5 alkanes at Mace Head

Continuous in-situ measurements of NMHCs at Mace Head, Ireland during two full annual cycles from January 2005 to January 2007 were used to investigate NMHC emission sources and transport including dilution and photochemical oxidation. The Mace Head research station is ideally located to sample a wide range of air masses including polluted European transport, clean North Atlantic and Arctic air masses and the ultra-clean, Southern Atlantic air masses. The variety in air mass sampling is used to investigate interaction of emissions, transport, dilution and photochemistry. Variability of long-lived hydrocarbon ratios is used to assess and estimate typical transport times from emission source to the Mace Head receptor. Seasonality in the ratios of isomeric alkane pairs (for butane and pentanes) are used to assess the effects of atmospheric transport and photochemical ageing. Finally, the natural logarithms of NMHC ratios are used to assess photochemical oxidation.     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Economic damages of ozone air pollution to crops using combined air quality and GIS modelling

This study aims at presenting a combined air quality and GIS modelling methodological approach in order to estimate crop damages from photochemical air pollution, depict their spatial resolution and assess the order of magnitude regarding the corresponding economic damages. The analysis is conducted within the Greater Thessaloniki Area, Greece, a Mediterranean territory which is characterised by high levels of photochemical air pollution and considerable agricultural activity. Ozone concentration fields for 2002 and for specific emission reduction scenarios for the year 2010 were estimated with the Ozone Fine Structure model in the area under consideration. Total economic damage to crops turns out to be significant and estimated to be approximately 43 M€ for the reference year. Production of cotton presents the highest economic loss, which is over 16 M€, followed by table tomato (9 M€), rice (4.2 M€), wheat (4 M€) and oilseed rape (2.8 M€) cultivations. Losses are not spread uniformly among farmers and the major losses occur in areas with valuable ozone-sensitive crops. The results are very useful for highlighting the magnitude of the total economic impacts of photochemical air pollution to the area’s agricultural sector and can potentially be used for comparison with studies worldwide. Furthermore, spatial analysis of the economic damage could be of importance for governmental authorities and decision makers since it provides an indicative insight, especially if the economic instruments such as financial incentives or state subsidies to farmers are considered.     

Study on ambient concentrations of PM10, PM10–2.5, PM2.5 and gaseous pollutants. Trace elements and chemical speciation of atmospheric particulates

This study provides the first comprehensive report on mass concentrations of particulate matter of various sizes, inorganic and organic gas concentrations monitored at three sampling sites in the city of Palermo (Sicily, Italy). It also provides information on the water-soluble species and trace elements. A total of 2054 PM₁₀ (1333) and PM_2.5 (721) daily measurements were collected from November 2006 to February 2008. The highest mass concentrations were observed at the urban stations, average values being about two times higher than those at the suburban (control) site. Time variations in PM₁₀ and also PM_10–2.5 were observed at the urban stations, the highest concentrations being measured in autumn and winter. CO, NOx, NO₂, benzene, toluene and o-xylene concentrations peaked in autumn and winter, a pattern similar to those recorded for PM₁₀ and PM_10–2.5 mass levels, indicating the importance of traffic emissions in urban air pollution. 91% and 51% of the benzene measurements exceeded the limit of 5 μg m^?3 at the two urban monitoring sites. Trace elements (As, Ba, Cr, Cu, Mo, Pb, Sb) suspected of being introduced into the atmosphere mainly by anthropogenic activities, were highly enriched with respect to local soil. Results indicate that a large fraction of PM₁₀ (31–47% in weight) and PM_2.5 (29% in weight) is made up of water-soluble ions. Ammonium sulphate and nitrate particles accounted for 14–29 wt% of particulate matter mass concentrations. Crustal and marine components, combined, account for 41% and 49% in PM_2.5 and PM₁₀, respectively. The calculated deficits in Cl^- and NH₄⁺ ions suggest that a proportion of these ions are lost, via the formation of gaseous NH₄Cl or HCl and NH₃.     

Chemical mass balance source apportionment for combined PM2.5 measurements from U.S. non-urban and urban long-term networks

The Minnesota Particulate Matter 2.5 (PM_2.5) Source Apportionment Study was undertaken to explore the utility of PM_2.5 mass, element, ion, and carbon measurements from long-term speciation networks for pollution source attribution. Ambient monitoring data at eight sites across the state were retrieved from the archives of the Interagency Monitoring of Protected Visual Environments (IMPROVE) and the Speciation Trends Network (STN; part of the Chemical Speciation Network [CSN]) and analyzed by an Effective Variance – Chemical Mass Balance (EV-CMB) receptor model with region-specific geological source profiles developed in this study. PM_2.5 was apportioned into contributions of fugitive soil dust, calcium-rich dust, taconite (low grade iron ore) dust, road salt, motor vehicle exhaust, biomass burning, coal-fired utility, and secondary aerosol. Secondary sulfate and nitrate contributed strongly (49–71% of PM_2.5) across all sites and was dominant (≥60%) at IMPROVE sites. Vehicle exhausts accounted for 20–70% of the primary PM_2.5 contribution, largely exceeding the proportion in the primary PM_2.5 emission inventory. The diesel exhaust contribution was separable from the gasoline engine exhaust contribution at the STN sites. Higher detection limits for several marker elements in the STN resulted in non-detectable coal-fired boiler contributions which were detected in the IMPROVE data. Despite the different measured variables, analytical methods, and detection limits, EV-CMB results from a nearby IMPROVE-STN non-urban/urban sites showed similar contributions from regional sources – including fugitive dust and secondary aerosol. Seasonal variations of source contributions were examined and extreme PM_2.5 episodes were explained by both local and regional pollution events.     

湿式纤维层非稳态过滤净化阻力的研究

在干式纤维层过滤净化阻力的理论基础上,提出清洗水均匀分布于纤维丝表面的基本假设,使湿式过滤中对液滴、液膜、液珠的分析简单具体化。并通过实验结论归纳出净化阻力随时间的变化规律,导出湿式纤维层非稳态过滤净化阻力的表达式,并用实验验证了其准确性。     

Patagonian Fjord Ecosystems in Southern Chile as a Highly Vulnerable Region: Problems and Needs

Southern Chile encompasses one of the most extensive fjord regions of the world, the Patagonia, currently exposed to natural and anthropogenic perturbations. These fjord ecosystems provide important services to humans, which have not been adequately measured and valued. As a consequence, ecosystem services are commonly ignored in public policy design and in the evaluation of development projects. Here we tackle questions that are highly relevant for the nation’s development, namely (1) understanding fjord functioning, and (2) developing management strategies based on ecosystem services, in order to secure simultaneous and adequate use of these ecosystems which area influenced by ecological (e.g., biogeochemical) and productive (e.g., aquaculture, fisheries) processes. We also seek to strengthen the analysis of fjord ecosystem value from the economical (including coastal zoning), socio-cultural, institutional, and governmental points of view. In addition, the investigation of current and future effects of climate change on this large region offers a unique opportunity to understand the social and economic consequences of a global phenomenon at local to regional scales. Biogeochemical and socio-economic models will be used to simulate future scenarios under a gamut of management options.